A new efficient 3D non-hydrostatic free-surface flow model for simulating water wave motions

A new three-dimensional, non-hydrostatic free surface flow model is presented. For simulating water wave motions over uneven bottoms, the model employs an explicit project method on a Cartesian the staggered gird system to solve the complete three-dimensional Navier–Stokes equations. A bi-conjugated gradient method with a pre-conditioning procedure is used to solve the resulting matrix system. The model is capable of resolving non-hydrostatic pressure by incorporating the integral method of the top-layer pressure treatment, and predicting wave propagation and interaction over irregular bottom by including a partial bottom-cell treatment. Four examples of surface wave propagation are used to demonstrate the capability of the model. Using a small of vertical layers (e.g. 2–3 layers), it is shown that the model could effectively and accurately resolve wave shoaling, non-linearity, dispersion, fission, refraction, and diffraction phenomena.     

The Working Mechanism and An Analytic Method of the Deep Embedded Large Cylinder Structure

The large cylinder is a new-type structure that has been applied to harbor and offshore engineering. An analytic method of the relationship between loads and the structure displacement is developed based on the failure mode of deep embedded large cylinder structures. It can be used to calculate directly the soil resistance and the ultirnate bearing capacity of the structure under usage. A new criterion of the large cylinder structure, which discriminates the deep embedded cylinder from the shallow embedded cylinder, is defined. Model tests prove that the proposed method is feasible for the analysis of deep embedded large cylinder structures.     

Undular tidal bore dynamics in the Daly Estuary, Northern Australia

Measurements in the macro-tidal Daly Estuary show that the presence of an undular tidal bore contributed negligibly to the dissipation of tidal energy. No recirculation bubble was observed between a trough and the following wave crest in the lee waves following the undular bore. This differs to stationary undular bores in laboratory experiments at larger Froude numbers where a recirculation bubble exists. Secondary motions and the turbulence generated by the undular bore had no measurable influence on the sediment transport. This situation contrasts with the intense sediment resuspension observed in breaking tidal bores. The tidally averaged sediment budget in the Daly Estuary was controlled by the asymmetry of tidal currents. The undular bore may widen the river by breaking along the banks that it undercuts, leading to bank slippage. A patch of river-wide macro-turbulence of 3-min duration occurred about 20 min after the passage of the bore during accelerating tidal currents.     

泥石流平面形态的统计分析

泥石流扇的平面形态可用规划的几何图形来模拟。在研究了中国西南地区小江流域和意大利东北部阿尔卑斯山区的５２个泥石流扇的基础上，本文提出了两种泥石流扇的平面形态：中国西南地区的“等腰三角形＋半圆形”泥石流扇和意大利东北部的“几何扇”。用统计分析建立了两组泥石流扇和泥石流流域之间的形态度量关系。通过两个研究区域的对比，两个流域参数：流域面积和主沟比降确定为影响泥石流扇平面形态和面积的最重要的因素。     

The intertidal erosion rate of cohesive sediment: a case study from Long Island Sound

Over the past decades, many attempts have been made to generate useful bottom erosion models for the study of cohesive sediment movement. This study addresses some of the key questions involved in determining the functional relationship between erosion rate and bottom shear stress. Current, wave, and turbidity data were collected from a bottom mounted instrument array in a moderately energetic estuarine environment. The bottom shear stress was calculated from a wave–current interaction model. The erosion rate was derived from the observed sediment concentration using a vertical mixing model. Examination of the relationship between erosion rate and bottom stress showed that the erosion rate varied at intertidal frequency. When averaged over the tidal fluctuation, the erosion rate remained approximately constant at low stress, but increased sharply when the shear stress rose above a critical value. This suggests two-stage erosion. The bed has a layered structure, in which a thin layer of loose, high water content material overlies a more consolidated bed. The top layer of high water content material (fluff) was easily disturbed and re-suspended by tidal currents, but the consolidated bottom layer was eroded only under conditions of high shear stress.     

海洋中液-固界面作用的分形研究Ⅰ.SAXS法测量固体交换剂的分维

本文将分形作为一个新概念,应用到海洋化学的液-固界面作用的一系列的研究上。根据用SAXS法测定一些常见的粘土矿物(高岭石,蒙脱石)和水合氧化物(水锰矿、δ-MnO_2、氧化铁凝胶、针铁矿、无定形氧化铁)的分维结果,可将这些结果划分成三类:(1)小尺度模量下具有表面分形;大尺度模量下具有质量分形。(2)只有一种分维值的表面分形。(3)在小尺度模量下和大尺度模量下分别具有不同分维值的表面分形。     

In-line response of a cylinder in oscillatory flow

The most widely used mathematical model to represent flow-induced in-line forces on structures is based on the Morison¹ equation. The present paper investigates the validity of using an extension of Morison's equation for non-stationary structures, by comparing predictions with results from a simple laboratory experiment. An elastically-mounted circular cylinder is placed in the sinusoidal flow of a U-tube, and responds in-line with the flow. Cylinder forces and responses are recorded over a range of Keulegan Carpenter numbers up to 35. An equation of motion is solved simply by using relative coordinates and by employing equivalent linearisation. The linear results are compared over a wide variation of parameters with solutions using the full nonlinear equation. Thereafter experimental results are compared with linear predictions.     

浮体间距对多浮体系统水动力系数的影响

根据三维线性势流理论，采用格林函数法，对多浮体系统的水动力系数进行了数值分析。数值算例中给出了在固定波频下水动力系数与浮体间相对位置关系曲线。水动力系数的变化幅度随着浮体间距离增大而变小。随着浮体间距的变化，水动力系数极值的出现具有明显的规律，相邻的极大值(或极小值)的间距为半个波长或一个波长。     

Computational study of sail performance in upwind condition

Airflow around yacht sails with imposed final geometry is simulated using a CFD code, reproducing experimental tests carried in a wind tunnel. Two configurations are considered: one, mast–main sail and the other, mast–jib–main sail. Both configurations were studied in the same flow conditions of air velocity and incidence angle. The grid is structured-like next to the sails and unstructured in the rest of the domain. The turbulence model used is Shear Stress Transport. The results are compared against experimental and numerical results.     

一个简单食物链的能流实验

食物链能量转换是生态系统的主要功能之一。海洋生物生产就是海洋食物链能量流动的一种表现形式。它把来自以藻类为主的植物性生产，通过被食－取食多级转换，形成了贝、虾、鱼等各级动物性生产，这就为人类提供了丰富的渔业资源。海岸带水域是我国目前海洋开发的主攻目标，揭示这个海区中食物链能流转移过程，对其经济生物生产力估算和开发前景预测有着重要意义。测定自然条件下海洋食物链能流是极其困难的。借助实验结果进而推算，就比较方便。本研究选择我国海岸带水域中属于不同营养级的４个经济种，构成一个简单的人工食物链，即金藻（…