套管井偶极弯曲波频散向高频偏移的特性

对套管井偶极弯曲模式波的频散特性进行了系统的数值考察、实例对比和分析.发现套管井弯曲波频散曲线随地层横波速度的降低,特别是地层横波速度小于2000 m·s^-1以下,会迅速移向高频区,偶极弯曲波基础模式主频散区（或截止频率）可出现在13 kHz以上,以致超出了现行低频偶极子声波测井仪的激发与接收频带,这是一过去没有被研究者注意到的现象,并进一步被现场实例所证实.研究表明控制套管井弯曲波频散曲线主频散区位置的主要是钢套管的厚度和地层横波速度.对地层横波速度大于井孔流体声速的快速地层,在钢套管壁厚一定（8 mm）的情况下,频散曲线主频散区可移至11 kHz以上,可能出现的最大可能频域位置是同一井孔内径,井外全钢时的频散曲线上等于、小于地层横波速度那一段,这对各种地层和套管参数都是适用的.对地层横波速度小于等于井孔流体声速（1500 m·s^-1）的慢速地层,弯曲波频散曲线随地层横波速度的降低移向高频区的特点更为明显,可能移至16 kHz以上;而套管厚度的影响,也比快速地层大的多,对地层横波速度小于1380 m·s^-1的慢速地层,无论用多高的频率激发,都不能在现行使用的各类套管井（壁厚6~12 mm）中用偶极声波测井仪测到弯曲模式波.     

大功率高频电波加热电离层中人工沿场不均匀体散射特性的理论与数值模拟研究

大功率高频电波与电离层的相互作用会引起电子密度扰动,进而产生人工沿场不均匀体,其对无线电波特别是超短波信号有强的定向散射能力,可形成一种新型的超短波通信方式.基于各向异性介质的散射理论,首先通过求解电子密度扰动产生的附加极化势获得电子密度扰动散射方程,然后对电子密度扰动进行高斯自相关处理,并结合入射波/散射波与地磁场方向的空间几何关系,获得电子密度扰动的波数谱表达式,建立了人工沿场不均匀体的散射系数理论模型.利用模型对Platteville站实验中产生的人工不均匀体散射截面积进行了数值模拟,并通过与实测值对比验证了模型的正确性.根据人工沿场散射原理给出了利用其进行无线电信号传输的约束条件.重点仿真分析了人工沿场不均匀体的散射系数和散射覆盖区范围,结果表明：同等条件下,相对于高纬度地区,低纬度地区人工沿场不均匀体的散射系数小5~10 dB,但其散射覆盖区的地面范围大,东西向可达3000 km,南北向可达1500 km,完全可用于超短波信号的超远距离传输.本文结果为中低纬度地区开展相关实验研究提供了理论指导,对利用人工沿场不均匀体进行无线信号的超远距离传输应用研究具有重要意义.     

The effect of land cover change on duration and severity of high and low flows

Land cover has been increasingly recognized as an important factor affecting hydrologic processes at the basin and regional level. Therefore, improved understanding of how land cover change affects hydrologic systems is needed for better management of water resources. The objective of this study is to investigate the effects of land cover change on the duration and severity of high and low flows by using the Soil Water Assessment Tool model, Bayesian model averaging and copulas. Two basins dominated by different land cover in the Ohio River basin are used as study area in this study. Two historic land covers from the 1950s and 1990s are considered as input to the Soil Water Assessment Tool model, thereby investigating the hydrologic high and low flow response of different land cover conditions of these two basins. The relationships between the duration and severity of both low and high flow are defined by applying the copula method; changes in the frequency of the duration and severity are investigated. The results show that land cover changes affect both the duration and severity of both high and low flows. An increase in forest area leads to a decrease in the duration and severity during both high and low flows, but its impact is highest during extreme flows. The results also show that the land cover changes have had significant influences on changes in the joint return periods of duration and severity of low and high flows. While this study sheds light on the role of land cover change on severity and duration of high and low flow conditions, more studies using various land cover conditions and climate types are required in order to draw more reliable conclusions in the future. Copyright © 2016 John Wiley & Sons, Ltd.     

Application of Structure‐from‐Motion photogrammetry to river restoration

Structure‐from‐Motion (SfM) photogrammetry is now used widely to study a range of earth surface processes and landforms, and is fast becoming a core tool in fluvial geomorphology. SfM photogrammetry allows extraction of topographic information and orthophotos from aerial imagery. However, one field where it is not yet widely used is that of river restoration. The characterisation of physical habitat conditions pre‐ and post‐restoration is critical for assessing project success, and SfM can be used easily and effectively for this purpose. In this paper we outline a workflow model for the application of SfM photogrammetry to collect topographic data, develop surface models and assess geomorphic change resulting from river restoration actions. We illustrate the application of the model to a river restoration project in the NW of England, to show how SfM techniques have been used to assess whether the project is achieving its geomorphic objectives. We outline the details of each stage of the workflow, which extend from preliminary decision‐making related to the establishment of a ground control network, through fish‐eye lens camera testing and calibration, to final image analysis for the creation of facies maps, the extraction of point clouds, and the development of digital elevation models (DEMs) and channel roughness maps. The workflow enabled us to confidently identify geomorphic changes occurring in the river channel over time, as well as assess spatial variation in erosion and aggradation. Critical to the assessment of change was the high number of ground control points and the application of a minimum level of detection threshold used to assess uncertainties in the topographic models. We suggest that these two things are especially important for river restoration applications. Copyright © 2016 John Wiley & Sons, Ltd.     

