Nouvelle interprétation structurale de la « faille Nord- Pyrénéenne » en vallée d'Aspe (Pyrénées-Atlantiques). Remise en question d'un plutonisme ophitique danien dans le secteur de Bedous

In the Aspe Valley (western Pyrenees), the Europe/Iberia boundary corresponds to a complex fracturing zone, called the ‘Bielle–Accous Wrench-Faulting Corridor’, which represents the classical ‘North-Pyrenean Fault’. Located between the High Primary Range and the North-Pyrenean Zone, the BAWC shows different south-verging sheets mainly composed of Triassic materials. The Bedous ophite, associated with Muschelkalk and Keuper sediments, is also Triassic in age and involved in the same Pyrenean thrusting structures. So, contrary to a recent interpretation, this magmatic rock cannot be related to a supposed Danian plutonism inducing metamorphic processes in the surrounding Mesozoic formations. To cite this article: J. Canérot et al., C. R. Geoscience 336 (2004).     

美国"阳光带"的崛起对中国西部城市化战略的启示

美国西部开发以城市化为先导，中国西部大开发本质上也是西部城市化。西部大开发战略应以城市为中心组织与落实。本文通过透视美国“阳光带”城市崛起的历史，尤其是产业集群的成功经验，提出中国西部城市化战略实施中应将培育地方产业集群作为推动城市化的重要战略方式和地方重要的公共政策工具。     

Slow mass movement in the Kangchenjunga area, eastern Nepal Himalaya

Abstract   The rates of the accumulated and continuous displacement of solifluction lobes in the Kangchenjunga area, eastern Nepal Himalaya, were determined using glass fiber tubes and a strain probe. Ground temperature, precipitation and soil moisture were monitored at two sites, whose altitude differed by approximately 100 m, to understand the solifluction process. The average movement rate of the glass fiber tubes on a 31° slope at altitudes of 5412–5414 m a.s.l. was approximately 11 mm/year, being almost threefold greater than that observed on a 22° slope at 5322–5325 ma.s.l. There was no significant difference in the depth of displacement at these sites. The continuous displacement measurement near the ground surface at 5414 m showed permanent downslope movement from early July. Such movement may be attributed to additional moisture supply during the monsoon season. The amplitude of the displacement cycle was highest at the ground surface, and decreased to virtually zero at and below 20 cm in depth. Probable factors leading to the relatively slow rates of downslope displacement at the surface and depth at the studied altitudes are the lack of concurrence of the freeze–thaw cycles and the high moisture condition in the soil, and the low moisture retention capacity of the soil because of steep slopes and superficial desiccation. The rate of displacement may be more pronounced at altitudes above 5600 m because of the freeze–thaw cycles during the summer season.     

Grassland productivity in an alpine environment in response to climate change

Situated in a climatically stressful environment, alpine grassland is sensitive to subtle climate changes in its productivity. We remedy the current deficiency in studying grassland productivity by taking the integrated effect of all relevant factors into consideration. The relative importance of temperature, rainfall and evaporation to the alpine grassland productivity in western China was determined through analysis of their relationship with the normalized difference vegetation index (NDVI) between 1981 and 2000. Climate warming stimulated grassland productivity in the 1980s, but hampered it in the 1990s. Temperature is more important than rainfall to grassland productivity early in the growing season. However, their relative importance is reversed late in the growing season. Monthly summer month rainfall modified by maximum monthly temperature is a good predictor of alpine grassland productivity at 62.0 per cent. However, the best predictor is water deficiency, which is able to improve the estimation accuracy to 78.3 per cent. Hence, the impact of temperature on grassland productivity is better studied indirectly through evaporation.     

Environmental pollution impact on water and sediments of Kumaun lakes, Lesser Himalaya, India: a comparative study

A study of the water and sediment chemistry of the Nainital, Bhimtal, Naukuchiyatal and Sattal Lakes of Kumaun, has shown that the water of these lakes are alkaline and that electrical conductivity, total dissolved solid and bicarbonate HCO ₃ ⁻ are much higher in Nainital than in the other three lakes. The weathering of limestone lithology and anthropogenic pollution, the latter due to the very high density of population in the Nainital valley, are the primary sources of enhanced parameters. The low pH of Nainital Lake water is due to low photosynthesis and enhanced respiration, increasing CO₂ in the water and the consequent enhancement of Ca²⁺ and HCO ₃ ⁻ . The dissolved oxygen in Nainital Lake is less compared to other lakes, indicating anoxic conditions developing at the mud–water interface at depth. The PO ₄ ³⁻ content in Nainital is higher (124 μg/l), showing an increasing trend over time leading to eutrophic conditions. The trace metals (Cu, Co, Zn, Ni, Mn, and Sr) are present in greater amounts in the water of Nainital Lake than in the other three lakes, though Fe and Cr are high in Bhimtal and Fe in Naukuchiyatal. The higher abundance is derived from the leaching of Fe–Mg from metavolcanic and metabasic rocks. Most of the heavy metals (Cr, Ni, Cu, Mn, Fe, Sr, and Zn) significantly enrich the suspended sediments of the lakes compared to the bed sediments which due to their adsorption on finer particles and owing to multiple hydroxide coating and organic content, except for Fe, which is enriched in the bed sediments. The high rate of sedimentation, 11.5 mm/year in Nainital, compared to Bhimtal with 4.70 mm/year, Naukuchiyatal with 3.72 mm/year, and Sattal with 2.99 mm/year, has resulted in shorter residence time, poor sorting of grains, and lesser adsorption of heavy metals, leading consequently, their depletion in the bed sediments of Nainital Lake.     

