Numerical Simulation of Wind and Temperature Fields over Beijing Area in Summer

1. IntroductionThe basic role of urban-rural boundary layer re-search is to study all kinds of physical process changesin the atmosphere boundary layer over urban and itssurrounding areas. Urban heat island (UHI) is a well-known feature of urban-rural climate. Attempts toincrease the understanding of the causes of the UHIand other urban-rural boundary layer phenomena haveused observational, theoretical and modelling methodssince long before. Seaman (1989) used a hydrostaticmodel, with real …     

The Application of ARGO Data to the Global Ocean Data Assimilation Operational System of NCC

1. Introduction It is well-known that the state of ocean plays very important role in the climate change. But there is a paucity of the ocean observation data. The data distri- bution in the space, time and different components is very inhomogeneous, even in some areas, there are no any observation data. Hence, it brings some diffcul- ties to the scientists to study many problems relevant to ocean. This situation has been being changed since ARGO (Array for Real-time Geostrophic Oceanogra-…     

Slow mass movement in the Kangchenjunga area, eastern Nepal Himalaya

Abstract   The rates of the accumulated and continuous displacement of solifluction lobes in the Kangchenjunga area, eastern Nepal Himalaya, were determined using glass fiber tubes and a strain probe. Ground temperature, precipitation and soil moisture were monitored at two sites, whose altitude differed by approximately 100 m, to understand the solifluction process. The average movement rate of the glass fiber tubes on a 31° slope at altitudes of 5412–5414 m a.s.l. was approximately 11 mm/year, being almost threefold greater than that observed on a 22° slope at 5322–5325 ma.s.l. There was no significant difference in the depth of displacement at these sites. The continuous displacement measurement near the ground surface at 5414 m showed permanent downslope movement from early July. Such movement may be attributed to additional moisture supply during the monsoon season. The amplitude of the displacement cycle was highest at the ground surface, and decreased to virtually zero at and below 20 cm in depth. Probable factors leading to the relatively slow rates of downslope displacement at the surface and depth at the studied altitudes are the lack of concurrence of the freeze–thaw cycles and the high moisture condition in the soil, and the low moisture retention capacity of the soil because of steep slopes and superficial desiccation. The rate of displacement may be more pronounced at altitudes above 5600 m because of the freeze–thaw cycles during the summer season.     

Curie-point depth from spectral analysis of magnetic data in central-southern Europe

The basal depth of the outer layer with internal magnetic sources was calculated from magnetic data available within a roughly 500 km wide and 1200 km long area, running from central Germany to southern Italy. The dataset, deriving from different aeromagnetic surveys, is reduced to the reference altitude of 3000 m a.s.l. and a reference year of 1980.0. The adopted method, which transforms the spatial data into the frequency domain, provides a relationship between the two-dimensional spectrum of the magnetic anomalies and the top and centroid depths of the magnetic sources. The magnetic layer bottom depth (MLBD) thus obtained is 29-33 km deep in the stable areas (central Europe Variscan units, Corsica-Sardinia Variscan block) and corresponds to the Moho, having an average temperature of 560 °C. From the Alps to the Apennines, MLBD ranges between 22 and 28 km and is clearly shallower than the Moho. In these units, the wide variation of MLBD appears to be compatible with the presence of shallow magnetised bodies, consisting of lower crustal rocks (Ivrea-Verbano zone), ophiolitic units (Penninic zone and Voltri Massif) and intrasedimentary basic volcanic bodies (Po Basin). An average value of 25 km can be attributed to MLBD, which corresponds to a temperature of 550 °C. In the peri-Tyrrhenian zone and the Ligurian Sea, MLBD is below the Moho, which ranges from 17 to 20 km depth, and it has a temperature matching approximately to the Curie temperature of magnetite (580 °C).     

