Observed Evolution of Linear and Nonlinear Effects at the Dahan Downhole Array,Taiwan: Analysis of the September 21, 1999 M 7.3 Chi-Chi Earthquake Sequence

— In this paper, the site characteristics of the Dahan downhole array are studied by analyzing the September 21, 1999 M 7.3 Chi-Chi earthquake sequence including the main shock and some aftershocks. The four-level array (0 m, 50 m, 100 m and 200 m) is located to the north of Hualien City in eastern Taiwan. Polarization analysis is used to check the orientation errors of the seismometers at different levels of depth. If the surface instrument is chosen as reference, the angle between the major polarization axes of the surface and any downhole records is the orientation error that must be corrected for the downhole accelerographs. The orientation errors at depths of 50 m, 100 m and 200 m are 32°, 120° and –84°. After the corrections, the coherency between the surface and downhole records is substantially improved. Spectral ratio analysis shows that the predominant frequency of the Chi-Chi main shock shifts to a lower frequency. We also simulate ground motions at different depths by using the Haskell method with a linear velocity structure model. The record at surface is chosen as the input motion. Compared with the observed data, ground acceleration can be well reproduced for the aftershocks (weak-motion events) of the September 21, 1999 M 7.3 Chi-Chi earthquake. However, for the Chi-Chi main shock, the synthetic waveform cannot match well with the observation neither in amplitude nor in phase. This indicates that large ground shaking probably induced the nonlinear site effect at that time, and the model used cannot support it.Acknowledgement. The authors would like to express their thanks to Dr. L.F. Bonilla and one anonymous reviewer for their valuable suggestions. This research was supported by the National Science Council under grant number NSC 89-2921-M-194-007. The Institute of Earth Sciences, Academia Sinica supplied the strong-motion data. The support of these organizations is gratefully acknowledged.     

云南省祥(云)-临(沧)公路红土坡隧道变形原因及加固方案

云南省祥(云)-临(沧)公路红土坡隧道，在施工过程中变形严重，洞内数次冒顶、产生地面陷落，并诱发滑坡，严重影响了施工进度并造成较大经济损失。文章根据现场勘查及变形监控量测资料，详细论述了隧道变形特点，从地层岩性、构造、地应力条件、地下水作用、施工工艺、滑坡影响等方面综合分析了隧道变形原因。红土坡隧道变形是软弱的地层岩性、地应力条件改变、地下水作用、施工工艺以及滑坡偏压等各种因素共同作用的结果。且隧道变形诱发滑坡，滑坡又促使隧道进一步变形。基于此，文章提出了首先对滑坡进行支挡，再对隧道围岩进行加固的整治思路，并提出具体工程方案。整治工程实施后，红土坡隧道变形已得到完全控制，取得良好的治理效果。     

复杂条件下深圳汝南大厦基础工程方案的优选与实践

位于复杂地质条件和环境条件下的深圳汝南大厦在基坑支护的施工过程中出现钻进困难,必须重新选择基础工程施工方案.结合场地特殊地质和环境条件在对人工挖孔桩、换填法、树根桩法、旋喷桩复合地基等8种基础工程施工方案进行分析与优选的基础上,借助模糊决策理论进行方法优选验算,最终选定了人工挖孔桩加部分钻(冲)成孔灌注桩的方案.采用该方案在深圳市汝南大厦的施工实践表明其施工效果良好.     

用叠加谱比法研究新疆地区Lg尾波Q值的区域性变化

运用叠加谱比法,对分布于新疆地区的5个台站所记录的51个地震数据进行分析,得出与各射线路径相对应的Lg尾波Q0(Lg尾波在1Hz处的Q)值。结果表明:Q0值呈现出明显的区域性变化特点,与构造活动关系紧密。在较为稳定的塔里木地台,Q0呈现出高值,在350～450之间。在南部构造活动较为激烈的昆仑褶皱系,Q0呈现出较低的值,约为200～250。在构造活动最为激烈的帕米尔地区,Q0值在170～200之间。在北部的天山褶皱系,Q0值约为220～270。准葛尔褶皱系比天山褶皱系的Q0值略高,约为260～290。     

Polymetamorphism in garnet micaschists of the Saualpe Eclogite Unit (Eastern Alps,Austria), resolved by automated SEM methods and EMP–Th–U–Pb monazite dating

