超深地下连续墙施工中几个问题的探讨

结合武汉某地下连续墙工程,探讨了超深嵌岩地下连续墙施工过程中出现的因三轴搅拌桩施工造成成槽困难的问题,以及超深地下连续墙接头管安装和起拔问题,并提出了相应的解决措施。实践证明,这些措施是有效的,可以为武汉地区的类似工程提供参考。     

核磁共振测井T2cutoff确定方法及适用性分析

T2cutoff是核磁共振测井中的一个重要参数,它决定了核磁共振测井测量的有效孔隙度、渗透率、自由流体饱和度、束缚水饱和度等参数的精确程度.目前国内外普遍选取的T2cutoff为:砂泥岩储层取33ms,碳酸盐岩储层取92ms.实际研究发现T2cutoff应是变化的量而并非单一值.简单的运用单一的T2cutoff来计算各种地层参数势必会产生误差甚至得出错误的解释结论.叙述了33ms作为T2cutoff的由来及其不合理性,同时分析了目前国内外确定T2cutoff的各种方法及其适用性.     

线翼截断方式对大气辐射计算的影响

在大气辐射传输计算方法中,有3种基本方法,即,逐线积分方法,k-分布方法和带模式方法。其中,逐线积分方法是最精确的计算大气透过率的方法,本文根据透过率计算方式的不同,将逐线积分方法分为追线积分法和追点积分法。由于逐线积分计算需要耗费大量的计算时间,在大气遥感和大气探测业务中使用时,必须减少计算成本,提高计算速度。本文在追线积分法的基础上,给出了简化的逐线积分的基本方法,在保证同样计算精度的同时,大大提高了计算速度。对在精确的和简化的逐线积分下,不同线翼截断方式(CUTOFF)对吸收系数、大气透过率和冷却率的影响进行了更详细的探讨。通过数值试验发现,对谱线线翼的截断方式是影响辐射计算精度和计算速度的重要因子。在不同压力下,用CUTOFF=2计算的吸收系数误差最大;对CUTOFF=1,在大多数取样点上误差都小于2%;对CUTOFF=3或4,对绝大多数取样点上计算的吸收系数误差都在5%以内,但所用的计算时间却明显减少。大气低层的透过率对不同的计算方法和不同的线翼截断方式不敏感;对大气高层,无论是对精确的还是简化的逐线积分方法,当CUTOFF=2时的透过率结果与其他线翼截断方式的结果差别较大。通过比较,本文给出线翼截断的优选方案。     

The Effects of Line-Wing Cutoff in LBL Integration on Radiation Calculations

There are three basic methods in radiative transfer calculations, i.e., line-by-line (LBL) integration, correlated k-distribution method, and band model. The LBL integration is the most accurate of all, in which, there are two quadrature algorithms named in this paper as integration by lines and by sampling "points when calculating atmospheric transmittance in the considered wavenumber region. Because the LBL integration is the most expensive of all, it is necessary and important to save calculation time but increase calculation speed when it is put into use in the daily operation in atmospheric remote sensing and atmospheric sounding. A simplified LBL method is given in this paper on the basis of integration by lines, which increases computational speed greatly with keeping the same accuracy. Then, we discuss the effects of different cutoff schemes on atmospheric absorption coefficient, transmittance, and cooling rate under both of accurate and simplified LBL methods in detail. There are four cutoff schemes described in this paper, i.e., CUTOFFs 1, 2, 3, and 4. It is shown by this numerical study that the way to cut off spectral line-wing has a great effect on the accuracy and speed of radiative calculations. The relative errors of the calculated absorption coefficients for CUTOFF 2 are the largest under different pressures, while for CUTOFF 1, they are less than 2% at most of sampling points and for CUTOFFs 3 or 4, they are ahnost less than 5% in the calculated spectral region, however, the calculation time is reduced greatly. We find in this study that the transmittance in the lower atmosphere is not sensitive to different LBL methods and different cutoff schemes. Whereas for the higher atmosphere, the differences of transmittance results between CUTOFF 2 and each of other three cutoff schemes are the biggest of all no matter for the accurate LBL or for the simplified LBL integrations. By comparison, the best and optimized cutoff scheme is given in this paper finally.     

