Effects of fracture lineaments and in-situ rock stresses on groundwater flow in hard rocks: a case study from Sunnfjord, western Norway

Systematic field mapping of fracture lineaments observed on aerial photographs shows that almost all of these structures are positively correlated with zones of high macroscopic and mesoscopic fracture frequencies compared with the surroundings. The lineaments are subdivided into zones with different characteristics: (1) a central zone with fault rocks, high fracture frequency and connectivity but commonly with mineral sealed fractures, and (2) a damage zone divided into a proximal zone with a high fracture frequency of lineament parallel, non-mineralized and interconnected fractures, grading into a distal zone with lower fracture frequencies and which is transitional to the surrounding areas with general background fracturing. To examine the possible relations between lineament architecture and in-situ rock stress on groundwater flow, the geological fieldwork was followed up by in-situ stress measurements and test boreholes at selected sites. Geophysical well logging added valuable information about fracture distribution and fracture flow at depths. Based on the studies of in-situ stresses as well as the lineaments and associated fracture systems presented above, two working hypotheses for groundwater flow were formulated: (i) In areas with a general background fracturing and in the distal zone of lineaments, groundwater flow will mainly occur along fractures parallel with the largest in-situ rock stress, unless fractures are critically loaded or reactivated as shear fractures at angles around 30° to σ_H; (ii) In the influence area of lineaments, the largest potential for groundwater abstraction is in the proximal zone, where there is a high fracture frequency and connectivity with negligible fracture fillings. The testing of the two hypotheses does not give a clear and unequivocal answer in support of the two assumptions about groundwater flow in the study area. But most of the observed data are in agreement with the predictions from the models, and can be explained by the action of the present stress field on pre-existing fractures.     

Natural and man-induced stress evolution of slopes: the Monte Mario hill in Rome

The paper deals with stress-release effects induced by man-made cuts or excavations into natural stiff clay slopes that experienced erosion in response to valley deepening. The study was focused on the Monte Mario hill in Rome (Italy), which formed part of an area of recent urban expansion. The methodology of the study relied on a reference engineering-geology model, which was developed on the basis of site and laboratory data and stress–strain analyses. The latter analyses were carried out with the finite-difference code FLAC 4.0. Numerical modelling was based on a sequential approach, taking into account the main evolutionary stages of the Tiber river valley in Romeȁ9s urban area and then making cuts at the bottom of the slope located south of the Monte Mario Astronomical Observatory. The simulation revealed the stress-release effects that fluvial erosion and excavation fronts have caused on the investigated slopes and their consequent gravitational instabilities. These processes appear with metre-scale displacements, followed by stress-release cracks (actually observed on the slopes under review). In quantifying stress-release deformations, the simulation took into account the possible role of creep in the observed retardation of stress-release effects.Research activities were carried on with the co-operation of Dȁ9Arcangelo A. (Consorzio TREESSE, andrea.darcangelo@libero.it) and Moretti S. (IMG S.r.l. Servizi Tecnici per lȁ9Ingegneria e lȁ9Ambiente, moretti@img-srl.it)     

Occurrence of salt water above fresh water in dynamic equilibrium in a coastal groundwater flow system near De Panne, Belgium

A salt water lens is found above fresh water under the shore between Dunkerque (France) and Nieuwpoort (Belgium). This inverse density distribution is in a dynamic equilibrium. It develops due to the infiltration of salt water on the back shore during high tide. Under this salt water lens, water infiltrated in the adjacent dune area flows towards the sea and discharges at the seabed. This water quality distribution differs from the classic salt water wedge under fresh water described in the literature. Here, the evolution to this water quality distribution is simulated with a density dependent numerical model. A large tidal range, shore morphology and a permeable groundwater reservoir are the main conditions for the observed water quality distribution. By altering these conditions, intermediate water quality distributions between the classic salt water wedge and the one discussed here develop. Based on these simulations, it is expected that similar kinds of inverse density distribution could be present in a number of coastal areas, which have tides, a gently sloping shore and a permeable substratum.     

Initiation and development of pull-apart basins with Riedel shear mechanism: insights from scaled clay experiments

Typical pull-apart structures were created in scaled clay experiments with a pure strike-slip geometry (Riedel type experiments). A clay slab represents the sedimentary cover above a strike-slip fault in the rigid basement. At an early stage of the development of the deformation zone, synthetic shear fractures (Riedel shears) within the clay slab display dilatational behaviour. With increasing basal displacement the Riedel shears rotate and open further, developing into long, narrow and deep troughs. The shear displacement and the low angle with the prescribed principal basal fault set them apart from tension gashes. At a more evolved stage, synthetic segments (Y-shears) parallel to the basal principal fault develop and accommodate progressive strike-slip deformation. The Y-shears connect the tips of adjacent troughs developed from the earlier Riedel shears, resulting in the typical rhomb-shaped structures characteristic for pull-apart basins. The Strait of Sicily rift zone, with major strike-slip systems being active from the Miocene to the Present, comprises pull-apart basins at different length scales, for which the structural record suggests development by a mechanism similar to that observed in our experiments.     

