Methane exchange between coal-bearing basins and the atmosphere: the Ruhr Basin and the Lower Rhine Embayment, Germany

A precise knowledge of methane exchange processes is required to fully understand the recent rise of atmospheric methane concentration. Three of these processes take place at the lithosphere/atmosphere boundary: bacterial consumption of methane and emission of bacterial or thermogenic methane. This study was initiated to quantify these processes on a regional scale in the Ruhr Basin and the Lower Rhine Embayment. Since these areas are subject to bituminous coal and lignite mining, natural and anthropogenically-induced methane exchange processes could be studied. The methane emission and consumption rates and their carbon isotope signal were measured at the lithosphere/atmosphere boundary using flux chambers. On most of the soils studied, methane consumption by bacteria was identified. Thermogenic methane was released only at some of the natural faults examined. In active and abandoned bituminous coal mining areas methane emissions were restricted to small areas, where high emission rates were measured. The carbon isotope composition of methane at natural faults and in mining subsidence troughs was typical of thermogenic methane (−45 to −32 ‰ δ¹³C). Methane exchange balancing revealed that natural methane emissions from these two basins represent no source of atmospheric importance. However, methane release by upcast mining shafts dominates the methane exchange processes and is by about two orders of magnitude greater than methane consumption by bacterial oxidation in the soils.     

Microbial Processes in Stratified Lake Doroninskoe(Transbaikal Region)

正In recent decades,meromictic ponds attract the attention of researchers in different directions,because here the character of the physical,chemical and biological processes differ from those of typical mixing waters(Kuznetsov,1970;Hutchinson,1969).In Transbaikalia widely distributed soda and salt lakes with different salinity.Notable among them is Lake Doroninskoye,which has a pronounced stratification for a     

Comparative Study of the Carbon Emission Situation and Goals between China and India

As the two large developing and populous countries, China and India face the dual challenges of economic development and climate change. Both of them are active in carbon emissions reduction, while India also bears the pressure of being “benchmarked” against China. With taking China and India as the sample of a comparative analysis, and the statistical value of a long sequence as the basic analysis data, based on the detailed analysis and comparison of carbon emissions history, the carbon emissions situation of the two countries from various dimensions including economic development, energy reserves and consumption, etc. were comparatively analyzed. The carbon intensity and energy structure after achieving the objectives were measured and compared by focusing on the carbon emissions reduction targets in China and India. The comparative results show that: China’s total carbon emissions are greater than India’s, but the growth rate of emissions, per capita emissions are significantly lower than India’s, while the carbon intensity decreases significantly faster than that of India. China has taken more efforts to make commitments to carbon reduction than India. With India’s energy structure adjustment, the situation will be gradually better than that in China.     

内蒙古乌拉山石英－钾长石脉金矿床铅和硫同位素研究

内蒙古乌拉山金矿床是近年在我国北方发现的大型金矿床之一。矿床主要由赋存在太古界乌拉山群变质岩地层中一系列石英－钾长石脉和石英脉组成。矿区范围内晚古生代—中生代花岗岩类分布广泛并且同金矿化具密切时、空分布关系。本文对乌拉山金矿床，大桦背花岗岩体和变质岩地层的硫、铅同位素比值进行了系统测定，并解释了不同地质体硫、铅同位素变化特征。研究表明：金成矿作用发生在２４０×１０￣６ａ，成矿物质主要来自大桦背花岗岩体及有关的岩脉，乌拉山金矿床形成过程中，亦有部分非岩浆物质混入。     

高温炉燃烧-红外吸收法测定重铀酸盐中硫质量分数

建立了高温燃烧红外碳硫仪测定重铀酸盐中硫质量分数的分析方法。样品以五氧化二钒为助熔剂,在高温炉燃烧后,用红外吸收测定重铀酸盐中的硫,样品分析重现性好,精密度高,相对标准偏差为0.26%;样品加标回收率在97.1%~103%之间。     

Evolution of Hydrothermal System at the Dizon Porphyry Cu-Au Deposit, Zambales, Philippines

