Underice Operation of SJT-5 ROV

- The authors have used a low-cost ROV of observation type for underice surveying of the Nen-Jiang Cross-river oil pipe line in the Da Qing oil field. The operation method, process and the safety measures for severe cold areas are presented. The fruitful tries and experience may be useful to ROV operators in severe cold areas.     

Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

Long-range underwater photography in the deep ocean

Although the optical properties of seawater at extreme depths are more suitable for underwater photography than those at the surface or on continental shelves, they still impose severe limitations on long-range wide area bottom photography. Additionally, deep ocean operations impose technical limitations on control, power and bandwidth. This chapter reviews the approaches contemplated or made towards improving the camerato-target range in underwater photography in the deep ocean. Further significant improvements await advances in control, power/light sources and bandwidth reduction. With the developments now contemplated, TV and video systems will eventually present a strong challenge to emulsion film techniques.     

Application of Microbial BOD Sensors in Marine Monitoring

A strain of yeast, which can endure high osmotic pressure, is employed for the sensitive material of the microbial BOD sensor. Two immobilization methods are used, I.e. Calcium alginate gel be ads and PV A gel beads. The results show that the PVA gel beads is better. The influences of osmosis and heavy metal ions on the yeast entrapped in the PVA gel beads are also studied in the experiment.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

1999年以来台湾及邻近海域7.5级以上强震前的条带现象

中国台湾地区地处欧亚板块与菲律宾海板块之间,地震活动频繁．本文报道了 我国台湾地区及其邻近海域1985～2002年间5．5级以上地震的条带内外频度比分 布,并着重研究了1999—2002年中发生的3次7．5级以上地震前的条带现象．其结 果表明:台湾地区近期发生的3次7．5级以上大地震前,5．5级以上地震呈条带分 布．这些条带符合条带内地震个数Nin≥6的条件,符合条带内、外频度比Nin／(Nin Nout)≥75％的条件,也符合条带长宽比大于5的要求,只是与板内地震条带相比,条 带的长度较短．     

氮磷营养盐与有机汞联合作用对微氏海链藻生长的影响

探讨在高营养盐（氮、磷、硅分别为浮游植物生长的营养盐阚值≥40、50、9倍）条件下，氮浓度及氮磷摩尔比值[n（N）／n（P）]变化、汞（甲基汞和乙基汞）对微氏海链藻（Thalassiosira weissflogii）生长的影响。结果表明，高营养盐区海链藻的生长遵循营养盐限制的唯一因子论；氮浓度和氮磷比提高促进生长，当n（N）／n（P）=64则呈抑制效应；生长初期，甲基汞和乙基汞均产生毒性抑制作用，生长中后期，适量甲基汞（浓度≤1．0μg／L）、乙基汞（浓度≤0．5μg／L）却呈兴奋效应，促进生长；汞形态不同，剂量-效应关系不同。氮和有机汞是海链藻生长的刺激因子。适度有机汞污染与氮富营养化对微氏海链藻的生长产生协同效应。