The role of clay minerals in marly soils on its stability

In many sub-tropical and tropical regions of the world, lime or cement stabilization of marly soils is used as a convenient and expedient means for the development of foundation base courses and inexpensive wearing courses for transport purposes. The failure of many of these natural and stabilized marly soils to perform their functions have been reported. Mechanical factors generally used to explain the causes for the foundation failures have not been satisfactorily accepted. This study uses thermodynamic modelling and X-ray diffraction analysis to explain the general basic causes for deterioration of the support capability of these types of soils. The presence of palygorskite in marly soils provides it with some very unique features in its natural state, and particularly when it is stabilized with lime or cement. Formation of an expansive mineral, ettringite, as a transformation product of palygorskite increases the swelling potential of the stabilized soils. The various interactions, reactions and factors contributing to the stability and instability of marly soils, and lime stabilized marly soils are discussed.     

13.7米望远镜用3mm振荡器恒温电路的改进

本文介绍了青海站 1 3.7米射电望远镜上 3mm振荡器恒温电路的改进情况。新的恒温电路有别于原来所使用的恒温电路的工作方式。实际使用证明 ,该电路性能可靠 ,显著提高了系统稳定性。     

稳定化方法与后稳定化方法的比较

对BaumgaLrte的稳定化和Chin的后稳定化进行了详尽讨论与数值比较．用经典数值方法并结合这两种稳定化方式都能提高数值精度和改善数值稳定性．在最佳稳定参数下稳定化精度一般不等价于后稳定化．两者精度优劣并无常定．考虑到Baumgarte的稳定化使得数值积分的右函数更复杂和增加计算耗费,尤其是存在稳定参数最佳选取的麻烦,故推荐后稳定化投入实算．但值得注意的是用后稳定化与没有经过稳定化处理的经典积分器来比不宜扩大积分步长．     

Stabilization of swelling clays by Mg(OH)2. Factors affecting hydroxy-Mg-interlayering in swelling clays

The damage caused to structures and other human endeavours, on or in the ground, by swelling clay soils is considered as a natural hazard. In order to mitigate this hazard an attempt was made to stabilize the swelling clay mineral structure by the addition of Mg(OH)₂. This will turn the swelling minerals, like montmorillonite, into non-swelling ones, e.g., chloride. Accordingly, the various factors affecting the precipitation-adsorption of the Mg-hydroxide by clays, was investigated, and the conditions giving the best results were established. The factors examined were: the base used as precipitant (NH₄OH and NaOH); the preparation of the precipitate, inside or outside the clay suspension; the sequence and the duration of the reagents addition; the OH/Mg ratio; the time of clay-chemical contact; and the drying time and temperature. The method, was applied to different clay minerals (swelling and non-swelling). The material produced after the Mg-hydroxide precipitation was examined by the methylene blue dye adsorption test, XRD, DTA and DTGA methods; the results were treated statistically by factorial analysis. From the results obtained, it is concluded that the factors affecting the Mg-hydroxide adsorption by clays are: the base used as a precipitant, the preparation of the hydroxide directly inside or outside the clay suspension, the drying temperature, and the rate of titration of the reagents. Therefore, the best conditions for the laboratory preparation of hydroxy-Mg-interlayers are a dilute (1–2%) and well-dispersed clay suspension, pH between 10–12; some 12 meq Mg²⁺, as Mg-salt (e.g., MgCl₂) per gram of clay, added before the base and followed by the dropwise titration of 1–2 N NaOH solution into the clay suspension, to give a molar ratio OH/Mg of about 1.5; vigorous agitation of the suspension during titration of the reagents; centrifugation and decantation of the supernatant liquid, and drying the product at about 250°C. Satisfactory results are also obtained with the fast titration of the base and drying at 105°C to complete dryness.     

