Soil erosion susceptibility assessment and validation using a geostatistical multivariate approach: a test in Southern Sicily

A certain number of studies have been carried out in recent years that aim at developing and applying a model capable of assessing water erosion of soil. Some of these have tried to quantitatively evaluate the volumes of soil loss, while others have focused their efforts on the recognition of the areas most prone to water erosion processes. This article presents the results of a research whose objective was that of evaluating water erosion susceptibility in a Sicilian watershed: the Naro river basin. A geomorphological study was carried out to recognize the water erosion landforms and define a set of parameters expressing both the intensity of hydraulic forces and the resistance of rocks/soils. The landforms were mapped and classified according to the dominant process in landsurfaces affected by diffuse or linear water erosion. A GIS layer was obtained by combining six determining factors (bedrock lithology, land use, soil texture, plan curvature, stream power index and slope-length factor) in unique conditions units. A geostatistical multivariate approach was applied by analysing the relationships between the spatial distributions of the erosion landforms and the unique condition units. Particularly, the density of eroded area for each combination of determining factors has been calculated: such function corresponds, in fact, to the conditional probability of erosion landforms to develop, under the same geoenvironmental conditions. In light of the obtained results, a general geomorphologic model for water erosion in the Naro river basin can be depicted: cultivated areas in clayey slopes, having fine-medium soil texture, are the most prone to be eroded; linear or diffuse water erosion processes dominate where the topography is favourable to a convergent or divergent runoff, respectively. For each of the two erosion process types, a susceptibility map was produced and submitted to a validation procedure based on a spatial random partition strategy. Both the success of the validation procedure of the susceptibility models and the geomorphological coherence of the relationships between factors and process that such models suggest, confirm the reliability of the method and the goodness of the predictions.     

Effect of Inter-Column Spacing on Soil Stresses due to Vibro-Installed Stone Columns: Interesting Findings

This paper reveals the interesting relation between the inter-column spacing and the corresponding alteration of soil state of stresses due to the vibro-installation technique. This relation is inferred from analyses for load settlement records of various field load tests, performed for stone columns arrangements with different inter-column spacing values. In order to have adequate confidence in the findings, a well-documented case history, involving three columns patterns along with their relevant field and laboratory test results, is utilized for this study. Moreover, a well-tested finite element model, capable of simulating both elasto-plastic and time dependent soil deformations as well as pore water pressure building and dissipation, is employed in the analysis. Instead of determining the soil response to the test load, based on known initial soil stresses and material properties, the analysis is inversely posed to determine the soil initial stresses, based on the recorded settlements and the post-installation material properties. The alteration in the soil state of stress is represented by the increase in the post-installation horizontal to vertical stress ratio, K*, as a function of the inter-column spacing. It is found that this alteration experiences a systematic decrease in its magnitude as the inter-column spacing increases.     

江苏潮滩沉积物激光粒度仪与移液管-筛析分析结果的对比

激光粒度仪的广泛应用带来了与历史数据的对比问题,因此需要建立激光粒度仪与早期分析结果之间的关系。根据江苏海岸潮滩沉积物样品的激光粒度仪和移液管-筛析法分析,对粒度参数、粒度组分等进行了对比,对两种方法的差异进行了分析。结果表明,对于江苏潮滩沉积物粒度参数中平均粒径的激光粒度仪与移液管-筛析分析结果之间有良好的线性关系;筛分法测得的粗颗粒物质较激光法偏少,而移液管法法测得的细颗粒物质较激光法偏多;将样品分类之后再进行两种方法所获粒度参数的回归分析,相关性得以提高,说明不同粒度组成的沉积物对分析结果的对比有不同的影响。两种方法之间的换算关系不仅与研究区域有关,而且与沉积物本身的粒度组成有关。     

柴达木盆地北缘侏罗系两类不同有机质丰度泥岩的 生物标志物特征对比研究

在柴达木盆地北缘地区,分别选取有机碳含量很低和较高的侏罗系泥岩样品,对比分析了它们在生物标志物组成上的差异。结果发现,高有机质丰度泥岩的生标组成与我国西北地区侏罗纪煤系有机质的特征差异不大,相比而言,低有机质丰度泥岩的正烷烃以前主峰为特征,Pr/Ph比值在1.0左右,三环萜烷和伽马蜡烷丰度较高,并在部分样品中检出了25 降藿烷系列。结合泥岩的有机岩石学特征,认为这些差异可能反映了泥岩沉积环境和生烃母质的不同:高有机质丰度泥岩的有机显微组分以相对弱还原条件下的形态有机质为主,包括藻类体、孢子体和角质体等,而低有机质丰度泥岩的有机显微组分以相对强还原条件下的矿物沥青基质为主,其母质可能来源于低等显微菌藻类。进一步通过对比不同有机质丰度泥岩,以及区内原油生标组成之间的相互关系,讨论了研究区的油源问题。     

