环境地转基本气流的计算及热带气旋运动与其偏差的统计分析

利用国家气象中心T63L16的1.875×1.875经纬网格点资料和中央气象台编号的热带气旋实时中心位置资料,计算了1996年全年25个热带气旋,共126个时次的环境地转基本气流,分析了环境地转基本气流的垂直分布特征,并对热带气旋的实际运动与环境地转引导气流的偏差(后文将称其为引导偏差,即热带气旋的实际中心位置与按引导气流推算出的位置之间的偏差)进行了分析,发现引导气流的计算区域不同,其引导偏差是不一样的。得到了引导气流的最佳计算区域,并且发现热带气旋运动与环境地转基本气流的垂直切变结构的关系以及引导偏差与引导气流的速度、气旋本身的初始纬度位置和强度等有关。结果还表明,200～1000 hPa的深层加权平均的基本气流的引导效果最佳,可作为最佳引导气流使用。了解这些规律和特征,对热带气旋运动预报具有一定的参考意义。     

大腔体人造金刚石合成工艺的研究

分析了我国现阶段金刚石的合成工艺－φ23mm腔体工艺的基础上，利用变功率合成技术和瓶颈效应后改变组装方式，使腔体内的物量比合理化，以达到腔体内合成温度和压力均匀，控制金刚石的生长速度，在较低的合成压力和合成功率下，在φ28.5mm腔体和φ31mm腔体上，合成优质高产金刚石。     

The world''s large lake basins as denudation-accumulation systems and implications for their lifetimes

The mechanical denudation rates of 81 large lake basins (lake area > 500 km²) were determined from long-term river loads and erosion maps. Using the drainage area/lake area ratios the mean sedimentation rates of the lakes were calculated for a porosity of 0.3. The mean sedimentation rates of different lake types vary between 0.1 mm/a (glacial lakes, lowland) and 5.4 mm/a (mostly sag basin lakes). The calculated lifetimes of the lakes are based on the lake volumes and mean sedimentation rates, assuming steady-state conditions and solely clastic material. On average, glacial lakes in highlands and fault-related lakes show the shortest lifetimes (c. 70 ka), glacial lakes in lowlands and rift lakes have the longest lifetimes (c. 1 Ma). Some lakes remain unfilled for very long time spans due to rapid subsidence of their basin floors. The calculated lifetimes are compared with those derived from sediment core studies. Most core studies indicate lower mechanical sedimentation rates than the calculated ones because a major part of the incoming sediment is trapped in deltas. However, a number of lakes (e.g., the Great Lakes of North America) show the opposite tendency which is largely caused by extensive shoreline erosion and resuspension. The lifetimes of large glacial lakes often exceed the duration of interglacials. Hence, their lifetimes are restricted by glaciation and not by sediment infill. Rift lakes persist for long time periods which exceed the calculated lifetimes in some cases. Time-dependent subsidence, basin extension, as well as the impact of climate change are briefly described.     

孵漂石地层大口径钻头与钻进工艺的选择

根据工程实例，通过钻头和钻进工艺的对比试验，得出了利用大直径滚刀钻头，在致密卵漂石地层施工中大口径桩孔，能大幅度提高钻进效率。     

某住宅楼的地基加固与纠偏

面对连云港市新浦区软土地基上施工的某住宅楼 ,施工时由于对北楼部分桩出现的缩颈及断裂未能妥善处理 ,造成楼房北倾的问题。经协商 ,及时采取了旋喷桩加固法加固北楼基础 :采用沉降法(切桩 )、纠偏 (使各承台均匀、协调、沉降 )、接桩、固封等措施 ,效果良好。     

Bestimmung der Phytoplanktonvolumina — Methodik und Ergebnisse am Beispiel Niederrhein

For data treatment of phytoplankton countings in the Lower Rhine the specific biovolume was calculated. The used computer-aided method is described, and the correlation between phytoplankton biomass, cell number and chlorophyll a is presented.     

Distorted Froude‐scaled flume analysis of large woody debris

This paper presents the results of a movable‐boundary, distorted, Froude‐scaled hydraulic model based on Abiaca Creek, a sand‐bedded channel in northern Mississippi. The model was used to examine the geomorphic and hydraulic impact of simplified large woody debris (LWD) elements. The theory of physical scale models is discussed and the method used to construct the LWD test channel is developed. The channel model had bed and banks moulded from 0·8 mm sand, and flow conditions were just below the threshold of motion so that any sediment transport and channel adjustment were the result of the debris element. Dimensions and positions of LWD elements were determined using a debris jam classification model. Elements were attached to a dynamometer to measure element drag forces, and channel adjustment was determined through detailed topographic surveys. The fluid drag force on the elements decreased asymptotically over time as the channel boundary eroded around the elements due to locally increased boundary shear stress. Total time for geomorphic adjustment computed for the prototype channel at the Q₂ discharge (discharge occurring once every two years on average) was as short as 45 hours. The size, depth and position of scour holes, bank erosion and bars created by flow acceleration past the elements were found to be related to element length and position within the channel cross‐section. Morphologies created by each debris element in the model channel were comparable with similar jams observed in the prototype channel. Published in 2001 John Wiley & Sons, Ltd.     

淮阴台井下测震震级偏差初探

依据台站两年来实测的地震震级和江苏省区域测震台网定的震级进行比较,计算出各个地震的偏差值和台站的震级校正值,并获得相应的标准误差,最后对影响震级差值因素进行了探讨。     

ENCORE钻孔导斜系统

ENCORE钻孔导斜系统由设计先进的MOLE型固定楔、MULE型活楔、RATTY型扩孔导向矛和DOLPHIN型定向仪组成。可在40－96mm钻孔中进行定向钻进，解决钻孔纠斜或分支孔钻进问题。在分析研究其、工作原理和操作方法基础上进行对比分析，指出优点并介绍了使用效果。     

西昌—滇中地区大、中型内生矿床分布规律及预测

用王亚光研究大型矿床空间分布规律理论来研究西昌—滇中地区大、中型内生矿床的分布规律及预测,用“矿结”一词来表明经纬线方向深大断裂交汇处是大矿的分布空间。1990年所预测的一些成矿区为1991年地质找矿工作所证实,如大红山式铁铜矿的新发现和会东发嵩铝锌矿的新进展。