Refractor velocity analysis: a signal processing procedure

This paper presents a signal processing procedure to perform refractor velocity analysis. The procedure enables one to obtain the seismic velocity from the refracted wavefield without the picking of refracted arrival times. Two processing procedures are derived, one starting from a seismic interferometric approach and another, from the conventional reciprocal method and generalized reciprocal method approaches. The theoretical equivalence of the two approaches is also demonstrated. The proposed processing procedure is applied to synthetic data in order to test the influence of some procedural parameters and its capability to reconstruct a known velocity model starting from refracted signals, without and with perturbations, in arrival times and noise; finally, it is applied to a field data set.     

Seismic interferometry experiment in a shallow cased borehole using a seismic vibrator source‡

We present the results of a seismic interferometry experiment in a shallow cased borehole. The experiment is an initial study for subsequent borehole seismic surveys in an instrumented well site, where we plan to test other surface/borehole seismic techniques. The purpose of this application is to improve the knowledge of the reflectivity sequence and to verify the potential of the seismic interferometry approach to retrieve high‐frequency signals in the single well geometry, overcoming the loss and attenuation effects introduced by the overburden. We used a walkaway vertical seismic profile (VSP) geometry with a seismic vibrator to generate polarized vertical and horizontal components along a surface seismic line and an array of 3C geophones cemented outside the casing. The recorded traces are processed to obtain virtual sources in the borehole and to simulate single‐well gathers with a variable source‐receiver offset in the vertical array. We compare the results obtained by processing the field data with synthetic signals calculated by numerical simulation and analyse the signal bandwidth and amplitude versus offset to evaluate near‐field effects in the virtual signals. The application provides direct and reflected signals with improved bandwidth after vibrator signal deconvolution. Clear reflections are detected in the virtual seismic sections in agreement with the geology and other surface and borehole seismic data recorded with conventional seismic exploration techniques.     

Salt-dissolution-induced subsidence in the Dead Sea area detected by applying interferometric techniques to ALOS Palsar Synthetic Aperture Radar images

This paper discusses the interpretation of ground motions detected in the dried up Lynch Strait, Dead Sea area, by applying radar interferometric techniques to ALOS Palsar Synthetic Aperture Radar images. Four ALOS scenes spanning from December 15, 2007 to May 17, 2008 have been processed leading to the generation of five interferograms. Three ground deformation zones have been detected. One of them shows surface displacement which could be related to an earthquake (ML 3.1) that took place on April 13, 2008. High rates of subsidence have been measured in the northern Lynch Strait. They suggest that these subsidence phenomena follow the same trend of rapid increase as sinkholes. Additional measurements should be carried out in order to refine this observation.

The comparison between sinkholes' distributions in the Lynch Strait with that of Ghor Al Haditha, six kilometers eastward, supports the idea that the earthquake that hit the southern Dead Sea on April 23, 1979 (M 5.1) reactivated faults and fractures in the Lynch Strait triggering the development of sinkholes and subsidence in the frame of the Dead Sea recession.     

钢纤维混凝土断裂过程激光实时全息干涉法研究

应用激光实时全息干涉法实现了钢纤维混凝土三点弯曲切口梁断裂全过程的实时动态观测研究,连续动态捕获了钢纤维混凝土试件的干涉条纹图。实时全息干涉条纹的动态特征和分布规律直观准确地演示了钢纤维混凝土的初裂点和各阶段的变形特征以及裂缝扩展全过程。试验研究表明,当混凝土试件的钢纤维掺量大于1.0 %时,钢纤维的阻裂增韧效应是明显的。钢纤维混凝土断裂力学参量的计算与分析显示,断裂能是反映钢纤维阻裂效应的敏感参数,用全息干涉条纹图的判识和用断裂能描述获得的试件断裂行为是一致的,激光实时全息干涉法能够为混凝土断裂力学研究提供可靠的试验支撑。     

Modeling coseismic displacements resulting from SAR interferometry and GPS measurements during the 1997 Umbria-Marche seismic sequence

In this study we analyse coseismic GPS displacements and DInSAR data to constrain a dislocation model for the three largest earthquakes of the 1997 Umbria-Marche seismic sequence. The first two events, which occurred on September 26 at 00:33 GMT (Mw 5.7) and 09:40 GMT (Mw 6.0) respectively, are investigated using both GPS displacements and DInSAR interferograms. We discuss and compare the results of previous studies which separately modeled a smaller subset of geodetic data. We provide a dislocation model for these two earthquakes which fits well both GPS and DInSAR data and agrees with the results of seismological and geological investigations. The first event consists of a unilateral rupture towards the southeast with a uniform dislocation. The strike, rake and dip angles are those resulting from the CMT solution. The second event consists of an unilateral rupture towards the northwest and a variable slip distribution on the fault plane. The strike and the rake are consistent with the CMT solution, but the dip angle has been slightly modified to improve the simultaneous fit of GPS and DInSAR data. While the second rupture (09:40 GMT) arrived very close to the surface, the fit to geodetic data shows that the first rupture (00:33 GMT) is deeper (2 km), despite the more evident surface geological effects. The analysis of new SAR interferograms allows the identification of a 5–6 cm additional displacement caused by the October 3 (Mw 5.2) and 6 (Mw 5.4) seismic events.We use data from a new DInSAR interferogram to model the displacement field of the Sellano earthquake of October 14, 1997. For this event significant GPS measurements were not available. We tested two different fault plane geometries: a blind, planar fault (top depth = 2.4 km), and a curved (listric) fault reaching the surface. The two models provide a generally similar fit to the data, and show that most of the slip was released at depths greater than 2.4 km along a gently dipping (40^°–45^°) fault surface. They also show that a unilateral rupture does not allow fitting the interferometric fringes since there is evident surface deformation to the northwest of the hypocenter. Moreover, we suggest that the concentration of high residuals in the southern part of our uniform slip model may in fact indicate a certain slip variability in this area.We conclude that, despite the moderate magnitudes and the lack of significant surface faulting, the space geodetic data allowed to constrain dislocation models giving new insights in the rupture process of the three largest events of the sequence.     