Abstract. Evolution of hydrothermal system from initial porphyry Cu mineralization to overlapping epithermal system at the Dizon porphyry Cu‐Au deposit in western central Luzon, Zambales, Philippines, is documented in terms of mineral paragen‐esis, fluid inclusion petrography and microthermometry, and sulfur isotope systematics. The paragenetic stages throughout the deposit are summarized as follows; 1) stockwork amethystic quartz veinlets associated with chalcopyrite, bornite, magnetite and Au enveloped by chlorite alteration overprinting biotite alteration, 2) stockwork quartz veinlets with chalcopyrite and pyrite associated with Au and chalcopyrite and pyrite stringers in sericite alteration, 3) stringer quartz veinlets associated with molybdenite in sericite alteration, and 4) WNW‐trending quartz veins associated with sphalerite and galena at deeper part, while enargite and stibnite at shallower levels associated with advanced argillic alteration. Chalcopyrite and bornite associated with magnetite in quartz veinlet stockwork (stage 1) have precipitated initially as intermediate solid solution (iss) and bornite solid solution (bnss), respectively. Fluid inclusions in the stockwork veinlet quartz consist of gas‐rich inclusions and polyphase inclusions. Halite in polyphase inclusions dissolves at temperatures ranging from 360d?C to >500d?C but liquid (brine) and gas (vapor) do not homogenize at <500d?C. The maximum pressure and minimum temperature during the deposition of iss and bnss with stockwork quartz veinlets are estimated to be 460 bars and 500d?C. Fluid inclusions in veinlet stockwork quartz enveloped in sericite alteration (stage 2) consist mainly of gas‐rich inclusions and polyphase inclusions. In addition to the possible presence of saturated NaCl crystals at the time of entrapment of fluid inclusions that exhibit the liquid‐vapor homogenization temperatures lower than the halite dissolution temperatures in some samples, wide range of temperatures of halite dissolution and liquid‐vapor homogenization of polyphase inclusions from 230d?C to >500d?C and from 270d?C to >500d?C, respectively, suggests heterogeneous entrapment of gaseous vapor and hypersaline brine. The minimum pressure and temperature are estimated to be about 25 bars and 245d?C. Fluid inclusions in veinlet quartz associated with molybdenite (stage 3) are dominated by gas‐rich inclusions accompanied with minor liquid‐rich inclusions that homogenize at temperatures between 350d?C and 490d?C. Fluid inclusions in vuggy veinlet quartz associated with stibnite (stage 4) consist mainly of gas‐rich inclusions with subordinate polyphase inclusions that do not homogenize below 500d?C. Fluid inclusions in veinlet quartz associated with galena and sphalerite (stage 4) are composed of liquid‐rich two‐phase inclusions, and they homogenize into liquid phase at temperatures ranging widely from 190d?C to 300d?C (suggesting boiling) and the salinity ranges from 1.0 wt% to 3.4 wt% NaCl equivalent. A pressure of about 15 bars is estimated for the dilute aqueous solution of 190d?C from which veinlet quartz associated with galena and sphalerite precipitated. In addition to a change in temperature‐pressure regime from lithostatic pressure during the deposition of iss and bnss with stockwork quartz veinlets to hydrostatic pressure during fracture‐controlled quartz veinlet associated with galena and sphalerite, a decrease in pressure is supposed to have occurred due to unroofing or removal of the overlying piles during the temperature decrease in the evolution of hydrothermal system. The majority of the sulfur isotopic composition of sulfides ranges from ±0 % to +5 %. Sulfur originated from an iso‐topically uniform and homogeneous source, and the mineralization occurred in a single hydrothermal system.     

Chemistry and Sulfur Isotopes in a Chert-dominant Sequence around the Stratiform Manganese Deposit of the Noda-Tamagawa Mine, Northern Kitakami Terrane, Northeast Japan: Implication for Paleoceanographic Environmental Setting

