Qualitätsanforderungen an Oberflächengewässer: Zielvorgaben,Qualitätsziele und chemische Gewässergüteklassifizierung

Quality Requirements for Fresh Waters: Water Quality Targets, Water Quality Objectives, and Chemical Water Quality Classification In the Federal Republic of Germany, water quality requirements for the protection of inland surface waters against hazardous substances are formulated on the basis of a quality targets derivation concept developed jointly by the Federal Government and the Federal States. The quality requirements were termed “water quality targets” in order to make it clear that the values derived are orientational values rather than legally binding limit values. The international comparison of quality requirements for surface waters shows that, on the whole, the national quality targets ensure a high level of protection. According to present scientific knowledge, impairments of uses, such as supply of drinking water, or risks to aquatic communities need not to be expected if the quality targets are complied with. A comparison of water quality data with the water quality targets makes it possible, on the one hand, to identify those substances whose inputs must be further reduced; on the other hand, it also shows that, for a number of substances, there is no need at present for concern over their adversely water quality. A further differentiation of the aquatic hazard potential of pollutants allows a water quality classification system to be developed on the basis of the quality targets derivation concept. The basic elements of this water quality classification system are presented, and its application is explained by way of examples.     

Gaschromatographische Bestimmung von polychlorierten Biphenylen in Wasser nach Headspace-Festphasenmikroextraktion

Gas-chromatographic Determination of Polychlorinated Biphenyls in Water after Headspace Solid-phase Microextraction Headspace-analytical techniques are usually applied to the determination of easily volatile substances in water, whereas semivolatiles are generally isolated by liquid-liquid or solid-phase extraction. In the present paper, a method is presented for isolating high boiling polychlorinated biphenyls (PCB) using headspace solid-phase microextraction at elevated temperature. In spite of their low vapor pressure, the analytes are adsorbed very efficiently on a poly-dimethylsiloxane-coated fiber. Thus, in combination with GC/ECD, a very simple and sensitive solventless determination of PCB is accomplished. Using the simplest possible standard conditions, limits of determination in the lowest nanogram-per-liter range are achieved. Further increased sensitivity down to the ppq (parts per quadrillion) range is possible by stirring and increasing the sample volume and adsorption time. Moderate matrix effects have been observed in some surface and groundwaters.     

Untersuchung der Sorptionseigenschaften des Kationenaustauschers KB-2M mit Makronetzstruktur zur Abtrennung von Zinkionen aus Ab- und Spülwässern

Study of Sorptional Properties of the Cation Exchanger KB-2M with Macroreticular Structure for Recovery of Zinc Ions from Sewage and Rinsing Water Although a number of ion-exchange methods have been employed for the recovery of some transition metals from industrial effluents, knowledge about ion-exchange resins with macroreticular structure is poor. The present paper describes the mechanism of sorption on such exchangers and their application for recovery of zinc from sewage rinsing water. Ion exchanger of macroreticular structure are polymers with long-chained cross-linking agents. We have synthesized carboxylic ion-exchange resins by hydrolysis of copolymerisates of methyl acrylate with different cross-linking agents: divinylbenzene, divinyl sulfide, divinyl ester of ethylene glycol and divinyl ester of di- or triethylene glycol. The sorption process on modifications of the carboxylic resins KB-2 of various structure was studied with different methods: potentiometric titration, infrared spectroscopy, electron microscopy, X-ray structural analysis. The initial zinc concentration in rinsing water was 0.05 mol/L at pH from 3 to 6. For the sorption, 0.2…1.0 g of resin were equilibrated with 100 mL of zinc solution. After equilibrium (12 h), the resin was separated from solution. The zinc ions were determined by atomic absorption spectrometry after stripping with 100 mL of 10% sulfuric acid. The distribution ratio D was calculated (D: mmole of Zn sorbed per gram of resin divided by mmole of Zn per millilitre of solution). By means of infrared spectroscopy, the mechanism of sorption of zinc ions from rinsing water was determined. There may be a possibility of the formation of complexes in the cation-exchange resin phase. It was found out in this paper that the cation-exchanger KB-2M of macroreticular structure is the most effective for the sorption of the Zn²⁺-ions from sewage and rinsing water.     