3D numerical modelling of fluid flow in the Val-d’Or orogenic gold district: major crustal shear zones drain fluids from overpressured vein fields

Fluid flow patterns have been determined using oxygen isotope isopleths in the Val-d’Or orogenic gold district. 3D numerical modelling of fluid flow and oxygen isotope exchange in the vein field shows that the fluid flow patterns can be reproduced if the lower boundary of the model is permeable, which represents middle or lower crustal rocks that are infiltrated by a metamorphic fluid generated at deeper levels. This boundary condition implies that the major crustal faults so conspicuous in vein fields do not act as the only major channel for upward fluid flow. The upper model boundary is impermeable except along the trace of major crustal faults where fluids are allowed to drain out of the vein field. This upper impermeable boundary condition represents a low-permeability layer in the crust that separates the overpressured fluid from the overlying hydrostatic fluid pressure regime. We propose that the role of major crustal faults in overpressured vein fields, independent of tectonic setting, is to drain hydrothermal fluids out of the vein field along a breach across an impermeable layer higher in the crust and above the vein field. This breach is crucial to allow flow out of the vein field and accumulation of metals in the fractures, and this breach has major implications for exploration for mineral resources. We propose that tectonic events that cause episodic metamorphic dehydration create a short-lived pulse of metamorphic fluid to rise along zones of transient permeability. This results in a fluid wave that propagates upward carrying metals to the mineralized area. Earthquakes along crustal shear zones cause dilation near jogs that draw fluids and deposit metals in an interconnected network of subsidiary shear zones. Fluid flow is arrested by an impermeable barrier separating the hydrostatic and lithostatic fluid pressure regimes. Fluids flow through the evolving and interconnected network of shear zones and by advection through the rock matrix. Episodic breaches in the impermeable barrier along the crustal shear zones allow fluid flow out of the vein field.     

基于点重要度的地形LOD简化算法及精度

在分析、讨论目前关于3维地形模型简化与误差控制方法的基础上,提出了一种基于点重要度进行连续LOD模型简化的算法.并以5种典型地貌的实验数据作为运行实例,给出了点重要度与地貌类型之间的精度关系.这为今后连续LOD模型的合理建立提供了一种新思路和方法,也为模型的简化提供了科学依据.     

Low-low satellite-to-satellite tracking: a comparison between analytical linear orbit perturbation theory and numerical integration

Low-low satellite-to-satellite tracking (ll-SST) range-rate observations have been predicted by two methods: one based on a linear perturbation theory in combination with the Hill equations, and one based on solving the equations of motion of two low-flying satellites by numerical integration. The two methods produce almost equivalent Fourier spectra of the range-rate observations after properly taking into account a few resonant terms. For a typical GRACE-type configuration, where the two satellites trail each other at a distance of 300 km at an altitude of 460 km, and in the presence of the EGM96 gravity field model, complete to spherical harmonic degree and order 70, the agreement between the Fourier spectra is about 1 mm/s compared to a root-mean-square (RMS) value of more than 220 mm/s for the range-rate signal. The discrepancy of 1 mm/s can be reduced significantly when not taking into account perturbations caused by the J₂ term. Excluding the J₂ term, the agreement between the two methods improves to 0.4 mm/s compared to a RMS value of 6 mm/s for the range-rate signal. These values are 0.01 and 2.3 mm/s when ignoring the spectrum for frequencies below two cycles per orbital revolution, reducing the discrepancy even further to about 0.5% of the signal. The selected linear perturbation theory is thus capable of modeling gravity field induced range-rate observations with very high precision for a large part of the spectrum.     

Spatial process and data models: Toward integration of agent-based models and GIS

The use of object-orientation for both spatial data and spatial process models facilitates their integration, which can allow exploration and explanation of spatial-temporal phenomena. In order to better understand how tight coupling might proceed and to evaluate the possible functional and efficiency gains from such a tight coupling, we identify four key relationships affecting how geographic data (fields and objects) and agent-based process models can interact: identity, causal, temporal and topological. We discuss approaches to implementing tight integration, focusing on a middleware approach that links existing GIS and ABM development platforms, and illustrate the need and approaches with example agent-based models.     

不同辐射传输方案对中尺度降水影响的对比分析

在MM5非静力稳定中尺度气象模式中引进了建立在δ-4流近似和相关-k分布基础上的对云水、雨水、冰晶和霰的辐射特性进行详细描述的辐射传输方案。新建立的辐射传输方案和MM5中原有的辐射传输方案在华南暴雨中的模拟结果相互比较，并与天气实况的对比表明:辐射在中尺度暴雨中起着重要的作用；辐射传输方案对云辐射特性描述的准确程度对于地面降水影响是明显的；不同的辐射传输方案对地面降水的影响存在较大的差异，并且这些差异在白天比在夜间明显；辐射传输过程对地面降水影响的差异主要表现在降水中心上，而对降水的地理分布改变很小；相对而言，不同的辐射传输方案之间对短波描述的差异对地面降水的影响明显，而对长波描述差异的影响不大；新辐射传输方案能够在一定程度上改进MM5对中尺度降水的模拟能力。     

大气热力学的若干新发展

对自20世纪80年代以来的大气热力学发展进行了综合评述, 阐述了如城市热岛效应、全球增暖等非传统大气热力学问题; 基于大气非平衡态热力学的非线性理论, 提出应发展突显热力学作用的数值模式, 并阐述其必要性和可能性。