以SRTM-DEM为控制的光学卫星遥感立体影像正射纠正

针对全球测图缺少统一的控制基准的问题,提出了利用SRTM-DEM作为控制基准,对光学卫星遥感影像进行正射纠正的方法。首先,对光学卫星影像构建的立体影像对进行自由网平差并制作DEM;然后,以SRTM-DEM作为控制,将DEM作为单元模型,进行独立模型法DEM区域网平差,获得单元模型的定向参数;最后,改正立体影像的成像几何模型参数,进行正射纠正。选取湖北咸宁和江西某地两个测区的资源三号数据进行试验,试验结果表明,资源三号正视全色影像的平面定向精度由12.93像素提高到6.85像素。     

运用社交网络分析淹水空间信息之关联性

随着社交网络的普遍发展,大量的讯息透过智能手机发布在个人的微博或其他社交网站。台湾地区的社交网站以脸书(Facebook)的使用量最大,平均每天有近千万笔的讯息量,大多数的讯息多以食衣住行或个人讯息为主,但从本研究所撷取自2010年至2015年的数据中显示,公众在社交网站所分享的信息中具有降雨、淹水或相关灾情的讯息,而这些讯息具有极高比例的正确性。由于社交网站无法提供私人讯息,故本研究将从社交信息中,以地点为单位撷取大量的数据信息再辅以语意关键词萃取出有关可作为淹水预判的讯息数据。为检核资料的可性度,本研究透过历史台风数据FLO-2D仿真重建淹水之空间信息进行检核。从研究比对分析中发现,经萃取后的公众信息其与灾害的关联性及正确性相当显着,故透过社交网站中大量的非结构讯息,透过语意及空间的转换,可萃取转化为防灾信息,对广域的都市治理而言,此一讯息将可作为预判区域淹水或防救灾情报之有效参考。     

Laboratory Simulation of the Formation Process of Surface Geochemical Anomalies Applied to Hydrocarbon Exploration

The formation mechanisms and processes of geochemical anomalies used as proxies in surface geochemistry exploration (SGE) have not been well understood. Previous studies cannot realize 3D measurement of microseeping hydrocarbons from reservoirs to the surface, which made it difficult to understand the features and pathways of deep hydrocarbon microseepages. Understanding the processes of hydrocarbon microseepages will contribute to the acceptance and effectiveness of surface geochemistry. Based on a simplified geological model of hydrocarbon microseepages, including hydrocarbon reservoir, direct caprock, overlying strata and Quaternary sediments, this work established a 3D experimental system to simulate the mechanisms and processes of deep hydrocarbon microseepes extending to the surface. The dispersive halos of microseeping hydrocarbons in the subsurface were adequately described by using this 3D experimental system. Results indicate that different migration patterns of hydrocarbons above the point gas source within the simulated caprock and overlying strata can be reflected by the ratio of i-butane to n-butane (i-C4/n-C4), which follow diffusion and infiltration (buoyancy) mechanisms. This is not the case for vertical measurement lines far from the point gas source. A vertical gas flow in the form of a plume was found during hydrocarbon microseepage. For sampling methods, the high-density grid sampling is favorable for delineating prospecting targets. Hydrocarbon infiltration or buoyancy flow occurs in the zones of infiltration clusters, coupling with a diffusion mechanism at the top of the water table and forming surface geochemical anomalies. These results are significant in understanding hydrocarbon microseepage and interpreting SGE data.     

直线型海洋重力仪负漂移原因分析及处理

分析了直线型KSS31M(SN035)海洋重力仪短期负漂移现象的原因、采取的处理措施和经验总结,认为在减震措施不足的情况下,重力仪长期经受震动,而频繁的搬动会使重力仪弹性系统中的金属弹簧产生较大的弹性疲劳,这种影响在短时间内无法完全消除,由此可能导致月漂移超标;陀螺稳定平台轴因承受震动磨损较严重,轴承间隙变大,导致安装在平台之上的重力传感器经过抛物线测试之后不能完全垂直指向地心,重力在水平方向存在一个微小的分量,最终导致重力读数偏小,即短期负漂移;重力基点环境的变化等对漂移也有一定的影响。建议在搬动重力仪后将仪器保持足够长时间的恒温后再开机,密切监测一段时间,以确保仪器处于良好的工作状态。     

定点式声学多普勒流速仪的应用难点与误差分析

定点式声学多普勒流速仪(简称"HADCP")在国内已较为普及,但对其应用却多停留在表面,鲜有人研究其测验误差控制及参数优化方法,影响HADCP测流精度。为解决HADCP使用中的一些疑难问题,从流速仪测验误差表现的三方面对HADCP的测流误差开展讨论。以测验误差为控制指标,对HADCP在使用中各个环节的误差来源及应用难点进行分析,并以多个实例阐明提高仪器应用精度的优化设置方法。按照所论及方法进行对照检查并合理优化,可减小测流误差,提高HADCP测流方案的整体精度。     

