Vent conditions for expected eruptions at Vesuvius

Determining consistent sets of vent conditions for next expected eruptions at Vesuvius is crucial for the simulation of the sub-aerial processes originating the volcanic hazard and the eruption impact. Here we refer to the expected eruptive scales and conditions defined in the frame of the EC Exploris project, and simulate the dynamics of magma ascent along the volcanic conduit for sub-steady phases of next eruptions characterized by intensities of the Violent Strombolian (VS), Sub-Plinian 2 (SP2), and Sub-Plinian 1 (SP1) scale. Sets of conditions for the simulations are determined on the basis of the bulk of knowledge on the past history of Vesuvius [Cioni, R., Bertagnini, A., Santacroce, R., Andronico, D., Explosive activity and eruption scenarios at Somma–Vesuvius (Italy): towards a new classification scheme. Journal of Volcanology and Geothermal Research, this issue.]. Volatile contents (H₂O and CO₂) are parameterized in order to account for the uncertainty in their expected amounts for a next eruption. In all cases the flow in the conduit is found to be choked, with velocities at the conduit exit or vent corresponding to the sonic velocity in the two-phase non-equilibrium magmatic mixture. Conduit diameters and vent mixture densities are found to display minimum overlapping between the different eruptive scales, while exit gas and particle velocities, as well as vent pressures, largely overlap. Vent diameters vary from as low as about 5 m for VS eruptions, to 35–55 m for the most violent SP1 eruption scale. Vent pressures can be as low as less than 1 MPa for the lowest volatile content employed of 2 wt.% H₂O and no CO₂, to 7–8 MPa for highest volatile contents of 5 wt.% H₂O and 2 wt.% CO₂ and large eruptive scales. Gas and particle velocities at the vent range from 100–250 m/s, with a tendency to decrease, and to increase the mechanical decoupling between the phases, with increasing eruptive scale. Except for velocities, all relevant vent quantities are more sensitive to the volatile content of the discharged magma for the highest eruptive scales considered.     

Thermal structure and paleo-heat flow in the Shimanto accretionary prism, Southwest Japan

Abstract Thermal structural analysis and paleo-heat flow estimation provide clues to understanding the thermal evolution of the accretionary complex. The thermal structure and heat flow in the Jurassic Chichibu and Cretaceous to Tertiary Shimanto accretionary complex, Southwest Japan, have been investigated by vitrinite reflectance measurement and fluid inclusion analysis. As a result, the local and multistage metamorphisms were recognized as follows. First, the Tertiary complex around the Miocene Ashizuri granite underwent exposure to extra-high temperatures. Second, the Okitsu Melange underwent exposure to higher temperatures than the surrounding strata and was formed concurrently with the Kula-Pacific ridge subduction beneath the Japanese Islands in the Eocene. Finally, the thermal structure of most of the Cretaceous and southern Jurassic complexes is independent of the geologic structure, indicating that these areas suffered thermal overprint. Regional radiometric dating studies show that most of the Cretaceous Shimanto complex was heated in the Eocene; the thermal overprint might have occurred as a result of ridge subduction. The heat flow during peak heating was estimated to be 95–120 mW/m² except for the Cretaceous Okitsu melange and the Cretaceous Nonokawa formation, north of the Okitsu Melange; a much higher value of heat flow of ~200 mW/m² was estimated in the Okitsu Melange. An estimation of heat flow failed for the non-okawa formation because thermal equilibrium between the fluid and rocks has not yet been reached. It is probable that the southern strata underwent a higher heat flow. Such a trenchward increase in heat flow resembles the present situation of the Nankai Trough, although the heat flow in the Eocene was much higher.     

A framework for sourcing of evaporation between saturated and unsaturated zone in bare soil condition

ABSTRACT

Sourcing subsurface evaporation (E_ss) into groundwater (E_g) and unsaturated zone (E_u) components has received little scientific attention so far, despite its importance in water management and agriculture. We propose a novel sourcing framework, with its implementation in dedicated post-processing software called SOURCE (used along with the HYDRUS1D model), to study evaporation sourcing dynamics, define quantitatively “shallow” and “deep” water table conditions and test the applicability of water table fluctuation (WTF) and “bucket” methods for estimation of E_g and E_u separately.