双曲面模型深海三维定位数据模拟及精度分析

结合声波射线传播规律提出了双曲面模型水声定位的数据模拟方法。利用该方法模拟一定浮标网形下声源位于某区域约2 000m水深处10km×10km范围内的声线双曲面模型定位观测数据,进行定位解算,并将截止角的概念引入水声定位中。定位结果显示,大部分区域水下DGPS定位系统的外符合定位精度在水平方向优于5m,垂直方向优于10m;网形中间区域精度较高,三维定位精度为亚米级。引入角度限制后,定位区域内外符合定位精度水平方向优于1m,垂直方向优于4m。     

Analytical solution for transient groundwater flow during slug test in vertical cutoff walls

An analysis method for transient groundwater flow during slug tests performed in vertical cutoff walls is presented. The analytical solution for evaluating hydraulic conductivity of vertical cutoff walls is derived by applying the method of images to the previously developed analytical solution that is exclusively applicable to an infinite aquifer. Two distinct boundary conditions are considered to account for the configuration of the vertical cutoff wall: the wall‐soil formation interfaces with or without the existence of filter cakes, that is, constant‐head boundary and no‐flux boundary conditions. A series of type curves is constructed from the analytical solution and compared with those of a partially penetrated well within an aquifer. The constant‐head boundary condition provides faster hydraulic head recovery than the aquifer case. On the other hand, the no‐flux boundary condition leads to a delayed hydraulic head recovery. The greater the shape factor and well offset from the center of the cutoff wall, and the smaller the width of the cutoff wall, the greater the effect of the boundary condition observed in the type curves. This result shows the significance of considering proper boundary conditions at the vertical cutoff wall in analyzing slug tests. Copyright © 2014 John Wiley & Sons, Ltd.     

商南地区商丹断裂带特征

商丹断裂带是北秦岭加里东造山带与中秦岭海西造山带的分界断裂,在空间上由韧性剪切带、逆冲推覆构造带、断陷-走滑地堑断裂带及其所夹持的岩块、岩片、褶皱所组成的大型复杂断裂带。其演化历史至少经历晋宁期海沟俯冲;加里东期陆内俯冲-碰撞;海西—印支期陆内俯冲;燕山期的逆冲-推覆和喜山期断块-走滑的复杂演化过程,而形成今日所见的复杂断裂构造。     

On hydraulic falls of two-layer flow

Ｏｎｈｙｄｒａｕｌｉｃｆａｌｌｓｏｆｔｗｏ－ｌａｙｅｒｆｌｏｗ￥ＸｕＺｈａｏｔｉｎｇ;ＬｏｕＳｈｕｎｌｉ;ＴｉａｎＪｉｗｅｉａｎｄＳａｍｕｅｌＳｈａｎｐｎＳｈｅｎ（ＩｎｓｔｉｔｕｔｅｏｆＰｈｙｓｉｃａｌＤｅｅａｎｏｐａｐｈｙａｎｄＰｈｙｓｉｃａｌｏｃ...     

利用C波段RADARSAT-2单极化SAR图像的方位向截断波长估计有效波高

This paper proposes two simple models, look-up table(LUT) model and empirical model, to directly retrieve significant wave height(Hs) using synthetic aperture radar(SAR) azimuth cutoff(λc). Both models aim at C-band VV, HH, VH, and HV single-polarization SAR images. The LUT model relates Hs to λc, while the empirical model relates Hs to both λc and SAR range-to-velocity(β). The LUT model coefficients are derived by simulation under different sea states and observation conditions, which depend on incidence angle(θ), wave direction(dw), and βbut are independent of polarization. The empirical model coefficients are obtained by fitting the collocated data,which only depend on polarization. To fit empirical model coefficients and validate the two models, C-band RADARSAT-2 fine quad-polarization(VV+HH+VH+HV) single-look complex(SLC) SAR images and collocated buoy data are collected. Retrieved Hs, using Yang model and the two models proposed in this paper from four kinds of polarization SAR data, are compared with buoy Hs. Results show that both LUT and empirical models have the capacity of retrieving Hs from C-band RADARSAT-2 co-polarization SAR data, while Yang model is not suitable for these kinds of SAR data. Moreover, the empirical model is also valid for cross-polarization SAR data showing clear ocean wave stripes.     

振动切喷技术在重庆草街航电枢纽工程中的应用

在振动切刀下部安装有定喷的喷嘴,振动切槽之前,超前进行定喷,将振动切槽与定喷两种工艺综合成一种工艺,构成一种新的薄防渗墙的施工工艺——振动切喷技术。介绍了该新技术在重庆草街航电枢纽工程中的应用情况,实践证明,此工艺提高了防渗墙的施工效率与成墙质量。