Impact of lightning on organic matter-rich soils: influence of soil grain size and organic matter content on underground fires

A detailed study was carried out on a piece of land that had been struck by lightning during the violent rainstorm that raged over the Island of S?o Miguel (Azores Archipelago) in late October 2006. Temperature and gas measurements (CO₂, CO, H₂S and CH₄) were performed in four study trenches, dug in an area of ∼3 m², where an underground fire had been initiated by the impact with a lightning stroke, followed by the emission of a column of gases and smoke. The soil under study was originally a well-pedogenized about 80 cm thick bed, made of volcanic clayey to silty tephra fallouts and contained 5.5–9.7% of organic matter. The underground fire was monitored for one week and revealed a peak release of 404 ppm CO and 3.4% CO₂ originating from a horizon located about 45 cm under the soil surface. Measurements of temperature, performed one week after the impact, indicated a maximum value of 326°C inside the soil, while 516.5°C were measured on the surface of a lava block interred about 20 cm under the surface. Subsequently, a stratigraphic and sedimentologic study proved the role of the grain-size of the soil and of the organic matter content of the different horizons of the impact area, in determining the ratio between anoxic/oxidised combustion conditions and in the progress of the process itself. It was also noticed that combustion was not total all over in the soil bed and that the process had slightly migrated toward SW during the observation period. The combustion process went on for about ten days, in spite of several other violent rainstorms, until it was artificially extinguished through the excavations made to obtain study trenches. This particular circumstance evidenced the potential natural hazard represented by this kind of atmospheric event, especially in a land where the volcanic nature of the soil may easily mislead inexperienced observers and, consequently, delay proper action.     

The effect of naturally acidified irrigation water on agricultural volcanic soils. The case of Asembagus, Java, Indonesia

Acid water from the Banyuputih river (pH  3.5) is used for the irrigation of agricultural land in the Asembagus coastal area (East Java, Indonesia), with harmful consequences for rice yields. The river water has an unusual composition which is caused by seepage from the acidic Kawah Ijen crater lake into the river. This unique irrigation setting allows the study of soil acidification in situ. This paper assesses the effects of volcanogenically contaminated irrigation water on the chemical properties of the agricultural soils.The changes in soil properties were evaluated by comparing samples taken from the topsoil and sub-soil (1–3 m depth) from areas irrigated with acid water and areas irrigated with neutral water. The field survey thus resulted in four soil categories. Bulk soil composition, organic matter content, moisture content and particle size distribution were determined. Reactive phases were quantified with the selective extractions 1 M KCl, 0.1 M Na-pyrophosphate and 0.2 M acid ammonium oxalate (AAO).By comparing the four soil categories it is shown that the use of the naturally polluted irrigation water has had a large influence on the chemical composition of the topsoil. The composition of the soil solution has changed over the entire investigated soil profile. Furthermore the acid irrigation water has strongly modified the composition of the reactive phases, extracted as KCl, pyrophosphate, and AAO extractable elements, and also the bulk soil composition has been significantly modified. Overall this has resulted in the net dissolution of some elements and the net precipitation of others. The changes in the reactive phases and bulk soil composition are only apparent in the topsoil (0–20 cm) but not in the deeper soil.     

Effect of Inter-Column Spacing on Soil Stresses due to Vibro-Installed Stone Columns: Interesting Findings

This paper reveals the interesting relation between the inter-column spacing and the corresponding alteration of soil state of stresses due to the vibro-installation technique. This relation is inferred from analyses for load settlement records of various field load tests, performed for stone columns arrangements with different inter-column spacing values. In order to have adequate confidence in the findings, a well-documented case history, involving three columns patterns along with their relevant field and laboratory test results, is utilized for this study. Moreover, a well-tested finite element model, capable of simulating both elasto-plastic and time dependent soil deformations as well as pore water pressure building and dissipation, is employed in the analysis. Instead of determining the soil response to the test load, based on known initial soil stresses and material properties, the analysis is inversely posed to determine the soil initial stresses, based on the recorded settlements and the post-installation material properties. The alteration in the soil state of stress is represented by the increase in the post-installation horizontal to vertical stress ratio, K*, as a function of the inter-column spacing. It is found that this alteration experiences a systematic decrease in its magnitude as the inter-column spacing increases.     

