西藏札达盆地控盆断裂有限元数值模拟

札达盆地是喜马拉雅构造带中的一个山间断陷盆地,其演化过程与盆地两侧的控盆构造密切相关。对控盆断裂的构造应力场进行模拟计算,将有助于进一步深化对本区构造控盆的认识。因此,在对盆地构造地质进行详细调查的基础上,结合本区的深部地质与地球物理资料,对札达盆地控盆断裂的构造应力场进行了模拟。计算结果表明,札达盆地的演化明显受盆地两侧边界断裂的控制,札达盆地是在整体南北向挤压应力的作用下,不同块体差异隆升作用的结果。其南侧的控盆断裂为北倾的正断层,北侧的控盆断裂为南倾的逆断层,二者共同形成了南降北升的翘板式断陷盆地运动过程,是喜马拉雅地块在陆内汇聚挤压构造环境中构造应力场调整的一种方式。     

顾及DEM误差自相关的坡度计算模型精度分析

基于DEM的坡度计算,其误差来源于DEM误差、DEM结构和坡度计算模型。在顾及DEM误差自相关的前提下,对四种DEM坡度计算模型进行了分析和评价。研究表明,三阶不带权差分能给出较高的坡度计算精度;在局部窗口中,格网点数量越多,坡度计算越准确;等权比不等权的坡度计算模型更准确;DEM误差自相关结构形式对坡度计算无影响。进一步的理论分析和试验分析还表明：DEM误差自相关性的存在,不仅能够改善地形分析的精度,也能改善DEM自身精度。     

人工边坡潜在滑动面研究——以广州科学城某人工高边坡为例

运用强度参数的改变对边坡破坏面形迹影响不明显这一特点,在数值模拟过程中通过改变岩体强度参数,有效地获取潜在滑动面的位置和形态,较好地解决了滑动面搜索的难题。将该法应用于广州科学城某人工高边坡稳定性的研究,在三维数值模拟过程中,将强度参数大幅度折减,计算后获得各剖面的剪应变增量图,从这些图中可获得潜在滑动面。这与人们通常将此类边坡的中风化面作为滑动面存在较大差别。将该滑动面运用极限平衡法进行计算,计算结果显示各剖面的安全系数基本都大于1.2,边坡稳定但仍需要加固处理,与三维数值模拟结果相一致。由此认为用这种分析法确定出的潜在滑动面合理、计算结果可靠,可作为搜索边坡潜在滑动面并计算安全系数的方法之一。     

非均匀月壤介质的被动微波辐射传输模拟

基于非均匀月壤物理模型和辐射传输方程,模拟月壤介质中的微波辐射传输特性,探讨频率、月壤厚度等与月表亮温的关系。结果表明:在低频段,月壤微波辐射亮温的动态变化范围较大,可探测的月壤厚度大,3 GHz时的最大可探测月壤厚度达12.4 m;在高频段对应的可探测月壤厚度较小,特别是从50GHz往后的频率段内,最大可探测月壤厚度均小于2 m。不同频率的亮温-厚度变化曲线没有交叉点,且频率越高,所能探测的月壤厚度越小。根据模拟结果,建立了月壤厚度与亮温的查找表。基于查找表,利用单个波段的亮温数据即可得到月壤厚度信息。     

贵州糯东井田水文地质条件分析

通过对井田内泉和暗河流量的调查研究,认为永宁镇组一、三段碳酸盐岩裂隙溶洞水为井田的主要含水层,含水层主要接受大气降水及河流的渗透补给;煤层上覆地层飞仙关组为相对隔水层,厚度大于500m,下覆无强含水层,其地下水对煤层的开采影响不大,井田水文地质条件较简单。采用比拟法对井田的涌水量进行了预算,推算该矿井开采设计涌水量为13 238m^3/d。     

