Simulation experiment on hydrocarbon generating potential of various source rocks on the northern margin of the Qaidam Basin,Qinghai, China

The northern margin of the Qaidam Basin is one of the main oil-gas exploration areas in western China, where source rocks are composed mostly of Middle and Lower Jurassic dark mud shale, carbargillite and coal. A large number of subsurface and outcrop samples differing in lithology with different types of organic matter were selected for resource evaluation, research and calculation. And among them, 13 samples were used for simulation experiment on hydrocarbon generating potential of various source rocks. At first, two kinds of heating modes were compared through simulation experiment, including single temperature-step heating and continual heating. Perhaps, the process of hydrocarbon generation and expulsion occurred naturally between a close system and an open system. In addition, the first heating mode was convenient, and all its reaction products were involved in the whole thermal evolution, and the final simulation experimental results were basically in consistency with the natural evolution trend Therefore, the first heating mode was adopted and the hydrocarbon yield of every sample was worked out. According to the type and lithology of organic matter and the hydrocarbon yield of samples for simulation experiment, hydrocarbon generation and expulsion mode with three kinds of lithology and five types of source rock has been established to provide the basis for hydrocarbon generation evaluation, research and resource calculation.     

GNSS three carrier ambiguity resolution using ionosphere-reduced virtual signals

This paper presents a general modeling strategy for ambiguity resolution (AR) and position estimation (PE) using three or more phase-based ranging signals from a global navigation satellite system (GNSS). The proposed strategy will identify three best “virtual” signals to allow for more reliable AR under certain observational conditions characterized by ionospheric and tropospheric delay variability, level of phase noise and orbit accuracy. The selected virtual signals suffer from minimal or relatively low ionospheric effects, and thus are known as ionosphere-reduced virtual signals. As a result, the ionospheric parameters in the geometry-based observational models can be eliminated for long baselines, typically those of length tens to hundreds of kilometres. The proposed modeling comprises three major steps. Step 1 is the geometry-free determination of the extra-widelane (EWL) formed between the two closest L-band carrier measurements, directly from the two corresponding code measurements. Step 2 forms the second EWL signal and resolves the integer ambiguity with a geometry-based estimator alone or together with the first EWL. This is followed by a procedure to correct for the first-order ionospheric delay using the two ambiguity-fixed widelane (WL) signals derived from the integer-fixed EWL signals. Step 3 finds an independent narrow-lane (NL) signal, which is used together with a refined WL to resolve NL ambiguity with geometry-based integer estimation and search algorithms. As a result, the above two AR processes performed with WL/NL and EWL/WL signals respectively, either in sequence or in parallel, can support real time kinematic (RTK) positioning over baselines of tens to hundreds of kilometres, thus enabling centimetre-to-decimentre positioning at the local, regional and even global scales in the future.     

GM（1，1）动态模型在吴江市地下水水位预测中的应用

以吴江市地下水水位预测为例,详细阐述了地下水水位时间序列的GM（1,1）动态模型的原理和建立过程,并根据模型的预测值和实测值,对模型的精度进行了检验,结果表明,模型的预测精度达到了99．27％,等级属于Ⅰ级,具有实际的应用价值,为地下水资源的科学管理提供了依据。     

某基坑工程土钉支护工作性状试验研究

通过对广州天河荟雅苑基坑工程土钉支护进行试验和研究,分析了土钉支护体系的工作性状,并为同类工程的设计提供了一定的依据。     

葛店矿双庙扩大区三维地震勘探

葛店煤矿双庙扩大区位于豫、皖两省交界处。勘探区为一轴向北北东向的不对称向斜构造,地层倾角26°～30°,测区深部有岩浆岩侵入体,严重影响煤层赋存形态;地表条件复杂,村庄密集、河流较多,测区东侧塌陷区水塘大面积分布．三维地震勘探野外施工难度大。本区地震勘探观测系统设计为12线18炮制,为避免偏移归位及叠加次数降低等问题,在向斜轴部两侧、村子周边及河岸处适当加密炮点,并在塌陷区利用钢钎插置检波器以保证CDP点完整性。数据处理采取了叠前反褶积、叠前时间偏移等技术,数据处理效果显著。遵循多波组对比、多个数据体综合解释的原则,以纵向、横向和任意时间剖面相结合,充分利用三维可视化技术进行地震资料解释。本次勘探成果查明了主采煤层三2^2、二2煤层的构造形态及埋藏深度;解释落差5m以上断层34条,其中修改原有断层5条;另外新发现小于5m的异常断点22个。经巷道验证煤层底板标高误差0．43％～1．96％,巷道已揭露断层7条,与解释成果基本一致。     

第二次土地调查若干问题探讨

第二次土地调查的目的是全面查清全国土地利用状况,掌握真实的土地基础数据,如何保证调查的质量?文章以江阴市为例进行探讨。     

About the specification of erosion flux for soft stratified cohesive sediments

The present paper deals with the specification of bed erosion flux that accounts for the effects of sediment-induced stratification in the water column. Owing to difficulties in measuring the bed shear stress _b and the erosive shear strength _s, we suggest a series of methods that combine laboratory and numerical experiments. A simplified turbulent transport model that includes these effects helps to quantify _b and _s. Focusing on soft stratified beds, the present study considers erosion rate formulas of the form =_f exp {[T_b-T_s]} where is a model constant (=1 for Gularte's (1978) formula and =1/2 for Parchure's (1984) formula). First, the bed erosive strength profile _s(Z) is adjusted by forcing the turbulent transport model with measured erosion rates. Second, three procedures are suggested to determine the erosion rate formula coefficients _f and : a global procedure and two different layer-by-layer procedures. Each procedure is applied to an erosion experiment conducted in a rotating annular flume by Villaret and Paulic (1986). The use of the layer-by-layer procedure based on a least squares fitting technique provides a closer fit than the global procedure. The present study points out the complementarity of experimental and numerical approaches and also suggests possible improvements in laboratory test procedures.     

随钻测录井地质导向二维分解实时绘图方法

根据随钻测录井实时地质导向和大斜度、水平井评价成图技术需求，针对传统绘图方法存在的弊端，提出了将测录井信息、井眼轨迹和地质模型进行二维分解的实时绘图方法。针对二维分解绘图方法绘图时空复杂度较高的问题，给出了不同事件驱动下的局部实时计算和拷屏重绘算法，控制了对CPU和内存的消耗、提高了绘图效率，消除了实时绘图的闪烁和卡顿现象。应用实例表明，二维分解实时绘图方法能够实现大尺度随钻测录井地质导向图形的流畅、无卡顿实时绘图，可提高大斜度、水平井储层模型评价的刻画精度和时效。     

Timing effects on the fragmentation of small scale blocks of granodiorite

A series of small scale tests, simulating multi-hole blasts have been performed to establish the effect of delays on blast fragmentation. The blasts were performed in high quality granodiorite blocks, which were cut from stone prepared by dimensional stone quarry operations. The pattern used was equilateral triangular, with a distance of 10.2 cm between boreholes, which had a diameter of 11 mm, were loaded with detonating cord and the coupling medium was water. The delays used were achieved using different lengths of detonating cord for the cases of delays between 0 and 100 μs between holes and a sequential blasting machine firing seismic detonators for larger delays up to 4 ms. All fragments were collected and screened. The experiments showed that the worst fragmentation was achieved with simultaneous initiation of all charges. Fragmentation improved with the delay time between holes up to 1 ms between holes. If the experiments are scaled up, the results show that in granodiorite, fragmentation optimization requires delays of few milliseconds per metre of burden. The findings, agree with previously published work, involving larger scale experiments and other rock types.