Abstract. Chemistry and sulfur isotopes are analyzed for a series of rocks in the chert‐dominant sequence around the stratiform manganese ore deposit of the Noda‐Tamagawa mine in the northern Kitakami Terrane, northeast Japan. The sequence is litholog‐ically classified into six units in ascending order: lower bedded chert, lower black shale, massive chert, manganese ore, upper black shale, and upper bedded chert. The rocks around the manganese ore deposit exhibit anomalous enrichment in Ni (max. 337 ppm), Zn (102) and U (30) in the upper part of lower bedded chert, Mo (122), Tl (79) and Pb (33) in the lower black shale, MnO, Cu (786) and Co (62) in the manganese ore, and As (247) and Sb (17) in the upper black shale. The aluminum‐normalized profiles reveal zonal enrichment of redox‐sensitive elements around the manganese bed: Zn‐Ni‐Fe‐Mo‐U(‐Co), Tl‐Pb(‐Mo), Mn‐Fe‐Cu‐V‐Cr‐Co(‐Zn) and As‐Sb in ascending order. The uppermost part of the lower bedded chert and black shale exhibit negative Ce/Ce* values, whereas the massive chert, manganese ore and lower part of the upper bedded chert display positive values. The isotopic δ³⁴S values are 0±6 % in the lower part of the lower bedded chert, ‐19 to ‐42 % in the upper part of the lower bedded chert, ‐36 to ‐42 % in the lower black shale, ‐28 to ‐35 % in the massive chert, manganese ore and upper black shale, and ‐23±5 % in the upper bedded chert. Thus, there is a marked negative shift in δ³⁴S values in the lower bedded chert, and an upward‐increasing trend in δ³⁴S through the manganese ore horizon. The present data provide evidence for a change in the paleoceanographic environmental resulting from inflow of oxic deepwater into the stagnant anoxic ocean floor below the manganese ore horizon. This event is likely to have triggered the precipitation of manganese oxyhydroxides. The redistribution of redox‐sensitive elements through the formation of metalliferous black shale and manganese carbonate ore may have occurred in association with bacterial decomposition of organic matter during early diagenesis of initial manganese oxyhydroxides.     

云南兰坪盆地北部东缘铅锌矿床喷流沉积成因的厘定———来自矿物学和硫同位素证据

通过详细的野外地质工作和显微镜下观察,对云南兰坪盆地东北部维西—乔后断裂带上三叠统石钟山组(T₃s)中产出的铅锌矿床成因进行厘定。研究结果表明,测区内存在大量典型的同生沉积矿床标志,如:纹层构造、条纹条带构造、网脉构造、黄铁矿条带软沉积构造、黄铁矿草莓状结构、黄铁矿胶状构造、闪锌矿同心环状构造等。青甸湾矿床金属硫化物硫同位素测试结果显示,黄铁矿的δ34 S介于3.7‰ ~ 8.1‰,均值5.34‰; 闪锌矿的δ34 S介于5.2‰ ~ 10.0‰之间,均值为7.18‰; 方铅矿的δ34 S介于5.2‰ ~ 9.9‰之间,均值为7.275‰,铅锌矿床硫来源于海水硫酸根无机还原。结合矿床形成时代及大地构造背景,认为该区铅锌矿为喷流沉积作用形成。      

Sulfur Concentration in Geochemical Reference Materials by Solution Inductively Coupled Plasma‐Mass Spectrometry

With implications for the origin of ore deposits, redox state of the atmosphere, and effects of volcanic outgassing, understanding the sulfur cycle is vital to our investigation of Earth processes. However, the paucity of sulfur concentration measurements in silicate rocks and the lack of well‐calibrated reference materials with concentrations relevant to the rocks of interest have hindered such investigations. To aid in this endeavour, this study details a new method to determine sulfur concentration via high mass resolution solution inductively coupled plasma‐mass spectrometry (ICP‐MS). The method is based on an aqua regia leach, involving relatively rapid sample preparation and analysis, and uses small test portion masses (< 50 mg). We utilised two independently prepared standard solutions to calibrate the analyses, resulting in 4% accuracy, and applied the method to eight geochemical reference materials. Measurements were reproducible to within ~ 10%. Sulfur concentrations and isotopes of six reference materials were measured additionally by elemental analyser‐combustion‐isotope ratio mass spectrometry to independently evaluate the accuracy of the ICP‐MS method. Reference materials that yielded reproducible measurements identical to published values from other laboratories (JGb‐1, JGb‐2 and MAG‐1) are considered useful materials for the measurement of sulfur. Reference materials that varied between studies but were reproducible for a given test portion perhaps suffer from sample heterogeneity and are not recommended as sulfur reference materials.