四川盆地潜在震源区的细致划分

四川盆地包括川中台拱和川东陷褶束的范围，具有相对稳定的大地构造环境.鉴于该地区地震活动水平相对较低、发震构造不甚明确的特点，在编制1990年版中国地震烈度区划图时，划分的潜在震源区面积也相对较大.本文在总结四川盆地中强地震（Ms=4.7-5.7）发震构造条件的基础上，用地震构造类比原则对四川盆地的潜在震源区进行了重新划分.确定潜在震源区边界时，充分考虑了背斜轴走向、背斜构造的影响带宽度、小震活动密集条带和余震的分布范围.得到了四川盆地更加细致的潜在震源区划分方案.这对于低地震活动水平地区的潜在震源区的细化研究具有一定参考意义。     

土壤有机碳同位素样品制备过程的影响因素讨论

土壤有机碳同位素地球化学在气候和植被恢复方面的研究已得到广泛应用,但目前对不同类型、不同时代的土壤总有机碳同位素样品制备过程的系统研究较少.本文选取黄土高原不同地区、不同类型的现代土壤和古土壤,对其有机碳同位素样品制备过程进行了较系统的研究.( 1)去除土壤中无机碳酸盐对有机碳同位素组成的干扰:对于现代土壤样品,在室温条件下,用 0.5～ 6 mol/L HCl反应 1 d去除碳酸盐,均可获得理想数据;在 70 ℃反应条件下,用 0.5～ 2 mol/L HCl反应 2 h去除碳酸盐可获得理想数据,但用 6 mol/L HCl,δ 13C值偏负 0.65‰;( 2)在 850 ℃氧化温度条件下,样品制备加铜丝,对现代土壤及古土壤样品的δ 13C值均没有影响,结果表明在用封管法进行现代土壤及古土壤的有机碳同位素样品制备时,可以不加铜丝;( 3)对于有机碳含量较高的有机碳标准物质、植物和现代土壤样品,在 850 ℃氧化条件下,恒温 2.5 h,足以保证样品有机质氧化完全,不会产生同位素分馏;对于深层黄土和红粘土样品,由于样品体系复杂,在上述氧化条件下难以获得理想数据,合适的氧化条件有待进一步深入研究.     

山东泰安朱家庄自然硫矿床地质概要

山东省泰安朱家庄自然硫矿床,赋存于鲁西断隆古近纪汶东陆相盆地。自然硫矿层在汶口组二段上亚段,泥质灰岩-含泥灰岩-含云灰岩-石膏岩韵律层中的白云岩-石膏岩层段发育。自然硫以胶态、晶态、土态3种形态产出,可划分为顺层型、准顺层型、斑杂型及不顺层型4大类10余种矿石类型。从矿区去膏化作用普遍、自然硫与石膏-硬石膏分别富集轻-重同位素的特征、油气显示明显及地下水主要径流方向自然硫矿化最强等各种证据,表明该矿属生物后生成因的矿床。     

复杂条件下深圳汝南大厦基础工程方案的优选与实践

位于复杂地质条件和环境条件下的深圳汝南大厦在基坑支护的施工过程中出现钻进困难,必须重新选择基础工程施工方案.结合场地特殊地质和环境条件在对人工挖孔桩、换填法、树根桩法、旋喷桩复合地基等8种基础工程施工方案进行分析与优选的基础上,借助模糊决策理论进行方法优选验算,最终选定了人工挖孔桩加部分钻(冲)成孔灌注桩的方案.采用该方案在深圳市汝南大厦的施工实践表明其施工效果良好.     

复杂条件下的地下管线探测技术

以深圳市某大道顶管施工地下管线的探测成果为例,研究了在复杂场地条件下,探测地下管线的地球物理方法和技术,着重研究了电磁感应探测法.认为在复杂条件下,对钢质煤气管,应采用电磁感应探测法;对钢质或铁质给水管,应采用直接法;对电力管和电信管,应尽量采用夹钳法;对排水(管)渠等非金属材质管线,应采用地质雷达探测的方法.     

江西修水西部金矿成矿地质条件分析

通过对地层、岩浆岩、构造及化探异常与成矿关系的分析，认为江西修水西部地区具有寻找中一大型金矿床的潜力。     

泥石流运动衰减动力学初步研究

我国公路泥石流病害严重，泥石流淤埋公路构建筑物是一类常见的公路泥石流病害类型。泥石流衰减动力学是防治泥石流淤埋病害的重要关键技术，也是泥石流运动学、动力学研究的核心问题之一。本文作者运用泥沙运动力学及流体力学原理，初步建立了泥石流固相颗粒和液相浆体的能量衰减条件，把泥石流衰减模式概化为两类，即能量抑制衰减和能量自由衰减；通过泥石流沉积模型试验，得到了不同粘度泥石流体的沉积扇变化形态，随着泥石流体粘度的增大，沉积扇边缘变陡、扩展范围变小、纵轴线长度减小等结论与实际情况吻合；初步建立了泥石流能量衰减速率计算方法。研究成果为防治公路泥石流病害奠定了基础。     

