Transmission and reflection of Rayleigh waves at a thin low velocity vertical layer: A laboratory and theoretical study

A three-dimensional ultrasonic modelling was used to study the Rayleigh waves reflected from a thin low velocity vertical layer and those transmitted through the same zone. The reflection and transmission coefficients of the Rayleigh waves have been calculated by an approximate method based on the Green function technique. Nonrigid contact boundary conditions were used for the low velocity layer modelling. A rather good correspondence between the theoretical and experimental absolute values of the reflection and the transmission coefficients was obtained. Some discrepancies between experimental and theoretical results, in particular with regard to phase shifts, may be explained by a certain inadequacy of the theoretical model to the low velocity layer investigated by the ultrasonic modelling.     

The petroleum generation potential and effective oil window of humic coals related to coal composition and age

A worldwide data set of more than 500 humic coals from the major coal-forming geological periods has been used to analyse the evolution in the remaining (Hydrogen Index, HI) and total (Quality Index, QI) generation potentials with increasing thermal maturity and the ‘effective oil window’ (‘oil expulsion window’). All samples describe HI and QI bands that are broad at low maturities and that gradually narrow with increasing maturity. The oil generation potential is completely exhausted at a vitrinite reflectance of 2.0–2.2%R_o or T_max of 500–510 °C. The initial large variation in the generation potential is related to the original depositional conditions, particularly the degree of marine influence and the formation of hydrogen-enriched vitrinite, as suggested by increased sulphur and hydrogen contents. During initial thermal maturation the HI increases to a maximum value, HI_max. Similarly, QI increases to a maximum value, QI_max. This increase in HI and QI is related to the formation of an additional generation potential in the coal structure. The decline in QI with further maturation is indicating onset of initial oil expulsion, which precedes efficient expulsion. Liquid petroleum generation from humic coals is thus a complex, three-phase process: (i) onset of petroleum generation, (ii) petroleum build-up in the coal, and (iii) initial oil expulsion followed by efficient oil expulsion (corresponding to the effective oil window). Efficient oil expulsion is indicated by a decline in the Bitumen Index (BI) when plotted against vitrinite reflectance or T_max. This means that in humic coals the vitrinite reflectance or T_max values at which onset of petroleum generation occurs cannot be used to establish the start of the effective oil window. The start of the effective oil window occurs within the vitrinite reflectance range 0.85–1.05%R_o or T_max range 440–455 °C and the oil window extends to 1.5–2.0%R_o or 470–510 °C. For general use, an effective oil window is proposed to occur from 0.85 to 1.7%R_o or from 440 to 490 °C. Specific ranges for HI_max and the effective oil window can be defined for Cenozoic, Jurassic, Permian, and Carboniferous coals. Cenozoic coals reach the highest HI_max values (220–370 mg HC/g TOC), and for the most oil-prone Cenozoic coals the effective oil window may possibly range from 0.65 to 2.0%R_o or 430 to 510 °C. In contrast, the most oil-prone Jurassic, Permian and Carboniferous coals reach the expulsion threshold at a vitrinite reflectance of 0.85–0.9%R_o or T_max of 440–445 °C.     

Hydrology and hydrogeology of Sakaryabaşı Karstic springs, Çifteler, Turkey

The Sakarya River is one of the largest rivers in Turkey and is fed mainly from Sakaryabaşı springs. The Sakaryabaşı springs are located in the Central Anatolia and issue from confined/semi-confined karst having a thermal component and therefore, having quite different hydrogeological characteristics as compared to the Taurus Karst region, a typical example of the Mediterranean type of karst. The karstic carbonate rocks that form the groundwater reservoir are overlain by a thick semi-pervious overburden of mainly clastics of Neogene age. Tectonics is the major factor controlling the occurrence of the karst springs in the area where topography is rather flat. This study aimed at explaining the occurrence and movement of the karst groundwater within the system by use of hydrogeological, chemical, and isotopic tools. Isotopic composition of the waters revealed that all waters in the region are of meteoric origin and the thermal component is due to deep circulation. The catchment area of the hydrogeological system extends to the south and groundwater movement is towards the outlets, which are in a depression along a major fault. The movement of the groundwater, based on analysis of remotely sensed images, is controlled mainly by structural elements.     

Geophysical methods applied to fault characterization and earthquake potential assessment in the Lower Tagus Valley, Portugal

The study region is located in the Lower Tagus Valley, central Portugal, and includes a large portion of the densely populated area of Lisbon. It is characterized by a moderate seismicity with a diffuse pattern, with historical earthquakes causing many casualties, serious damage and economic losses. Occurrence of earthquakes in the area indicates the presence of seismogenic structures at depth that are deficiently known due to a thick Cenozoic sedimentary cover. The hidden character of many of the faults in the Lower Tagus Valley requires the use of indirect methodologies for their study. This paper focuses on the application of high-resolution seismic reflection method for the detection of near-surface faulting on two major tectonic structures that are hidden under the recent alluvial cover of the Tagus Valley, and that have been recognized on deep oil-industry seismic reflection profiles and/or inferred from the surface geology. These are a WNW–ESE-trending fault zone located within the Lower Tagus Cenozoic basin, across the Tagus River estuary (Porto Alto fault), and a NNE–SSW-trending reverse fault zone that borders the Cenozoic Basin at the W (Vila Franca de Xira–Lisbon fault). Vertical electrical soundings were also acquired over the seismic profiles and the refraction interpretation of the reflection data was carried out. According to the interpretation of the collected data, a complex fault pattern disrupts the near surface (first 400 m) at Porto Alto, affecting the Upper Neogene and (at least for one fault) the Quaternary, with a normal offset component. The consistency with the previous oil-industry profiles interpretation supports the location and geometry of this fault zone. Concerning the second structure, two major faults were detected north of Vila Franca de Xira, supporting the extension of the Vila Franca de Xira–Lisbon fault zone northwards. One of these faults presents a reverse geometry apparently displacing Holocene alluvium. Vertical offsets of the Holocene sediments detected in the studied geophysical data of Porto Alto and Vila Franca de Xira–Lisbon faults imply minimum slip rates of 0.15–0.30 mm/year, three times larger than previously inferred for active faults in the Lower Tagus Valley and maximum estimates of average return periods of 2000–5000 years for M 6.5–7 co-seismic ruptures.     

