Finite-difference model of land subsidence caused by cluster loads in Zhengzhou,China

Groundwater exploitation has been regarded as the main reason for land subsidence in China and thus receives considerable attention from the government and the academic community.Recently,building loads have been identified as another important factor of land subsidence,but researches in this sector have lagged.The effect of a single building load on land subsidence was neglected in many cases owing to the narrow scope and the limited depth of the additional stress in stratum.However,due to the superposition of stresses between buildings,the additional stress of cluster loads is greater than that of a single building load under the same condition,so that the land subsidence caused by cluster loads cannot be neglected.Taking Shamen village in the north of Zhengzhou,China,as an example,a finite-difference model based on the Biot consolidation theory to calculate the land subsidence caused by cluster loads was established in this paper.Cluster loads present the characteristics of large-area loads,and the land subsidence caused by cluster loads can have multiple primary consolidation processes due to the stress superposition of different buildings was shown by the simulation results.Pore water migration distances are longer when the cluster loads with high plot ratio are imposed,so that consolidation takes longer time.The higher the plot ratio is,the deeper the effective deformation is,and thus the greater the land subsidence is.A higher plot ratio also increases the contribution that the deeper stratigraphic layers make to land subsidence.Contrary to the calculated results of land subsidence caused by cluster loads and groundwater recession,the percentage of settlement caused by cluster loads in the total settlement was 49.43%and 55.06%at two simulated monitoring points,respectively.These data suggest that the cluster loads can be one of the main causes of land subsidence.     

土工三轴试验方法-静动耦合试验

尝试了一种新的土工三轴试验方法,即在一个试样同时得到与土体静动变形和强度特性相关的各种参数。文中讨论了采用耦合试验方法时应变循环大小对静力变形和强度特性的影响;并通过与常规试验结果的比较,给出了等效弹性模量、等效阻尼比和动永久应变等动力变形参数的试验结果。试验结果表明：采用耦合试验复杂加载方式,能够更深入地研究土体的静、动变形和强度特性,尤其在复杂应力条件下的动力变形特性方面。     

长江中下游典型浅水湖泊沉积物水界面磷与铁的耦合关系

目前普遍认为磷铁耦合关系是P迁移的主要机制,但大部分研究结果并未提供直接的原位证据.为了探索沉积物剖面磷(P)与铁(Fe)的耦合关系,利用Zr O-Chelex薄膜扩散梯度技术(ZrO-Chelex DGT),分别对太湖、巢湖、鄱阳湖和洞庭湖4个浅水湖泊沉积物有效态Fe和P进行高分辨采样和分析.结果表明,不同湖区有效态Fe和P浓度在沉积物-水界面处开始增加,之后波动变化,垂向异质性较强,但两者浓度变化同步.有效态P和Fe浓度的相关分析结果证明两者浓度具有显著的线性相关.室内厌氧培养实验进一步表明,Fe~(3+)的还原性促使Fe~(2+)与铁结合态磷的释放,促使DGT有效态P与Fe同步变化.该结果表明沉积物P的二次迁移和释放受Fe氧化还原过程的控制,为铁磷耦合关系提供了直接证据.     

Seismic receiver coupling to the seafloor

The presence of geophysical receivers on the seafloor changes the local wave field due to the receiver seafloor interaction. The resulting PP- and PS-wave distortion of the wave field is often referred to as receiver coupling to the seafloor and can make data processing challenging and sometimes impossible. This paper provides an overview of the mathematical approaches to describe receiver coupling, how to estimate receiver coupling and what the difficulties and possible solutions are. The first section shows how the mathematical approach developed from a simple model considering only the vertical receiver component to include all three receiver components and their interactions with the seafloor. In the second section, I show how receiver coupling can be measured and how it can be improved using mathematical and data-driven approaches.     

特高压互连电气设备减震性能振动台试验

为研究铅金属减震器对特高压互连电气设备的减震效果,进行由硬管母线连接的特高压避雷器设备和电容式电压互感器设备组成的互连耦合体系的地震模拟振动台试验。通过白噪声扫频、抗震及减震试验,测定互连耦合体系抗震结构及减震结构的自振频率以及关键部位的应变、加速度响应。试验结果表明:抗震结构中避雷器设备的最大应变响应大于互感器设备,互连耦合体系中的避雷器设备属于易损设备;安装减震器后互连设备频率降低幅度较小,减震器基本不会影响电气设备的正常运行;安装减震器后互连耦合体系中的避雷器设备和互感器设备在较大峰值加速度地震波作用下,设备顶端加速度响应和最大应变响应均有较大幅度的降低,避雷器设备和互感器设备的最大应变响应的减震效率分别为75%和50%,减震效果显著,减震器的应用大幅提升了互连耦合体系的抗震能力。     

