Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.     

中国海区区域地质编图中重磁图的编制方法

本文简要介绍了局控项目《中国海区１∶５０万区域地质编图（大连幅）》重力异常图、磁力异常图的编制过程，给出了一种以计算机为手段、实现编图自动化的新方法，并分析了该方法与以往编图方法的不同和优点，以国际分幅在中国海区开展区域地质编图尚属首次，在既无海区地质调查规范，又无海区地质调查编图规范的情况下，这一工作无异具有开创性。从理论上系统总结出一套切实可行的编图方法，对于编制中国海区区域地质调查编图规范以     

走航测深数据的自动采集

本文介绍应用IBM微机实现走航实时水深及定位数据的自动采集系统。给出了联机系统方框图及采集、传送数据的程序流程图。并对IBM-PC/XT微机与测深仪之间的接口、数码转换和数据处理作了简要的叙述。     

北太平洋宽吻海豚正常生理指标数值的算法

连续5年对青岛海豚表演馆中北太平洋宽吻海豚(Tursiops gille Dall)进行现场实验和行为学研究，获取了大量的生理指标数据，运用不同的分析和计算方法对所得数据进行了筛选、剔除及处理，确立了海豚各生理指标的正常闽值和范围确定的方法，从而为准确了解海豚机体的生理状况、疾病诊断及治疗奠定了基础。     

关于胶莱盆地东南缘基性火山熔岩喷发时代上限的讨论

首次对采自青岛即墨WN部两个深钻孔中新鲜玄武岩样品进行Rb-Sr同位素测年,测定年龄值为65.77±13.6Ma。认为该年龄值代表了胶莱盆地东南缘基性火山熔岩喷发的时代上限,对于整个胶莱盆地中基性火山岩的划分和对比具重要的年代学意义。     

埕岛油田数据基础重组及开发应用

从数据管理及后期应用的角度提出了数据平台的要领，讨论了该数据平台的物理结构、逻辑结构，在分类与组织的基础上给出了相应的数据字典。同时，还基于该平台探讨了测井曲线库及图形库的建设方法，并实现了具体功能。     

动态基准实时测量系统的开发与应用

介绍了动态基准实时测量系统的硬件组成、站点上全站仪棱镜组合安装与检测方法、系统软件的开发及特点，最后对系统在广州地铁某地铁站结构变形自动监测中的应用情况进行了阐述。通过实际应用表明该系统能应用在自动化、高精度的变形监测领域。     

自动海洋站数据接收与处理软件的功能及特点

采集设备采集数据发送到值班PC机，在无人干预的情况下接收处理软件自动对数据进行回放和进一步处理，为用户提供数据产品和服务，并提供一个界面，使用户能够了解系统的运行状况，获得相关数据和状态参数。