格尔木井水温异常特征及其与地震关系分析

简要介绍了格尔木井水温动态观测的环境与条件,在研究正常动态特征和影响因素的基础上,对水温异常的映震关系进行了分析,并成功地进行了一次短临地震趋势预测。探讨了水温异常的形成原因。     

Changes in the spatial scale of Beijing UHI and urban development

The seasonal and interannual variations of Beijing urban heat island (UHI) are investigated in this paper using the temperature data from 1960 to 2000 at 20 meteorological stations in the Beijing region, and then the relationship between the intensity and spatial scale of UHI and Beijing urbanization indices is analyzed and discussed. Main conclusions are the followings. First, Beijing UHI shows obvious seasonal variations, and it is strongest in winter, next in spring and autumn, and least in summer. The seasonal variation of the UHI mainly occurs in the urban area. The UHI intensity at the center of Beijing is more than 0.8℃ in winter, and only 0.5℃ in summer. Second, the intensity of Beijing HUI exhibits a clear interannual warming trend with its mean growth rate (MGR) being 0.3088℃/10 a. The MGR of HUI is largest in winter, next in spring and autumn, and least in summer, and the urban temperature increase makes a major contribution to the growth of HUI intensity. Third, since the Reform and Opening, the urbanization indices have grown several ten times or even one hundred times, the intensity of HUI has increased dramatically, and its spatial scale also expanded distinctively along with the expansion of urban architectural complexes. Fourth, the interannual variation of urbanization indices is very similar with that of HUI intensity, and their linear correlation coefficients are significant at a more than 0.001 confidence level.     

Primary Ore Mineral Assemblage and Fluid Inclusion Study of the Batu Hijau Porphyry Cu-Au Deposit, Sumbawa, Indonesia

Abstract. The Batu Hijau porphyry Cu‐Au deposit, Sumbawa Island, Indonesia, is associated with a tonalitic intrusive complex. The temperature‐pressure condition of mineralization at the Batu Hijau deposit is discussed on the basis of fluid inclusion microthermometry. Then, the initial Cu‐Fe sulfide mineral assemblage is discussed. Bornite and chalcopyrite are major copper ore minerals associated with quartz veinlets. The quartz veinlets have been classified into ‘A’ veinlets associated with bornite, digenite, chalcocite and chalcopyrite, ‘B’ veinlets having chalcopyrite bornite along vuggy center‐line, rare ‘C’ chalcopyrite‐quartz veinlets, and late ‘D’ veinlets consisting of massive pyrite and quartz (Clode et al., 1999). Copper and gold mineralization is associated with abundant ‘A’ quartz veinlets. Abundant fluid inclusions are found in veinlet quartz consisting mainly of gas‐rich inclusions and polyphase inclusions throughout the veinlet types. The hydrothermal activity occurred in temperature‐pressure conditions of aqueous fluid immiscibility into hypersaline brine and dilute vapor. The halite dissolution (Tm[halite]) and liquid‐vapor homogenization (Th) temperatures of the polyphase inclusions in veinlet quartz range from 270 to 472d?C and from 280 to 454d?C, respectively. The estimated salinity ranges from 36 to 47 wt% (NaCl equiv.). The apparent pressures lower than 300 bars are estimated to have been along the liquid‐vapor‐halite curve for the fluid inclusions having the Th lower than the Tm that trapped the brine saturated with halite, or at slightly higher pressure relative to liquid‐vapor‐halite curve for the fluid inclusions having the Th higher than the Tm that trapped the brine unsaturated with halite. The actual temperature and pressure during the hydrothermal activity at the Batu Hijau deposit are estimated to have been around 300d?C and 50 bars. At such temperature‐pressure conditions, the principal and initial Cu‐Fe sulfide mineral assemblages are thought to be chalcopyrite + bornite solid solution (bnss) for the chalcopyrite‐bearing assemblage, and chalcocite‐digenite solid solution and bnss for the chalcopyrite‐free assemblage.     