磷酸镁水泥固化铅污染土的力学特性试验研究及微观机制

采用磷酸镁水泥（MPC）对铅污染土进行固化/稳定化处理。基于无侧限抗压强度试验和渗透试验,研究了MPC添加量、水土比对固化污染土强度及渗透特性的影响规律。结果表明,固化土的强度随MPC添加量增加而增大,渗透系数减小;水土比对固化土的强度及渗透特性的影响均存在临界值,为0.45。低于临界值时,固化土的强度随着水土比的增加而增加,渗透系数随着水土比的增加而减小。压汞试验（MTP）结果表明,随MPC添加量的增大,固化土孔隙体积减小,水土比不超过临界值时,固化土孔隙体积随着水土比的增大而减小。扫描电镜试验结果表明,随着MPC添加量的增加,土颗粒团聚化越明显,胶结程度加强;水土比不超过临界值时,土颗粒团聚体增多。镁钾磷酸盐晶体（MKP）主要通过减少孔径大于1 ?m的孔隙体积来影响固化土的强度和渗透特性。     

压实度对铁盐稳定化砷、锑污染土特性的影响及机制研究

压实度是影响铁盐稳定化砷(As)、锑(Sb)污染土环境岩土工程特性的主要因素之一。通过测定不同压实度铁盐稳定剂(PFSC)稳定化As、Sb污染土无侧限抗压强度(UCS)、As和Sb浸出浓度、渗透系数kw,研究了压实度对PFSC稳定化As、Sb污染土环境岩土工程特性的影响规律。通过工业CT扫描、X射线光电子能谱(XPS)明确了稳定化土微观孔隙特征、元素价态随压实度的变化规律。As的浸出浓度随着压实度的提高先降低后略微上升,压实度为93%时,As的浸出浓度最低;Sb的浸出浓度随着压实度的提高而降低,压实度大于85%后趋于平稳。压实度由75%提高至96%,稳定化土UCS由4.26 kPa增大至43.78 kPa。压实度由80%提高至96%,稳定化土k_w由1.33×10^–7 m/s降低至2.81×10^–9 m/s。工业CT扫描结果表明,随着压实度的提高,土体逐渐紧实,土体孔隙度由7.54%降低至5.30%。As、Sb和Fe的XPS分析结果表明,压实度增高促使As(Ⅴ)、Sb(Ⅴ)和Fe(Ⅲ)分别向As(Ⅲ)、Sb(Ⅲ)和Fe(Ⅱ...     

水泥固化重金属污染土的强度特性试验研究

土体受到重金属离子污染后,会引起土的工程性质的改变,重金属离子的渗出也会给周围环境带来严重的危害。在国外,目前常采用水泥固化技术来处治重金属污染土;而在我国,这方面的研究成果还很少。主要通过系统的室内试验和理论分析,研究了在不同污染物掺量、污染物类型、水泥掺量以及养护龄期条件下固化污染土的强度特性。试验结果表明,金属污染物的存在会导致土体无侧限抗压强度较小幅度的降低,但随着水泥掺入量及养护龄期的增加,土体强度会有显著提高。试验结果还发现,不同的污染物类型及掺入量对固化污染土强度存在不同的影响,NaCl能促进水泥固化土早期强度的提高,而CuCl2和AlCl3则会阻碍水泥与土的固化反应。     

Recovery of Phosphate Sludge as Concrete Supplementary Material

The automotive industry plays a major role in the worldwide economy and represents an opportunity to increase the performance of the Turkish economy. Phosphating units in the automotive manufacturing plants generate phosphate sludge as waste, which is classified as hazardous waste in the European Waste Catalogue. Phosphate sludge must be disposed of in licensed disposal plants according to the current environmental regulations. Solidification/stabilization (S/S) is a widely used treatment technology for the disposal of hazardous wastes. Portland cement is used for the solidification and stabilization processes to immobilize Ni and Zn in the phosphate sludge as well as to create construction material to be used as cobble stone for pavement. Examination of products obtained by S/S processes is performed for two points: to determine the quality and to assess the environmental impacts. The phosphate sludge samples are subjected to chemical characterization and a size distribution analysis leaching test. Concrete for cobble stone was produced by the S/S process with the addition of phosphate sludge to replace sand. Tests for the quality of the product were carried out to determine compressive strength, permeability, and elasticity. At the end of the leaching test, elution concentrations of Zn and Ni while using water with pH values of 4.0, 5.4, and 9.0 were determined to be under the limit of inert material properties. Use of phosphate sludge should be considered as a sand replacement in the proportion of 1% of phosphate sludge to cement in concrete production, such as for cobble stone for pavement, without any adverse environmental impacts.