新型抗高温二次交联凝胶堵漏材料的研制

针对普通凝胶抗温能力较差难以适用于高温地层堵漏作业的问题,通过设计合成抗高温凝胶主剂GN-1并运用二次交联技术,研发了新型抗高温凝胶堵漏材料。优选配方为：淡水+1.5%GN-1+0.15%地面交联剂+1%井下交联剂+0.2%抗氧化剂。通过热滚老化与高温流变测试相结合的手段对凝胶抗温能力进行评价。结果表明,该凝胶材料具有良好的热稳定性,在180 ℃下老化24 h后,7.34 s-1下剪切粘度＞10000 mPa?s。大幅加重后180 ℃老化24 h仍能保持较好的粘弹性。此外还考察了不同温度和pH值下的成胶性能以及与聚磺钻井液体系的配伍性,为抗高温凝胶堵漏材料在现场的应用奠定基础。     

Why GPS makes distances bigger than they are

Global navigation satellite systems such as the Global Positioning System (GPS) is one of the most important sensors for movement analysis. GPS is widely used to record the trajectories of vehicles, animals and human beings. However, all GPS movement data are affected by both measurement and interpolation errors. In this article we show that measurement error causes a systematic bias in distances recorded with a GPS; the distance between two points recorded with a GPS is – on average – bigger than the true distance between these points. This systematic ‘overestimation of distance’ becomes relevant if the influence of interpolation error can be neglected, which in practice is the case for movement sampled at high frequencies. We provide a mathematical explanation of this phenomenon and illustrate that it functionally depends on the autocorrelation of GPS measurement error (C). We argue that C can be interpreted as a quality measure for movement data recorded with a GPS. If there is a strong autocorrelation between any two consecutive position estimates, they have very similar error. This error cancels out when average speed, distance or direction is calculated along the trajectory. Based on our theoretical findings we introduce a novel approach to determine C in real-world GPS movement data sampled at high frequencies. We apply our approach to pedestrian trajectories and car trajectories. We found that the measurement error in the data was strongly spatially and temporally autocorrelated and give a quality estimate of the data. Most importantly, our findings are not limited to GPS alone. The systematic bias and its implications are bound to occur in any movement data collected with absolute positioning if interpolation error can be neglected.     

大地电磁测深（MT）与土壤氡气测量在涡阳地区地热勘查中的应用

为了研究涡阳地区深部构造和热源条件,在高炉镇附近进行了大地电磁测深(MT)测量和土壤氡气测量工作。通过对大地电磁测深结果和土壤氡气浓度异常分布范围分析和解释,指导区内地热勘查工作。通过资料解释,基本查明区内构造的走向及其垂向延展特征,查明基底起伏变化情况并了解深断裂的控制性,预测地热成矿区有利地段。研究证明,利用MT与土壤氡气测量对隐伏断裂位置和地热异常具有较好的指示意义。     

浮托安装进船过程中护舷碰撞力实测研究

浮托安装法广泛应用于大型组块海上安装。导管架平台上部组块浮托安装进船过程中,风、浪、流引起的浮托驳船横向运动造成浮托驳船与导管架桩腿的碰撞,碰撞力可能会对导管架结构造成损伤。陆丰7-2上部组块浮托安装中,为了监测碰撞力大小,设计了碰撞力海上监测系统。通过在导管架外侧四个桩腿上安装光纤光栅应变传感器对碰撞过程中导管架桩腿进行应力监测,进而计算碰撞力。对碰撞过程,载荷作用位置、方向进行简化,并对载荷大小及垂向作用位置对计算的影响进行了研究。结构分析模型简化后,测点von-Mises应力与碰撞力大小成正比,对导管架整体结构建模计算并取局部结构计算比例系数,结合应力实测数据计算出进船过程中驳船对导管架桩腿碰撞力。     

Evaluation of Effective Depth of PVD Improvement in Soft Clay Deposit: A Field Case Study

This article presents a case history of determination of effective depth of prefabricated vertical drains (PVDs) under embankment loading on a very soft clay deposit in central China, near Jiujiang, Jiangxi Province. The height of the embankment was 5.3 m and construction time was about one year. The PVDs were installed to a depth of 8.5 m at a spacing of 1.5 m in a triangular pattern. Field observations and the finite element method (FEM) were employed to analyze the performance of the soft deposit during embankment construction. The influential depth of the embankment loading was evaluated based on settlement, excess pore pressure, and stress increase in subsoil, both from the observed data and FEM analysis. The effective PVD depth was determined in the following ways: (1) the depth of 5% subsoil settlement of surface settlement; (2) vertical stress increase in subsoil of 25% in-situ stress; and (3) consolidation time/PVD depth relation by FEM. Based on the analysis, the effective depth of PVDs was determined to be between 10 and 12.8 m for this field case.