Stabilization Mechanism and Effect Evaluation of Stabilized Silt with Lignin Based on Laboratory Data

The potential of a lignin-based by-product to stabilize silt was evaluated. The physical and mechanical properties of silt in its natural state, as well as when treated with varying proportions of lignin, were analyzed. The parameters tested include the particle size distribution, Atterberg limits, compaction characteristics, unconfined compressed strength, pH value, and electrical resistivity. To understand the stabilization mechanism of lignin-treated silt at a microscopic level, scanning electron microscopy (SEM), X-ray diffraction (XRD) analysis, and Fourier transform infrared resonance (FTIR) spectroscopy were also carried out on lignin and representative samples after 28 days of curing. The results indicate that the engineering properties of silt are improved by the addition of lignin. Particle size distribution is changed and plastic index is reduced from 8.8 to 7.7. After improvement, the maximum dry density increases and the optimum moisture content decreases, while the change of dry density with moisture content is enhanced. The treated silt has greater strength performance than the natural silt in terms of unconfined compressed strength and all of the samples have a pH value lower than 10. Curing time and moisture content have a significant impact on unconfined compressed strength but almost no effect on pH. Micro-chemical analysis reveals that the improvement of performance exhibited by lignin-treated silt may be mainly attributed to the cation exchange and the formation of more stable soil structure by lignin cementing. The stabilization mechanism of lignin-treated silt was proposed according to the results of chemical analysis. It is shown that lignin-based stabilizers have potential to improve the engineering properties of silt.     

MICP技术联合多孔硅吸附材料对锌铅复合污染土固化/稳定化修复的试验研究

近年来,工业和科技的快速发展使得重金属污染土固化/稳定化的修复研究成为热点。运用微生物诱导碳酸钙沉淀(MICP)技术联合吸附材料对锌铅复合重金属污染土进行固化/稳定化的修复,通过无侧限抗压强度试验、毒性浸出试验,评价处理前后污染土的固化效果与重金属的稳定化效果,结合扫描电镜(SEM)和X射线衍射(XRD)等检测手段,揭示MICP技术处理锌铅重金属污染土的修复机制。研究结果表明,采用MICP技术对锌铅重金属污染土进行固化/稳定化之后,可以有效降低污染土中有害重金属的浸出性。当矿化时间为10d时,试样无侧限抗压强度为942.5k Pa;铅的浸出浓度为4.20mg/L,比未处理时降低了44.81%;锌的浸出浓度为4.31mg/L,比未处理时降低了46.19%,效果显著。在此基础上,添加10%的多孔硅吸附材料后,试样无侧限抗压强度可达到1 021 kPa,强度提高了8.3%;铅的浸出浓度为2.45mg/L,与未经处理时相比,降幅达到了67.81%,与单纯MICP方法处理时相比,铅浸出浓度被二次降低了41.67%;锌的浸出浓度仅为2.93 mg/L,与未经处理时相比,降幅达到了63.4%,与单纯...     

石灰桩加固软弱地基的若干问题简述

本文简要综述了石灰桩加固软弱地基的机理和石灰桩复合地基的形状，对其设计及有关问题进行了简要探讨，得出了一些有益的结论。     

粘土矿物对油气层的损害及防治研究

粘土矿物的分散运移、膨胀以及酸敏导致沉淀物的生成,都严重地造成了地层孔隙的堵塞,对油气的三次开采造成了很大的危害。本文从粘土矿物的晶体结构入手,对粘土矿物损害油气层的机理进行了初步探讨,并对粘土矿物损害地层的三种方式提出了有效的防治措施,并通过室内实验,找出了有效的合理配方。     

Geochemical demobilization of metallic pollutants in solid waste—implications for arsenic in waterworks sludges

During stabilization or demobilization of contaminants in solid waste materials, different approaches can be taken, which also can be combined: (1) sufficient long-term buffer capacity can be provided, according to the environmental conditions; (2) permeability for dissolved contaminants can be reduced by secondary mineral precipitations or by soft gels injected into the pore space of the waste body; and (3) new formations of ‘reservoir minerals' can incorporate potential pollutants in their internal structure. Emphasizing the geochemical engineering approach, two examples are presented from the field of water management, both focussing on the demobilization of arsenic species. The first example (after Driehaus, W., 1994. Arsenentfernung mit Mangandioxid und Eisenhydroxid in der Trinkwasseraufbereitung. Vol. 133, Ser. 15, VDI-Reports, Düsseldorf, 117 pp.) relates to the problems during purification of arsenic-rich raw water, suggesting the potential application of iron and manganese oxide minerals as oxidizing agents and mineral lattice structures for the elimination of arsenic. In the second example, contaminated sludges from water treatment plants were investigated for their leaching characteristics and long-term stability. A pH-stat test procedure was used to assess the leaching characteristics of metals at typical pH values. Due to the presence of iron and manganese oxides pentavalent arsenic is protected against conversion into the mobile trivalent form at neutral to low pH. Experimental data suggest that co-disposal with reducing organic matter and alkaline stabilization material or wastes could negatively influence the binding properties and, therefore, should be avoided.     

