地震波形数据实时监控软件的实现

介绍了地震数据采集器监控软件的设计思路,特别是在实时波形显示上,采用“环形”的显示缓存和“滑动显示窗口”技术,大数据量时也能以左移的方式连续显示实时曲线的动态变化;实时波形的纵坐标范围也是动态变化的,在任何时刻都恰好能在显示区域内完整显示。文章还介绍了如何在显示中消除明显的屏幕闪烁现象,以及对数据从传输到存储、显示的分层设计思想和多线程技术的应用。     

热德拜油田水平井优快钻井配套技术

为加快热德拜油田水平井钻井开发步伐,通过对岩石力学特性、岩石理化特性、井眼轨道、钻具组合、钻头选型等方面的研究,形成了以PDC钻头复合钻井技术、井眼轨迹控制技术、防漏堵漏钻井液技术、筛管顶部双级注水泥固井技术等为主的科学、合理的配套工艺技术,并应用于现场施工,加快了热德拜水平井开发步伐,节约了开发成本。2012年水平井平均钻井周期为42.96天,完井周期53.38天;2013年水平井平均钻井缩短至19.58天;完井周期37天,同比钻井周期缩短54.4％,完井周期缩短41.1％。     

微型高频双层振动筛在绿色勘查钻探中的应用

绿色勘查钻探施工广泛采用便携式全液压钻机,受便携钻机泥浆工艺、占地面积的影响,没有配套的泥浆净化设备,施工中存在浪费水资源、废弃泥浆没有环保处理的问题。综合分析各种泥浆净化方法,提出使用微型高频双层圆形振动筛净化泥浆的方案,效果较好,经济实用,符合绿色勘查要求。     

Kinetics of heterogeneous bubble nucleation in rhyolitic melts: implications for the number density of bubbles in volcanic conduits and for pumice textures

We performed decompression experiments to simulate the ascent of a phenocryst-bearing rhyolitic magma in a volcanic conduit. The starting materials were bubble-free rhyolites water-saturated at 200 MPa–800°C under oxidizing conditions: they contained 6.0 wt% dissolved H₂O and a dense population of hematite crystals (8.7 ± 2 × 10⁵ mm⁻³). Pressure was decreased from the saturation value to a final value ranging from 99 to 20 MPa, at constant temperature (800°C); the rate of decompression was either 1,000 or 27.8 kPa/s. In all experiments, we observed a single event of heterogeneous bubble nucleation beginning at a pressure P _N equal to 63 ± 3 MPa in the 1,000 kPa/s series, and to 69 ± 1 MPa in the 27.8 kPa/s series. Below P _N, the degree of water supersaturation in the liquid rapidly decreased to a few 0.1 wt%, the nucleation rate dropped, and the bubble number density (BND) stabilized to a value strongly sensitive to decompression rate: 80 mm⁻³ at 27.8 kPa/s vs. 5,900 mm⁻³ at 1,000 kPa/s. This behaviour is like the behavior formerly described in the case of homogeneous bubble nucleation in the rhyolite-H₂O system and in numerical simulations of vesiculation in ascending magmas. Similar degrees of water supersaturation were measured at 27.8 and 1,000 kPa/s, implying that a faster decompression rate does not result in a larger departure from equilibrium. Our experimental results imply that BNDs in acid to intermediate magmas ascending in volcanic conduits will depend on both the decompression rate and the number density of phenocrysts, especially the number density of magnetite microphenocrysts (1–100 mm⁻³), which is the only mineral species able to reduce significantly the degree of water supersaturation required for bubble nucleation. Very low BNDs (≈1 mm⁻³) are predicted in the case of effusive eruptions ( ≈ 0.1 kPa/s). High BNDs (up to 10⁷ mm⁻³) and bimodal bubble size distributions are expected in the case of explosive eruptions: (1) a relatively small number density of bubbles (1–100 mm⁻³) will first nucleate in the lower part of the conduit ( ≈ 10 kPa/s), either at high pressure on magnetite or at lower pressure on quartz and feldspar (or by homogeneous nucleation in the liquid) and (2) then, extreme decompression rates near the fragmentation level ( ≈ 10³ kPa/s) will trigger a major nucleation event leading to the multitude of small bubbles, typically a few micrometers to a few tens of micrometers in diameter, which characterizes most silicic pumices.     