三峡库区生基包滑坡监测及成果分析

生基包滑坡监测属于三峡库区奉节县三期地质灾害监测预警项目之一,该滑坡位于长江左岸,临近人口稠密的安坪乡集镇,地理位置重要。三峡水库175 m蓄水后,其变形破坏特征有何表现？对航道安全运营有无潜在威胁？是否会对滑坡体上的重要建筑及村民生产生活构成危害？针对这些问题,首先分析了滑坡的工程地质特征及主要的影响因素;其次,确立以4种监测手段为主、人工巡查为辅的监测方案;通过对大地变形GPS、深部位移、滑坡推力等几种监测方法的运用及对其成果进行分析研究,以实例说明其在滑坡监测中的应用;再次,结合宏观人工巡查进行对照分析,以充分说明大地变形、深部位移和滑坡推力监测在实际运用中的可行性;最后,根据监测结论提出对生基包滑坡防治的建议。     

滑坡体三维地质建模与可视化分析

针对滑坡地质研究的自身特点,提出了面向滑坡地质体三维建模的NURBS-BRep混合数据结构和地质结构单元实体构造技术.通过对滑坡基础地质数据的预处理、滑坡数字地形和滑动面的三维建模、地质结构面的系统构造、地质结构体的生成和显示,形成了一套完整的滑坡三维地质模型的构建方法.将该方法应用于某水库滑坡,建立了相应的三维滑坡地质模型,并基于此模型进行了三维剖切分析、数字钻孔、等值线生成、滑块自动剖分、滑坡失稳可视化动态模拟和滑坡体方量精确计算等一系列实用的可视化分析,为滑坡稳定性的准确计算和客观评价提供了有力的支持.     

盘山山前地下水与矿泉水污染成因分析

文章利用主成分分析方法,结合揭示变量和样品之间在成因或空间上联系的对应分析,通过SPSS统计分析软件,对盘山山前地区地下水和矿泉水污染成因进行分析。研究表明,盘山山前存在地下水和矿泉水污染;局部范围的污染主要是由于食品厂等企业的排污引起的,污染成分主要是Cl-和NO3—N,主要污染地区是塔院地区,其次是西大佛塔至南营,污染程度与至污染源的距离有关;大部分地区存在三氮面状污染,农业氮肥的施用是其主要原因。     

粗颗粒悬移质测验误差分析

本文根据流速与含沙量分布,研究了悬移质积点法对粗颗粒含沙量测验误差.首先指出无论从输沙率还是从悬浮高度看,粗颗粒悬移质集中于河底,致使水文测验中的一些测验方法(如一点法、二点法、三点法等)带有较大的误差.进而分析了各种测法对粗颗粒的相对误差,并且随着颗粒变粗,误差愈来愈大,以致不能接受.这种情况在水库下游河道冲刷过程中,会在一定程度上出现,必须重视研究和调整测验方法.最后通过与长江委水文局在沙市及监利两水文站试验结果对比,证明本文理论上的分析是可信的.     

敦化盆地上侏罗统-上新统地层划分对比讨论

利用野外资料、地震资料、煤田钻孔资料以及古生物资料,对松辽盆地外围探区敦化盆地的代表性地层划分方案进行了梳理,通过敦化盆地与周缘盆地之间的对比和分析,得出下列认识:(1)明确了珲春组的时代为始新世—渐新世;(2)指出白垩系上统龙井组地层在敦化盆地内可能是不存在的;(3)将原帽儿山组上段和下段分别划归泉水村组和长财组;(4)认为大砬子组、泉水村组、长财组和屯田营组在敦化盆地内是存在的,并通过盆间岩性地层和古生物地层对比指出大砬子组的时代可能为早白垩世阿普特期(Aptian)—阿尔布期(Albian),长财组时代可能为早白垩世贝利阿斯期—阿普特期;(5)对敦化盆地内几个地方地层名称的使用进行了修正;(6)建立了敦化盆地内目前可供参考使用的地层序列。     

海洋湍流的测量及相关分析

对海洋湍流速度脉动的一维概率密度作了测量，并把测量结果与高 斯分布进行了比较。比较的结果表明，一个接近于高斯分布而另一个却差别较 大。计算到直至五阶湍流相关函数并与网格湍流进行了比较，结果都表明小时 间间隔中测量结果与网格湍流的结果近似一致，而大时间间隔中却相差很大。 以上结论说明了较长的测量时间的必要性。