金沙江下游支流黑水河松新电站幼鱼下行过坝研究

梯级小水电的开发一定程度上破坏了河流连通性并阻碍了鱼类洄游通道。黑水河流域松新坝址为了满足鱼类上行产卵修建了松新鱼道,然而作为洄游物种生命周期中的关键行为,鱼类下行洄游的需求也同等重要。为了寻求一种可行、高效、低损伤的下行过鱼方式,了解河流中不同环境因素对鱼类下行效率的影响,本研究在金沙江下游支流黑水河松新水电站补水通道开展鱼类下行过坝效果评估研究。针对两种鲤科鱼类(棒花鱼Abbottina rivularis和短须裂腹鱼Schizothorax wangchiachii)幼鱼和两种鳅科鱼类(短体副鳅Paracobitis potanini和红尾副鳅Paracobitis variegatus)幼鱼各放鱼90尾,定量分析鱼种、水体透明度、放鱼位置、流量、水温、水位等因素对鱼类下行效率的影响。结果表明:棒花鱼、短须裂腹鱼、短体副鳅、红尾副鳅的下行率依次为22.22%(20尾)、28.89%(26尾)、8.89%(8尾)、15.56%(14尾);幼鱼下行成功率与上游河道水温呈正相关趋势,且放鱼位置、鱼种、上游河道水温和流量均对鱼类下行成功率有显著影响。通过构建二元Logistic回归模型识...     

VORTEX FLOW FIELD IN A SCOUR HOLE AROUND ABUTMENTS

The three-dimensional flow field in a scour hole around different abutments under a clear water regime was experimentally measured in a laboratory flume, using the Acoustic Doppler Velocimeter (ADV). Three types of abutments used in the experiments were vertical-wall (rectangular section), 45° wing-wall (45° polygonal section) and semicircular. The three-dimensional time-averaged velocity components were detected at different vertical planes for vertical-wall abutment and azimuthal planes for wing-wall and semicircular abutments. The velocity components were also measured at different horizontal planes. In the upstream, presentations of flow field through vector plots at vertical / azimuthal and horizontal planes show the existence of a primary vortex associated with the downflow inside the scour hole. On the other hand, in the downstream, the flow field shows a reversed flow near the abutments having a subsequent recovery with a passage of flow as a part of the main flow. The data presented in this p     

海原断裂带中东段地貌差异及其成因探讨

以定量化地形因子为切入点的构造地貌学方法已成为活动构造研究的有效手段,被广泛用于定性或半定量解析地貌对新构造运动的响应及其演化过程。针对海原断裂带中东段现今地貌差异,以SRTM 90m分辨率DEM为基础,利用ArcGIS软件和Matlab程序脚本,提取了海原断裂带中东段高程、坡度、地形起伏、地形侵蚀以及河流陡峭系数等地形因子。从空间分布上看,上述各项地形因子沿断裂走向均呈现 “西高东低”的整体分布特征。西段海拔高、坡度陡、起伏大、侵蚀强、抬升快,中段和东段海拔低、坡度缓、起伏小、侵蚀弱、抬升慢,此外,在断裂带的东南尾端呈略微增加趋势,达到小范围内的峰值。在此基础上,通过对比分析地形因子与年降水量、基岩岩性,初步探讨了构造与降水、岩性等因素对地形地貌的控制作用,认为不同降水条件对地貌后期改造起显著作用,基岩岩性与现今地貌之间并无显著关系,该区域地貌类型主要受构造抬升差异所控制。沿断裂带走向上的现今地貌差异表明,西段处于相对快速的构造隆升和强挤压造山构造背景,中段由于受到黄河下切及河流冲积作用影响,地貌参数记录的抬升特征并不显著,而东段则反映出大型断裂带尾端挤压调整效应。     

龙门山断裂带精细速度结构的双差层析成像研究

利用川西流动地震台阵、汶川地震震后应急台网记录到的P波到时资料,对2008年5月至2008年10月期间发生的汶川地震余震序列应用双差层析成像方法进行了地震震源和三维P波速度结构的联合反演.结果显示,联合反演获得的地震重定位结果与基于一维地壳参考模型的双差定位方法结果相近;研究区15 km以上速度结构与地表断裂分布密切相关,20 km以下深度呈现北东向和北西向交错结构.汶川地震破裂带南段龙门山断裂带之间上地壳呈现高速异常,速度结构的非均匀变化是控制余震分布和主震破裂传播的主要因素;联合反演结果给出了小鱼洞—理县方向存在隐伏断裂的速度结构证据,同时发现,破裂带北东段可能沿新发断裂扩展;结果确认了汶川地震起始段的高角度逆冲断裂特征,也确认了前山断裂和中央断裂在约20 km深度合并到脆韧转换带的特征.     

数字化地震观测及技术系统建设若干问题

首先论述了数字地震台网的基本特点和优点,然后着重论述数字地震台网技术系统建设中的若干问题,包括台址的选择,拾振器,采集器,传输信道和无线数字传输设备的选择和安装,以及系统安装中的总体技术要求等。     

