基于高光谱Hyperion数据的线性光谱混合模型与神经网络模型的比较

混合像元问题是定量遥感中的热点问题之一,为了改进从遥感数据中提取定量信息,人们建立了各种混合光谱分解技术,其中线性光谱混合模型和神经网络模型就是两种比较成熟的方法。以陕西省横山地区的高光谱Hyperion数据为研究基础,通过最小噪声变换(MNF)、像元纯度指数(PPI)转换和RMS误差分析的迭代方法相结合提取影像中的纯净像元作为终端端元。分别运用神经网络模型和线性光谱混合模型对影像进行光谱分解,得到各个组分的分解图像。以标准植被指数(NDVI)影像为衡量标准,选取训练样本点,分别对两种模型进行回归分析,结果显示NDVI影像与线性光谱混合模型植被分解图像的判定系数(R2=0.91)要大于其与神经网络模型的判定系数(R2=0.81)。进一步分析表明在一般情况下,线性光谱混合模型具有比神经网络模型略高的分离精度,但是神经网络模型对细部信息的提取的效果要好于线性光谱混合模型,最后提出了端元均方根误差(EAR)指数,一种新的混合像元分解的思路。     

重金属污染胁迫下盐肤木的生化效应及波谱特征

利用遥感生物地球化学的原理和方法,分析了德兴铜矿的重金属污染状况和植物盐肤木的生物地球化学效应,对盐肤木生物地球化学效应的波谱特征进行了系统的提取和分析.研究发现酸、铜、镉等是德兴铜矿地区主要的环境污染因子,野外调查及样品的化验分析表明盐肤木对铜元素呈现一定的富集作用和很强的位移效应,是适合铜矿复垦的植被.利用导数光谱、包络线去除、红边效应、植被指数等光谱信息处理方法对盐肤木的野外波谱分析表明,随着叶片中Cu等金属元素含量的增大,其产生的毒化效应的波谱特征越明显,盐肤木叶片光谱反射率明显升高,波形蓝移,红边陡坡斜率增大,叶绿素吸收深度变浅,吸收中心稍有蓝移,水的吸收深度变浅,吸收中心位置红移,绿度指数变化明显.对波谱特征及其与重金属含量的相关关系综合分析后认为,红边特征、植被指数NDVI、叶绿素吸收深度与叶片铜含量关系显著,可以作为植被铜污染遥感图像特征提取的参考.     

水平井含水率上升影响因素

利用塔里木油田塔中4油田(TZ4)底水油藏相关的地质、流体数据建立数值模型。在所建模型的基础上,应用数值模拟计算的累积产油、产水和产液量回归俞启泰水驱特征曲线,以反映水平井见水特征的参数b。以参数b为研究对象,采用正交试验的方法研究不同因素对b值的影响,筛选影响水平井见水特征的主要因素,认为原油粘度、油层厚度、非均质性及水平井水平段在油藏中的位置是影响水平井含水上升趋势的主要指标。最后建立主要因素与b值的关系式,结合俞启泰曲线b值图版,提出预测水平井见水规律的公式——图版法(F-b法)。应用F-b法对塔里木水平井含水率进行预测,并与其他相关方法及实际生产数据对比,认为F-b法可作为预测塔里木油田水平井含水率、估算可采储量的一种有效方法。     

火山沉积岩及其矿床研究中伽马测井曲线解释的误区

根据酸性凝灰岩和酸性火山事件粘土岩的自然伽马测井曲线,对当前流传的"沉积岩层的放射性强度(或放射性核素的含量)随泥质含量的增加而增高"的概念和用自然伽马值及经验公式求泥质含量提出质凝。酸性凝灰岩的自然伽马曲线有高异常响应,若解释为泥岩显然是误解,故将沉积岩伽马曲线高异常一律解释为泥岩是片面的。各类火山事件粘土岩的伽马值相差悬殊,但其泥质含量几乎相等,用它们的伽马值计算泥质含量误差甚大。最后对铝土矿层的伽马曲线稍加解释,指出核测井应用的远景。     

New basin modelling results from the Polish part of the Central European Basin system: implications for the Late Cretaceous–Early Paleogene structural inversion

