西南三江地区矿产资源遥感综合预测方法

详细阐述了矿产资源遥感综合预测方法的工作程序、控矿要素的数字化分析与遥感找矿模型的建立,以及遥感矿产的综合分析评价方法与应用等,并以西南三江中段遥感综合预测成果佐证了矿产资源遥感综合预测方法在矿产资源预测中能使野外调查工作更具预见性和目的性,从而大大缩短了矿产资源调查的工作周期。     

多因素复杂系统最佳因素权重确定的一种新思路——以深港西部通道工程深圳湾公路大桥为例

为了客观地反映各因素对目标问题的影响程度,本文首次提出了最佳因素权重概念。定义最佳因素权重为研究区域内系统质量处于极限状态时的各因素权重之组合。结合深港西部通道工程深圳湾公路大桥桥址比选方案,详细说明了本方法的研究思路及其确定方法。通过最佳因素权重方法,能客观地、定量地确定出多因素复杂系统中的最优场址。     

GPS-measured land subsidence in Ojiya City, Niigata Prefecture, Japan

Land subsidence caused by compression of clay layers in Ojiya City, Japan was measured by global positioning system (GPS) between 1 April 1996 and 31 December 1998.

Three baselines were selected in and around the city, and height difference on a WGS-84 ellipsoid was measured by GPS on each baseline. The ground at the GPS station in the city subsides and rebounds 7 cm every winter and spring, respectively. Measurement accuracy was 9.5 mm standard deviation. Ground water level was observed at a well near the GPS station. Regression analysis between total strain, calculated as ratio of the height difference displacement to the total thickness of the clay layers, and the layers' effective stress change with ground water level change gave good correlation. The slope of regression line 7.0×10⁻¹¹ m²/N was obtained as an average apparent coefficient of volume compressibility of the layers.     

Digital model of corrected accumulated flow for peak discharge data acquisition and drainage system design

The design of a drainage system for a roofing slate quarry was implemented by the enhancement of discharge peak estimation, and the uncertainty inevitably associated with the engineering model was reduced.

The development of a topographical, geological, and vegetation cover database developed from a Geographical Information System (GIS) allowed for the definition of the drainage network for a hydraulic system, along with the calculation of the runoff coefficient. This is applied to the digital model of accumulated flow (DMF) as a weight correction coefficient, using a matrix-based model at 5×5 m resolution. The new digital model of corrected accumulated flow (DMCF) is the result of combining the thematic maps with the map of slope <3%, which was previously created from the slope model. It is demonstrated that this new model allows to apply the “Rational Method” on cartographic units defined by the GIS.

The DMCF is compared with other traditional applications of the Rational Method based on the calculation of the discharge peak considering: (1) the drainage basin as a single watershed or (2) defining an average runoff coefficient in each sub-watershed. Both approaches have bigger discharge peaks than those obtained by the DMCF since the slope, lithology, and vegetation cover have average values, and the runoff coefficient is poorly defined, increasing the uncertainty in the discharge peak.     

An experimental investigation of LNAPL migration in an unsaturated/saturated sand

Accidental spills of hydrocarbons, such as Light Non-Aqueous Phase Liquids (LNAPLs), are one of the most common sources of subsurface contamination. Migration of LNAPL in a porous medium is influenced by various factors such as the number of fluids present in the unsaturated/saturated zones and the proportion of pores occupied by each fluid. The results for relationship between matric suction and degree of saturation are presented in this paper for water–air, water–LNAPL and LNAPL–air systems in a sand. A simple and reliable setup using Buchner funnel was designed to obtain these relations. It was found that the relationship between matric suction head and degree of saturation is hysteretic for all the fluid systems (water–air, water–LNAPL and LNAPL–air). Furthermore, the amount of hysteresis depended upon the fluid system, with the maximum hysteresis occurring for water–air system. The results suggest that the amount of trapped air depends upon the reversal degree of saturation from drying to wetting.     

