微波消解-电感耦合等离子体质谱法测定海泡石中的稀土元素

海泡石是一种纤维状含水的富镁硅酸盐黏土矿,其中的稀土元素含量在1×10~(-7)～1×10~(-5)之间,目前还没有建立海泡石中稀土元素的国家标准分析方法。测定岩石中的稀土元素主要是采用电感耦合等离子体质谱法(ICP-MS),样品前处理一般采用封闭溶矿和碱熔,但这两种处理方法耗时较长,效率不高。本文通过比较硝酸-氢氟酸-过氧化氢、硝酸-氢氟酸、硝酸-过氧化氢三种样品前处理方法,确定使用硝酸-氢氟酸溶矿,然后进行微波消解同时赶去氢氟酸,避免氢氟酸与稀土元素生成难溶的氟化物,再采用ICP-MS法测定15种稀土元素的含量。由于海泡石中的镁含量较高,为降低基体效应,以~(103)Rh和~(185)Re作内标补偿基体效应和校正灵敏度漂移,各元素测定值的准确性显著提高,回收率为91. 2%～110. 9%,检出限为0. 002～0. 011μg/L,精密度≤2. 79%。本方法与封闭酸溶ICP-MS法的分析结果吻合较好,且用酸量少(7 mL),溶矿效率高(1 h),检出限更低。     

2000-2014年西藏雅鲁藏布江流域积雪时空变化分析及对气候的响应研究

利用2000-2014年MODIS逐日无云积雪产品对雅鲁藏布江流域积雪特征的空间分布及变化、积雪随高程变化的规律进行了分析,并采用被动微波数据SMMR （1979-1987年）和SSM/I （1988-2008年）以及中国地面降水和气温0.5°×0.5°日值格点数据集,研究了雅鲁藏布江流域关键积雪参数对气候要素的响应等。结果表明：流域下游积雪日较大且变化剧烈;流域整体上呈显著减少的趋势;积雪日随高程的上升而增加;流域内降水呈不显著的增加趋势,而气温呈显著的增加趋势,最高气温对积雪变化影响最大;气温对积雪终日的影响明显高于积雪初日;在积雪消融期降水的增多促进了积雪的消融。     

微波辐射计在对流天气预报中的应用

选取2016—2018年每年4—9月份RPG-HATPRO型42通道微波辐射计观测的不稳定指数参数(K、SI、CAPE、LI)及水汽参数(IWV、LWP),研究得出各参数触发雷雨大风、短时强降水的阈值条件为K>37℃、SI<-1℃、IWV>60 kg/m~2、LWP>400 g/m~2,而LI、CAPE无法对3种天气类型进行区分。利用费舍判别分析方法,将不稳定指数参数及水汽参数作为预报因子,建立预报方程并进行检验,结果表明:二级判别方程预测对流天气的准确率为76%,可以作为预报对流天气的辅助工具;多级判别方程不能很好地区分3种天气类型,但将其作为修正后的二级判别方程使用,能提高对流天气的测中概率。     

微波等离子体原子发射光谱法测定偏远矿区海泡石中的主微量元素

海泡石是具有层状结构的含水富镁硅酸盐黏土矿物,其中无机元素含量是揭示其成矿物质来源、成矿流体性质和矿床成因的重要依据,通常采用电感耦合等离子体发射光谱/质谱法(ICP-OES/MS)进行测定,等离子体(ICP)的高温激发会产生成大量谱线干扰,维持ICP稳定工作需使用高纯氩气,持续供气对于偏远矿区海泡石的检测还将面对气体采购和运输不便的问题。本文基于微波等离子体原子发射光谱(MP-AES)的低温激发技术减少光谱干扰,建立了准确测定偏远矿区海泡石中主量元素Mg、Al、Ca、Fe、K、Na和微量元素Cu、Zn、Mn、Pb含量的分析方法。利用硝酸-盐酸-氢氟酸混合酸对海泡石进行微波消解,避免了样品处理过程中分析元素的损失,加快了样品处理速度,同时提高了样品溶液的稳定性。通过选择各元素光谱线的分析波长,并利用快速线性干扰校正(FLIC)技术校正光谱干扰,以Lu为内标元素校正基体效应,提高了灵敏度和准确度。各元素的检出限为0.19～14.6μg/L。海泡石国家标准物质(GBW07138)各元素测定值与认定值的相对误差在-5.0%～6.7%之间。本方法具有检出限低、线性范围宽、结果准确等优点;MP-AES采用自带的氮气发生器为等离子体提供氮气作为工作气,无需引入复杂气体,提高了分析效率,尤其适用于气体采购和运输不便的偏远矿区。     