Permo-Carboniferous Radiolarians from the Wupata＇erkan Group, Western South Tianshan, Xinjiang, China

The Wupata‘erkan Group, also called Wupata‘erkan Formation, distributed in the South Tianshan, Xinjiang,China, mainly consists of gray and dark gray fine-grained clastic rocks, interlayered with volcanic rocks, carbonates and cherts. Some ultra-basic rocks (blocks) punctuate the formation. The formation was variously assigned to Silurian-Middle Devonian, Silurian-Lower Devonian, and pre-Devonian, mainly based on Atrypa bodini Mansuy, Hypothyridina parallelepipedia (Brour.) and Prismatophyllum hexagonum Yoh collected from the limestone interlayers, respectively.However, radiolarian fossils obtained from 24 chert specimens of the Wupata‘erkan Group, mainly include Albaillella sp.cf. A. undulata Deflandre, Albaillella sp. cf. A. paradoxa Deflandre, Albaillella cf. A. deflandrei Gourmelon, Albaillella sp. cf. A. indensis Won, Albaillella sp. cf. A. excelsa Ishiga, Kito and Imoto, Albaillella sp. and Latentifistulidae gen. et. sp.indet., are earliest Carboniferous and Late Permian. The earliest Carboniferous assemblage is characterized by Albaillella sp. cf. A. undulata Deflandre, Albaillella sp. cf. A. paradoxa Deflandre, Albaillella cf. A. deflandrei Gourmelon and Albaillella sp. cf. A. indensis Won, and the Late Permian assemblage by Albaillella sp. cf. A. excelsa Ishiga, Kito and Imoto. This new stratigraphic evidence indicates that the Wupata‘erkan Group is possibly composed of rocks with different ages from Silurian to Permian, and therefore, it is probably an ophiolite mrlange. The discovery of Late Permian Albaillella sp. cf. A. excelsa provides more reliable evidence supporting the existence of a Permian relic ancient oceanic basin in the western part of Xinjiang South Tianshan.     

生态足迹模型在山区生态可持续评价中的初步应用--以1999年北京西部山区为例

在剖析生态足迹分析法的理论基础上，进一步考虑不同消费水平对生态足迹时空变异的影响，划分农村居民和城镇居民两类不同的消费群体，分别计算各自的生态足迹，其次进一步细化模型中人均水资源足迹，从而构建生态足迹与生态容量平衡模型。根据平衡模型计算出生态盈亏，得出区域生态持续性评价结果。并以1999年北京西部山区门头沟区为例，进行模型计算和生态可持续评价，结果表明1999年门头沟区处于生态赤字状态，说明该区生态系统处于不可持续状态。在对门头沟区的初步研究基础上，指出生态足迹作为山区生态可持续评价指标的优点及当前存在的缺点。     

Pressure and temperature conditions for crystallization of metamorphic allanite and monazite in metapelites: a case study from the Miyar Valley (high Himalayan Crystalline of Zanskar,NW India)

The textural and chemical evolution of allanite and monazite along a well‐constrained prograde metamorphic suite in the High Himalayan Crystalline of Zanskar was investigated to determine the P–T conditions for the crystallization of these two REE accessory phases. The results of this study reveals that: (i) allanite is the stable REE accessory phase in the biotite and garnet zone and (ii) allanite disappears at the staurolite‐in isograd, simultaneously with the occurrence of the first metamorphic monazite. Both monazite and allanite occur as inclusions in staurolite, indicating that the breakdown of allanite and the formation of monazite proceeded during staurolite crystallization. Staurolite growth modelling indicates that staurolite crystallized between 580 and 610 °C, thus setting the lower temperature limit for the monazite‐forming reaction at ~600 °C. Preservation of allanite and monazite inclusions in garnet (core and rim) constrains the garnet molar composition when the first monazite was overgrown and subsequently encompassed by the garnet crystallization front. Garnet growth modelling and the intersection of isopleths reveal that the monazite closest to the garnet core was overgrown by the garnet advancing crystallization front at 590 °C, which establishes an upper temperature limit for monazite crystallization. Significantly, the substitution of allanite by monazite occurs in close spatial proximity, i.e. at similar P–T conditions, in all rock types investigated, from Al‐rich metapelites to more psammitic metasedimentary rocks. This indicates that major silicate phases, such as staurolite and garnet, do not play a significant role in the monazite‐forming reaction. Our data show that the occurrence of the first metamorphic monazite in these rocks was mainly determined by the P–T conditions, not by bulk chemical composition. In Barrovian terranes, dating prograde monazite in metapelites thus means constraining the time when these rocks reached the 600 °C isotherm.