Virgin rock temperatures from well logs — accuracy analysis for some advanced inversion models

Temperature data from 18 measurement series obtained during logging of the Oseberg field in the northern North Sea are presented. Because the measurement series are taken at approximately the same depth, they should give identical temperatures after depth correction, and are suitable for assessing the performance of different models used to determine virgin rock temperatures from well log information.We have used this data set to test the properties of the different models given by Shen and Beck (1986). Although these models were built to simulate closely the thermal recovery of a well and are unbiased, the uncertainties in the temperature estimates when applied to real data are found to be no less than those from simpler (biased) models. This fact confirms the conclusion of Hermanrud (1989a) who showed that physical factors other than those presently accounted for significantly influence the thermal recovery of a borehole.     

A semi-analytical solution for random wave-induced soil response and seabed liquefaction in marine sediments

In this study, unlike most previous investigations for wave-induced soil response, a simple semi-analytical model for the random wave-induced soil response is established for an unsaturated seabed of finite thickness. Two different wave spectra, the B-M and JONSWAP spectra, are considered in the new model. The influence of random wave loading on the soil response is investigated by comparing with the corresponding representative regular wave results through a parametric study, which includes the effect of the degree of saturation, soil permeability, wave height, wave period and seabed thickness. The maximum liquefaction depth under the random waves is also examined. The difference on the soil response under the two random wave types, B-M and JONSWAP frequency spectra, is also discussed in the present work.     

装载GPCTD传感器的海翼水下滑翔机观测数据实时质量控制

Profiles observed by Sea-Wing underwater gliders are widely applied in scientific research. However, the quality control(QC) of these data has received little attention. The mismatch between the temperature probe and conductivity cell response times generates erroneous salinities, especially across a strong thermocline. A sensor drift may occur owing to biofouling and biocide leakage into the conductivity cell when a glider has operated for several months. It is therefore critical to design a mature real-time QC procedure and develop a toolbox for the QC of Sea-Wing glider data. On the basis of temperature and salinity profiles observed by several Sea-Wing gliders each installed with a Sea-Bird Glider Payload CTD sensor, a real-time QC method including a thermal lag correction, Argo-equivalent real-time QC tests, and a simple post-processing procedure is proposed. The method can also be adopted for Petrel gliders.     

Stability of waterfront retaining wall subjected to pseudo-static earthquake forces

Waterfront retaining walls supporting dry backfill are subjected to hydrostatic pressure on upstream face and earth pressure on the downstream face. Under seismic conditions, if such a wall retains a submerged backfill, additional hydrodynamic pressures are generated. This paper pertains to a study in which the effect of earthquakes along with the hydrodynamic pressure including inertial forces on such a retaining wall is observed. The hydrodynamic pressure is calculated using Westergaard's approach, while the earth pressure is calculated using Mononobe-Okabe's pseudo-static analysis. It is observed that when the horizontal seismic acceleration coefficient is increased from 0 to 0.2, there is a 57% decrease in the factor of safety of the retaining wall in sliding mode. For investigating the effect of different parameters, a parametric study is also done. It is observed that if φ is increased from 30° to 35°, there is an increase in the factor of safety in the sliding mode by 20.4%. Similar observations were made for other parameters as well. Comparison of results obtained from the present approach with [Ebeling, R.M., Morrison Jr, E.E., 1992. The seismic design of waterfront retaining structures. US Army Technical Report ITL-92-11. Washington DC] reveal that the factor of safety for static condition (k_h=0), calculated by both the approaches, is 1.60 while for an earthquake with k_h=0.2, they differ by 22.5% due to the consideration of wall inertia in the present study.     

龙口的海风及其影响

本文运用龙口气象站近５年自记风资料及实测探空资料，分析了龙口海风的生消规律、海风强度、空间结构及海风生成后对温、湿度的影响。同时为分析海风环流对大气污染物的影响。本文提出了一个简单地计算热内边界层的方法。