土壤热异常影响地表能量平衡的个例分析和数值模拟

The statistical relationship between soil thermal anomaly and short-term climate change is presented based on a typical case study. Furthermore, possible physical mechanisms behind the relationship are revealed through using an off-line land surface model with a reasonable soil thermal forcing at the bottom of the soil layer.In the first experiment, the given heat flux is 5 W m-2 at the bottom of the soil layer (in depth of 6.3 m)for 3 months, while only a positive ground temperature anomaly of 0.06℃ can be found compared to the control run. The anomaly, however, could reach 0.65℃ if the soil thermal conductivity was one order of magnitude larger. It could be even as large as 0.81℃ assuming the heat flux at bottom is 10 W m-2. Meanwhile, an increase of about 10 W m-2 was detected both for heat flux in soil and sensible heat on land surface, which is not neglectable to the short-term climate change. The results show that considerable response in land surface energy budget could be expected when the soil thermal forcing reaches a certain spatial-tem poral scale. Therefore, land surface models should not ignore the upward heat flux from the bottom of the soil layer. Moreover, integration for a longer period of time and coupled land-atmosphere model are also necessary for the better understanding of this issue.     

金刚石工具富铁胎体掺杂稀土的研究

稀土的加入量、加入形态和在混料中的均匀弥散性直接影响热压富铁金刚石复合材料的性能。改进的稀土掺杂工艺，保证了稀土在胎体中的均匀弥散性；通过试验研究了稀土的加入量与富铁胎体的抗弯强度、抗冲击韧性和孔隙率的关系，从而确定了稀土的最优加入量。通过差热分析试验，认为稀土可以改变富铁胎体的热物理特性。     

山东车镇凹陷东部古近系沙河街组成岩作用

车镇凹陷沙河街组的沉积体系受控于盆地内的构造、物源供给以及沉积时的气候环境。以岩石学特征为基础，描述了成岩过程中压实与压溶作用、胶结作用、溶解作用与次生孔隙的特征，以及次生孔隙带在本区的分布。论述了碳酸盐胶结物与粘土矿物胶结作用的特点。粘土矿物蒙脱石-伊利石转变具有明显的渐变与突变交替的演化程式，其演化经历了蒙脱石带、渐变带、迅速转化带和伊利石带以及蒙脱石向伊利石的转变带。沙河街组的成岩作用划分为早期成岩阶段（A期、B期）和晚期成岩阶段（A期、B期、C期），并提出了成岩阶段的划分标志。     

泌阳凹陷安棚油田深层系成岩作用研究及其在成岩圈闭预测中的应用

深层系一般指沉积盆地中埋藏深度在2 500～2 700 m以下的地层,其储集物性普遍很差,但在一定条件下,深部溶蚀作用可产生优质储层,形成成岩圈闭.然而这种成岩圈闭的预测一直是一个难题.安棚油田位于河南泌阳凹陷东南部,勘探成果表明,在该油田深层系下第三系核桃园组核三段下部(简称(核三下)席状的扇三角洲砂体中存在成岩圈闭.本次通过定量的成岩作用研究和成岩阶段划分,对成岩圈闭的形成机理和分布进行了探讨.研究表明,该区核三下的砂体经历了压实、胶结、溶蚀等多种成岩作用,不同的成岩作用发生于不同的埋藏深度.2 700～3 100 m之间以胶结强烈为特征,属于胶结带.3 100～3 900 m之间以次生溶蚀孔隙发育为特征,尤其是3 200～3 600 m之间, 属于深部溶蚀带.本区核三下砂体自南而北埋藏深度逐渐变浅,其上倾方向处于胶结带的部分由于强烈胶结而变成致密层,可封堵油气,而下倾方向处于溶蚀带的部分由于次生溶蚀孔隙发育而成为良好储层,从而形成成岩圈闭.根据不同埋藏深度、不同成岩阶段孔隙发育和保存的特征,可预测成岩圈闭分布。     

机械研磨对平鲁煤系高岭石热行为的影响

对煤系高岭石进行0-2h的研磨之后，再在900℃、1000℃、1400℃的温度条件下分别对其加热1h，然后利用X射线衍射（XRD）、差热分析（DTA）、红外光谱（IR）等手段，研究机械研磨对于煤系高岭石晶体结构的破坏作用以及对其热行为的影响。结果显示，煤系高岭石被研磨1h之后，高岭石的晶体结构几乎全部跨塌。把研磨1h的煤系高岭石加热到1000℃（加热1h），便能形成结晶良好的莫来石。     

High-T, low-P metamorphism in the Palaeoproterozoic Halls Creek Orogen, northern Australia: the middle crustal response to a mantle-related transient thermal pulse

