基于UDF的水平轴潮流能水轮机被动旋转水动力性能研究

针对水平轴潮流能水轮机被动旋转问题,基于Fluent 17.0,运用UDF(User Defined Function)控制滑移网格对网格进行动态调整,仿真研究水轮机在不同安放角下被动旋转的水动力特性。通过仿真分析,结果表明:潮流能水轮机随着叶片安放角度的增加,尖速比、输出功率、捕能系数都是先增大后减小,叶片安放角为6°时,叶轮前后速度差最大,对潮流能利用充分,且各项性能均达到最佳;通过分析叶片受力,叶尖叶素在安放角为2°时阻力最大,3°时升力最大,升阻比在6°时最大,此时叶尖叶素升阻比C_L/C_D=6.27、攻角α=3.06°。由仿真结果可知水平轴潮流能叶轮的自启动过程由5个阶段组成,即加速度增大的加速运动段—加速度减小的加速运动段—加速度反向增大的减速运动段—加速度反向减小的减速运动段—稳定运行段,这对潮流能水轮机的设计具有重要的指导意义。     

An experimental study on water entry of asymmetric wedges

The aim of the paper is to provide an experimental reference for investigation of asymmetric water entry of wedges. Parameters of the study include initial deadrise angle, inclination angle and impact speed. Initial deadrise angles of the wedges were 20° and 30° with inclination angles ranging from 0° to 15° in 5° increments. Wedges were freely fallen from three different heights. Time histories of impact pressure and body acceleration were recorded. Sampling rate of measurements were set to 25 KHz. Main configuration of each test including mass of the wedge and water level were kept unchanged during all experiments. Additionally, several calibration tests were conducted to assess the repeatability and accuracy of the recorded data. The experimental results are compared with different entry theories and other available experiments. The comparison shows a reasonable agreement and indicates that the inclination angle can dramatically affect the impact pressure experienced by the wedges. Finally, the results show that the traditional asymmetric theories are not appropriate for all inclination angles.     

Principal stress rotation and cyclic shear strength for an elliptical rotation stress path

Based on the analytical solutions for wave-induced soil response in an unsaturated anisotropic seabed of finite thickness, an elliptical, i.e., noncircular rotation stress path is proven to be a more common state in a soil element with the cyclic shear stresses due to the traveling linear wave. The influence of an elliptical stress path on the characterization of failure strength is analyzed using three new parameters representing the shape, size, and the orientation of the ellipse. A series of cyclic rotational shear tests on the reconstituted specimens of Chinese Fujian Standard Sand have been performed to investigate the effect of elliptical stress path. A strength function in term of failure cycles is derived to quantify the failure strength of a given sand within a seabed subjected to regular wave loading. The results provide a basis for the evaluation of liquefaction potential of seabed but also point to a unique backbone cycle shear strength curve for soil under principal stress rotation.     

小入射角下海浪后向散射系数不对称性和各向异性分析验证

基于北京遥测技术研究所机载波谱仪实测数据以及ECMWF提供的风场数据,分析了不同风速条件下小入射角海浪平均后向散射系数不对称性与各向异性随入射角的变化特性,并对导致这一现象的原因进行了初步分析。结果表明:小入射角下,海浪平均后向散射系数随入射角增大呈现递减趋势并在18°时达到某一稳定值,之后基本维持不变;海浪后向散射系数不对称性与各向异性均随入射角增大呈现递增趋势,同样在18°增大至某一稳定值,之后基本维持不变;低风速条件下,海浪不对称性和各向异性与风速有关,且风速越大不对称性与各向异性越明显。     

Large tectonic movement of the Japan Arc in late Cenozoic times inferred from paleomagnetism: Review and synthesis