Sediment transport in high‐speed flows over a fixed bed: 2. Particle impacts and abrasion prediction

Single bed load particle impacts were experimentally investigated in supercritical open channel flow over a fixed planar bed of low relative roughness height simulating high‐gradient non‐alluvial mountain streams as well as hydraulic structures. Particle impact characteristics (impact velocity, impact angle, Stokes number, restitution and dynamic friction coefficients) were determined for a wide range of hydraulic parameters and particle properties. Particle impact velocity scaled with the particle velocity, and the vertical particle impact velocity increased with excess transport stage. Particle impact and rebound angles were low and decreased with transport stage. Analysis of the particle impacts with the bed revealed almost no viscous damping effects with high normal restitution coefficients exceeding unity. The normal and resultant Stokes numbers were high and above critical thresholds for viscous damping. These results are attributed to the coherent turbulent structures near the wall region, i.e. bursting motion with ejection and sweep events responsible for turbulence generation and particle transport. The tangential restitution coefficients were slightly below unity and the dynamic friction coefficients were lower than for alluvial bed data, revealing that only a small amount of horizontal energy was transferred to the bed. The abrasion prediction model formed by Sklar and Dietrich in 2004 was revised based on the new equations on vertical impact velocity and hop length covering various bed configurations. The abrasion coefficient k_v was found to be vary around k_v ~ 10⁵ for hard materials (tensile strength f_t > 1 MPa), one order of magnitude lower than the value assumed so far for Sklar and Dietrich's model. Copyright © 2017 John Wiley & Sons, Ltd.     

地震作用下双薄壁高墩刚构桥桥台处的碰撞效应及减碰措施

针对双薄臂高墩连续刚构桥两侧桥台处主梁与背墙的碰撞现象,基于桥台-背土作用简化模型和Kelvin碰撞模型,采用非线性时程法研究碰撞对双薄臂墩地震剪力、弯矩、曲率和位移,以及支座纵向变形的影响。提出可牺牲背墙、阻尼器、加强型横系梁等三种减碰措施,并对比分析其减碰效果。研究表明:碰撞会显著增大高墩的地震内力和曲率响应,降低墩顶位移和支座的纵向变形;碰撞刚度的变化对碰撞效应的影响在20%以内;可牺牲背墙和阻尼器两种减碰措施均可大幅降低桥墩的地震内力和曲率,使其接近不考虑碰撞时的状态,阻尼器同时还可以保护支座不超过容许变形,而可牺牲背墙则会导致支座的地震破坏;加强型横系梁不能发挥减碰作用,反而会增大桥墩的地震响应。     

高烈度区大跨刚构-连续梁桥地震响应分析

为研究大跨刚构-连续梁桥在高烈度地区的地震响应,选取羊记沟左线大桥为工程背景,利用Midas软件建立多个有限元模型,考虑纵、横桥向的水平地震波输入,比较反应谱与时程分析结果,获得结构动力响应特点,为大跨刚构-连续梁桥的抗震设计提供参考依据。结果表明:刚构-连续体系仅单墩刚构时不宜采用反应谱分析,高烈度地区桥梁进行地震响应时程分析时,选用与场地适应的地震波的同时,应考虑采用本地地震参数转化人工波作为地震激励源。桥墩不等高时,可通过改变墩截面形状及其与主梁连接方式调节内力分布,避免矮墩刚度大导致的内力集中。     

Spatio‐temporal tracer variability in the glacier melt end‐member — How does it affect hydrograph separation results?

Geochemical and isotopic tracers were often used in mixing models to estimate glacier melt contributions to streamflow, whereas the spatio‐temporal variability in the glacier melt tracer signature and its influence on tracer‐based hydrograph separation results received less attention. We present novel tracer data from a high‐elevation catchment (17 km², glacierized area: 34%) in the Oetztal Alps (Austria) and investigated the spatial, as well as the subdaily to monthly tracer variability of supraglacial meltwater and the temporal tracer variability of winter baseflow to infer groundwater dynamics. The streamflow tracer variability during winter baseflow conditions was small, and the glacier melt tracer variation was higher, especially at the end of the ablation period. We applied a three‐component mixing model with electrical conductivity and oxygen‐18. Hydrograph separation (groundwater, glacier melt, and rain) was performed for 6 single glacier melt‐induced days (i.e., 6 events) during the ablation period 2016 (July to September). Median fractions (±uncertainty) of groundwater, glacier melt, and rain for the events were estimated at 49±2%, 35±11%, and 16±11%, respectively. Minimum and maximum glacier melt fractions at the subdaily scale ranged between 2±5% and 76±11%, respectively. A sensitivity analysis showed that the intraseasonal glacier melt tracer variability had a marked effect on the estimated glacier melt contribution during events with large glacier melt fractions of streamflow. Intra‐daily and spatial variation of the glacier melt tracer signature played a negligible role in applying the mixing model. The results of this study (a) show the necessity to apply a multiple sampling approach in order to characterize the glacier melt end‐member and (b) reveal the importance of groundwater and rainfall–runoff dynamics in catchments with a glacial flow regime.     

圆钢管约束高强灌浆料局部承压性能研究

以圆钢管约束高强灌浆料局部承压性能试验为基础,基于ABAQUS有限元计算平台,通过建立分段模型(Multi-section Model简称MSM模型)进行数值模拟,探究圆钢管约束高强灌浆料在局部承压作用下的力学性能,并将软件计算得到的荷载-位移曲线与试验结果进行对比分析。结果表明,分段模型适用于圆钢管约束高强灌浆料局部承压作用下的数值模拟,且计算结果与试验结果吻合较好;增大试件高径比、钢管壁厚和高强灌浆料强度均可提高其极限承载力。