数值模拟技术在海坨子油田开发调整研究中的应用

讨论分析数值模拟技术在海坨子油田开发调整研究中的思路和方法,采用美国Landmark公司VIP2003．4版本数值模拟软件包进行模拟研究,通过参数准备,静、动态拟合,模拟出海坨子油田海S9—11井组1—9砂组各小层剩余储量大小及不同阶段流体饱和度分布,结合可视化技术形象描述了海坨子油田剩余油变化规律及潜力区,在此基础上预测不同井网加密方式开发指标,并优选出最佳方案,为海坨子油田下步开发调整提供了重要依据,取得了较好的效果。     

CSU－RAMS模式在区域气侯模拟中的应用

将ＣＳＵ－ＲＡＭＳ（中尺度）数值模式改造成“区域气候数值模式”以及进行区域气候数值模拟的试验研究。说明将有限区域中尺度数值模式与ＧＣＭ模式嵌套应用到区域气候数值模拟研究上能够取得有意义的结果。它能在一定程度上改善ＧＣＭ模式的不足。可以更为细致地描述大气环流的变化特征,是了解区域气候变化的有效方法之一。     

Information structure analysis for quantitative assessment of mineral resources and the discovery of a silver deposit

We propose an information-structure-analysis (ISA) method to quantify the correlations between quantitative and qualitative variables as well as within each type of variable. This method is applied to the evaluation of mineral resources in the western Zheijiang Province of China. The district contains a number of silver-bearing Fe–Cu–Pb–Zn mineral deposits near igneous complexes and FeCuPbZn zones away from the complexes. Silver anomalies occur not only in the known Fe–Cu–Zn–Pb deposits, but also in the country rock, suggesting the possible existence of silver deposits far from the igneous complexes.The tonnage distribution of silver is modeled by Monte Carlo simulation. This simulation is conducted on the basis of the correlations between silver (Ag) and lead (Pb), since no known data on silver is available. The known tonnage distribution of lead in 11 control cells was used to approximate the tonnage distribution of silver in the Monte Carlo simulation. With ISA and Monte Carlo methods, the total amount of potential polymetallic resources in 49 cells in the western Zhejiang Provice is predicted. Significantly, a deposit with about 24 tonnes of silver has been found within our exploration target area.     

Simco,a simulation software for CONICA,the coude nir camera for the very large telescope

CONICA is an acronym for COudé Near Infrared Camera. It is one of the four currently planned Infrared instruments for ESO's Very Large Telescope (VLT) in Chile. This multimode instrument is to be installed at the Coudé-focus (of Unit Telescope no. 1), where adaptive optics and speckle interferometry will also be available. High angular resolution imaging (to the diffraction limit) will be possible in the 1–5 m range, as well as spectroscopy with low- and medium resolution and polarimetry by means of Wollaston prism and wiregrid analysers. Various softwares are developed for this instrument. One of them: the Simulation Software has a threefold aim: 1. provide the user with feedback information on his/her choices of observational parameters. This is be achieved by displaying the calculated performance and throughput of the combined Source-Atmosphere-Telescope-Camera-Detector system in various formats, such as images, tables, isophotical images ... for point as well as for extended sources (also annular, double, etc.); 2. verify if his expectations are realistic, before actually using CONICA itself. 3. give feedback on the design to the developers of the instrument.On leave from his original institute, now at ESTEC in the ISO-project     

Effects of onshore and offshore topography on sea breeze circulation: An observational study at eastern Attica,Greece

Field measurements of wind, air temperature and humidity were taken at the eastern part of the Attika district in June 1991, to examine the topographic influences exerted on the local sea breezes. These influences are due either to the elongated Evia island, faced by the northern half of Attica coastline some tens of kilometers offshore, or to the coast-parallel range of Hymettos mountain, rising steeply 12 km onshore. The instrumentation consisted mainly of three tethered meteorological balloons released at characteristic sires (i.e., the coast, a location between shoreline and mountain foot and the mountain top) and three autographic ground-based anemometers operating at selected locations. Data from the ground-based and upper air stations of the Hellenic National Meteorological Service, as well as the diurnal weather maps were also obtained and analyzed. Observations were made under different synoptic wind and the latter was found to determine remarkably the significance of the topographic effects. A preliminary two-dimensional numerical approach was also made concerning the sea breeze capability to reach the Hymettos mountain top in the case of a weak opposing geostrophic flow.