郯庐断裂带的断裂活动对渤海东部中、新生代裂谷盆地发育的控制作用

郯庐断裂带自南而北穿越渤海东部,自中生代中期至新生代中期表现裂谷发育特征。裂谷发育经历两个旋回,各旋回的裂谷发育演化、盆地分布格局,沉积相带,沉积补偿速度等均受断裂带的断裂活动的强烈控制。     

红河断裂构造带在东南亚的延伸特征及其大地构造意义

根据地质、地貌及地球物理资料分析,探讨展布于云南边陲哀牢山两侧的北西向断裂组成的红河断裂构造带,在东南亚的延伸特征。提出在该延伸带两侧沉积建造、构造活动,地球物理场和大地构造发展上均有显著差异。并进一步探讨该断裂构造带在大地构造上的意义。     

新疆阿尔泰山南部富蕴右旋走滑断裂带晚第四纪错断水系的遥感分析研究

富蕴断裂带位于阿尔泰山南侧,横切阿尔泰山褶皱带南缘及额尔齐斯深断裂,是一条呈北北西向展布的右旋走滑断裂带。沿断裂带发育一系列错断水系、错断冲积扇、挤压脊、走滑拉分盆地等反映右旋走滑活动的典型构造地貌标志。本研究在高分辨率遥感图像和数字高程模型分析的基础上,结合野外实地构造地貌测量,对沿富蕴断裂带发育的系统错断水系特征进行了详细分析研究。研究结果表明,沿富蕴断裂带发育不同级别的错断水系,大致可划分为6级:1931年地震形成的冲沟;90m左右断距的错断水系;150m左右断距的错断水系;500m左右断距的错断水系;1500m左右断距的错断水系;2000m以上断距的错断水系。同时,结合研究区及邻区的第四纪冰川资料讨论了不同级别水系可能形成时间:恰尔沟三级支流可能形成时间为末次冰期Ⅲ阶段末期,约20ka;恰尔沟二级支流可能形成时间为末次冰期Ⅰ阶段末期,约120ka;恰尔沟一级支流可能形成于该地区冰川广泛消融的倒数第2次冰期的Ⅱ阶段末期,约为250ka;恰尔沟、水磨沟、白杨沟、乌铁布拉克河、卡布尔特河等可能形成于倒数第3次冰期Ⅱ阶段末期,约为360ka。最后,我们估算出富蕴断裂带晚第四纪以来的平均右旋走滑速率为1.46～4.99mm/a。     

丽江市地质灾害易发性遥感影像判译

丽江市地质灾害多发,在滇西北旅游城市中较典型。应用遥感技术对丽江市地质灾害易发性的遥感研究,可突破传统方法,发挥宏观、综合、直观、快速特点,取得较好效果。     

福建戴云山隧道断层性质与稳定性研究

隧道断层（F2）为张性正断层,破坏原岩中较为对称的应力平衡,加之带内岩石破碎,节理裂隙发育,使得断层更加容易坍塌和涌水。建议采用稳定掌子面法和专门支护保证硐室稳定。     

中缓倾角结构面分类及其抗剪强度的研究

西南某坝区中缓倾角结构面具有分别倾向上游和下游的空间分布规律。根据结构面接触情况,首先将结构面分为刚性结构面和软弱结构面两大类。其中,刚性结构面属于裂隙型;软弱结构面根据其物质组成和结构特征,可以细分为岩块岩屑型、岩屑夹泥型、泥夹岩屑型3个亚类。断层类结构面具有垂直于断层走向,由高高程到低高程,由泥夹岩屑型岩屑夹泥型岩屑砾型裂隙型逐渐过渡的发育规律。最后在分析抗剪试验资料和分类及发育规律的基础上,提出了抗剪强度指标的建议值。     

郑州市城区深部基岩层热储特征分析

通过对郑州市城区深部基岩层热储的岩性、构造、热源及盖层条件分析研究,总结了该区热储特征,并首次提出了断裂循环型带状热储构造网络体系的构思,这对该区今后深部基岩层热储的研究具有一定的参考意义。     

Redefining active volcanoes: a discussion

The analysis of the current definitions of active volcanoes indicates that they are empirical, conventional, inaccurate, nongeological, and arbitrarily constraining. Redefinition is therefore needed. One possible approach is to refine the current empirical definitions. A statistically reasonable and practical redefinition using a geologically based time convention-Holocene or 10000 years-is suggested. A set of time conditions according to volcano typology-i.e. 1000; 10000 and 100000 years for high-frequency basaltic shields, andesitic-dacitic composite volcanoes and low-frequency large silicic calderas, respectively-as further refinement of the empirical definition is also envisaged. Devising a phenomenological definition as a theoretical approach is another possibility, but in practice extant diagnostic means are still unsatisfactory to discriminate accurately between dormant and extinct volcanoes. As a consequence of the redefinition, a classification of volcanoes according to their eruptive status is proposed. Redefinition of active volcanoes might increase accuracy in the usage of basic terms in volcanology and influence volcanic hazard assessment and risk mitigation projects.     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

Fault zone geometry of a mature active normal fault: A potential high permeability channel (Pirgaki fault, Corinth rift, Greece)

We present results from petrophysical analysis of a normal fault zone with the aim of defining the flow pathways and their behavior during seismic and interseismic periods. Data are obtained on porosity geometry, strain structure and mineralogy of different domains of a normal fault zone in the Corinth rift. Data point out a close relationship between mineralogy of the clayey minerals, porosity network and strain structures and allow definition of a macroscopic anisotropy of the flow parameters with a strong control by microscopic ultracataclasite structures. The Pirgaki fault zone, developed within pelagic limestone, has a sharp asymmetric porosity profile, with a high porosity volume in the fault core and in the damage zone of the hanging wall. From porosity volumes and threshold measurements, a matrix permeability variation of 6 orders of magnitude could be expected between the protolith and the fault core. Modifications of this pathway during seismic and interseismic phases are depicted. Healing of cracks formed during seismic slip events occurred in the fault core zone and the porous network in the damage zone is sealed in a second step. The lens geometry of the fault core zone is associated with dissolution surfaces and open conduits where dissolved matter could move out of the fault core zone. These elementary processes are developed in particular along Riedel's structures and depend on the orientation of the strain surfaces relative to the local stress and depend also on the roughness of each surface type. P-surfaces are smooth and control shearing process. R-surfaces are rough and present two wavelengths of roughness. The long one controls localization of dissolution surfaces and conduits; the short one is characteristic of dissolution surfaces. The dissolved matter can precipitate in the open structures of the hanging wall damage zone, decreasing the connectivity of the macroscopic conduit developed within this part of the fault zone.