For the “shallow” and “deep” water table we propose E_g?>?0.95E_ss and E_g = 0 criteria, respectively. Assessment of the WTF method allowed sourcing of very small fluxes otherwise neglected by standard hydrological methods. Sourcing with SOURCE software was more accurate than the standard “bucket” method mainly because of greater flexibility in spatio-temporal discretization. This study emphasized the dry condition relevance of groundwater evaporation which should be analysed by applying coupled flow of heat, vapour and liquid water.

Editor D. Koutsoyiannis; Associate editor S. Kanae     

EXPERIMENTS ON FLOW AROUND A CYLINDER IN A SCOURED CHANNEL BED

The flow pattern around a cylinder, installed in a scoured channel bed, was experimentally investigated. Detailed measurements of the instantaneous 3D velocities were performed by using an Acoustic Doppler Velocity Profiler (ADVP), from which the profiles of the time-averaged velocities and turbulence stresses were obtained. It is shown that the influence of the cylinder and of the scour hole alters the approach flow; this is essentially confined to the vicinity of the cylinder and to the inside of the scour hole. The horseshoe vortex is measured as a flow reversal inside the scour hole, formed by the downward flow along the cylinder face and the reversed flow at the scour bed.     

Undular tidal bore dynamics in the Daly Estuary, Northern Australia

Measurements in the macro-tidal Daly Estuary show that the presence of an undular tidal bore contributed negligibly to the dissipation of tidal energy. No recirculation bubble was observed between a trough and the following wave crest in the lee waves following the undular bore. This differs to stationary undular bores in laboratory experiments at larger Froude numbers where a recirculation bubble exists. Secondary motions and the turbulence generated by the undular bore had no measurable influence on the sediment transport. This situation contrasts with the intense sediment resuspension observed in breaking tidal bores. The tidally averaged sediment budget in the Daly Estuary was controlled by the asymmetry of tidal currents. The undular bore may widen the river by breaking along the banks that it undercuts, leading to bank slippage. A patch of river-wide macro-turbulence of 3-min duration occurred about 20 min after the passage of the bore during accelerating tidal currents.     

Sub-Alfvénic flows in the quiet and recurrent solar winds

Observed instances are given in this paper to show that sub-Alfvénic flow can be formed in the quiet and recurrent low-speed solar wind streams. This kind of flow appears in regions with abnormal enhancement of Alfvénic speed and is associated with a specific type of magnetic configuration.     

线性工程建设对地下水流场的影响分析

出于降低高速公路坡度的目的, 团结桥连接线高速公路路基开挖在Ⅱ级阶地前缘处排水盲沟最大开挖段基本将原来连续的天然含水层切穿, 导致地下水排泄基准面下降, 使得地下水流场发生改变, 部分民井出现水位下降或干涸现象. 得出路基开挖排水是导致工程区附近地下水含水层结构及流场改变、 水位下降或局部疏干的主要原因.     

四川夹金山王家山沟泥石流灾害特征及防治

王家山沟位于四川省阿坝藏族羌族自治州小金县达维乡境内,流域面积8.02km2,沟长5.14km,相对高度1614m,纵坡降314.0‰,沟内滑坡发育,形成泥石流的地形和松散固体物质条件充分;偶尔出现的高强度、短历时暴雨是泥石流形成的水源条件和激发因素。针对危害特征,对泥石流采取了以拦挡工程为主,辅以防护堤及生物措施的综合治理方案。     

西宁盆地泥石流类型及其防治意见

概略地叙述了西宁地区的泥石流形成条件和形成机理,并将西宁地区泥石流划分为稀性泥石流类及泥石质泥石流种类。在此基础上提出防治泥石流灾害的意见。     

REGULATION OF FLOW AND SEDIMENT LOAD IN THE YELLOW RIVER

Small runoff, large sediment load, and incompatible relationship of flow and sediment load are very important characteristics of the Yellow River. They are also the crux of the most prominent problems of the Yellow River. To solve these problems, the regimes of flow and sediment load have to be improved by increasing water, reducing sediment load, and by using reservoirs to regulate flow and sediment load. The results of experiments for regulating the flow and sediment load in the last three years by the Xiaolangdi Reservoir have indicated that this measure is a realistic and effective way to mitigate the prominent problems in flood control of the Lower Yellow River at present and in the near future. However, the regulation system is still imperfect. It is advisable to speed up the pace of research and construction of the system for regulating flow and sediment load.