大型双槽渡槽地震反应分析

为了得到比较精确的大型双槽渡槽结构的地震反应，根据渡槽结构复杂、影响动力因素较多等特点，采用8结点空间块体单元对渡槽槽身和槽墩进行有限元离散，分别用耦合自由度和多个弹簧单元分别模拟渡槽槽身横向拉杆、加劲肋和盆式橡胶支座，建立了大型双槽渡槽结构地层反应分析的有限元模型，计算了南水北调水利工程中的双洎河大型双槽渡槽的振动特性，并分别用反应谱法和时程分析法对该渡槽进行了地震反应分析，计算结果可为该渡槽的抗震设计提供参考。     

结构随机响应的一种改进的概率谱叠加方法

目前有一些关于多自由度结构体系的地震响应中响应峰值按降序(即由大到小的顺序)排列时的峰值统计性质的研究。本文对这些研究中的概率方法提出一些改进。由于这些改进，概率谱叠加方法在实际应用中就变得更准确和实用。本文以五层的结构模型为例，计算其在埃尔森特罗(1940)地震激励下的响应，并与时程分析结果进行比较。结果表明，改进的概率谱叠加方法能够谁确的计算较高几阶重要响应峰值的幅值。     

美国西部地震烈度衰减规律

在国家和地区地震动区划和重大工程的地震安全性评价工作中，区域地震动衰减规律的确定是重要环节，而借用法是目前常用的建立区域地震动衰减的方法。我国借用法通常都把美国西部作为参考地区，但一般都采用调整美国学者已有烈度衰减规律的办法确定美国西部烈度衰减规律。本文讨论美国西部已有烈度衰减规律，并直接采用美国西部烈度调查资料建立烈度衰减规律，结果可供我国工程地震工作者参考。     

液化地基的评价及处理的体会

合理评价液化地基及采用科学的处理方案对工程建设有重要意义，总结了影响地基液化的主要因素及液化判定的一般方法，提出了一种新的液化判定方法——归一法。结合实例就液化地基的设计与处理谈了一些体会。     

1995年永登地震山体变形计算机模拟与机理分析

1995年甘肃永登5．8级地震引起了黄土山梁的酥裂震陷，说明黄土在较小震级下也会有失稳现象．利用三维土体的有限元计算方法，对永登地震山体变形进行了计算机模拟，并定量地分析了变形的机理。     

Principle and mathematical method for inverting stress State of a medium from the remote sensing data

It has been proved through experiments that the electromagnetic radiation energy of a substance will vary when stress acts on the substance. This moment, the electromagnetic radiation energy (observation value) received by the remote sensor is triggered not only by the substance temperature and also by the stress. Separating quantitatively these two kinds of electromagnetic radiation energy and then inversing the actual temperature state and stress state of a medium is a matter with practical significance in earthquake prediction and stability monitoring for the large-scale geotechnical engineering. In this paper the principle and the mathematical method for inversing stress by using multiband remote sensing data are discussed in detail. A calculation example is listed.     

A synthetic optimization analysis method on structures with viscoelastic dampers

The paper introduces a synthetic optimization analysis method of structures with viscoelastic (VE) dampers, namely the simplex method. The optimal parameters and location of VE dampers can be determined by this method. Numerical example and a shaking table test about reinforced concrete structures with VE dampers show that the seismic responses of structures will be reduced more effectively when the parameters and location of VE dampers are designed in accordance with the results calculated by the simplex method.     

Anelastic structure of the upper mantle beneath the northern Philippine Sea

We investigated the upper mantle anelastic structure beneath the northern Philippine Sea region, including the Izu-Bonin subduction zone and the Shikoku Basin. We used regional waveform data from 69 events in the Pacific and the Philippine Sea slabs, recorded on F-net and J-array network broadband stations in western Japan. Using the S–P phase pair method, we obtained differential attenuation factors, δt^*, which represent the relative whole path Q. We conducted a tomographic inversion using 978 δt^* values to invert for a fine-scale (50–100 km) three-dimensional anelastic structure.

The results shows two high-Q regions (Q_P>1000) which are consistent with the locations of the Pacific and the Philippine Sea slabs. Also there is a low-Q (Q_P110) area extending to the deeper parts (350–400 km) of the model just beneath the old spreading center and the Kinan Seamount Chain in the Shikoku Basin. A small depth dependence of the laterally averaged Q_P was found, with values of 266 (0–250 km), 301 (250–400 km), and 413 (400–500 km).     

Decoupled seismic analysis of an earth dam

The seismic stability of an earth dam is evaluated via the decoupled displacement analysis using the accelerograms obtained by ground response analysis to compute the earthquake-induced displacements. The response analysis of the dam is carried out under both 1D and 2D conditions, incorporating the non-linear soil behaviour through the equivalent linear method. Ten artificial and five real accelerograms were used as input motions and four different depths were assumed for the bedrock.1D and 2D response analyses were in a fair agreement with the exception of the top third of the dam where only a 2D modelling of the problem could ensure that the acceleration field is properly described. The acceleration amplification ratio obtained in the 2D analyses was equal to about 2 in all the cases considered, consistently with data from real case histories.The maximum permanent displacements computed by the sliding block analysis were small, being less than 10% of the service freeboard; a satisfactory performance of the dam can then be envisaged for any of the seismic scenarios considered in the analyses.