Latitudinal and Scan-dependent Biases of Microwave Humidity Sounder Measurements and Their Dependences on Cloud Ice Water Path

The relationship between differences in microwave humidity sounder(MHS)–channel biases which represent measured brightness temperatures and model-simulated brightness temperatures, and cloud ice water path(IWP) as well as the influence of the cloud liquid water path(LWP) on the relationship is examined. Seven years(2011–17) of NOAA-18 MHS-derived measured brightness temperatures and IWP/LWP data generated by the NOAA Comprehensive Large Array-data Stewardship System Microwave Surface and Precipitation Products System are used. The Community Radiative Transfer Model, version2.2.4, is used to simulate model-simulated brightness temperatures using European Center for Medium-Range Weather Forecasts reanalysis data as background fields. Scan-angle deviations of the MHS window channel biases range from-1.7 K to1.0 K. The relationships between channels 2, 4, and 5 biases and scan angle are symmetrical about the nadir. The latitudedependent deviations of MHS window channel biases are positive and range from 0–7 K. For MHS non-window channels,the latitudinal deviations between measured brightness temperatures and model-simulated brightness temperatures are larger when the detection height is higher. No systematic warm or cold deviations are found in the global spatial distribution of difference between measured brightness temperatures and model-simulated brightness temperatures over oceans after removing scan-angle and latitudinal deviations. The corrected biases of five different MHS channels decrease differently with respect to the increase in IWP. This decrease is stronger when LWP values are higher.     

SNOW WETNESS ESTIMATES OF VEGETATED TERRAIN FROM SATELLITE PASSIVE MICROWAVE DATA

The Special Sensor Microwave/Imager (SSM/I) radiometer is a useful tool for monitoring snow wetness on a large scale because water content has a significant effect on the microwave emissions at the snowpack surface. To date, SSM/I snow wetness algorithms, based on statistical regression analysis, have been developed only for specific regions. Inadequate ground-based snow wetness measurements and the non-linearity between SSM/I brightness temperatures (T_Bs) and snow wetness over varied vegetation covered terrain has impeded the development of a general model. In this study, we used a previously developed linear relationship between snowpack surface wetness (% by volume) and concurrent air temperature (°C) to estimate the snow wetness at ground weather stations. The snow condition (snow free, dry, wet or refrozen snow) of each SSM/I pixel (a 37 × 29 km area at 37.0 GHz) was determined from ground-measured weather data and the T_B signature. SSM/I T_Bs of wet snow were then linked with the snow wetness estimates as an input/output relationship. A single-hidden-layer back-propagation (backprop) artificial neural network (ANN) was designed to learn the relationships. After training, the snow wetness values estimated by the ANN were compared with those derived by regression models. Results show that the ANN performed better than the existing regression models in estimating snow wetness from SSM/I data over terrain with different amounts of vegetation cover.     