A cavity expansion–based solution for interpretation of CPTu data in soils under partially drained conditions

A cavity expansion–based solution is proposed in this paper for the interpretation of CPTu data under a partially drained condition. Variations of the normalized cone tip resistance, cone factor, and undrained-drained resistance ratio are examined with different initial specific volume and overconsolidation ratio, based on the exact solutions of both undrained and drained cavity expansion in CASM, which is a unified state parameter model for clay and sand. A drainage index is proposed to represent the partially drained condition, and the critical state after expansion and stress paths of cavity expansion are therefore predicted by estimating a virtual plastic region and assuming a drainage-index–based mapping technique. The stress paths and distributions of stresses and specific volume are investigated for different values of drainage index, which are also related to the penetration velocity with comparisons of experimental data and numerical results. The subsequent consolidation after penetration is thus predicted with the assumption of constant deviatoric stress during dissipation of the excess pore pressure. Both spherical and cylindrical consolidations are compared for dissipation around the cone tip and the probe shaft, respectively. The effects of overconsolidation ratio on the stress paths and the distributions of excess pore pressure and specific volume are then thoroughly investigated. The proposed solution and the findings would contribute to the interpretation of CPTu tests under a random drained condition, as well as the analysis of pile installation and the subsequent consolidation.     

Discharge‐sediment processes of the Zhadang glacier on the Tibetan Plateau measured with a high frequency data acquisition system

In high elevation cold regions of the Tibetan Plateau, suspended sediment transfer from glacier meltwater erosion is one of the important hydrological components. The Zhadang glacier is a typical valley‐type glacier in the Nyainqentanglha Mountains on the Tibetan Plateau. To make frequent and long period records of meltwater runoff and sediment processes in the very high elevation and isolated regions, an automatic system was installed near the glacier snout (5400 m a.s.l) in August 2013, to measure the transient discharge and sediment processes at 5‐min interval, which is shorter than the time span for the water flow to traverse the catchment from the farthest end to the watershed outlet. Diurnal variations of discharge, and suspended sediment concentration (SSC) were recorded at high frequency for the Zhadang glacier, before suspended sediment load (SSL) was computed. Hourly SSC varied from the range of 0.2 kg/m³ to 0.5 kg/m³ (at 8:00–9:00) to the range of 2.0 kg/m³ to 4.0 kg/m³ (at 17:00–18:00). The daily SSL was 32.24 t during the intense ablation period. Hourly SSC was linearly correlated with discharge (r = 0.885**, n = 18, p < 0.01). A digit‐eight hysteresis loop was observed for the sediment transport in the glacier area. Air temperature fluctuations influence discharge, and then result in the sediment variations. The results of this study provide insight into the responses of suspended sediment delivery processes with a high frequency data in the high elevation cold regions. Copyright © 2016 John Wiley & Sons, Ltd.     

Suspended sediment and total dissolved solid yield patterns at the headwaters of Urumqi River,northwestern China: a comparison between glacial and non‐glacial catchments

In order to understand the differences in the suspended sediment and total dissolved solid (TDS) yield patterns between the glacial and non‐glacial catchments at the headwaters of Urumqi River, northwestern China, water samples were collected from a glacier catchment and an empty cirque catchment within the region, during three melting seasons from 2006 to 2008. These samples were analyzed to estimate suspended sediment and TDS concentrations, fluxes and erosion rates in the two adjoining catchments. There were remarked differences in suspended sediment and TDS yield patterns between the two catchments. Suspended sediment concentrations were controlled mainly by the sediment source, whereas TDS concentrations were primarily related to the hydrologic interaction with soil minerals. Generally, the glacial catchment had much higher suspended sediment and TDS yields, together with higher denudation rates, than the non‐glacial catchment. Overall, glacial catchment was mainly dominated by physical denudation process, whereas the non‐glacial catchment was jointly influenced by physical and chemical denudation processes. The observed differences in material delivery patterns were mainly controlled by the runoff source and the glacial processes. The melting periods of glacier and snow were typically the most important time for the suspended sediment and TDS yields. Meanwhile, episodic precipitation events could generate disproportionately large yields. Subglacial hydrology dynamics, glaciers pluck and grind processes could affect erodibility, and the large quantities of dust stored on the glacier surface provided additional sources for suspended sediment transport in the glacial catchment. These mechanisms imply that, in response to climate change, the catchment behaviour will be modified significantly in this region, in terms of material flux. Copyright © 2013 John Wiley & Sons, Ltd.