Ein kompetitiver Immunoassay zur Bestimmung des Herbizids Fluazifop in Trink- und Grundwasser

A Competitive Immunoassay for the Determination of the Herbicide Fluazifop in Drinking Water and Groundwater A competitive solid-phase enzyme immunoassay using rabbit polyclonal antibodies was developed for the detection of the herbicide fluazifop [(RS)-2-[4-(5-trifluoromethyl-2-pyridyloxy)phenoxy]propionic acid] in drinking water and groundwater. Present regulatory limits for drinking water in Germany were taken as the critical level. The carrier protein was bovine serum albumin; horseradish peroxidase was used as marker enzyme with 3,3′,5,5′-tetramethylbenzidine as substrate. A high concentration of high-affinity antibodies in the serum, optimization of test conditions (antibody and enzyme tracer concentration, incubation time etc.), and very low cross reactivities to substances of similar structures led to a highly sensitive and specific ELISA with a detection limit below 0.1 μg/L for fluazifop as free acid. On testing the suitability of the assay's use as a screening test with one hundred drinking-water samples, the three samples which had been spiked in the laboratory were recognized as positive with respect to their fluazifop content. Confirmation by gas chromatography-mass spectrometry showed the test results of two other samples to be false positive. False negative results did not appear. The concentration was in the detection limit region of 0.1 μg/L.     

Bildung bromhaltiger Desinfektionsnebenprodukte nach Chlorung von Bodenseewasser in Abhängigkeit von Aufbereitungsschritten und der Bromidkonzentration

Formation of Brominated Disinfection By-products after Chlorination of Water from Lake Constance Depending on Treatment Steps and Bromide Concentration The formation of halogenated disinfection by-products (DNP) (trihalomethanes (THM), haloacetic acids (HES), haloacetonitriles (HAN), haloketones (HKE) and chloropicrin (TCNM)) was studied after chlorination (0.5 mg/L) of raw water and drinking water from Lake Constance. The objectives of this study were to investigate the effect of bromide ion on the distribution of DNP-species resulting from chlorination and to draw up a bromide mass-balance. The treatment of water from Lake Constance with ozone decreased the formation of DNP about 35% and of total organic halogens (AOX) about 45%. This decline in DNP-formation is mainly due to the formation of chloroform, dichloro- and trichloroacetic acid. Though there is only a small amount of bromide (6.2 μg/L) in water from Lake Constance, about 32% of THM, 16% of HES, and 30% of HAN contained bromine after chlorination of treated water. The addition of bromide ion (up to 1 mg/L) shifted the DNP-composition to more brominated species. The distribution of the DNP-species depends on the initial molar bromide-to-chlorine ratio. A mathematic model showed the same pattern of DNP-species depending on the initial molar bromide-to-chlorine ratio that was observed experimentally in microstrained raw water and drinking water from Lake Constance. After chlorination of microstrained raw water, 27% of the bromide were incorporated in known DNP, 34% in unknown substances, and about 39% of bromide were not converted to organic bromine. After chlorination of treated water, only 16% of the bromide were incorporated in unknown substances, whereas 34% were found in known DNP. About 50% were found as bromide again. After addition of bromide (up to 25 μg/L) to ozonated and treated water from Lake Constance, between 60 and 72% of the bromide that had reacted after chlorination were found in analyzed low-molecular DNP.     

A Simple Parameterisation for Flux Footprint Predictions

Flux footprint functions estimate the location and relative importance of passive scalar sources influencing flux measurements at a given receptor height. These footprint estimates strongly vary in size, depending on receptor height, atmospheric stability, and surface roughness. Reliable footprint calculations from, e.g., Lagrangian stochastic models or large-eddy simulations are computationally expensive and cannot readily be computed for long-term observational programs. To facilitate more accessible footprint estimates, a scaling procedure is introduced for flux footprint functions over a range of stratifications from convective to stable, and receptor heights ranging from near the surface to the middle of the boundary layer. It is shown that, when applying this scaling procedure, footprint estimates collapse to an ensemble of similar curves. A simple parameterisation for the scaled footprint estimates is presented. This parameterisation accounts for the influence of the roughness length on the footprint and allows for a quick but precise algebraic footprint estimation.     

