近断层地震动作用下桥梁结构的组合隔震分析

为改善近断层地震动作用下隔震桥梁结构的抗震性能,基于Benchmark结构振动控制问题,研究附加黏滞阻尼器、磁流变(MR)阻尼器的组合隔震策略.非线性动力分析过程中,优化了黏滞阻尼器的阻尼系数和速度指数,并设计了分散模糊控制器来确定施加给磁流变阻尼器的电压.研究结果表明:采用黏滞阻尼器和磁流变阻尼器可提高隔震桥梁结构在...     

单层网壳结构振动压电控制分析与试验研究

通过试验,研究自主研发的压电主动杆件在单层网壳结构中的主动智能控制问题.利用集传感器、作动器和承受荷载等功能于一体的压电主动杆件,对网壳结构的地震响应振动实施主动智能控制.结果表明,这种压电主动构件作为网壳结构的内在控制源,可以有效地控制网壳结构的地震响应,起到抑制网壳振动的作用.     

结构地震反应性态的物理随机最优控制

本研究发展了结构地震反应性态的随机最优控制理论和方法。这一研究建立在物理随机系统思想的新理论框架下,突破了以I^to随机微分方程描述动力系统的经典随机最优控制的藩篱。提出了基于系统二阶统计量评价、单目标超越概率和多目标能量均衡的控制器参数设计准则,以及基于概率可控指标的控制器位置设计准则,并将它们统一为物理随机最优控制的广义最优控制律。数值算例分析表明,本文发展的物理随机最优控制方法能够实现结构地震反应性态的精细化控制。     

大跨径钢管混凝土拱桥减震控制装置参数的研究

大跨度桥梁结构的减震控制研究对于桥梁结构的抗震安全具有重要意义。本文以主跨368m的茅草街大桥为研究对象,基于ANSYS建立了该桥的三维有限元模型,并采用子空间迭代法分析了该桥的动力特性。在此基础上进行了大跨度钢管混凝土拱桥的地震响应及减震控制研究,重点进行了弹性连接装置和粘滞阻尼器减震效果的参数敏感性分析,并对比分析了不同位置布设减震装置时的效果。结果表明,纵飘振型对该桥肋纵向相对位移的贡献最大;弹性连接装置和阻尼器均能有效减小地震作用下该桥的肋梁纵向相对位移;综合考虑各关键部位的地震响应时,同时采用两类减震装置并将其分散布置时的减震效果最佳。结论可供大跨度中承式钢管混凝土系杆拱桥的抗震设计参考。     

浅谈新疆测震台网传输链路的改造

要做到IP到台站有很多种方式可选,根据新疆测震台网各台站的现状列举了7类不同的数据传输方式,这些数据传输方式在新疆测震台网中均得到应用,也都达到IP到台站的目的.分别对这些数据传输链路的原理及优缺点进行阐述,并结合目前各台站具体情况作链路适用性的相关分析,希望能够对其他省局台网的台站通信链路设计、改造起到参考.     

高层隔震结构扭转分析

为研究高层隔震结构在地震作用下的扭转效应,用Etabs软件建立1个高层抗震结构和4个具有不同扭转特性的高层隔震结构的空间模型进行地震响应分析,以验证此原则上部结构质量中心与隔震层刚度中心的重合与否对结构扭转效应的影响程度,而后考察偏心高层隔震结构在偶然偏心地震作用下结构的扭转效应。结果表明:由于地震作用的减小,扭转效应要远小于原抗震结构,且隔震本身对于结构扭转效应的抑制效果要好于上述原则;扭转效应的减震率大于平动效应的减震率。布置在隔震层平面外围的铅芯橡胶隔震支座对隔震层的扭转有一定的控制作用。     

Predicting the equilibrium bed slope in natural streams using a stochastic model for incipient sediment motion

In this paper, a method to predict the equilibrium bed slope in natural streams based on the incipient motion criterion is proposed. The method is based on the criterion suggested by Gessler to simulate the grain size distribution of the armour coat using the concept of critical shear stress of a sediment mixture. In particular, a different expression of the probability for a single particle size to be part of the armour coat is firstly proposed; then, a simple two‐steps criterion is suggested to estimate the safety factor required by the proposed approach. The method is applied in three different Italian regions (Calabria, Basilicata, and Tuscany) and required several field campaigns involving the survey of 251 stream reaches upstream of grade‐control structures. The area including five Calabrian streams is firstly used to test the suitability of the two‐steps approach. In this area, considering the detailed information about the particle size of bed material, the effect of using a simplified grain size distribution for each torrent is also checked. The method is then applied within the two additional areas (Basilicata and Tuscany) in order to check the geographic influence on the prediction of the stable longitudinal profile. A comparison between measured and estimated values of the equilibrium bed slope showed a good agreement for the Calabrian streams, where the number of the investigated stream reaches is greater, and satisfactory results for the torrents located in Basilicata and Tuscany where the field data set is more limited. The overall results encourage the extension of the proposed method to additional field data and suggest the use of this approach by hydraulic designers in order to stabilize the longitudinal profile of natural streams. Copyright © 2011 John Wiley & Sons, Ltd.     

Tall building vibration control using a TM‐MR damper assembly: Experimental results and implementation

This paper summarizes the relevant results of the design, construction, testing, and implementation of a nominal 120 kN magnetorheological damper developed to control a free‐plan tall building in Santiago, Chile, equipped with two 160‐ton tuned masses. Cyclic as well as hybrid simulation tests were performed on the prototype damper. Global building responses using measured MR properties showed good correlation with analytical estimations. Also, a proposed physical controller for the MR damper was validated through hybrid and building pull‐back tests. Its performance is essentially equivalent to that of an LQR controller, but the information needed in its implementation is considerably less. Pull‐back tests of 10 cm amplitude were performed on one mass along the flexible edge of the building and its response controlled using the passive and controlled modes of the MR damper. The MR damper was capable of controlling the TM displacements very effectively, as well as the simulated building response for different ground motions and harmonic excitation. Copyright © 2010 John Wiley & Sons, Ltd.     

不同海域影响热带气旋强度变化的环境动力因素对比

利用1982-2007年NCEP/NCAR再分析资料、月平均海平面温度(SST)资料和西北太平洋、北大西洋以及北印度洋热带气旋(TC)资料,对比分析了环境动力因素对不同海域TC强度在不同时间尺度变化的影响.结果表明,在各时间尺度上,TC强度变化与垂直风切变变化有密切的联系.在西北太平洋,使TC过程强度增强或减弱的风切变...