The geotechnical properties and behaviour of a pro-glacial lake clay, and its cementitious stabilization

The Tees Laminated Clay forms a continuous deposit around the Tees estuary in north east England and was deposited in a proglacial lake which occupied the Teesside area during late Devensian times, disappearing about 13 000 years ago. It overlies till, with which it has a sharp contact and reaches a maximum thickness in parts of central Middlesbrough of just over 9 m. The laminations consist of alternating thin layers of clay and silt, and represent seasonal increments of sediment. Kaolinite and illite, with lesser amounts of chlorite, dominate the mineral composition. Quartz tends to account for less than 35%. The notable carbonate content may be diagenetic in origin. The birefringence ratio of the clay minerals indicates a medium degree of particle orientation which suggests a partially flocculated fabric.This laminated clay has a high plasticity. However, the liquid and plastic limits of the silty layers differ significantly from those of the clay layers or the bulk samples. The clay fraction has a greater influence on these limits than the silty fraction. In addition, the linear shrinkage, liquidity indices and consistency indices of the silty layers differ appreciably from those of the clay layers and the bulk samples. The laminated clay is inactive. The orientation of the laminations in relation to the direction of maximum principal stress influences the shear strength, the lowest strengths being developed when these orientations are between 30° and 60°. The stress paths, anisotropic ratios and values of Af indicate that the Tees Laminated Clay is normally consolidated or lightly overconsolidated. The McLamore–Gray concept possibly can be applied to the anisotropic strength behaviour.Tees Laminated Clay can give rise to problems during construction operations since it can lose strength significantly on remoulding. Accordingly, these soils were treated with cementitious materials to determine the extent to which their engineering behaviour was enhanced by the addition of such materials. © Rapid Science Ltd. 1998     

Effect of soil stabilization on audible band railway ground vibration

Although railway-generated ground vibrations usually have greater energy levels at lower frequencies, vibrations in the audible range above 20 Hz can nevertheless be relevant for secondary noise problems in buildings. One countermeasure is soil stabilization under the track embankment. While effective at low frequencies, a potential side effect is amplification in some audible bands. Presented here are both experimental and theoretical assessments of the countermeasure in the audible bands. The main innovation is the treatment of an infinite periodic track–ground system, using a transfer matrix approach with a repeating element including the rail, pad, sleeper, and an underlying half-space (ballast and soil). Excitation in this band is attributed to rail and wheel roughness. The model makes successful predictions when the half-space properties are allowed to be frequency-dependent such that the dispersion of the surface wave matches that in the actual layered earth (including ballast and underlying soil layers). The field measurements are also unique in that both before and after evaluation of the countermeasure was possible.     

多道伽马能谱仪中的特征峰稳谱技术

介绍一种用于微机多道伽马能谱仪的稳谱装置及稳谱方法,该装置采用新型非易失性数字电位器、89C52控制器等大规模集成电路,具有集成度高、功耗低、可靠性高等优点.文中详细介绍了有关软硬件、稳谱方法及实际应用效果.试验结果表明,对102道微机伽马能谱仪在-5～5 ℃的工作环境下,其特征峰漂移≤±1道.     

Geotechnical characterization and rockfall simulation of a slope: a practical case study from South Tyrol (Italy)

Rockfalls occur often along the state road SS241 Val d'Ega in the Val d'Ega Valley (South Tyrol, Italy). In order to protect the road and the traffic, stabilization works are necessary. Detailed geological and geomorphologic mapping along structural and geomechanic sections was carried out, and experimental rockfall trails were examined on the slope above the state road between km 3.550 and 3.830. Rockfall simulation, rock mass classification and an interpretation of field data, especially concerning joints, wrapped up the investigations. They helped find the specific need for stabilization work and its positioning along the slope. The stabilization works were completed on February 2002. Another important aspect concerns ongoing geotechnical investigations and stabilization works urgently realised during autumn 1999.

This paper is a practical approach in solving rockfall problems along public roads. It should be considered as a workbook for university personnel and also for professional geologists.