Process of Housing Damage Assessment: The 1995 Hanshin-Awaji Earthquake Disaster Case

Rebuilding of victims' livelihoods was a crucial issue in the restoration process in the1995 Hanshin-Awaji Earthquake Disaster. Housing damage assessment influencedmost of the rebuilding of the livelihood in the long term, because the Victim Certificatesissued by the local governments based on the results of the Housing damage assessmentwas required to receive most of the individual assistance measures. In the process ofHousing damage assessment, many complex problems arose, leading to extensivework on the part of the disaster responders. Consequently, a considerable number ofvictims were dissatisfied with the assessment and applied for a resurvey. Due to a floodof requests for resurvey, disaster responders had to work on damage assessment, leavingrelief activities aside.In order to facilitate Housing damage assessment, this paper discusses thefollowing five points: (1) the processes and the problems of assessments performedin the Hanshin-Awaji Earthquake Disaster, (2) the changes in the nature of informationneeded by the victims, (3) the improvements over the present damage assessment, (4)the housing situation in Japan, and (5) the international situation on damage assessment.It is obvious from the results that a poor damage assessment system and the size ofthe disaster produced a very large work load. Differences in appreciation among theinvestigators also contributed to unfair assessments and led to the victims beingincreasingly dissatisfied by the survey results. Finally, a design concept for acomprehensive damage assessment system, which has been derived from theabove five points, is proposed for post-disaster management.     

Use of Geomorphological Information in Indirect Landslide Susceptibility Assessment

The objective of this paper is to evaluate the importance of geomorphological expert knowledge in the generation of landslide susceptibility maps, using GIS supported indirect bivariate statistical analysis. For a test area in the Alpago region in Italy a dataset was generated at scale 1:5,000. Detailed geomorphological maps were generated, with legends at different levels of complexity. Other factor maps, that were considered relevant for the assessment of landslide susceptibility, were also collected, such as lithology, structural geology, surficial materials, slope classes, land use, distance from streams, roads and houses. The weights of evidence method was used to generate statistically derived weights for all classes of the factor maps. On the basis of these weights, the most relevant maps were selected for the combination into landslide susceptibility maps. Six different combinations of factor maps were evaluated, with varying geomorphological input. Success rates were used to classify the weight maps into three qualitative landslide susceptibility classes. The resulting six maps were compared with a direct susceptibility map, which was made by direct assignment of susceptibility classes in the field. The analysis indicated that the use of detailed geomorphological information in the bivariate statistical analysis raised the overall accuracy of the final susceptibility map considerably. However, even with the use of a detailed geomorphological factor map, the difference with the separately prepared direct susceptibility map is still significant, due to the generalisations that are inherent to the bivariate statistical analysis technique.     

Magnetotelluric Investigation of the Hydrothermal System and Heat Source in the Muine-Toyoha Geothermal Area, Hokkaido, Japan

Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area.     

小湾电站高边坡系统锚固与排水的优化设计方法

据小湾电站地下厂房进水口开挖高边坡的岩体结构与工程地质特征,采用基于结构面网络模拟的随机楔体稳定分析方法对边坡的稳定性进行了三维分析。进一步运用风险分析理论对边坡系统锚杆与预应力锚索的布置进行了优化设计,最后运用结构面网络模拟理论对排水方案进行了优化设计。     

Regional Fault Systems of Qaidam Basin and Adjacent Orogenic Belts

The purpose of this paper is to analyze the regional fault systems of Qaidam basin and ad-jacent orogenic belts. Field investigation and seismic interpretation indicate that five regional fault sys-tans occurred in the Qaidam and adjacent nment.qin belts, controlling the development and evolution of the Qaidam basin. These fault systems are: (1)north Qaidam-Qilian Mountain fault system; (2) south Qaidam-East Kunhm Mountain fault system;（3）Altun strike-slip fault system; (4) Elashan strike-slip fault system, and (5) Gansen-Xiaochaidan fault system. It is indicated that the fault systems controlled the orientation of the Qaidam basin, the formation and distribution of secondary faults within the basin,the migration of depocenters and the distribution of hydrocarbon accmnulation belt.