兰州数字遥测地震台网信号传输方式的设计

介绍了地震信号传输的常用方式及各自的优缺点，提出了数字遥测地震台网信号传输方式设计的总原则和基本原则。实际应用表明，兰州数字遥测地震台网信号传输方式的是符合要求的，提出的数字遥测地震台网信号传输方式的总原则和基本原则，对数字遥测地震台网建设有直接的借鉴作用。     

地震前兆仪器嵌入TCP/IP协议的初步试验

根据“十五”总体设计方案的要求，对TCP／IP协议在地震前兆仪器上的实现进行了试验，在有关设备上进行了程序开发，取得了预期的效果。     

岳阳及周边地区地震构造与地震活动性研究

陈述了岳阳市及周边地区的主要断裂带及其地震活动，归纳了发震部位。认为利用小震条带预报本区地震具有积极意义，并运用数理统计法预测了本区今后50及100年内的地震活动水平。     

Study of crustal structure with S—wave data from Maqen—Jingbian profile

2-D crustal velocity structure and vp/vs are obtained by processing and interpretation of S-wave data from Maqen-Jingbian deep seismic sounding(DSS)profile.The result shows that there exist obvious differences in 2-D S-wave velocity structure and vp/vs ratio structure along the profile.The S-wave velocities are low and vp/vs ration is high for the westem section of the profile and Haiyuan region,while they are normal for the middle and eastern sections.The changes in lithologic characters of two major anomalous zones are discussed according to lateral variation of S-wave velocity structure and vp/vs ratio structure.It is concluded that the development and occurrence of the Haiyuan strong earthquake is not only related to tectonic activities,but also to lithologic characters of the region.     

甚宽频带数字地震仪震级偏差的初步研究

仅对高台地震台数字地震仪记录的震级与标准震级的偏差问题进行了分析。     

Statistical tests for regional seismic phase characterizations

In seismic analysis some assumptions are often made aboutthe data, e.g. stationarity and Gaussianity. This is not obvious for all realseismic data. Here, we use statistical tests for characterization of regionalseismic data. We apply tests for stationarity, symmetry, linearity, andtime-reversibility. In the analysis we use twelve regional seismic events inFennoscandia recorded with the seismic small-aperture arrays NORESS,ARCESS and FINESA at hypocentral distances in the range from 160 to1580 km. For the tests we use the regional phases Pn, secondary P, Sn and Lg-phases and the preceding noise. Two of the eventsare explosions, two are rockbursts and eight are earthquakes. Theperformance and possibilities of using statistical tests based on bispectra, asa complementary tool for conventional analysis of seismic phases isdemonstrated. The preceding noise recorded before the first onset of theP-wave for the twelve events is tested to be spatially stationarybetween each channel within each array and temporal stationary in 21consecutive time windows of 3.2 sec each. Also, the preceding noise issymmetric and linear. The seismic phases defined by the symmetry test asnon-Gaussian (not symmetric) are all linear. This means a linear model canbe used to characterize both the noise and the phases. The first P-phase for the two explosions is characterized as non-Gaussian at thethree arrays. For all 36 possibly first P-phase arrivals at the three arraystations, 23 are non-Gaussian. The second P-phase is non-Gaussian at13 of 36 data records, the S-phase at eleven of 36 and the Lg-phase at nine of 36. For all the four phases more than 32 of possible36 are time-reversible.     

Nonlinear Rate Dependent Model of High Damping Rubber Bearing

The accurate analysis of the response of isolated structures requires the application of appropriate models of isolation devices. The purpose of this paper is to analyse a nonlinear strain rate dependent model of a high damping rubber bearing which simulates the horizontal behaviour of the device under specified vertical load using a nonlinear elastic spring-dashpot element. The effectiveness of the model is checked by fitting the experimental data concerning three different rubber bearings. The results of the study show that the model can simulate the bearing behaviour over a wide shear strain range with small simulation errors. This revised version was published online in July 2006 with corrections to the Cover Date.     

Inelastic dynamic analysis of RC bridges accounting for spatial variability of ground motion,site effects and soil–structure interaction phenomena. Part 1: Methodology and analytical tools

During strong ground motion it is expected that extended structures (such as bridges) are subjected to excitation that varies along their longitudinal axis in terms of arrival time, amplitude and frequency content, a fact primarily attributed to the wave passage effect, the loss of coherency and the role of local site conditions. Furthermore, the foundation interacts with the soil and the superstructure, thus significantly affecting the dynamic response of the bridge. A general methodology is therefore set up and implemented into a computer code for deriving sets of appropriately modified time histories and spring–dashpot coefficients at each support of a bridge with account for spatial variability, local site conditions and soil–foundation–superstructure interaction, for the purposes of inelastic dynamic analysis of RC bridges. In order to validate the methodology and code developed, each stage of the proposed procedure is verified using recorded data, finite‐element analyses, alternative computer programs, previous research studies, and closed‐form solutions wherever available. The results establish an adequate degree of confidence in the use of the proposed methodology and code in further parametric analyses and seismic design. Copyright © 2003 John Wiley & Sons, Ltd.     

Seismic response predictions of multi‐span steel bridges through pushover analysis

In the new trend of seismic design methodology, the static pushover analysis is recommended for simple or regular structures whilst the time‐history analysis is recommended for complex structures. To this end, the applicable range of the pushover analysis has to be clarified. This study aims at investigating the applicability of pushover analysis to multi‐span continuous bridge systems with thin‐walled steel piers. The focus is concentrated on the response demand predictions in longitudinal or transverse directions. The pushover analysis procedure for such structures is firstly summarized and then parametric studies are carried out on bridges with different types of superstructure‐pier bearing connections. The considered parameters, such as piers' stiffness distribution and pier–0.5ptdeck stiffness ratio, are varied to cover both regular and irregular structures. Finally, the relation of the applicability of pushover analysis to different structural formats is demonstrated and a criterion based on the higher modal contribution is proposed to quantitatively specify the applicable range. Copyright © 2003 John Wiley & Sons, Ltd.     

千兆网支持下的城市公众GIS

当前GIS技术的发展已经进入到一个新的阶段,呈现出网络化、专业化、智能化、大众化等特点。公众GIS是近年来新兴的GIS应用领域,它主要的目的是面向公众提供信息服务。介绍了城市公众GIS的基本概念、特点和系统功能,在分析了当前公众GIS存在的问题之后,继而提出一种适合宽带网络(千兆以太网)支持下的公众GIS系统结构,并进一步分析了它的功能和用途。