Sensitivity to stress of the estuarine bivalve Macoma balthica from areas between the Netherlands and its southern limits (Gironde)

Variation in the sensitivity to stress of Macoma balthica was measured in several French and Dutch estuaries. For adult and juvenile Macoma balthica exposed to copper under conditions of starvation, differences in mortality rate, condition, glycogen, burrowing rate and copper content were assessed. No significant differences were observed between adults and juveniles; the influence of treatment and origin was always evident. Animals from the most southern estuaries, Loire and Gironde, near to the species's southern limit of distribution, showed, in the field, the strongest deviations for the ecophysiological traits measured, and were in the experiments the most sensitive to stress.     

Design of ship's bow form by potential-based panel method

A surface panel method treating a boundary-value problem of the Dirichlet type with the free surface is presented to design a three-dimensional body corresponding to a prescribed pressure distribution. The free surface boundary condition is linearized with respect to the oncoming flow, and computed by four-point finite difference scheme. Sample designs for submerged spheroids and Wigley hull are carried out to demonstrate the stable convergence, the effectiveness and the robustness of the method. The design of a 5500TEU container carrier is performed with respect to reduction of the wave resistance. To reduce the wave resistance, calculated pressure on the hull surface is modified to have the lower fluctuation, and is applied as a Dirichlet type dynamic boundary condition on the hull surface. The designed hull form is verified to have the lower wave resistance than the initial one not only by computation but also by experiment.     

Factors involved in growth plasticity of cockles Cerastoderma edule (L.), identified by field survey and transplant experiments

In Arcachon Bay, a macrotidal coastal lagoon in southwest France, growth rates of cockles Cerastoderma edule (L.) differ greatly between locations. Sampling of populations at different tidal levels showed that the mean shell length was significantly and positively correlated with immersion time, whereas no correlation was found with population density and microphytobenthos biomass. Transplants of cockles between two intertidal sites were used to examine the relative importance of habitat and site of origin for growth rate and condition index. Artifacts due to manipulation were assessed, i.e. the impact of enclosures on growth, conditon index and mortality. During a 5-mo reciprocal transplant experiment, growth rates of the transplanted cockles and the cockles already present were similar, whereas the sites of origin did not affect growth rate. Condition index, however, displayed significant differences in relation to both transplant and origin sites. During a further 6-mo experiment in which cockles were transplanted from one site to four new sites, growth was mainly influenced by tidal level. These results indicate that net growth started when cockles were immersed 30% of the time. It is concluded that, on the scale of Arcachon Bay (156 km²), differences in growth and condition between cockle populations are largely phenotypic. Tidal level (i.e. food supply and emersion stress) accounts for most of these differences, but the existence of genetically or physiologically different populations cannot be excluded.     

关于多项式特征值的条件数

Tisseur(2000)研究了非齐次多项式特征值问题的条件数，所得结果的不足是对无穷特征值必须另外处理；Declieu和Tisseur(2003)运用微分几何方法研究了齐次多项式特征值问题的条件数，所得结果的不足之处是与系数矩阵的尺度化(scaling)有关。这两种条件数都有各自的应用范围。本文基于投影尺度引入齐次多项式特征值问题的条件数，其优点是与系数矩阵的尺度化无关，因而也许会有较广泛的应用。     

产复合酶菌株Pseudomonas sp.NJ197产酶发酵条件的研究

从南极普利兹湾深海900m的沉积物中筛选到一株同时产多种低温复合酶的菌 株NJ197,作者对其进行碳源、氮源、无机盐、起始pH值、培养时间、接种量等发酵条 件的优化实验．实验结果证明,在以0．5％可溶性淀粉为碳源,以0．5％豆饼粉为氮 源,无机盐:0．424％NH4H2PO4、0．075％K2HPO4、0．02％MgSO4、0．5％CaCO3,起始 pH值8．5,接种36h种龄的种子10％,20℃、250r／min的条件下在旋转摇床中培养 72h,产复合酶菌株产脂肪酶和淀粉酶活性最高．最佳的生理条件下复合酶中的碱性 脂肪酶和淀粉酶的产量分别提高到22．4U／cm3和30．9U／cm3,该产复合酶菌株可以 作为诱变育种、基因工程菌改造的出发菌株,在洗涤和制革工业中有良好的应用前 景．     

闽江口水动力和污染扩散数值模拟

本文建立了闽江口二维水动力、污染扩散数值模型，模型采用ＡＤＩ双向隐式求解。在水动力模拟中，对岸界的丁坝有用线性边界进行拟合，并考虑到河口区侧向摩擦作用；在污染扩散模拟中，用动态拟合的方法对浓度水边界进行了较为合理的改进。计算结果表明，本模型是成功的。     

Air-Sea Gas Transfer Velocity in Stormy Winter Estimated from Radon Deficiency

Thirteen vertical profiles of ²²⁶Ra and ²²²Rn in the near-surface water were obtained in the western North Pacific in winter, and the gas transfer velocities across the air-sea interface were estimated. The transfer velocities found by applying a steady state model varied widely from 2.1 to 30.2 m day⁻¹ with a mean of 9.4 m day⁻¹. The mean value is almost 5 times higher than that in summer in other oceans, and the maximum value is a record high for world oceans. This is partly due to the inadequacy of the steady state model, which overestimates when stronger winds blow in more recent days than the ²²²Rn half-life of about 4 days. In fact, a strong low pressure zone passed through the station about 2 days earlier, which was one of the low pressure zones that with a period of develop once a week or so in the northwestern North Pacific in winter. Instead of steady-state removal, if half of the radon removal occurred sporadically every 7 days, and the last removal took place two days before the observation, the transfer velocity would be 26 m day⁻¹. Our mean transfer velocity, which is less than 20% different from the steady state value including both overestimated and underestimated values, 9.4 ± 4.8 m day⁻¹, seems to represent the mean state of this region in winter. This suggests that the gas exchange fluxes under extremely rough conditions in the open ocean are larger than those estimated by using a transfer velocity equation with a linear or quadratic relationship with wind speed. This revised version was published online in July 2006 with corrections to the Cover Date.     

南海晚第四纪硅藻遗体及其地质意义：Ⅷ.几个问题的讨论

本文根据分析结果阐述了两种不同样品处理方法所获得的硅藻丰度和微型硅藻的人主要种类和相对百分含量。研究表明洗涤富集法所获得的硅藻丰度存在较大误差；微型硅藻的含量普遍介于１０％－２０％之间，最高可达４２．３１％，最低为５．６６％，并指出了在微型硅藻相对含量大于２０％的样品中 ，其主要种类为具槽直链藻和条纹小环藻等沿岸底格格不入中，并成群体产出。