Three dimensional numerical simulation of residential building on shrink–swell soils in response to climatic conditions

Shrink–swell soils can cause distresses in buildings, and every year, the economic loss associated with this problem is huge. This paper presents a comprehensive system for simulating the soil–foundation–building system and its response to daily weather conditions. Weather data include rainfall, solar radiation, air temperature, relative humidity, and wind speed, all of which are readily available from a local weather station or the Internet. These data are used to determine simulation flux boundary conditions. Different methods are proposed to simulate different boundary conditions: bare soil, trees, and vegetation. A coupled hydro‐mechanical stress analysis is used to simulate the volume change of shrink–swell soils due to both mechanical stress and water content variations. Coupled hydro‐mechanical stress‐jointed elements are used to simulate the interaction between the soil and the slab, and general shell elements are used to simulate structural behavior. All the models are combined into one finite element program to predict the entire system's behavior. This paper first described the theory for the simulations. A site in Arlington, Texas, is then selected to demonstrate the application of the proposed system. Simulation results are shown, and a comparison between measured and predicted movements for four footings in Arlington, Texas, over a 2‐year period is presented. Finally, a three‐dimensional simulation is made for a virtual residential building on shrink–swell soils to identify the influence of various factors. Copyright © 2015 John Wiley & Sons, Ltd.     

Experimental characterization of the impact of temperature and humidity on the breakdown of soil water repellency in sandy soils and composts

Soil water repellency is a widespread phenomenon with the capacity to alter hydrological and geomorphological processes. Water repellency decays with time, and the consequences are only of concern during the timescale at which the water repellency persists. This study aimed to characterize the influence of temperature and humidity on the breakdown of water repellency. Apparent contact angle measurements were carried out on samples consisting of sand treated with stearic acid as well as naturally repellent dune sands and composts. Temperature and humidity were controlled using a cooled incubator and a purpose designed enclosed box in which humidity could be raised or lowered. Results showed the contact angle of the stearic‐acid‐treated sands decayed with time and that there was a significant increase with stearic acid concentration. For all samples, the decay in apparent contact angle could be described with a continuous breakdown model. The stearic‐acid‐treated sands showed a significant increase in contact angle with relative humidity at a temperature of 10 and 20 °C. These differences diminished with increasing temperature. Similar results were seen for the dune sands and composts. Despite the influence of temperature and humidity on contact angles, there was no significant change in the rate at which the contact angle decayed in any sample. Absolute humidity was found to provide a more relevant indicator than relative humidity when assessing the influence of humidity on repellency over a range of temperatures. The contact angle initially increased with absolute humidity before plateauing owing to the confounding effect of temperature. Copyright © 2014 John Wiley & Sons, Ltd.     

Variation of stream temperature among mesoscale habitats within stream reaches: southern Appalachians

Stream mesoscale habitats have systematic topographic relationships to hyporheic flow patterns, which may create predictable temperature variation between mesoscale habitat types. We investigated whether systematic differences in temperature metrics occurred between mesoscale habitats within reaches of small streams tributary to the upper Little Tennessee River, southern Appalachians. Surface water temperature was recorded over three or four mid‐summer days in four mesoscale habitat types: riffle, main riffle, pool and alcove in 44 stream segments (sites). Temperature metrics were calculated for each mesoscale habitat relative to the mean value of the metric over the stream: Δ maximum temperature, Δ average maximum temperature and Δ maximum daily variation and also for each site: standard deviation of the maximum temperature and average diurnal variation (ADV). Sites were categorized as fully or partially forested. Pool tailouts had statistically significantly lower Δ maximum temperature and Δ average maximum temperature than riffle tailouts in partially forested sites, although differences were small. This was the opposite of what was expected in the presence of hyporheic exchange, indicating hyporheic exchange is not a dominant driver of mesoscale habitat temperatures at these sites. Temperature differences between mesoscale habitat units were small and unlikely to have ecological significance. We also evaluated relationships between stream temperature and riparian condition, watershed % impervious surfaces, watershed % non‐forested and elevation. ADV and standard deviation of the maximum temperature were significantly higher in partially forested sites, indicating that partially forested sites have greater temperature ranges and spatial variation of maximum temperatures. ADV decreased with elevation and increased with % impervious surfaces. Copyright © 2013 John Wiley & Sons, Ltd.