Continuous air rate measurement in flotation cells: Some fundamental considerations

A robust and reliable sensor to measure gas (air) superficial velocity (J_g) continuously in flotation systems is introduced. It is based on the sampling of bubbles by buoyancy with the accumulating air allowed to exit through an orifice. At steady state, pressure drop is measured and related to the J_g by prior calibration. The continuous device is readily automated and extended to a multi-unit set-up. The sensor and data collections are described. The governing gas flow equation and models of the dynamic response to air flow rate set point change and fluctuations in froth depth are derived. Model predictions are confirmed against plant data. By taking a moving average, the J_g remains valid in the face of typical plant disturbances.     

Mais comment s'écoule donc un glacier ? Aperçu historique

Ice and snow have often helped physicists understand the world. On the contrary it has taken them a very long time to understand the flow of the glaciers. Naturalists only began to take an interest in glaciers at the beginning of the 19th century during the last phase of glacier advances. When the glacier flow from the upslope direction became obvious, it was then necessary to understand how it flowed. It was only in 1840, the year of the Antarctica ice sheet discovery by Dumont d'Urville, that two books laid the basis for the future field of glaciology: one by Agassiz on the ice age and glaciers, the other one by canon Rendu on glacier theory. During the 19th century, ice flow theories, adopted by most of the leading scientists, were based on melting/refreezing processes. Even though the word ‘fluid’ was first used in 1773 to describe ice, more the 130 years would have to go by before the laws of fluid mechanics were applied to ice. Even now, the parameter of Glen's law, which is used by glaciologists to model ice deformation, can take a very wide range of values, so that no unique ice flow law has yet been defined. To cite this article: F. Rémy, L. Testut, C. R. Geoscience 338 (2006).     

Compressibility and swelling characteristics of Al-Khobar Palygorskite, eastern Saudi Arabia

Expansive soils are found in different locations in eastern Saudi Arabia. The area is arid with high temperatures, highly variable humidity and an excessive rate of evaporation compared to the low precipitation. This resulted in the formation of water sensitive soils. In the present investigation, line valve buildings for a sweet water feeder (1118 mm in diameter) were constructed on a highly expansive material consisting mainly of brown palygorskite and gray palygorskite with thin sheets of gypsum and limestone. Block samples from both palygorskites were brought to the laboratory and cores as well as remolded samples were obtained from the blocks. The two palygorskites were found to be highly plastic and have a very high swelling potential. The liquid limit (LL) and plastic limit (PL) values for the brown palygorskite are 261% and 140%, respectively. The gray palygorskite has a LL of a 285% and a PL of 123%. The oedometer free swell tests for the two palygorskites produced an expansion ranging between 31.8% and 42.5% for the remolded samples. However, the expansion for cores ranges between 8.3% and 19.3%. The constant volume pressure tests produced a stress in excess of 4240 kPa. The swell potential reached a steady state after four days while the swelling pressure reached a steady state in about 3 h. The paper addresses the geology of the area, the characterization of the geomaterial including mineralogical composition using X-ray diffraction and SEM techniques and the swelling characteristics of the material.     

Damage Survey of Water Supply Systems and Fragility Curve of PVC Water Pipelines in the Chi–Chi Taiwan Earthquake

Substantial damage to water supply systems, including water delivery pipelines, water treatment plants, reservoirs, and water storage tanks, was reported after the 1999 Chi–Chi Taiwan Earthquake. This paper first summarizes the damage survey and then presents the results of seismic fragility analysis for underground pipelines. Construction blueprints of the water delivery pipelines and repair work orders of 11 townships and cities in the disastrous area were digitized into a Geographical Information System (GIS) for analysis and assessment. With the aid of the GIS system, we found that PVC pipes made up 86% of water delivery pipelines while steel, cast iron, ductile iron, PE and others took the rest. Therefore, this paper focuses on the fragility analysis of PVC pipes. Three different methods were applied to derive the fragility relations between the PVC water pipes having nominal diameters (approximately inner diameters) greater than or equal to 65 mm and earthquake intensity parameters such as peak ground acceleration and peak ground velocity. The results were then examined with those of other countries. The discrepancy between our results and the empirical equation used by HAZUS, an earthquake loss estimation software developed by the Federal Emergency Management Agency was not significant.     

Threshold velocity for wind erosion: the effects of porous fences

Porous fence is a kind of artificial windbreak that has many practical applications. The threshold wind velocities at different distances downwind from porous fences were measured and the corresponding characteristics of particle movement observed to assess their shelter effect. It is found that the fence’s porosity is the key factor that determines the resulting shelter effect. The area near a fence can be typically classified into five regions, each with a different mode of particle movement. Dense fences, and especially solid fences, favor the accumulation of sand upwind of the fences. Fences with porosities of 0.3–0.4 produce the maximum threshold wind velocity; those with porosities of 0.3–0.6 (depending on the fence height) provide the maximum effective shelter distance. It is confirmed that the fence porosities of 0.3–0.4 that have been proposed for practical application in previous research are the most effective for abating wind erosion.