人造热带气旋垂直结构问题初探

在人造热带气旋中引入了倾斜垂直结构，并将其用于西折后9806号热带气旋登陆路径的数值模拟。结果表明：应用该方案所得到的模拟结果优于应用正压结构的人造热带气旋方案的模拟结果要准确。因此，此类热带气旋的预报中，其初始涡旋可采用倾斜垂直结构，从而提出改进热带气旋初始涡旋的一种新思路。若对其作进一步研究、推广，则具有广阔的业务应用前景。     

万家寨引黄工程泥灰岩段隧洞岩石掘进机(TBM)卡机事故工程地质分析和事故处理

隧道全断面岩石掘进机 (TBM )的施工对地质条件适应性是一个不断认识和深化的过程 ,其中很多认识是来自已发生的各种各样事故和对事故原因的理性认识。本文是在对某隧洞TBM卡机地段的岩性 (包括工程性质 )、构造、地应力及其在TBM施工条件下的变化等方面进行工程地质力学研究的基础上 ,指出层间剪切带的存在及由此而产生的较大变形速率是导致事故发生的工程地质原因 ,并提出了相应的处理意见和建议。TBM卡机问题的顺利解决和它重新开始快速掘进证明了作者分析和工程处理措施的合理性。本文的分析有助于加深TBM施工对复杂地质条件适应性的认识 ,并可望为避免类似事故的再次发生提供参考和借鉴。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

低温电镀孕镶金刚石石油取心钻头研制与应用

该钻头用于坚硬地层取心。河南油田以往常用园柱聚晶、三角聚晶钻头以及烧结孕镶金刚石钻头，取心效率低、钻速慢、成本高。近两年采用低温电镀孕镶金刚石钻头取心后，平均单筒进尺由原来的4．20m／筒提高到7．62m/筒，平均取心机械钻速由原来的0．21m/h提高到的0.84m/h。该钻头生产工艺完全改变原来高温（1000℃以上）烧结为低温（室温）电镀工艺，极大地避免了金刚石热损伤，采用高强度大颗粒的金刚石，提高了取心机械钻速。     

富碱斑岩中超镁铁深源包体岩石的矿物学特征

在云南省鹤庆县六合乡富碱斑岩体中找到超镁铁深源岩石包体，这对于研究富碱斑岩的起源和演化及其成岩成矿作用具有重要意义。本文较系统地研究了深源包体岩石的矿物学特征，揭示该深源包体具有原始上地幔岩在地幔条件下受到一定程度富集地幔流体交代作用改造的特征，具有富集地幔低程度部分熔融属性，为富碱斑岩的成岩成矿演化提供了重要的矿物学依据。     

Pseudotachylytes in the southern border fault of the Cenozoic intracontinental Teletsk basin (Altai, Russia)

The Cenozoic intracontinental Teletsk basin in the Central Asian Altai Mountains is composed of a complexly structured northern and a more simple southern sub-basin. These sub-basins formed in two distinct kinematic stages when first the NNW-striking Teletsk- and then the NE-striking West-Sayan shear zones became reactivated in the Cenozoic under dominant NS-oriented horizontal compression. Although the entire Teletsk basin strikes roughly NS, the southern sub-basin is parallel to the NNW-trending, amphibolite facies Teletsk ductile shear zone, while the northern sub-basin is NS-striking and flanked by differently structured, greenschist facies basement. Basement reactivation closely controlled the southern sub-basin formation, but this is less clear for the northern sub-basin. Contrasts between northern and southern basement and the exclusive occurrence of pseudotachylytes along the margins of the southern basin are explored for their contribution to the formation of the Teletsk basin with two distinct sub-basins.In the ductile shear fabric of the basement flanking the southern sub-basin, concordantly interleaved pseudotachylytes and isolated breccia lenses reflect local brittle deformation along the ductile fabric. The genetic link between breccia lenses and pseudotachylyte occurrences was defined by microstructural investigation. It allows to explore their possible development in a dextral strike–slip zone. These rocks occur in a large fault-bounded segment of the basement. The geometry of the structures in the segment is comparable with a dextral strike–slip sidewall-ripout structure along the Teletsk shear zone. Seismic slip related to pseudotachylytes is attributed to the sudden stress release on the NNW-striking Teletsk shear zone, when the latter became unconstrained by reactivation of the NE-trending West-Sayan fault zone at its northern boundary. The boundary of the sidewall-ripout structure was reactivated as a large listric fault in a later stage. The northern sub-basins roughly develop along an NS strike and are assumed to reflect reactivation of the ductile shear zone underneath the variably structured greenschist facies basement outcropping along the flanks of the sub-basin.     

Sm-Nd ISOTOPIC AGE OF LAMPROPHYRES IN THE GEZHEN GOLD-BEARING SHEAR ZONE ON HAINAN ISLAND AND ITS GEOLOGICAL IMPLICATIONS

Sm-Nd isotopic compositions of eight lamprophyre samples, which come from the Gezhen gold-bearing shear zone on western Hainan Island, are measured. The Sm-Nd isochron age is 495.98±13.14 Ma, (143Nd/144Nd) 0=0.512094, εNd(t) ranges from +1.80 to +2.00 and TDM from 982 Ma to 1196 Ma (average: 1060 Ma). The authors point out that the whole-rock Sm-Nd isochron age (495.98 ± 13.14 Ma) really represents the petrogenetic age of lamprophyre and the time of magmatism during subsequent subduction.     

A comparison of tectonic ambient shear stress value in China with that in western USA

Introduction The stress status of the earths crust is closely related to global structure, the direction of plate movement, the drive mechanism of plate, earthquake cause, etc. Therefore the researches of the stress status of the earths crust and the process of dynamic evolution are paid a great attention to by many people around the world (Zoback, Zoback, 1980; Zoback, et al, 1989; Zoback, 1989; Spence, 1997; Fuchs, 1997; Plenefish, Bonjer, 1997; Muller, et al, 1997; XU, et al, 1989; WAN…     

中国与美国西部平均构造剪应力值的比较

提出了一种估计一个地区平均构造剪应力值的方法．用这种方法，选取哈佛大学公布的1977～1999年共15 993次地震的矩张量数据，估计了美国西部19个地区、中国和邻区43个地区(每个地区为1010范围)的平均环境剪应力值．结果表明，美国西部南加州西部海域和南加州应力最高，达13.7和12.0 MPa，然后向北、向南和向东逐渐递减，但最小也达8.7 MPa，是最高值的63%．中国新疆西北部地区和西藏察隅地区应力水平最高，达17.2和12.9 MPa，比美国高．中国的华北、云南、四川、台湾和美国南加州的应力水平差不多．中国南北地震带的应力水平为13 MPa左右，比南加州略高．两个重要地区的平均剪应力值分布图，提供了地学的基本数据．这些结果可为研究地震活动的大背景提供依据，对研究强地面运动参数(如峰值加速度及反应谱等)的衰减关系也是有用的．      

薄钢板剪力墙抗震性能试验研究

通过4个薄钢板剪力墙和1个钢筋混凝土框架的试验，研究了薄钢板剪力墙在低周往复荷载作用下的刚度、承载力、延性和耗能性能。试验表明，利用薄钢板剪力墙在低周往复荷载作用下的刚度、承载力、延性和耗能性能。试验表明，利用薄钢板剪力墙作为抗侧力构件是可行的。在钢筋混凝土框架中设置薄钢板可有效地增加刚度，承载力和耗能性能。