High‐T, low‐P metamorphic rocks of the Palaeoproterozoic central Halls Creek Orogen in northern Australia are characterised by low radiogenic heat production, high upper crustal thermal gradients (locally exceeding 40 °C km^?1) sustained for over 30 Myr, and a large number of layered mafic‐ultramafic intrusions with mantle‐related geochemical signatures. In order to account for this combination of geological and thermal characteristics, we model the middle crustal response to a transient mantle‐related heat pulse resulting from a temporary reduction in the thickness of the mantle lithosphere. This mechanism has the potential to raise mid‐crustal temperatures by 150–400 °C within 10–20 Myr following initiation of the mantle temperature anomaly, via conductive dissipation through the crust. The magnitude and timing of maximum temperatures attained depend strongly on the proximity, duration and lateral extent of the thermal anomaly in the mantle lithosphere, and decrease sharply in response to anomalies that are seated deeper than 50–60 km, maintained for <5 Myr in duration and/or have half‐widths <100 km. Maximum temperatures are also intimately linked to the thermal properties of the model crust, primarily due to their influence on the steady‐state (background) thermal gradient. The amplitudes of temperature increases in the crust are principally a function of depth, and are broadly independent of crustal thermal parameters. Mid‐crustal felsic and mafic plutonism is a predictable consequence of perturbed thermal regimes in the mantle and the lowermost crust, and the advection of voluminous magmas has the potential to raise temperatures in the middle crust very quickly. Although pluton‐related thermal signatures significantly dissipate within <10 Myr (even for very large, high‐temperature intrusive bodies), the interaction of pluton‐ and mantle‐related thermal effects has the potential to maintain host rock temperatures in excess of 400–450 °C for up to 30 Myr in some parts of the mid‐crust. The numerical models presented here support the notion that transient mantle‐related heat sources have the capacity to contribute significantly to the thermal budget of metamorphism in high‐T, low‐P metamorphic belts, especially in those characterised by low surface heat flow, very high peak metamorphic geothermal gradients and abundant mafic intrusions.     

Hydrogeochemistry of the Simav geothermal field, western Anatolia, Turkey

Thermal waters hosted by Menderes metamorphic rocks emerge along fault lineaments in the Simav geothermal area. Thermal springs and drilled wells are located in the Eynal, Çitgöl and Na a locations, which are part of the Simav geothermal field. Studies were carried out to obtain the main chemical and physical characteristics of thermal waters. These waters are used for heating of residences and greenhouses and for balneological purposes. Bottom temperatures of the drilled wells reach 163°C with total dissolved solids around 2225 mg/kg. Surface temperatures of thermal springs vary between 51°C and 90°C. All the thermal waters belong to Na–HCO₃–SO₄ facies. The cold groundwaters are Ca–Mg–HCO₃ type. Dissolution of host rock and ion-exchange reactions in the reservoir of the geothermal system shift the Ca–Mg–HCO₃ type cold groundwaters to the Na–HCO₃–SO₄ type thermal waters. Thermal waters are oversaturated at discharge temperatures for aragonite, calcite, quartz, chalcedony, magnesite and dolomite minerals giving rise to a carbonate-rich scale. Gypsum and anhydrite minerals are undersaturated with all of the thermal waters. Boiling during ascent of the thermal fluids produces steam and liquid waters resulting in an increase of the concentrations of the constituents in discharge waters. Steam fraction, y, of the thermal waters of which temperatures are above 100°C is between 0.075 and 0.119. Reservoir pH is much lower than pH measured in the liquid phase separated at atmospheric conditions, since the latter experienced heavy loss of acid gases, mainly CO₂. Assessment of the various empirical chemical geothermometers and geochemical modelling suggest that reservoir temperatures vary between 175°C and 200°C.     

Chemical equilibria of thermal waters for the application of geothermometers from the Guanzhong basin, China

In this study, representative samples from thermal wells and springs were chemically analyzed and geothermometers were used to calculate the deep temperatures of geothermal reservoirs on the basis of water–mineral equilibrium. In some cases, however, the chemical components are not in equilibrium with the minerals in the reservoir. Therefore, log(Q/K) diagrams are used to study the chemical equilibrium for the minerals that are likely to participate. The Na–K–Mg triangular diagram is also applied to evaluate the equilibrium of water with reservoir rocks. Standard curves at the reference temperatures are prepared to reveal which type of silica geothermometer is appropriate for the specified condition. This study shows that water samples from geothermal wells W9 and W12 are in equilibrium with the selective minerals, and chalcedony may control the fluid–silica equilibrium. It is estimated that there is an exploitable low-temperature reservoir with possible temperatures of 80–90°C in the Guanzhong basin.     

History and necessity: the evolution of soil conservation technology in a Jamaican farming system

The soil conservation campaigns that have been a prominent feature of Jamaican agricultural policy since the 1950s are frequently presented as having failed to ameliorate the problem of soil erosion in hillside agriculture. A case study of a small farming community in the Blue Mountains explores the development of the soil conservation practices currently employed by farmers. The use of trash barriers in carrot farming is described and the origins of this technology and its subsequent adaptation are considered. The study concludes that extension interventions and government policy have influenced the development of current soil conservation practices; practices which have their roots in indigenous techniques. Other factors such as the adaptation of trash barriers to suit local conditions and their importance in soil fertility management also play a role in their widespread use in the study area. The study demonstrates that to understand the process of technical change in farming communities, it is necessary to consider a range of factors, external and internal, technical and social, that have over time influenced farmers' decision making.