数据墙显示系统的构建技术

构建了一个具有多屏拼接和笔式交互特性的数据墙显示系统,该系统由支撑框架、显示和激光笔交互3部分组成,支撑框架部分设计了可快速拆装的结构,保证了便携性;显示系统是由3块背投屏幕和3台投影机组成,可显示大数据量信息;激光笔交互则利用3块摄像头分别对屏幕进行实时捕捉图像,再对图像中激光点位置处理从而获得激光点位置,实现了用户直接在屏幕上进行笔式交互。     

大孔径闪烁仪观测数据的处理方法研究

大孔径闪烁仪可以获取公里级尺度的显热/潜热通量,其观测数据在农林业、水文、气象等领域的研究中具有越来越重要的作用.以海河流域2008年密云站和馆陶站大孔径闪烁仪的观测数据为例,讨论了数据筛选与处理方法,以及大气不稳定状态下不同处理方法对显热通量造成的影响.结果表明:空气折射指数结构参数应结合电压信号的方差进行计算、采用逐日的日平均波文比系数进行湿度订正、结合空间权重函数计算有效高度、选取Andreas(1988)稳定度函数计算显热通量等是可信的.通过对不同插补方法的比较可知,采用非线性回归方法和以零值替代的方法对不稳定状态和稳定状态下30 min缺失的显热通量进行插补,采用动态线性回归方法对日显热通量的缺失进行插补是可行的.为了解决由于冬天净辐射和显热通量较小,造成能量平衡方程余项法计算的蒸散量产生较大误差的问题,可采用根据大孔径闪烁仪与涡动相关仪观测的日蒸散量建立的关系式进行估算.基于上述方法的研究,形成了一套较为完整的大孔径闪烁仪观测数据的处理流程,保证了在不同下垫面、不同的天气状况条件下都能获取质量可靠、数据连续的大孔径闪烁仪观测的显热/潜热通量.     

花管注浆在全充填采空区治理工程的应用

为规范采空区治理工程设计方案和施工工艺,杜绝因设计方案导致的治理质量隐患,结合《高速公路采空区(空洞)勘察设计与施工治理手册》,通过对各采空区治理工程试验段试验、检测统计分析,提出全充填压力注浆法设计、施工优化改进技术方案——浆液正循环花管注浆法。此法可完全消除冒落带和裂隙带通道堵塞、钻孔主通道封闭现象,彻底解决传统裸孔注浆法经常出现的注浆表观终止假象;可高压直接作用孔底和孔壁,有效突破煤柱边缘孔底通道;可完全解决注浆孔因堵塞、封闭等原因造成的报废事故,节约投资;提高浆液的充填率和结石率,能够安全有效保证治理质量。     

The evaluation method of total damage to ship in underwater explosion

Whipping response will happen when a ship is subjected to underwater explosion bubble load. In that condition, the hull would be broken, and even the survivability will be completely lost. A calculation method on the dynamic bending moment of bubble has been put forward in this paper to evaluate the impact of underwater explosion bubble load on the longitudinal strength of surface ships. Meanwhile the prediction equation of bubble dynamic bending moment has been concluded with the results of numerical simulation. With wave effect taken into consideration, the evaluation method of the total damage of a ship has been established. The precision of this evaluation method has been proved through the comparison with calculation results. In order to verify the validity of the calculation results, experimental data of real ship explosion is applied. Prediction equation and evaluation method proposed in this paper are to be used in ship structure design, especially in the preliminary prediction of the ultimate withstanding capability of underwater explosion damage for the integrated ship in preliminary design phase.     

AGN effect on cooling flow dynamics

We analyzed the feedback of AGN jets on cooling flow clusters using three-dimensional AMR hydrodynamic simulations. We studied the interaction of the jet with the intracluster medium and creation of low X-ray emission cavities (Bubbles) in cluster plasma. The distribution of energy input by the jet into the system was quantified in its different forms, i.e. internal, kinetic and potential. We find that the energy associated with the bubbles, (pV+γ pV/(γ−1)), accounts for less than 10 percent of the jet energy.     

Gas exsolution and flow during supersaturated water injection in porous media: II. Column experiments and continuum modeling

Degassing and in situ development of a mobile gas phase takes place when an aqueous phase equilibrated with a gas at a pressure higher than the subsurface pressure is injected in water-saturated porous media. This process, which has been termed supersaturated water injection (SWI), is a novel and hitherto unexplored means of introducing a gas phase in the subsurface. We give herein a first macroscopic account of the SWI process on the basis of continuum scale simulations and column experiments with CO₂ as the dissolved gas. A published empirical mass transfer correlation [Nambi IM, Powers SE. Mass transfer correlations for nonaqueous phase liquid dissolution from regions with high initial saturations. Water Resour Res 2003;39(2):1030. doi:10.1029/2001WR000667] is found to adequately describe non-equilibrium transfer of CO₂ between the aqueous and gas phases. Remarkably, the dynamics of gas-water two-phase flow, observed in a series of SWI experiments in homogeneous columns packed with silica sand or glass beads, are accurately predicted by traditional two-phase flow theory and the corresponding gas relative permeability is determined. A key consequence of this finding, namely that the displacement of the aqueous phase by gas is compact at the macroscopic scale, is consistent with pore scale simulations of repeated mobilization, fragmentation and coalescence of large gas clusters (i.e., large ganglion dynamics) driven entirely by mass transfer. The significance of this finding for the efficient delivery of a gas phase below the water table is discussed in connection to the alternative process of in situ air sparging, and potential advantages of SWI are highlighted.