可调节经线收敛度和经纬线间隔的伪圆柱投影

令纬度ψ<,j>转换为ψ<,j>后,中央经线方程用一个ψ<,j>的7次幂方程表示,中央经线方程的系数关联着纬线间隔.令经度λ<,i>转换为ξ<,i>后,赤道方程用一个ξ<,i>的7次幂方程表示,赤道方程的系数关联着经线间隔.经线的收敛度由经线方程的收敛系数调节.由此构建可调节经线收敛度和经纬线间隔的伪圆柱投影.用一实例...     

陇中和鲁西南乡村居民对当地气候变化感知研究

基于问卷调查、气温和降水资料等气象资料以及农业灾害资料,分析甘肃省会宁县和山东省单县乡村居民对当地气候变化感知情况,探讨影响感知的因素.研究发现,绝大部分受访者在大部分情况下正确感知到气候变化,但感知及其影响因素较复杂.气候变化及其产生的影响是制约人们感知的最重要的要素,决定了感知的总体特征;感知也受相较调查时间而言较...     

全球链网下的欠发达地区产业集群化研究——以韶关汽车零部件产业为例

全球链网下的地方产业集群,已成为区域经济发展的重要组织形式。欠发达地区产业集群的形成与发展是特色资源、产业基础、创新文化、政策激励和市场驱动对地方化和全球化两股力量“粘滞—集聚—再粘滞—再集聚”的循环积累结果。针对韶关资源丰富、产业基础厚实,但空间粘滞作用不强、产业集群化程度低的现状,认为韶关汽车零部件产业应走“立足资源,一园三片;精细专工,错位发展”的特色集群化道路。     

广东“18.8”季风槽极端降水事件对流尺度集合预报分析

受季风槽影响,2018年8月30—31日华南地区出现一次极端暴雨过程,单日站点累计降水量达1?056.7 mm,刷新了广东有历史纪录以来新的极值。对于此次极端降水事件,常用的业务模式包括欧洲中期天气预报中心全球模式（ECMWF）、日本气象厅谱模式（JMA）和中国气象局广东快速更新同化数值预报系统（CMA-GD）,都低估了降水强度。利用深圳市气象局业务对流尺度集合预报系统分析了此次特大暴雨过程,结果表明：对流尺度集合预报系统对本次特大暴雨过程具有比较好的预报能力,概率匹配平均最大雨量达348.7 mm·(24 h)-1,集合平均的强降水中心和观测基本一致,观测极值附近区域发生大暴雨（≥150 mm）概率最大值达到80%。选取了较“好”和较“差”集合成员预报进行对比分析,发现较“好”成员预报的强降水中心位置和观测基本一致,而较“差”成员预报的降水中心位置则偏向福建地区。较 “好”成员预报出莲花山南侧地面中尺度辐合线较长时间的维持和缓慢移动,导致强降水雨团在莲花山脉附近不断地触发和维持,同时地形的阻挡作用使得对流系统在地形附近区域持续维持,造成了罕见的特大暴雨;而较“差”成员辐合区位于莲花山以北,对流形成后向东、向北移动,最终导致强降水预报位置偏向福建地区。     

黔北一次下击暴流事件成因及雷达回波特征分析

利用地面自动站资料、探空资料、多普勒雷达观测资料以及ERA5逐时再分析资料对2021年5月15日发生在黔北的一次下击暴流事件成因及雷达回波特征进行分析。结果表明：（1）本次过程发生在500hPa槽前、西南低涡南侧、中低空急流北侧和地面锋前热低压内的大范围上升区内,地面辐合线是重要的触发机制。（2）大气为上干下湿不稳定状态,中等到强的垂直风切变维持,环境温度垂直递减率较大,低层有冷空气入侵,下沉气流接地时与周围大气形成10℃以上的温差,导致气流强烈辐散最终产生大风。（3）过程由多单体风暴引发,具有弓形回波、三体散射长钉、回波悬垂等结构特征,回波核强度在65dBz以上,大风出现时强回波核迅速降落。（4）大风发生前,风暴前侧有一支由前向后的斜升气流与后侧入流气流形成中层径向辐合（MARC）,大风出现时,低层有小尺度辐散区域,随后辐散尺度扩大,风速切变减小,大风强度减弱。     

Plate-driven extension and convergence along the East Gondwana active margin: Late Silurian–Middle Devonian tectonics of the Lachlan Fold Belt,southeastern Australia

