Variation in element release rate from different mineral size fractions from the B horizon of a granitic podzol

Far-from-equilibrium batch dissolution experiments were carried out on the 2000–500, 500–250, 250–53 and 53–2 μm size fractions of the mineral component of the B horizon of a granitic iron humus podzol after removal of organic matter and secondary precipitates. The different size fractions were mineralogically and chemically similar, the main minerals present being quartz, alkali and plagioclase feldspar, biotite and chlorite. Specific surface area increased with decreasing grain size. The measured element release rates decreased in the order 53–2>>>2000–500>500–250>250–53 μm. Surface area normalised element release rates from the 2000–500, 500–250 and 250–53 μm size fractions (0.6–77×10⁻¹⁴ mol/m²/s) were intermediate between literature reported surface area normalised dissolution rates for monomineralic powders of feldspar (0.1–0.01×10⁻¹⁴ mol/m²/s) and sheet silicates (100×10⁻¹⁴ mol/m²/s) dissolving under similar conditions. Element release rates from the 53–2 μm fraction (400–3000×10⁻¹⁴ mol/m²/s) were a factor of 4–30 larger than literature reported values for sheet silicates. The large element release rate of the 53–2 μm fraction means that, despite the small mass fraction of 53–2 μm sized particles present in the soil, dissolution of this fraction is the most important for element release into the soil. A theoretical model predicted similar (within a factor of <2) bulk element release rates for all the mineral powders if observed thicknesses of sheet silicate grains were used as input parameters. Decreasing element release rates with decreasing grain size were only predicted if the thickness of sheet silicates in the powders was held constant. A significantly larger release rate for the 53–2 μm fraction relative to the other size fractions was only predicted if either surface roughness was set several orders of magnitude higher for sheet silicates and several orders of magnitude lower for quartz and feldspars in the 53–2 μm fraction compared to the other size fractions or if the sheet silicate thickness input in the 53–2 μm fraction was set unrealistically low. It is therefore hypothesised that the reason for the unpredicted large release rate from the 52–3 μm size fraction is due to one or more of the following reasons: (1) the greater reactivity of the smaller particles due to surface free energy effects, (2) the lack of proportionality between the BET surface area used to normalise the release rates and the actual reactive surface area of the grains and, (3) the presence of traces quantities of reactive minerals which were undetected in the 53–2 μm fraction but were entirely absent in the coarser fractions.     

Cathodoluminescence of authigenic albite

Authigenic albites in carbonate rocks typically grow in a high-grade diagenetic to low-grade metamorphic environment and often show Roc-Tourné-twinning sensu Füchtbauer. Based on an investigation of four Middle to South European occurrences, they show Mn²⁺- and Fe³⁺-activated cathodoluminescence (CL), as revealed by combined high resolution spectroscopy of cathodoluminescence emission (HRS-CL), electron paramagnetic resonance (EPR), and proton-induced X-ray emission (μPIXE).     

Documentary and Geological Records of Tsunamis in the Aegean Sea Region of Greece and their Potential Value to Risk Assessment and Disaster Management

Understanding the nature and impacts of tsunamis within the Aegean Sea region ofGreece is of importance to both the academic community and those organisationsconcerned with tsunami disaster management. In order to determine hazard and riskand consequently pre-plan mitigative strategies, it is necessary to analyse historical(documentary) and geological records of former tsunami events. Therefore, firstlythis paper provides a summary of the written sources of information on Aegeantsunamis paying particular attention to published catalogues. From the availabledata, it is noted that a large number of events have been reported during the last3500 years. Secondly, the paper provides a review of the published on-shore(terrestrial) geological records of tsunamis within the region. From this analysisit is seen that little geological evidence has been identified for the large numberof tsunamis reported in the catalogues. Thirdly, the paper considers the reliabilityof the written and geological records and how problems of accuracy, coverage,extent and reliability, may have potential implications for the estimation of hazardand risk. The paper concludes by making recommendations for disaster managers,geologists and historians to work closely together.     

交流变频调速CD-2B型岩心钻机的研制

介绍了交流变频调速CD－2B型岩心钻机研制情况，技术参数，主要特点及型式检验，生产试验等情况。     

山地丘陵地区物探爆破孔钻机及配套机具的研究与开发

为满足我国山地丘陵地区物探爆破孔施工技术的要求，研究适合土层、岩层钻进用的钻机及工具，对钻机的配套设备进行了开发研究。分析了国内山地丘陵地区物探爆破孔施工技术现状，并着重介绍了研制设计内容及生产试验情况。     

吉林省大横路铜、钴矿床地质特征及控矿因素

大横路地区出露地层主要为元古界老岭群大栗子组和珍珠门组的低绿片岩相 -高绿片岩相到低角闪岩相的变质岩系 ,北部有少量英云闪长岩 -奥长花岗岩和表壳岩残块。侵入岩主要以燕山期基性 -中基性为主。铜钴矿床产于含碳绢云千枚岩中 ,矿体长 36 0～ 140 0m ,宽 95～ 80 0m ,厚 3～ 10 8.7m ,呈层状、似层状、分枝状 ,矿石以浸染状为主 ,次为脉状、网脉状。矿床属多期多成因类型 ,主要受大栗子组地层、北东向断裂构造和变质作用控制 ,并有岩浆热液的叠加。     

Gold Mineralization and Occurrence of Sinter in the Hoshino Area, Fukuoka Prefecture, Japan