Combined subsidence and thermal 1D modelling was performed on six well-sections located in the north-western Mid-Polish Trough/Swell in the eastern part of the Central European Basin system. The modelling allowed constraining quantitatively both the Mesozoic subsidence and the magnitude of the Late Cretaceous–Paleocene inversion and erosion. The latter most probably reached 2,400 m in the Mid-Polish Swell area. The modelled Upper Cretaceous thickness did not exceed 500 m, and probably corresponded to 200–300 m in the swell area as compared with more than 2,000 m in the adjacent non-inverted part of the basin. Such Upper Cretaceous thickness pattern implies early onset of inversion processes, probably in the Late Turonian or Coniacian. Our modelling, coupled with previous results of stratigraphic and seismic studies, demonstrates that the relatively low sedimentation rates in the inverted part of the basin during the Late Cretaceous were the net result of several discrete pulses of non-deposition and/or erosion that were progressively more pronounced towards the trough axis. The last phase of inversion started in the Late Maastrichtian and was responsible for the total amount of erosion, which removed also the reduced Upper Cretaceous deposits. According to our modelling results, a Late Cretaceous heat-flow regime which is similar to the present-day conditions (about 50 mW/m²) was responsible for the observed organic maturity of the Permian-Mesozoic rocks. This conclusion does not affect the possibility of Late Carboniferous–Permian and Late Permian–Early Triassic thermal events.     

Coalification in Carboniferous sediments from the Lötschberg base tunnel

Vitrinite reflectance (Rr), proximate analysis and carbon isotope composition (δ¹³C) have been used to characterise coal samples from two zones of Late Carboniferous sediments (Gastern and Ferden) in the Aar massif where they are penetrated by the Lötschberg base tunnel (constructed between 1999 and 2005). Samples are characterised by variable ash yields (21.7–93.9%; dry basis); those with ash yields of less than ~50% and with volatile matter content (V;dry ash-free basis) within the limits 2 < V% ≤ 8 are anthracite. Values of Rr range from 3.89% to 5.17% and indicate coalification to the rank of anthracite and meta-anthracite in both Gastern and Ferden Carboniferous zones. Samples of anthracite and shale from the Gastern Carboniferous exhibit a relatively small range in δ¹³C values (–24.52‰ to –23.38‰; mean: –23.86‰) and are lighter than anthracite samples from the Ferden Carboniferous (mean: –22.20‰). The degree of coalification in the Gastern and Ferden Carboniferous zones primarily depends on the maximum rock temperature (T) attained as a result of burial heating. Vitrinite reflectance based estimates of T range from ~290° –360 °C. For a proposed palaeogeothemal gradient of 25 ° C/km at the time of maximum coalification the required overburden is attributable to relatively thin autochtonous Mesozoic/Cenozoic sedimentary cover of the Aar massif and Gastern granite and deep tectonic burial beneath advancing Helvetic, Ultrahelvetic and Prealpine (Penninic) nappes in Early Oligocene to Miocene.     

Using Sequential Self-Calibration Method to Identify Conductivity Distribution: Conditioning on Tracer Test data

An iterative inverse method, the sequential self-calibration method, is developed for mapping spatial distribution of a hydraulic conductivity field by conditioning on nonreactive tracer breakthrough curves. A streamline-based, semi-analytical simulator is adopted to simulate solute transport in a heterogeneous aquifer. The simulation is used as the forward modeling step. In this study, the hydraulic conductivity is assumed to be a deterministic or random variable. Within the framework of the streamline-based simulator, the efficient semi-analytical method is used to calculate sensitivity coefficients of the solute concentration with respect to the hydraulic conductivity variation. The calculated sensitivities account for spatial correlations between the solute concentration and parameters. The performance of the inverse method is assessed by two synthetic tracer tests conducted in an aquifer with a distinct spatial pattern of heterogeneity. The study results indicate that the developed iterative inverse method is able to identify and reproduce the large-scale heterogeneity pattern of the aquifer given appropriate observation wells in these synthetic cases.     

松辽盆地宋芳屯油田扶杨油层孔隙结构及其影响因素

通过镜下观察,宋芳屯油田扶杨油层孔隙类型较多,以粒间孔为主。细管压力曲线上看,曲线较陡,分选差,孔隙结构特征参数总体上较差,与孔隙度、渗透率有一定的关系,大的孔隙对渗透率的贡献最大。扶杨油层的孔隙结构较复杂主要由于成岩作用影响,压实作用使孔隙空间显著缩小,胶结作用和自生粘土矿物生长使孔隙进一步缩小和复杂化,后期的溶蚀作用使孔隙空间增加。     

饱和软土压缩曲线的“反常”现象

饱和软土压缩试验时,经常出现压缩曲线“反常”、压缩系数“倒大”的现象。它是土的原始结构发生破坏前后的不同压缩性的客观反映。饱和软土的结构力很微弱,唯质量好的原状土才能见到这种“反常”。应从成孔、取样、测试及资料整理等多个环节保证其工程意义。