The Lachlan Fold Belt of southeastern Australia developed along the Panthalassan margin of East Gondwana. Major silicic igneous activity and active tectonics with extensional, strike-slip and contractional deformation have been related to a continental backarc setting with a convergent margin to the east. In the Early Silurian (Benambran Orogeny), tectonic development was controlled by one or more subduction zones involved in collision and accretion of the Ordovician Macquarie Arc. Thermal instability in the Late Silurian to Middle Devonian interval was promoted by the presence of one or more shallow subducted slabs in the upper mantle and resulted in widespread silicic igneous activity. Extension dominated the Late Silurian in New South Wales and parts of eastern Victoria and led to formation of several sedimentary basins. Alternating episodes of contraction and extension, along with dispersed strike-slip faulting particularly in eastern Victoria, occurred in the Early Devonian culminating in the Middle Devonian contractional Tabberabberan Orogeny. Contractional deformation in modern systems, such as the central Andes, is driven by advance of the overriding plate, with highest strain developed at locations distant from plate edges. In the Ordovician to Early Devonian, it is inferred that East Gondwana was advancing towards Panthalassa. Extensional activity in the Lachlan backarc, although minor in comparison with backarc basins in the western Pacific Ocean, was driven by limited but continuous rollback of the subduction hinge. Alternation of contraction and extension reflects the delicate balance between plate motions with rollback being overtaken by advance of the upper plate intermittently in the Early to Middle Devonian resulting in contractional deformation in an otherwise dominantly extensional regime. A modern system that shows comparable behaviour is East Asia where rollback is considered responsible for widespread sedimentary basin development and basin inversion reflects advance of blocks driven by compression related to the Indian collision.     

Evidence for Early Miocene wrench faulting in the Marlborough Fault System,New Zealand: structural implications

Abstract

In New Zealand, the Marlborough strike-slip faults link the Hikurangi subduction zone to the Alpine fault collision zone. Stratigraphic and structural analysis in the Marlborough region constrain the inception of the current strike-slip tectonics.

Six major Neogene basins are investigated. Their infill is composed of marine and freshwater sediments up to 3 km thick; they are characterised by coarse facies derived from the basins bounding relief, high sedimentation rates and asymmetric geometries. Proposed factors that controlled the basins generation are the initial geometry of the strike-slip faults and the progressive strike-slip motion. Two groups of basins are presented: the early Miocene (23 My) basins were generated under wrench tectonics above releasing-jogs between basement faults. The late Miocene (11 My) basins were initiated by halfgrabens tilted along straighter faults during a transtensive stage. Development of faults during Cretaceous to Oligocene times facilitated the following propagation of wrench tectonics. The Pliocene (5 My) to current increasing convergence has shortened the basins and distorted the Miocene array of faults. This study indicates that the Marlborough Fault System is an old feature that connected part of the Hikurangi margin to the Alpine fault since the subduction and collision initiation. © Elsevier, Paris     

频率域偶层位曲面位场处理和转换方法研究

在空间域偶层位法的基础上,研究了完整的频率域偶层位曲面位场处理和转换方法.该法可应用于平面或曲面、规则网或非规则网的位场数据处理和转换.通过对偶层面z坐标和计算面z坐标平移不同的量来加速正演快速收敛和保证反演稳定、快速收敛;提出了适合于不规则网曲面处理和转换的核心算法——单点快速Fourier变换;提出了频率域不规则网曲面处理和转换方法技术.通过以上技术措施解决了大数据量特别是曲面不规则网的位场处理和转换问题,模型试算以及实际资料处理验证了该方法的应用效果.     

改进的等参逆变换算法在耦合场分析中的应用

实际工程有限元计算中涉及多个物理场的相关分析或耦合分析时场变量之间的数据传递问题非常重要,往往会遇到等参逆变换的需求。分析并指出现有等参逆变换所存在问题,给出了新的改进算法,即在网格内采用新方法进行等参逆变换,在网格外采用距离加权法进行插值传递,并详细说明本算法实施关键。对一大型拱坝施工过程中的温度场和应力应变场耦合分析问题进行研究,结果表明所提出方法具有简便实用、高效和满足工程精度等特点,可应用于实际工程。     

探地雷达测量近地表含水量的研究

为充分验证探地雷达方法用于测量近地表含水量的有效性和可靠程度,基于探地雷达的反射波法,根据介电常数、电磁波传播速度和含水量三者之间的关系,着重分析了探地雷达反射波法用于测量含水量的相关理论和特点,设计了适用于高频雷达信号的速度分析算法,建立了用于分析该问题的局部含水层模型。利用FDTD方法模拟分析了不同测量方式下,局部含水层的探地雷达响应,借助速度分析理论及Topp公式,反演得到了研究区域的含水量。