Abstract. Several epithermal gold deposits occur in the Hoshino area, which is located in the western end of the late Cenozoic Hohi volcanic zone, north‐central Kyushu, Japan. The area is characterized by intermediate to felsic extrusive rocks of Pliocene age. In the Hoshino area, the shallow manifestation of the hydrothermal activity is exposed on the surface. Several outcrops of sinter are still preserved on the top of hydro thermally altered volcanic rocks, and high‐grade gold‐bearing quartz veins occur on the surface at lower levels. The hydrothermal alteration resulted into well‐developed alteration zones. The zonal alteration pattern, primarily of near‐neutral pH type, is characterized by the outer smectite zone of a lower temperature, and the inner mixed layer minerals zone of a higher temperature. Quartz vein‐related or fracture‐controlled alteration, is represented by the occurrence of interstratified illite/smectite and K‐feldspar, suggesting a potassium‐enriched alteration. The mineralization in the Hoshino area is recognized on the surface by the occurrence of gold‐bearing quartz veins distributed mainly in the mixed layer minerals zone. The fracture system related to the gold mineralization is mainly characterized by NW‐SE trend. The alteration pattern and the mineralogical composition of the veins suggest that the mineralizing fluids had near‐neutral pH and the mineralization is of low‐sulfidation‐type. Fluid inclusion data and textures observed in quartz veins indicate that gold precipitated during boiling. The chemical composition of quartz veins shows that high‐grade gold‐bearing quartz veins are characterized by higher content of Al₂O₃, K₂O and Rb. Several outcrops of silica‐sinters are distributed on the top of the mixed layer minerals zone. Although their structures are not very well preserved, because of later silicification, the Hoshino sinters still show characteristic textures identical to those observed in modern sinters, such as the presence of plant fossil incorporated into the sinters, the strongly developed depositional laminations and the columnar structures perpendicular to the depositional surfaces. Quartz is the only silica mineral constituting the Hoshino sinters presently. The conversion of amorphous silica into quartz was probably governed by higher temperatures resulting from later hydrothermal activity. This later hydrothermal activity is reflected by the intense silicification affecting mainly the lower parts of the sinters and also by the presence of quartz veins cutting the sinters. The distribution of sinters in the Hoshino area is very significant. The presence beneath the sinters of concealed high‐grade gold‐bearing quartz veins should be highly considered and exploration work is strongly suggested.     

Geochronology of Gold Deposits and Its Implication for Metallogenesis in the Fengxian-Lixian Area, Qinling Orogenic Belt, China

Abstract: A series of super large‐scale and large‐scale Pb and Zn, and Au deposits are distributed in the Qinling orogenic belt, China. Gold deposits were generally ascribed to Carlin‐type originated from circular meteoric water. Visible and coarse‐grained gold (up to over 3mm in grain size) was recently identified in some gold deposits in the Fengxian‐Lixian area, Qinling. Au‐bearing quartz lodes related to magmatism were discovered in the Xiaogouli gold deposit. Two types of Au‐bearing quartz veins, i.e., NW‐trending quartz veins and NE‐trending quartz veins cutting strata are widely present in the Baguamiao gold deposit. Both are spatially associated with each other. The former is generally snake–like, S‐shape or zigzag, which was resulted from plastic deformation by ductile shearing, being generally cut by the latter. The latter is generally linear with widely developed bleaching alteration zones in its adjacent wall rocks, which symbolizes the superimposition of brittle deformation and filling and metasomatism of magmatic hydrothermal solution in ductile shear zones after uplifting of the shear zones near the surface. The NW‐trending quartz veins contain Au of lower than 3ppm. The NE‐trending quartz veins contain Au of more than 3 ppm, so that NE‐trending quartz veins and the adjoining altered rocks are important ores. The NW‐trending Au–bearing quartz vein was dated as 210.61.26 to 232.581.59 Ma by ⁴⁰Ar–³⁹Ar method, i.e., late Indosinian epoch (Triassic). The NE‐trending Au–bearing quartz vein was dated as 131.910.89 to 197.451.13 Ma by ⁴⁰Ar–³⁹Ar method, i.e., Yanshanian epoch (Jurassic). The ⁴⁰Ar–³⁹Ar age of the NW‐trending Au–bearing quartz veins represents the age of the ductile shear formation. The isotope data of the NE‐trending quartz veins indicate that gold mineralization was closely related to Indosinian and Yanshanian granite intrusives not only in time and space, but also in origin.     

Experimental Study on Mine Spoils During Superficial Geochemistry Processes

Based on the mineral and chemical compositions of spoils taken from the Shilu Cu-Mo deposit and Hetai gold deposit, the leaching and batch experiments were made on spoils taken from these two deposits using the leaching column designed by the authors. The experimental results showed that it is not always true that the mine drainage is acidic. Its acidity depends on acid-buffering capacity of gangue, host rock and its alteration mineral assemblage. The composition of the drainage water is related with the interaction between superficial or underground water and solid materials in the spoils, including minerals, hydroxides and amorphous substances. The leaching extent of the element is related with its occurrence form in the deposit. The preferential flow results in leaching-out of heavy metals in large amounts. So it is important to prevent the generating of preferential flow in the system. The results will provide very important grounds for the comprehensive management of land and ecological rehabilitation of the mine site.     

新疆伽师及邻近地区现今地壳形变的GPS监测与研究

利用高精度数据软件对伽师及邻近地区的GPS监测网观测数据进行计算分析(基线精度达到了 10 - 8～ 10 - 9) ,获得了该地区的现今地壳形变速率图 .结果表明 ,伽师及邻近地区在印度板块的推挤作用下 ,地壳正快速缩短变形 ,主压应力为近南北方向 .各地块运动速率不同 ,平均应变率为 0 .0 4× 10 - 6 /a .