Toxic Cyanobacteria in Greek Freshwaters, 1987—2000: Occurrence,Toxicity, and Impacts in the Mediterranean Region

In a survey in Greece from 1987 to 2000 hepatotoxic cyanobacterial blooms were observed in 9 out of 33 freshwaters. Microcystins (MCYSTs) were detected by HPLC in 7 of these lakes, and the total MCYST concentration per scum dry weight ranged from 50.3 to 1638 ± 464 μg g^—1. Cyanobacterial genera (Microcystis, Anabaena, Anabaenopsis, Aphanizomenon, Cylindrospermopsis) with known toxin producing taxa were present in 31 freshwaters. From our data and a review of the literature, it would appear that Mediterranean countries are more likely 1) to have toxic cyanobacterial blooms consisting of Microcystis spp. and 2) to have higher intracellular MCYST concentrations. A case study in Lake Kastoria is used to highlight seasonal patterns of cyanobacterial and MCYST‐LR occurrence and to assess cyanotoxin risk. Cyanobacterial biovolume was high (> 11 μL L^—1) throughout the year and was in excess of Guidance Level 2 (10 μL L^—1) proposed by WHO for recreational waters and Alert Level 2 for drinking water. Further, surface water samples from April to November exceeded Guidance Level 3, with the potential for acute cyanobacterial poisoning. Intracellular MCYST‐LR concentrations (max 3186 μg L^—1) exceeded the WHO guideline for drinking water (1 μg L^—1) from September to November with a high risk of adverse health effects. Preliminary evidence indicates that in 3 lakes microcystins are accumulated in some aquatic organisms. Generally, a high risk level can be deduced from the data for the Mediterranean region.     

单管高压旋喷注浆技术在砂层加固、止水工程中的应用

就其他工艺在砂层的加固、止水工程中难以解决的问题，提出了单管高压旋喷注浆技术，并通过一些工程实例证实此工艺的可行性。     

The influence of floodplain geohydrology on the distribution of Sarcocornia pillansii in the Olifants Estuary on the West Coast, South Africa

The distribution of Sarcocornia pillansii (Moss) A.J. Scott was determined by water-table depth and electrical conductivity (EC) of the groundwater. Where the groundwater was accessible (<1.5 m) and had a low EC (<80 mS cm⁻¹), S. pillansii extended its roots down to the water-table where a suitable water potential gradient was shown to exist between the soil and roots. In areas where the groundwater was too deep and/or hypersaline, the plants grew on hummocks. The unconfined aquifer below the floodplain is linked to the estuary and although diurnal tidal waves were dampened, water-table level fluctuations were recorded between tidal events. The complex geomorphology of the floodplain influences groundwater flow, in turn affecting the distribution of the salt marsh vegetation.     

Distribution of trace metals in the Odra River system: Water–suspended matter–sediments

Extensive investigations of trace metals concentrations in water, suspended particulate matter (SPM) and bottom sediments of the whole Odra River system were carried out over the years 1997–2000. The vertical distribution of selected metals and their mobility were also studied in the sediment cores from upper and middle river sections. Significant levels of metal contamination were found. Median concentrations (Cd, Pb, Cu, Zn and As) in the SPM and sediments were (mg kg⁻¹) 7.1 and 8.9 Cd, 128 and 146 Pb, 81 and 119 Cu, 1198 and 1204 Zn, 48 and 54 As, respectively. The highest metal pollution of the Odra River solids was found with cadmium, zinc, lead and arsenic, showing high similarity in their frequency distributions in both SPM and sediments. Cd, Zn and As appear to be of particular concern because of the high levels, that appear to be bioavailable, and their high mobility. The exchangeable and carbonate chemical forms of Cd and Zn reached up to 50% of their total amount. Besides the determination of total metal concentration, the metal chemical forms in river solids were investigated. The results of very wide studies of the Odra River system through 4 years suggest that metal pollution decreased, especially for Zn, Pb and Cu. Among all metals studied in the Odra River sediments, substantial reductions of Cd contamination were observed neither in the period after ’97 flood, nor if compared with the earlier results obtained before ’97. No essential differences of the metal contents were observed among the samples for the same river compartment, from the same locality, taken within the five sampling campaigns. The pattern of spatial and vertical metal distributions in the river solids indicates that a variety of sources might be responsible for the contamination; very intensive, historical and current mining and smelting activities probably are the most important ones.