大型射电望远镜主反射面调整方法研究

随着毫米波天文学和空间通信的重要性日益提高, 对天线性能提出了越来越高的要求, 而天线性能往往受到其反射器表面精度的限制. 微波全息技术是一种快速有效的检测反射面天线表面轮廓的测量技术. 通过微波全息测量得到天线口径场, 计算天马65m射电望远镜反射面与理想抛物面的偏差. 天马65m射电望远镜的主反射面板是放射状的, 有14圈. 面板的每个角都固定在面板下方促动器的螺栓上进行上下移动, 且相邻面板交点处的拐角共用一个促动器. 采用平面拟合的方法可以计算各块面板拐角处的调整值, 但是同一个促动器会得到4个不同的调整量. 通过平面拟合, 同时以天线照明函数为权重的平差计算方法得到相邻面板拐角的一个平差值, 即天马65m射电望远镜1104个促动器的最佳调整值. 通过多次调整和新算法的应用, 天马65m射电望远镜反射面的面形精度逐渐提高到了0.24mm.     

航空重力弱信号提取的卡尔曼滤波方法研究

航空重力测量以飞机为载体对重力场数据进行采集.由于气流、飞行状态及机体自身振动等因素的影响,航空重力测量原始数据含有大量的噪声,信噪比高达上万级分之一,因此从原始测量数据中获取弱小重力信号成为航空重力测量系统发展的一个技术难题.本文针对航空重力测量系统将通用卡尔曼滤波公式进行了适应性调整,建立了航空重力异常的数学模型,...     

龙须菜琼胶的提取方法研究

采用多种方法提取了龙须菜(Gracilaria lemaneiformis)中的琼胶,并研究了碱处理、微波处理、超声波处理等方法对龙须菜的琼胶提取率、硫酸基质量分数和多糖质量分数的影响。结果表明:当碱质量分数由2.5%增加到10%时,琼胶产率由15%降低到9.8%,硫酸基质量分数由2.66%降低到2.06%,同时,多糖质量分数由98.3%增加到102.6%;微波和超声波处理在不同程度上增加了琼胶的提取率和多糖质量分数,同时降低了硫酸基质量分数。另外,还从宏观和微观两个角度考察了龙须菜碱处理前后藻体的变化。     

Coupling numerical simulation with remotely sensed information for the study of frozen soil dynamics

The acquisition of spatial-temporal information of frozen soil is fundamental for the study of frozen soil dynamics and its feedback to climate change in cold regions. With advancement of remote sensing and better understanding of frozen soil dynamics, discrimination of freeze and thaw status of surface soil based on passive microwave remote sensing and numerical simulation of frozen soil processes under water and heat transfer principles provides valuable means for regional and global frozen soil dynamic monitoring and systematic spatial-temporal responses to global change. However, as an important data source of frozen soil processes, remotely sensed information has not yet been fully utilized in the numerical simulation of frozen soil processes. Although great progress has been made in remote sensing and frozen soil physics, yet few frozen soil research has been done on the application of remotely sensed information in association with the numerical model for frozen soil process studies. In the present study, a distributed numerical model for frozen soil dynamic studies based on coupled water-heat transferring theory in association with remotely sensed frozen soil datasets was developed. In order to reduce the uncertainty of the simulation, the remotely sensed frozen soil information was used to monitor and modify relevant parameters in the process of model simulation. The remotely sensed information and numerically simulated spatial-temporal frozen soil processes were validated by in-situ field observations in cold regions near the town of Naqu on the East-Central Tibetan Plateau. The results suggest that the overall accuracy of the algorithm for discriminating freeze and thaw status of surface soil based on passive microwave remote sensing was more than 95%. These results provided an accurate initial freeze and thaw status of surface soil for coupling and calibrating the numerical model of this study. The numerically simulated frozen soil processes demonstrated good performance of the distributed numerical model based on the coupled water-heat transferring theory. The relatively larger uncertainties of the numerical model were found in alternating periods between freezing and thawing of surface soil. The average accuracy increased by about 5% after integrating remotely sensed information on the surface soil. The simulation accuracy was significantly improved, especially in transition periods between freezing and thawing of the surface soil.