小跨高比强化配筋连梁的抗震性能

强化配筋连梁是指采用HRB400及以上钢筋、加密加粗腰筋、加粗箍筋的连梁。期望通过腰筋和箍筋形成的2层或更多层的高强钢筋网片来承受剪力,提高其抗震性能,施工较为方便,适用于小跨高比连梁。利用非线性有限元方法,在已完成普通配筋小跨高比连梁抗震性能试验的基础上,研究了跨高比为1.25的不同配筋形式连梁的抗震性能。研究表明:强化配筋连梁的骨架曲线出现2个峰值,峰值荷载为普通配筋连梁的1.37倍,其荷载下降速率约为普通配筋连梁的39.42%,具有较高的承载力。强化配筋连梁的峰值位移是集中对角斜筋、交叉斜筋和对角暗撑配筋连梁的三倍多,具有较强的变形能力。最后,建议采用深梁的方法计算强化配筋连梁的受剪承载力。     

Test and analysis of reinforced concrete (RC) precast shear wall assembled using steel shear key (SSK)

Reinforced concrete (RC) precast shear walls are extensively applied in practical engineering, owing to their fast construction speed. However, because of the transport conditions, RC precast shear walls have to be separated into small wall segments during the factory prefabrication procedure before being assembled on site. Typically, wet-type jointing methods are adopted to link the segments, which is time-consuming and results in unreliable post-pouring area strength. To overcome this problem, the novel scheme of the steel shear key (SSK) featuring steel shear panels and combined fillet and plug welding is proposed. Three RC precast shear wall specimens with different linking strength, termed as weakened SSK wall, standard SSK wall, and strengthened SSK wall, respectively, and an integrated shear wall specimen were designed. Quasi-static cyclic loading was applied to investigate the specimens' dynamic properties. The test results suggest the prefabricated wall segments equipped with SSKs showed reliable stiffness and bearing capacity and were improved in energy dissipation ability, compared with conventional shear walls. As the shear stiffness and number of equipped SSKs increased, the specimens exhibited higher strength, but their ductility and energy dissipation were slightly decreased. Most importantly, the standard SSK wall specimen could achieve satisfactory bearing capacity and deformability and is thus recommended for precast building structures. Finite element method (FEM) models were established to validate the test results, and parametric study analysis was conducted based on the coupling ratio of the SSK walls. Finally, an appropriate coupling ratio range is recommended for practical engineering applications.     

层间隔震偏心结构双向地震耦合响应研究

建立双向地震作用下层间隔震双向偏心结构侧扭耦联分析模型;考虑上部结构及下部结构的弹塑性模型,隔震支座采用双向耦合非线性Bouc-wen模型模拟;分析偏心参数对层间隔震双向偏心结构的影响规律;评价双向地震作用下我国抗震规范给出的扭转影响系数静力预测值的准确性。结果表明,双向地震作用下设置中间柔性隔震层可以减小上\,下部结构扭转的耦连效应;下部结构存在双向偏心会对隔震层和下部结构扭转反应带来不利影响;LRB耦合效应对层间隔震地震响应影响较小;当下部结构偏心率较大时现行规范计算扭转系数偏于不安全。     

利用远震研究四川盆地及其周缘瑞利面波相速度和方位各向异性

基于四川盆地及周边的245个宽频带台站2010年9月—2014年9月期间的远震记录,提取双台路径瑞利面波相速度频散资料,反演得到四川盆地20～120s的高分辨率瑞利面波相速度及各向异性空间分布.在丰富区域地球物理基础数据的同时,结合已有研究成果对地壳上地幔变形耦合进行探讨,结果表明短周期(20～30s)的相速度分布与四川盆地的地质构造特征相吻合,作为川滇地块、松潘—甘孜地块和四川盆地之间的边界——龙门山断裂带和鲜水河断裂带对上述三个地块上地壳的速度结构具有明显的控制作用;松潘—甘孜地块,特别是川滇地块中下地壳普遍表现为明显的低速异常,表明中下地壳相对软弱;而四川盆地的中下地壳整体呈现相对高速,表明四川盆地具有相对坚硬的中下地壳.研究区域东南角接近北扬子地块与南扬子地块的缝合部位,呈现高速异常.四川盆地南部和东南邻区不同周期均具有较强的各向异性,且快波方向较为一致,反映这些地区不同深度变形耦合较好.四川盆地西部、北部及东北部邻区,不同周期的各向异性快波方向变化较大,不同深度变形耦合较差.这些特征与绕喜马拉雅东构造结的物质流动被扬子地块的高速地壳阻挡的宏观认识基本一致.