Abstract Paleomagnetic studies facilitate an understanding of the evolution of the Japan Arc in Cenozoic times from the perspective of tectonic movement. The Japan Arc rifted from the Asian continent in the middle Miocene, while East Asia, including the Japan Arc, moved northward at the same time. The rifting phenomenon of the Japan Arc is described by differential rotation of Southwest and Northeast Japan. Southwest Japan was rotated clockwise through about 45° and Northeast Japan was rotated counter-clockwise through about 40°. This differential rotation occurred concurrently at about 15 Ma. Eighty percent of the rotation was completed during a period of 1.8 million years. These factors lead us to propose a'double door'opening mode with a fast spreading rate of 21 cm/yr for the evolution of the Japan Sea, suggesting that the asthenosphere with a low viscosity was injected beneath the Japan Sea area. The large northward motion of East Asia in relation to Europe is expected from the apparent polar wander path constructed from the paleomagnetic data of the Japan Arc. East Asia may have moved northward by more than 1700 km between 20 Ma and 10 Ma accompanied by a slightly clockwise rotation of 10°. The eastern part of the Eurasian plate was subjected to extreme geodynamic conditions in late Cenozoic times.     

以夹角调制的矢量地图可逆水印算法

传统水印嵌入方法往往导致原始载体数据质量的下降,而可逆水印技术由于能完整恢复原始载体数据,因此,在精度要求较高的矢量地图版权保护应用中具有较高的适用性。目前,栅格图像的可逆水印算法研究较为成熟,而在矢量地图领域则主要借鉴栅格图像的相关方法,由于没有充分利用矢量数据的组织特性,因此鲁棒性不强。针对上述问题,本文以矢量地图坐标点之间的基本空间关系在常规地图操作前后的不变性,提出一种鲁棒的矢量地图可逆水印算法。算法首先利用道格拉斯—普克方法将要素点分为特征点与非特征点两类,在此基础上计算每个非特征点与其相邻前后特征点连线所构成的夹角。在水印嵌入时,利用该夹角来映射水印比特位,并通过调整非特征点坐标来对该夹角进行调制以实现水印信息的嵌入。实验表明该算法所生成的水印具有一般可逆水印的不可感知性与可逆性,同时,对旋转、平移、要素排序、裁剪、压缩、简化等攻击也具有较好的鲁棒性。     

贵州平坝榜上煤矿矿山环境影响分区研究

为准确划定矿山环境影响范围,有效地开展矿山环境保护与综合治理,促进矿山可持续发展,本文在详细分析贵州平坝榜上煤矿矿山环境现状存在问题的基础上,运用采掘活动过程中的安全开采深度、移动角、边界角和地下水均衡原理等理论．系统地分析和计算了榜上煤矿矿山环境影响的几类不同范围：利用上山移动角确定地质灾害危险性大区,采用边界角确定井下开采影响范围,运用“大井法”圈出疏排水影响范围。依据矿山环境问题类型影响程度．相应地划分为严重区、较严重区和较轻区等3类,并给出具体量化指标。     

Effects of backfill on seismic behavior of rectangular tanks

The reliability and/or stability of the lifeline structures against failure under seismic loads are of critical concern, and must be studied carefully. Therefore, the main objective of this paper is to demonstrate the commonly encountered backfill effects on the dynamic response of rectangular tanks. However, only the exterior wall of the tank which interacts with both the backfill and fluid is tackled, as each part of the structure shows considerable differences in terms of both the load bearing mechanisms and the geometrical and positional differences. Finite element analyses are employed, taking into consideration the fluid-wall-backfill interaction. The analyses are conducted to observe whether or not both backfill and wall behavior can be affected by variation of the internal friction angle. For that purpose, some comparisons are made on vertical displacements of the backfill, roof displacements, stress responses, etc., by means of internal friction angle variations of the backfill from 25° to 40°. Consequently, it is observed that the variations on maximum vertical displacements are affected considerably. In contrast, the maximum stress responses are affected partially. However, the inertial effects of the backfill show that pseudo-static approximations may be insufficient to understand the dynamic behavior of the backfill-wall-fluid system.     

桶形基础平台吊耳的设计及其应用

分析了桶形基础平台吊耳设计和施工过程中出现的问题及其原因,提出了导管架平台外侧吊耳的设计方案.