Polymetamorphic garnet micaschists from the Austroalpine Saualpe Eclogite Unit (Kärnten, Austria, Eastern Alps) display complex microstructural and mineral–chemical relationships. Automated scanning electron microscopy routines with energy dispersive X‐ray (EDX) spectral mapping were applied for monazite detection and garnet mineral–chemical characterization. When the Fe, Mg, Mn and Ca element wt% compositions are used as generic labels for garnet EDX spectra, complex zonations and porphyroblast generations can be resolved in complete thin sections for selective electron‐microprobe analyses. Two garnet porphyroblast generations and diverse monazite age populations have been revealed in low‐Ca and high‐Al‐metapelites. Garnet 1 has decreasing Mn, constant Ca and significantly increasing Mg from cores to rims. Geothermobarometry of garnet 1 assemblages signals a crystallization along a M1 prograde metamorphism at ~650 °C/6–8 kbar. Sporadic monazite 1 crystallization started at c. 320 Ma. Subsequent pervasive 300–250 Ma high‐Y and high‐Gd monazite 1 formation during decompression coincided with the intrusion of Permian and Early Triassic pegmatites. Monazite 1 crystallized along the margin of garnet 1. Coronas of apatite and allanite around the large 320–250 Ma monazite signal a retrogressive stage. These microstructures suggest a Carboniferous‐to‐Early‐Permian age for the prograde M1 event with garnet 1. Such a M1 event at an intermediate‐P/T gradient has not yet been described from the Saualpe, and preceded a Permo‐Triassic low‐P stage. The M2 event with garnet 2 postdates the corona formation around Permian monazite. Garnet 2 displays first increasing X_Ca at decreasing X_Mg, then increasing X_Ca and X_Mg, and finally decreasing X_Ca with increasing X_Mg, always at high Ca and Mg, and low Mn. This records a P–T evolution which passed through eclogite facies conditions and reached maximum temperatures at ~750 °C/14 kbar during decompression‐heating. A monazite 2 population (94–86 Ma) with lower Y and Gd contents crystallized at decreasing pressure during the Cretaceous (Eo‐Alpine) metamorphism M2 at a high‐P/T gradient. The Saualpe Eclogite Unit underwent two distinct clockwise metamorphic cycles at different P–T conditions, related to continental collisions under different thermal regimes. This led to a characteristic distribution pattern of monazite ages in this unit which is different from other Austroalpine basement areas.     

基于光谱角匹配算法的水体信息提取研究

针对水体信息提取时,传统算法不能较好地解决山体阴影被误提为水体的问题,引入多用于高光谱数据处理的光谱角匹配算法,以Land-sat8 OLI(band1-band7)为数据源,以黄河小浪底水库周边区域为实验区,开展水体信息提取研究,结果显示:水体指数法和波段关系提取的结果中有大量的山体阴影信息,提取精度不超过30%,而光谱角匹配法提取结果受阴影的影响较小,提取精度在99%以上。     

高分二号卫星影像融合方法探析

图像融合技术是卫星影像处理过程中的一个重要步骤,它可以将全色影像的高空间分辨率特点与多光谱影像的高光谱分辨率特点有机地结合起来,使得融合后的影像更利于后续解译。由于融合处理方法的原理以及获取影像的传感器特性不同,不同的卫星影像适合于不同的融合方法。针对高分二号卫星影像的特点,本文采用Gram-Schmidt融合法、FIHS变换方法、HPF方法、Pansharp方法进行试验。实验结果表明:HPF方法所得融合结果在光谱特性保持方法性能最优,而Pansharp方法融合结果在信息量的保持以及清晰度方面效果更优,因此,在实际应用中,应根据具体需求进行方法选择。     

Characterisation of carbonate minerals from hyperspectral TIR scanning using features at 14 000 and 11 300 nm

Rapid characterisation of carbonate phases in hyperspectral reflectance spectra acquired from drill core material has important implications for mineral exploration and resource modelling. Major infrared active features of carbonates lie in the thermal region around 6500 nm, 11 300 nm and 14 000 nm, with the latter two features being most useful for differentiating mineral species. A scatter diagram of the wavelength of the 14 000 nm feature vs that of the 11 300 nm feature, powerfully differentiates carbonates. Although the wavelength of the 11 300 nm peak is easily measured, the 14 000 nm trough and peak are commonly weak and their wavelengths can confidently be used only after filtering the spectra, e.g. selecting only those with the trough and peak separated by 175–230 nm, typical of common carbonates. The method is demonstrated with drillhole 120R from the Rosebery polymetallic VHMS deposit in western Tasmania, which has been scanned with the HyLogger-3 system. A 14 000–11 300 plot shows a high degree of clustering of the drillhole 120R data close to the library spectra of calcite, dolomite, Fe-dolomite, ankerite, kutnohorite, rhodochrosite, Fe-rhodochrosite and siderite. The interpreted compositions of the carbonate spectral populations strongly correlate with the chemical populations of 144 analysed carbonates and provide a highly resolved spatial framework for interpreting carbonate alteration.