A study on the focal parameters of Shidian M =5.9 earthquake sequences in 2001

On the basis of about 300 earthquake wave forms observed in the Shidian M _S=5.9 sequences on April 12, 2001 recorded in Kunming Digital Seismic Network, the spectra of shear wave have been used to estimate the focal parameters of these earthquake sequences. The results show that within the magnitude range of 1.5–5.3, the seismic moments are 10¹⁰–10¹⁶ N·m, the corner frequencies are 0.2–0.8 Hz, radii of the focal rupture are 200–2 500 m and the stress drops are 0.1×10⁵–20×10⁵Pa. Through the statistical analyses of variation of corner frequency f _c and stress drop Δσ with time, it is discovered that the average corner frequency of the foreshock sequences is obviously lower than that of the aftershock sequences. Contrarily, the average stress drops Δσ of the foreshock sequences are clearly higher than that of the aftershocks. It is considered that these variation characteristics of average corner frequency and stress drops before and after the main shock have index significance to the precursory information before a strong earthquake. The higher stress drops for the foreshock sequences show that the higher shear stresses have been stored in the area of main shock. After the main shock, most of the stresses have been released, so the aftershock sequences show a rupture process of lower stresses. Foundation item: Scientific and Technological Key Project of Yunnan Province (2001NG46)     

Study on the Source Parameters of Earthquakes in the Middle Eastern Area of North Tianshan in Xinjiang

INTRODUCTIONThe study of source parameters is usually based oninversionfromobservational seismic waveformdata.Seismic wave affected bygeometric spreading,inelastic attenuation,scatteringandsite effects ofthe mediumontheir way fromsource to station.Therefo…     

基于正交多项式逼近法的岩土参数概率分布推断

针对岩上参数样本容量较大的情况,基于数值分析中的逼近原理,直接根据试验样本值,运用勒让德正交多项式来拟合岩土参数的概率密度函数,并用K-S检验法从理论上证明所求的密度函数的正确性和实用性。     

珠江三角洲江村ZK2钻孔沉积物粒度的环境意义

运用MALVERN公司2000型粒度仪对珠江三角洲地区的江村ZK2钻孔作粒度分析，江村钻孔按粒度的偏态值可划分为两个河相与海相或湖泊沼泽相的沉积交替过程，同时与粒度参数、年代数据以及前人所做的孢粉等证据相结合，大致看出研究区气候变化的4个千年尺度的气候波动：第一阶段为较长时间的冷干期，该段时间约为20-10．7kaB．P．；第二阶段为回暖期，时间大致在10．7-7．5kaB．P.,总体比较湿润；第三阶段为升温期，该时期约在7．5-5kaB．P．之间，在此期间各有一次干湿交替；第四阶段为降温期，时间大约出现在5kaB．P．至今，这是一个波动性较大的时期，也各有一次干湿交替。     

Generalized plasticity state parameter‐based model for saturated and unsaturated soils. Part 1: Saturated state

The behavior of granular materials is known to depend on its loose or dense nature, which in turns depends both on density and confining pressure. Many models developed in the past require the use of different sets of constitutive parameters for the same material under different confining pressures. The purpose of this paper is to extend a basic generalized plasticity model for sands proposed by Pastor, Zienkiewicz and Chan by modifying the main ingredients of the model flow—rule, loading–unloading discriminating direction and plastic modulus—to include a dependency on the state parameter. The proposed model is tested against the available experimental data on three different sands, using for each of them a single set of material parameters, finding a reasonably good agreement between experiments and predictions. Copyright © 2010 John Wiley & Sons, Ltd.     

Generalized plasticity state parameter‐based model for saturated and unsaturated soils. Part II: Unsaturated soil modeling

The aim of this paper is to extend the generalized plasticity state parameter‐based model presented in part 1 to reproduce the hydro‐mechanical behavior of unsaturated soils. The proposed model is based on two pairs of stress–strain variables and a suitable hardening law taking into account the bonding—debonding effect of suction and degree of saturation. A generalized state parameter for unsaturated state is proposed to reproduce soil behavior using a single set of material parameters. Generalized plasticity gives a suitable framework to reproduce not only monotonic stress path but also cyclic behavior. The hydraulic hysteresis during a drying—wetting cycle and the void ratio effect on the hydraulic behavior is introduced. Comparison between model simulations and a series of experimental data available, both cohesive and granular, are given to illustrate the accuracy of the enhanced generalized plasticity equation. Copyright © 2010 John Wiley & Sons, Ltd.     