Water and nutrient fluxes off Northwest Africa

A historical data set is used to describe the coastal transition zone off Northwest Africa during spring 1973 and fall 1975, from 17° to 26°N, with special emphasis on the interaction between subtropical (North Atlantic Central Waters) and tropical (South Atlantic Central Waters) gyres. The near-surface geostrophic circulation, relative to 300 m, is quite complex. Major features are a large cyclonic pattern north of Cape Blanc (21°N) and offshore flow at the Cape Verde front. The large cyclone occurs in the region of most intense winds, and resembles a large meander of the baroclinic southward upwelling jet. The Cape Verde frontal system displays substantial interleaving that may partly originate as mesoscale features at the coastal upwelling front. Property–property diagrams show that the front is an effective barrier to all properties except temperature. The analysis of the Turner angle suggests that the frontal system is characterized by large heat horizontal diffusion as a result of intense double diffusion, which results in the smoothing of the temperature horizontal gradients. Nine cross-shore sections are used to calculate along-shore geostrophic water-mass and nutrient transports and to infer exchanges between the coastal transition zone and the deep ocean (import: deep ocean to transition zone; export: transition zone to deep ocean). These exchanges compare well with mean wind-induced transports and actual geostrophic cross-shore transport estimates. The region is divided into three areas: southern (18–21°N), central (21–23.5°N), and northern (23.5–26°N). In the northern area geostrophic import is roughly compensated with wind-induced export during both seasons. In the central area geostrophic import is greater than wind-induced export during spring, resulting in net import of both water (0.8 Sv) and nitrate (14 kmol s⁻¹), but during fall both factors again roughly cancel. In the southern area geostrophy and wind join to export water and nutrients during both seasons, they increase from 0.6 Sv and 3 kmol s⁻¹ during fall to 2.9 Sv and 53 kmol s⁻¹ during spring.     

Channel incision,evolution and potential recovery in the Walla Walla and Tucannon River basins,northwestern USA

We evaluated controls on locations of channel incision, variation in channel evolution pathways and the time required to reconnect incised channels to their historical floodplains in the Walla Walla and Tucannon River basins, northwestern USA. Controls on incision locations are hierarchically nested. A first‐order geological control defines locations of channels prone to incision, and a second‐order control determines which of these channels are incised. Channels prone to incision are reaches with silt‐dominated valley fills, which have sediment source areas dominated by loess deposits and channel slopes less than 0·1(area)^?0·45. Among channels prone to incision, channels below a second slope–area threshold (slope = 0·15(area)^?0·8) did not incise. Once incised, channels follow two different evolution models. Small, deeply incised channels follow Model I, which is characterized by the absence of a significant widening phase following incision. Widening is limited by accumulation of bank failure deposits at the base of banks, which reduces lateral channel migration. Larger channels follow Model II, in which widening is followed by development of an inset floodplain and aggradation. In contrast to patterns observed elsewhere, we found the widest incised channels upstream of narrower reaches, which reflects a downstream decrease in bed load supply. Based on literature values of floodplain aggradation rates, we estimate recovery times for incised channels (the time required to reconnect to the historical floodplain) between 60 and 275 years. Restoration actions such as allowing modest beaver recolonization can decrease recovery time by 17–33 per cent. Published in 2007 by John Wiley & Sons, Ltd.     

川西地区小震重新定位及其活动构造意义

使用双差地震定位法对川西地区1992～2002年的13367个小震进行重新定位, 初步分析了地震活动性与地表活动构造的关系及其揭示的构造信息. 重新定位后,地震活动沿活动断裂成线（带）状分布现象非常突出,呈现出与地表活动构造的密切关系：结构简单的单一走滑断层具有上宽下陡的花状结构特征,拉分盆地与逆断裂具有线性而发散的分布式结构特征,逆断裂之下还存在缺震层. 此外,沿活动断裂带地震活动还具有空间分段性,揭示出局部地段存在着隐伏活动断裂和可圈定为地震危险区的地震空区. 震源深度分布显示,川西高原在15～20km的深度范围内普遍存在厚度约5km的缺震层,以高温高压实验结果为基础,通过计算川西地区地壳强度表明,大约14～19km的深度范围花岗岩处于塑性流变状态,说明缺震层的出现具有地壳物质塑性变形基础.     

Bedload transport resistance in rough open‐channel flows

During bedload movement by saltation, streamwise momentum is transferred from the ?ow to the saltating grains. When the grains collide with other grains on the bed or in the ?ow, streamwise momentum is reduced, and there is a decrease in streamwise ?ow velocity and an increase in ?ow resistance, herein termed bedload transport resistance f_bt. Based on experiments in two ?umes with ?xed and mobile plane beds and previously published data, an equation is developed that may be used to predict f_bt for both capacity and non‐capacity ?ows. The variables in this equation are identi?ed by dimensional analysis and the coef?cients are determined by non‐linear regression. This equation applies to rough turbulent open‐channel ?ows, where the relative submergence is between 1 and 20 and the entire sediment load moves by saltation. An investigation of the relative magnitudes of f_bt and grain resistance f_c suggests that where dimensionless shear stress θ is less than 1 and saltation is the dominant mode of bedload transport, f_bt/f_c increases with θ but never exceeds 1. Copyright © 2004 John Wiley & Sons, Ltd.     

Comparison of hydraulic geometry between sand‐ and gravel‐bed rivers in relation to channel pattern discrimination

A comparison has been made between the hydraulic geometry of sand‐ and gravel‐bed rivers, based on data from alluvial rivers around the world. The results indicate a signi?cant difference in hydraulic geometry among sand‐ and gravel‐bed rivers with different channel patterns. On this basis, some diagrams for discrimination of meandering and braided channel patterns have been established. The relationships between channel width and water discharge, between channel depth and water discharge, between width–depth ratio and water discharge and between channel slope and water discharge can all be used for channel pattern discrimination. The relationship between channel width and channel depth can also be used for channel pattern discrimination. However, the accuracy of these relationships for channel pattern discrimination varies, and the depth–discharge relationship is a better discriminator of pattern type than the classic slope–discharge function. The cause for this difference has been explained qualitatively. To predict the development of channel patterns under different natural conditions, the pattern discriminator should be searched on the basis of independent or at least semi‐independent variables. The relationship between stream power and bed material grain size can be used to discriminate channel patterns, which shows a better result than the discriminator using the slope–discharge relationship. Copyright © 2004 John Wiley & Sons, Ltd.