吉林地区地电阻率震兆异常对比分析

对采用形态法、归一化变化速率法和各向异性度法提取到的吉林省内深源地震以及浅源地震前的地电阻率异常变化进行对比分析,结果表明:(1)震前地电阻率出现1~2年尺度中期异常,甚至短期异常,异常以负异常为主;(2)震前地电阻率原始月均值异常变化幅度1%,表明数字地电仪捕捉电信号灵敏度的提高,更与台址构造密不可分;(3)震前地电阻率出现异常变化,震后恢复到正常变化形态,反映出震前震中区地下应力的变化,震后区域构造应力场重新调整并逐渐恢复的过程。     

无锡马山抽水蓄能电站地面厂房边坡稳定性分析

以无锡马山抽水蓄能电站地面厂房建筑过程中形成的人工边坡为例,在对其工程地质剖面分析并找出可能的滑动模式后,利用极限平衡法和有限元法分析了4个典型地质剖面的稳定性安全系数以及应力应变关系。结果表明,通过对该边坡的极限平衡法得到了2-2剖面的安全系数和通过有限元法得到的计算结果比较接近,且都满足相关规范的要求;坡体的最大位移发生在高程为－20 m和－5.0 m附近,其值为－22 mm;最大主应力位于高程－45.0 m处,值为0.134 MPa;最小主应力位于坡内深处,其值为－6.22 MPa。同时,提出了下一阶段应考虑时间效应,对边坡的变形进行分析。     

Analysis on the law of occurrence of shallow geothermal energy in Zhoukou City of Henan Province,China

In this paper, through data collection and field investigation, the development and utilization status of shallow geothermal energy in Zhoukou urban area was discussed. Based on the analysis of hydrogeological conditions, rock and soil structure characteristics and field test research, the spatial distribution characteristics of rock and soil in the study area were summarized. The study shows that Zhoukou City is located in the alluvial plain of Huanghuai, and the loose deposits of river alluvial genesis range 0-200 m. These loose deposits and groundwater stored in their pores are the main carriers of shallow geothermal energy. In the central part of the Yinghe River in the middle of the study area, the aquifer thickness is within 200 m, the particle size is coarser, the water-bearing degree and recharge capacity is better. On this basis, the paper uses AHP to evaluate the suitability of shallow geothermal energy development and utilization to guide the rational development and utilization of shallow geothermal energy resources.     

Proposed nonlinear 3-D analytical method for piled raft foundations

The load distribution and deformation of piled raft foundations subjected to axial and lateral loads were investigated by a numerical analysis and field case studies. Special attention is given to the improved analytical method (YSPR) proposed by considering raft flexibility and soil nonlinearity. A load transfer approach using p–y, t–z and q–z curves is used for the analysis of piles. An analytical method of the soil–structure interaction is developed by taking into account the soil spring coupling effects based on the Filonenko-Borodich model. The proposed method has been verified by comparing the results with other numerical methods and field case studies on piled raft. Through comparative studies, it is found that the proposed method in the present study is in good agreement with general trend observed by field measurements and, thus, represents a significant improvement in the prediction of piled raft load sharing and settlement behavior.     

On the linear elastic responses of the 2D bonded discrete element model

The bonded discrete element model (DEM) is a numerical tool that is becoming widely used when studying fracturing, fragmentation, and failure of solids in various disciplines. However, its abilities to solve elastic problems are usually overlooked. In this work, the main features of the 2D bonded DEM which influence Poisson's ratio and Young's modulus, and accuracy when solving elastic boundary value problems, are investigated. Outputs of numerical simulations using the 2D bonded DEM, the finite element method, a hyper elasticity analysis, and the distinct lattice spring model (DLSM) are compared in the investigation. It is shown that a shear interaction (local) factor and a geometric (global) factor are two essential elements for the 2D bonded DEM to reproduce a full range of Poisson's ratios. It is also found that the 2D bonded DEM might be unable to reproduce the correct displacements for elastic boundary value problems when the represented Poisson's ratio is close to 0.5 or the long-range interaction is considered. In addition, an analytical relationship between the shear stiffness ratio and the Poisson's ratio, derived from a hyper elasticity analysis and applicable to discontinuum-based models, provides good agreement with outputs from the 2D bonded DEM and DLSM. Finally, it is shown that the selection of elastic parameters used the 2D bonded DEM has a significant effect on fracturing and fragment patterns of solids.     