One-dimensional consolidation of soil under multistage load based on continuous drainage boundary

In engineering practice, a rapid loading rate can result in ground failure when the strength of soft soils is relatively low, and a multistage loading scheme is always utilized to deal with this situation. Firstly, under a multistage load and the continuous drainage boundary, an analytical solution of excess pore-water pressure and consolidation degree is obtained by virtue of the superposition formula of excess pore-water pressure, and a more general continuous drainage boundary under arbitrary time-dependent load is developed. Then, a comparison with existing analytical solutions is conducted to verify the present solution. A preliminary attempt on applying the continuous drainage boundary into the finite element model is made, and the feasibility of the numerical model for the one-dimensional consolidation under the continuous drainage boundary is verified by comparing the results calculated by FEM with that from present analytical solution. Finally, the consolidation behavior of soil is investigated in detail for different int erface parameters or loading scheme. The results show that, in land reclamation projects, a horizontal drain should be placed close to the boundary with a smaller interface parameter to improve the consolidation efficiency. The degree of consolidation is also related to the applied time-dependent load and interface parameters.     

The impact of rural land management changes on soil hydraulic properties and runoff processes: results from experimental plots in upland UK

To develop an evidence base to help predict the impacts of land management change on flood generation, four experimental sites were established on improved grassland used for sheep grazing at the Pontbren catchment in upland Wales, UK. At each site, three plots were established where surface runoff was measured, supplemented by measurements of soil infiltration rates and soil and vegetation physical properties. Following baseline monitoring, treatments were applied to two of the plots: exclusion of sheep (ungrazed) and exclusion of sheep and planting with native broadleaf tree species (tree planted), with the third plot acting as a control (grazed pasture). Due to a particularly dry summer that occurred pre‐treatment, the soil hydrological responses were initially impacted by the effects of the climate on soil structure. Nevertheless, treatments did have a clear influence on soil hydrological response. On average, post‐treatment runoff volumes were reduced by 48% and 78% in ungrazed and tree‐planted plots relative to the control, although all results varied greatly over the sites. Five years following treatment application, near‐surface soil bulk density was reduced and median soil infiltration rates were 67 times greater in plots planted with trees compared to grazed pasture. The results illustrate the potential use of upland land management for ameliorating local‐scale flood generation but emphasise the need for long‐term monitoring to more clearly separate the effects of land management from those of climatic variability. Copyright © 2013 John Wiley & Sons, Ltd.     

Enhancement of backtracking search algorithm for identifying soil parameters

In this paper, an enhanced backtracking search algorithm (so-called MBSA-LS) for parameter identification is proposed with two modifications: (a) modifying the mutation of original backtracking search algorithm (BSA) considering the contribution of current best individual for accelerating convergence speed and (b) novelly incorporating an efficient differential evolution (DE) as local search for improving the quality of population. The proposed MBSA-LS is first validated with better performance than the original BSA and some other typical state-of-the-art optimization algorithms on a benchmark of soil parameter identification in terms of effectiveness, efficiency, and robustness. Then, the efficiency of the MBSA-LS is further illustrated by two representative cases: identifying soil parameters from both laboratory tests and field measurements. All comparisons demonstrate that the proposed MBSA-LS algorithm can give accurate results in a short time. Finally, to conveniently solve the problems of parameter identification, a practical tool ErosOpt for parameter identification is developed by integrating the proposed MBSA-LS and some other efficient algorithms for readers to conduct the parameter identification using optimisation algorithms.     

Sensitivity of soil parameters in unsaturated zone modelling and the relation between effective,laboratory and in situ estimates

Simulation of soil moisture content requires effective soil hydraulic parameters that are valid at the modelling scale. This study investigates how these parameters can be estimated by inverse modelling using soil moisture measurements at 25 locations at three different depths (at the surface, at 30 and 60 cm depth) on an 80 by 20 m hillslope. The study presents two global sensitivity analyses to investigate the sensitivity in simulated soil moisture content of the different hydraulic parameters used in a one‐dimensional unsaturated zone model based on Richards' equation. For estimation of the effective parameters the shuffled complex evolution algorithm is applied. These estimated parameters are compared to their measured laboratory and in situ equivalents. Soil hydraulic functions were estimated in the laboratory on 100 cm³ undisturbed soil cores collected at 115 locations situated in two horizons in three profile pits along the hillslope. Furthermore, in situ field saturated hydraulic conductivity was estimated at 120 locations using single‐ring pressure infiltrometer measurements. The sensitivity analysis of 13 soil physical parameters (saturated hydraulic conductivity (K_s), saturated moisture content (θ_s), residual moisture content (θ_r), inverse of the air‐entry value (α), van Genuchten shape parameter (n), Averjanov shape parameter (N) for both horizons, and depth (d) from surface to B horizon) in a two‐layer single column model showed that the parameter N is the least sensitive parameter. K_s of both horizons, θ_s of the A horizon and d were found to be the most sensitive parameters. Distributions over all locations of the effective parameters and the distributions of the estimated soil physical parameters from the undisturbed soil samples and the single‐ring pressure infiltrometer estimates were found significantly different at a 5% level for all parameters except for α of the A horizon and K_s and θ_s of the B horizon. Different reasons are discussed to explain these large differences. Copyright © 2004 John Wiley & Sons, Ltd.