Simulation of artificial random field considering the temporal-spatial variation

Introduction For the seismic design of special structures such as nuclear power station, marine platform, long-span bridge and dam, generally the time-history response analysis of the structure under seismic excitation is imperative, which was coded in most seismic design codes. The earthquake records suitable for the seismic situation and site condition are necessary to be used as the seismic input in the dynamic analysis of structures. As a result of the limited observational condition of st…     

To afforest the desert with the technology of peat composed of rotten mosses and the sustainable development of the oases

Only by providing the good conditions for the growth of plants can a favorable ecologicalenvironment on which human beings rely for existence be created. The upside-down-T dou-ble-layer water-conserving afforestation way is developed according to the situation of the short-age of water resources, low soil fertility and vast land in the arid areas. The characteristics of theafforestation way are to change the microenvironment in the root area of the plants, provide thefavorable conditions for the growth of plants, and reduce the necessary conditions for the growth ofplants in large areas in the arid regions. Meanwhile, the size of its water-conserving layer can bechanged according to the size of the planted trees. The different ways of the bottom wa-ter-conserving layer can be used according to the requirements. The afforestation way is suitablefor planting trees on a small scale and also for afforesting on a large scale under the adverse cir-cumstances in the arid areas, and has been effectively used in the afforestation in the hinterland ofTaklamakan Desert and the southern marginal zone of Gurbantonggut Desert. The prospects ofthe afforestation way are broad in afforestation and desertification control in the desert regions.     

螺旋CT三维重建在骨盆骨折中的应用

目的：探讨用螺旋CT三维重建评价骨盆骨折的临床应用价值。方法：收集骨盆骨折17例，采用螺旋CT三维重建检查。结果：17例检查均取得清晰立体图像，且可消除某一骨性结构，单独观察骨盆某一组成骨的骨折情况。结论：螺旋CT三维重建在骨盆骨折的诊断、手术方案的设计及教学等有较高价值。     

地震前兆时空非均匀性指标Cv值的实验检验

在双向加载条件下，对两种构造和介质不同的岩石标本进行变形实验，测量了标本表面不同部位的应变．在此基础上，利用王晓青和陈学忠等提出的描述地震前兆非均匀分布的参量————Cv值，分析了标本变形失稳过程中应变异常的分布，以期从实验角度检验Cv值方法并探讨其物理意义．研究表明，Cv值的变化与岩石变形特征的变化有关，是描述前兆分布非均匀性的一种有效指标；Cv值在失稳发生前先异常上升，然后下降，并在Cv值恢复过程中或恢复后伴随着失稳事件的发生．因此，Cv值是一种有效的预报指标．      

新疆伽师强震群区的横波分裂与应力场特征

利用在新疆伽师地区布设的流动台阵记录到的地方震波形数据,研究了伽师强震群附近各台站横波分裂现象,给出了相应的快波偏振方向的平面场分布. 发现在台阵的塔里木盆地一侧,波偏振方向为近SN向,与塔里木盆地的区域主压应力方向一致,但在塔里木盆地北部边缘的褶皱变形带内,快波偏振方向变为近EW向,特别是在柯坪断裂附近,快波偏振方向与阿图什地震的震源断层方向基本一致. 由于快波偏振方向平行于主压应力方向,给出的快波偏振方向反映了相应的主压应力场特征. 结果表明,伽师强震群的成因很可能是塔里木盆地北缘横向非均匀变形造成的局部张性剪切应变能的释放.     

Bedrock structure in Adapazari, Turkey—a possible cause of severe damage by the 1999 Kociaeli earthquake

The 1999 Kocaeli earthquake brought serious damage to downtown of Adapazari. To study why strong motions were generated at the town, a bedrock structure was investigated on the basis of Bouguer gravity anomaly, and SPAC and H/V analyses of microseisms. It was revealed that, the basin consists of three narrow depressions of bedrock with very steep edges, extending in E–W or NE–SW directions along the North Anatolia faults, and the depth to bedrock reaches 1000 m or more. Downtown of Adapazari is located 1–2 km apart from the basin-edge. It is considered that, the specific configuration of bedrock amplifies ground motions at the downtown area by focusing of seismic waves and/or interference between incident S-waves and surface-waves secondarily generated at the basin-edge. Studying 3D bedrock structure is an urgent issue for microzoning an urban area in a sedimentary basin.     

Melting of β-quartz up to 2.0 GPa and thermodynamic optimization of the silica liquidus up to 6.0 GPa

Melting relations of β-quartz were experimentally determined at 1.0 GPa (1900±20 °C), 1.5 GPa (2033±20 °C), and 2.0 GPa (2145±20 °C) using a new high-pressure assembly in a piston–cylinder apparatus and substantial differences were found with data previously reported. The new melting data of β-quartz were combined and optimized with all available thermodynamic, volumetric, and phase equilibria data for β-cristobalite, β-quartz and coesite to produce a P–T liquidus diagram for silica valid up to 6.0 GPa. Using the new optimized thermodynamic parameters, the invariant point β-cristobalite+β-quartz+liquid and β-quartz+coesite+liquid were determined to lie at 1687±17 °C and 0.457 GPa, and 2425±25 °C and 5.00 GPa, respectively.     

Optimal placement of dampers and actuators based on stochastic approach

A general method is developed for optimal application of dampers and actuators by installing them at optimal location on seismic-resistant structures. The study includes development of a statistical criterion, formulation of a general optimization problem and establishment of a solution procedure. Numerical analysis of the seismic response in time-history of controlled structures is used to verify the proposed method for optimal device application and to demonstrate the effectiveness of seismic response control with optimal device location. This study shows that the proposed method for the optimal device application is simple and general, and that the optimally applied dampers and actuators are very efficient for seismic response reduction.     

结构振动控制的半主动磁流变质量驱动器(MR-AMD)

本文首先提出了一种新型的半主动磁流变质量驱动器（MR－AMD），该装置用磁流变驱动器替代AMD的液压驱动系统；其次采用所提出的半主动控制算法仿真分析了MR－AMD用于结构振动控制的有效性；第三，比较了半主动质量驱动器（MR－AMD）、调谐质量阻尼器（TMD）及主动质量驱动器（AMD）对同一模型结构的控制效果。分析结果表明，MR－AMD作为一种半主动质量驱动器有效地降低了结构的反应，其控制效果虽然不如具有相同质量块参数的AMD但却优于TMD，且同AMD一样具有较宽的有效频带范围。     

海洋平台结构振动的AMD主动控制参数优化分析

本文针对海洋平台结构的冰激振动和地震反应控制问题，提出了采用AMD主动控制的控制策略，结合JZ20－2MUQ平台结构进行了AMD控制系统的硬参数和软参数的优化分析，并就相应于最优参数下的AMD控制海洋平台结构冰激振动和地震反应的几种代表性工况进行了时程分析，得到了一些定性和定量的结论，为实际工程的控制设计提供了基础。本文提出的AMD主动控制方法对类似的海洋平台结构的控制问题也有参考价值。