The eastern Tonale fault zone: a ‘natural laboratory’ for crystal plastic deformation of quartz over a temperature range from 250 to 700 °C

Near the eastern end of the Tonale fault zone, a segment of the Periadriatic fault system in the Italian Alps, the Adamello intrusion produced a syn-kinematic contact aureole. A temperature gradient from 250 to 700 °C was determined across the Tonale fault zone using critical syn-kinematic mineral assemblages from the metasedimentary host rocks surrounding deformed quartz veins. Deformed quartz veins sampled along this temperature gradient display a transition from cataclasites to mylonites (frictional–viscous transition) at 280±30 °C. Within the mylonites, zones characterized by different dynamic recrystallization mechanisms were defined: Bulging recrystallization (BLG) was dominant between 280 and 400 °C, subgrain rotation recrystallization (SGR) in the 400–500 °C interval, and the transition to dominant grain boundary migration recrystallization (GBM) occurred at 500 °C. The microstructures associated with the three recrystallization mechanisms and the transitions between them can be correlated with experimentally derived dislocation creep regimes. Bulk texture X-ray goniometry and computer-automated analysis of preferred [c]-axis orientations of porphyroclasts and recrystallized grains are used to quantify textural differences that correspond to the observed microstructural changes. Within the BLG- and SGR zones, porphyroclasts show predominantly single [c]-axis maxima. At the transition from the SGR- to the GBM zone, the texture of recrystallized grains indicates a change from [c]-axis girdles, diagnostic of multiple slip systems, to a single maximum in Y. Within the GBM zone, above 630±30 °C, the textures also include submaxima, which are indicative of combined basal a- and prism [c] slip.     

胜坨油田坨28断块沙河街组二段储层非均质性定量研究

运用模糊数学方法计算非均质综合指数和计算渗透率非均质参数,对胜坨油田坨28断块沙河街组二段储层的非均质性进行了定量研究。结果表明：储层的层间,层内和平面非均质性强,随着开发注水的深入进行,非均质性有减弱趋势,但减弱幅度不大;各小层及其韵律层在不同开发时期的非均质程度有明显的差异。沉积微相控制储层非均质程度;成岩作用使非均质性复杂化;注采井网不完善,加剧了非均质性的差异性。研究成果在剩余油挖潜的应用中起到重要作用。     

Tree-ring dated landslide movements and their relationship to seismic events in southwestern Montana, USA

To determine periods of incremental landslide movement and their possible relationship to regional seismic events, the tree-ring records of 32 tilted and damaged conifers at three sites on landslides in the Gravelly Range of southwestern Montana were examined. Several signs of disturbance in the tree-ring record indicating landslide movement were observed. Commonly, the tree-ring record displayed a marked reduction in annual ring width and/or the reaction wood formation. The tree-ring records from the three landslide sites indicate multiple periods of movement during the 20th century. Many of the periods of movement indicated by the strongest signals (most trees) at the sites occurred the year following significant earthquakes in the region. Those seismic events for which evidence in the tree-ring record was found at one or more of the three sites are the 1983 Borah Peak, 1959 Hebgen Lake, 1935 Helena, 1925 Clarkson, and 1908 Virginia City earthquakes. This study suggests that many of the landslide movements were triggered by, or are coincident with, earthquakes as much as 200 km from the study area.     

半干旱地区水资源承载能力研究——以松嫩平原西南部霍林河流域为例

水资源的合理开发利用与否是影响社会经济发展的瓶颈。以霍林河流域为研究对象,对该流域特征及其生态环境问题进行了分析,构建了水资源承载力研究的指标体系,该体系包括水资源形成的自然条件、开发利用及社会经济因素3个方面9项指标。应用因子分析法对流域内各县市水资源承载能力进行定量评价,结果表明,霍林河流域从上游到下游,水资源承载能力主要受水资源形成条件和开发利用强度的影响,水资源承载能力评价是水资源可持续利用的关键。     

边坡稳定性分析及治理设计软件Slide CAD的开发

以软件易用性为指导,系统阐述了Slide CAD的设计开发思路和主要功能。该软件以交互式输入为主,包括前处理,求解器,后处理3大模块。提供一系列滑面计算方法与搜索算法。同时为边坡治理提供对悬臂,锚索,“人”字型抗滑桩等优化设计计算。