低空大比例尺地形图航测生产关键技术

针对传统航空摄影测量生产工艺在生产过程中遇到的影响大比例尺测图精度的问题,该文探讨了低空航测生产大比例尺地形图的关键技术。通过选用宽角相机、低航高飞行、强化影像匹配、野外布设标志控制点、优选平差模型、精化测图操作等改进方式,以提高大比例尺航测精度;组建无人飞艇低空航测系统,对提出的技术方法予以实现;最后给出了山西境内近30个县市建成区1∶500测绘生产实践的部分验证成果。     

The use of WorldView-2 satellite imagery to model urban drainage system with low impact development (LID) Techniques

Within a wide range of best management practices for stormwater management in urban areas, there has been an increasing interest in source control measures. Source controls such as low-impact development (LID) techniques are potentially attractive as retrofit options for older developed areas that lack available land to implement conventional measures such as stormwater management ponds. Hence, distributed urban drainage models requiring detailed representation of developed drainage areas should be developed to accurately estimate the benefits that LIDs may provide. This study (1) presents a two-stage classification process on a high-resolution WorldView-2 image, and (2) demonstrates how to use the extracted land cover information in the subsequent hydrologic modelling and assessment of different LIDs’ performance. The proposed two-stage classification method achieved an overall accuracy of 80.6%, whereas a traditional pixel-based achieved 68.4% in classifying the same urban area into six land cover classes. From the classification results, the hydrologic properties of micro-subcatchments were imported in the United States Environmental Protection Agency Storm Water Management Model to assess the performance of LIDs. A reduction of run-off volume 18.2% and 37.1% was found with the implementation of porous pavement and bioretention, respectively, in a typical low-rise residential area located in the city of San Clemente, California, US. The study demonstrates the use of high-resolution remote sensing image to aid in evaluating LID retrofit options, and thus benefits in situations where detailed drainage area information is not available.     

生态敏感性限制下的城市建设用地适宜性评价

针对当前城市规划中对建设用地适宜性评价框架的不尽合理问题,以河南省西峡县为例构建了包含主导性和限制性逻辑的综合评价方案。利用遥感与地理信息系统相结合的方法,将生态敏感性作为限制性因素进行城市建设用地适宜性研究。研究区的分析结果显示:西峡县整体新增城镇建设区呈现南北区域不适宜而中间适宜的特征,而适宜和较适宜城市建设的用地主要分布在鹳河及其支流形成的河谷地带。但在中心城区外缘某些区域生态敏感性强,应禁止开发活动。研究结果有效体现出建设用地和生态用地的空间格局,对城市总体规划具有一定的参考价值。     

Integrating cellular automata,artificial neural network,and fuzzy set theory to simulate threatened orchards: application to Maragheh,Iran

Urbanization processes challenge the growth of orchards in many cities in Iran. In Maragheh, orchards are crucial ecological, economical, and tourist sources. To explore orchards threatened by urban expansion, this study first aims to develop a new model by coupling cellular automata (CA) and artificial neural network with fuzzy set theory (CA–ANN–Fuzzy). While fuzzy set theory captures the uncertainty associated with transition rules, the ANN considers spatial and temporal nonlinearities of the driving forces underlying the urban growth processes. Second, the CA–ANN–Fuzzy model is compared with two existing approaches, namely a basic CA and a CA coupled with an ANN (CA–ANN). Third, we quantify the amount of orchard loss during the last three decades as well as for the upcoming years up to 2025. Results show that CA–ANN–Fuzzy with 83% kappa coefficient performs significantly better than conventional CA (with 51% kappa coefficient) and CA–ANN (with 79% kappa coefficient) models in simulating orchard loss. The historical data shows a considerable loss of 26% during the last three decades, while the CA–ANN–Fuzzy simulation reveals a considerable future loss of 7% of Maragheh’s orchards in 2025 due to urbanization. These areas require special attention and must be protected by the local government and decision-makers.     

Use of an inside buffer method to extract the extent of urban areas from DMSP/OLS nighttime light data in North China

Defense Meteorological Satellite Program (DMSP)/Operational Linescan System (OLS) nighttime imagery provides a valuable data source for mapping urban areas. However, the spatial extents of large cities are often overestimated because of the effect of over-glow from nighttime light if a fixed thresholding technique is used. In the work reported here, an inside buffer method was developed to solve this issue. The method is based on the fact that the area overestimated is proportional to the extent of the lit area if a fixed threshold is used to extract urban areas in a region/county. Using this method, the extents of urban areas in North China were extracted and validated by interpretations from Landsat Thematic Mapper images. The results showed that the lit areas had a significant linear relationship with the urban areas for 120 representative cities in North China in 2000, with an R² value of over 0.95. This demonstrates that the inside buffer method can be used to extract urban areas. The validation results showed that the inside buffer model developed in 2000 can be directly used to extract the extent of urban areas using more recent nighttime light imagery. This is of great value for the timely updating of urban area databases in large regions or countries.     

