中下扬子区二叠系露头层序地层研究

按新近国际年代地层划分方案（ICS，2000），下扬子区二叠纪地层自下向上分为3统，9阶和相对应的华南传统6阶划分。二叠系从阿瑟尔阶至长兴阶（44Ma)共划分出14个三级层序，每个三级层序平均时限约为3.14Ma，其中“紫松阶”）相当阿瑟尔＋2／3萨克马尔阶）1个（船山组中上部）、“隆林阶、（相当1／3萨克马尔阶＋阿丁斯克阶）2个（分别对应船山组上部和梁山组或镇江组）、“栖霞阶”（相当库班甘德阶＋1／3罗德阶）3个（栖霞组），“茅口阶”（相当于2／3罗德阶＋沃德阶＋卡皮丹阶）4个（孤峰组，茅口组，堰桥组，银屏组和武穴组），吴家坪阶2个（龙潭组或吴家坪组），长兴阶2个（长兴组或大隆组）；共归并为4个层序组（sequence set)。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

H2O-CH4-H2-CO2-CO-O2在高温、高压和高密度条件下的状态方程

为了计算高温，高压和高密度流体的热力学性质，提出了一个具有19个参数的维里型状态方程，其中参数与温度间的函数关系采用由Sutherland位能函数导出的维里系数近似式。除临界点附近以外，在已报道的pVT数据所覆盖的大部分超临界区域内，该方程均可适用。用该方程对H2O，CH4，H2，CO2，CO和O2等流体pVT关系的计算结果令人满意，其中pVT上限分别为：91-610GPa,1.6-11.0cm^3/mol,4000-5000K。计算体积的平均偏 小于0．8％，最大偏差小于5．4％。     

运用层序不对称性分析海平面变化特征

目前研究海平面变化的方法尚不能精确确定海平面变化，对记录海平面变化的沉积体或层序物质组成及结构特点的研究尚显薄弱。在分析层序不对称性与海平面变化的关系基础，提出层序不对称系数S0，认为海平面的升降变化对浅水沉积区影响显著，其结果必然造成层序S0的增加；海平面的升降变化对沉水沉积区影响不大，层序S0较为恒定。对进行详细研究中扬子区S0分布特点，运用S0曲线计算了中扬子区海平面变化特点，并与其他方法进行对比，认为可以用S0判断水体相对深浅，分析海平面变化。     

鄂尔多斯盆地上古生界高分辨率层序地层分析

按基准面旋回原理，将鄂尔多斯盆地上古生界本溪组（C2b)、太原组（P1t）、山西组(P1s)和下石盒子组（P1xs)划分为3个超长期、8个长期、19个中期和62个短期旋回层序：较为详细地介绍了各级别层序的结构类型、叠加样式和沉积演化序列；建立以长期旋回层序为年代地层框架，中期旋回层序为等时地层对比单元的层序的地层格架；并讨论高分辨率层序地层与天然气藏的关系。     

三类高强度悬式瓷绝缘子的成分和物相分析

为探讨高原牌70kN和进口120，210kN瓷绝缘子的成分和结构性能，中采用原子吸收光谱（AAS）和X射线衍射（XRD）方法，对三类产品进行了检测。结果表明，有效成分除K2O外，70kN和210kN的SiO2,Al2O3,Fe2O3含量接近，主晶相基本相同，有刚玉，莫来石、石英和长石等；结晶相总量：70kN35%，120kN40%,210kN48%，这表明机械强度愈大，结晶相含量愈高，只需调整70kN原样的部分成分，粒度和工艺，即生产出高等级（如210kN)瓷绝缘子。     

高温高压下电解质溶液热力学性质的研究进展

高温高压下电解质溶液热力学性质的研究不仅对探讨地球内部流体的作用具有重要意义，而且在很多实际工业过程中也都有广泛应用。本综述了近10年来高温高压下电解质溶液热力学参数的实验测量和理论计算的进展，实验设备还有待进一步的改进和完善，以获得更高温度和压力下的数据，理论计算不仅有待于实验的发展，也与溶液的结构理论密切相关。     

厚层覆盖区综合物化探方法找金试验研究——以广西兴安金石金矿为例

在兴安金石金矿外围 4号分散流异常区 ,通过地电化学提取金测量法 ,查明测区存在 5个走向规模小于 5 0 m的金异常区 ,W( Au) 最大值为 72 .4× 10 - 9,高出背景值十几倍 ,并藉综合土壤吸附汞测量 ,高精度磁测和激发极化法等多种物化探方法来确定这些异常区的地质、地球化学和地球物理特征 ,提出金矿成矿的有利部位在金的地电提取高异常区、高汞量异常区、高磁性异常区、低视电阻率异常区和中等视极化率异常区的“三高一低一中”的找矿模式。确定测区的北北东角 (右下角 )一带具备有利的金矿成矿条件