InSAR复数影像配准方法探讨

复数影像配准是卫星合成孔径雷达干涉数据处理中的重要步骤之一,本文对目前影像配准最常用的方法进行了研究分析,提出了基于幅度影像的配准方案,并证明该方案配准精度高,适应能力强,运算效率高.     

基于DInSAR的洪河国家级自然保护区沼泽水位相对变化量监测研究

水文是沼泽形成、发育和演化的决定性因素.目前,沼泽水位的监测仍然以实地观测为主,需要花费大量的人力和物力.以洪河国家级自然保护区为研究区,利用2007年6?10月星载相控阵L波段合成孔径雷达(phase array type L-band synthetic aperture radar,L-band PALSAR)数...     

基于平面波模型重访地震背景噪声互相关及空间自相关(SPAC)

自Aki(1957)提出微震的空间自相关(SPatial AutoCorelation,SPAC)技术以来,SPAC技术一直独立发展,并在工程地震领域获得了广泛应用.近20年来,地震干涉(Seisimic Interferometry,SI)在多个领域引起人们的关注,该技术的核心思想是连续地震背景噪声的互相关函数(Noise Crosscorrelation Function,NCF)可以重建系统的格林函数(Green's Function,GF),对该技术的回溯性研究建立了SPAC和NCF的关系:它们是对同一物理现象的不同描述,SPAC在频率域中描述随机平稳噪声的空间相干,NCF在时间域中描述扩散场的互相关.理论上SAPC和NCF技术要求背景噪声源均匀分布,这样的噪声场可以用平面波叠加来模拟.本文基于平面波模型重访地震背景噪声的互相关和空间自相关技术,从单色平面波的互相关表示出发,对地震背景噪声互相关及空间自相关技术进行评述,试图使这些概念更易于理解.与之前众多研究地震干涉技术的理论相比,本文尤其关注以下几点:(1)基于简单的平面波模型,给出不同维度下,源或台站对方位均匀分布时,平面波互相关对入射波的方位平均和台阵对的方位平均结果,并对格林函数GF和时域互相关函数NCF的关系进行总结.(2)给出声源和(或)交叉台站方位分布不均匀时的互相关表示,指出这种非均匀性对方位的依赖关系,与弱各向异性介质中面波速度的方位依赖关系类似,因此,非均匀源的影响在反演时可能会映射到面波方位各向异性结果中.(3)互相关运算中,哪一个台站是虚拟源.NCF包含因果性和非因果性两部分,NCF的非对称性通常用于研究噪声源的方位分布,但由于源和接收的互易关系,及对互相关运算的不同定义和不同的傅里叶变换习惯,哪一个台站是虚拟源在目前的文献中并不明确.(4)方位平均和时间平均的关系.在SPAC处理中,需要对不同方位分布的台站对进行方位平均,本文从理论上说明,单个平面波入射时,交叉台站互相关系数对台站对的方位平均,等价于单个台站对互相关系数对入射波的时间平均.(5)几种特定分布非均匀噪声源的SPAC表示.包括单独的因果性噪声源和非因果性噪声源给出的互相关函数表示,及由此带来的相移问题.(6)利用SPAC、NCF和面波GF之间的关系,给出交叉分量的空间自相关系数表示.(7)衰减介质的空间相干表示.虽然利用地震干涉技术研究介质衰减在理论上仍然存在一些争议,但人们正试图研究从连续背景噪声记录中提取介质衰减的可能性.本文基于平面波模型,给出了不同坐标选择下,衰减介质的空间相干表示,这种表达的不同,指示了由地震干涉技术提取介质衰减的困难.与众多研究地震干涉的理论相比,比如稳相近似理论、互易定理、时间反转声学等,本文主要考虑均匀介质,不涉及非均匀介质的散射,从最简单的平面波模型,理解背景噪声重建系统格林函数这一地震干涉的核心思想和相应的基本概念.     

Long baseline interferometric observations of long period variable stars

Recent observations of long-period variable stars at spatial resolutions from approximately 1 arcsec to several milli-arcsecs have provided new insights into pulsation, dust formation, and mass-loss of AGB stars. These insights have come from long baseline interferometric observations obtained across a wide range of wavelengths, from the optical, through the infrared, to wavelengths as long as several millimeters. The present status and recent results from long baseline interferometry, particularly at optical and infrared wavelengths, are discussed. Such results include diameters and limb-darkening, surface features, mode of pulsation, location of SiO masers, inner radii of dust shells, physical conditions in the dust formation zone and of the inner regions of the dust shells. The results are interpreted in terms of present models of dust formation and mass-loss.