Effect of sensor modelling methods on computation of 3-D coordinates from Cartosat-1 stereo data

The orbital and the rational polynomial coefficients (RPC) models are the two most commonly used models to compute a three-dimensional coordinates from an image stereo-pair. But it is still confusing that with the identical user provided inputs, which one of these two models provides more accurate digital elevation model (DEM), especially for mountainous terrain. This study aimed to find out the answer by evaluating the impact of used models on the vertical accuracy of DEM extracted from Cartosat-1 stereo data. We used high-accuracy photogrammetric DEM as the reference DEM. Apart from general variations in statistics, surprisingly in a few instances, both the DEMs provided contrasting results, thus proving the significance of this study. The computed root mean square errors and linear error at 90% (LE90) were lower in case of RPC DEM for various classes of slope, aspect and land cover, thus suggesting its better relative accuracy.     

The effects of the North Anatolian Fault on the geomorphology in the Eastern Marmara Region,Northwestern Turkey

North-western Anatolia has been actively deformed since Pliocene by the right-lateral North Anatolian Fault (NAF). This transform fault, which has a transtensional character in its western end due to effects from the Aegean extensional system, is a major control on the regional geomorphologic evolution. This study applied some geomorphic analyses, such as stream longitudinal profiles, stream length-gradient index, ratio of valley floor width and valley height, mountain front sinuosity, hypsometry and asymmetry factor analyses, to an area just east of the Sea of Marmara in order to understand the tectonic effects on the area’s geomorphological evolution. The active and fastest northern branch of the NAF lies within a topographic depression connecting Sea of Marmara in the east to the Adapazar? Basin in the west. This depression filled with early Pleistocene and younger sediment after a series of pull-apart basins opened along the NAF. North of this depression lies the Kocaeli Peneplain, whose southern edge the NAF uplifted. Meandering streams on the central peneplain were incised possibly due to baselevel changes in the Black Sea. South of the depression, an E-trending mountainous area has a rugged morphology. Based on geomorphic analyses, uplifted Pliocene sediment, marine terraces, and recent earthquake activity, this area between northern and southern branches of the NAF is actively uplifting. The geomorphic indices used in this study are sensitive to vertical movements rather than lateral ones. The bedrock lithology that played an important role on the area’s geomorphologic evolution also affects the geomorphic indices used here.     

Influence of urban expansion on the urban heat island effect in Shanghai

The urban heat island (UHI) effect resulting from rapid urbanization is attracting increasing attention among the global scientific community. This research analyzed the relationship between urban expansion and the UHI effect utilizing an integrated approach, including urban land interpretation and retrieving land surface temperature based on remote sensing, and spatial overlay analysis for revealing the relationship for different time periods between 1984 and 2014 in Shanghai, China. The results show that (1) the spatiotemporal changes in UHI are consistent with the expansion of urban land, and rapid urban expansion leads to an expansion of the UHI, in particular along roadways. (2) The mode of urban expansion is an important factor influencing the UHI effect. Urban sprawl (urban expansion in the edge-expansion way) is a form of typical expansion that leads to the rapid increase in the UHI. When the urban compactness ratio is less than 0.15, a compact design can effectively control the expansion rate of the UHI and mitigate its range of influence and intensity. However, when the urban compactness ratio is greater than 0.15, the urban design has a marked influence on the UHI ratio index: a more compact form produces a stronger UHI effect. So, finding an equilibrium between urban compactness ratio and urban expansion rate is good for effective urban management and planning.     

Emerging Chinese Cities: Implications for Global Urban Studies

Chinese cities are emerging in multiple senses: They have created new physical spaces to accommodate the fast urbanization of the country but have also developed new properties and characteristics along with urban transformation. The novelty created by emerging cities in China is not easily covered by Western urban theory. This article examines the dynamism of Chinese urban transformation, especially political economic changes vis-à-vis so-called neoliberalism, and spatial outcomes as diverse and contrasting spaces of formality and informality. Finally, this article speculates on implications for global urban studies.     

Visualising 30 Years of Population Density Change in Australia’s Major Capital Cities

ABSTRACT

This study uses a novel spatial approach to compare population density change across cities and over time. It examines spatio-temporal change in Australia’s five most populated capital cities from 1981 to 2011, and documents the established and emerging patterns of population distribution. The settlement patterns of Australian cities have changed substantially in the last 30 years. From the doughnut cities of the 1980s, programs of consolidation, renewal and densification have changed and concentrated population in our cities. Australian cities in the 1980s were characterised by sparsely populated, low density centres with growth concentrated to the suburban fringes. ‘Smart Growth’ and the ‘New Urbanism’ movements in the 1990s advocated higher dwelling density living and the inner cities re-emerged, inner areas were redeveloped, and the population distribution shifted towards increased inner city population densities. Policies aimed at re-populating the inner city dominated and the resultant changes are now visible in Australia’s five most populated capital cities. While this pattern has been reported in a number of studies, questions remain regarding the extent of these changes and how to analyse and visualise them across urban space. This paper reports on a spatial method which addresses the limitations of changing statistical boundaries to identify the changing patterns in Australian cities over time and space.