城市非点源污染负荷估算研究

针对污染地表水环境的城市径流污染源,利用SCS降雨径流模拟建立了城市径流不同土地利用类型径流系数与年降雨量的相关关系,其相关性显著;在不同降雨强度条件下,对典型示范区城市排污口实施降雨过程监测,获得了有代表性的城市径流污染物平均浓度,从而估算出辽宁省城市径流污染负荷总量。     

武汉市科教区冬春季气溶胶的元素组成特征及来源分析

2006-2007年冬春季在武汉市湖北大学校区连续采集气溶胶样品,测定气溶胶元素组成,分析气溶胶样品总悬浮颗粒物（TSP）质量浓度,再结合污染源的特征元素组成来确定污染物的来源构成。结果表明：湖北大学校区大气气溶胶污染程度较轻,气溶胶元素以地壳元素为主,其次是具有代表性的人为污染物元素,再次是盐类元素。通过因子载荷分析和相关性分析显示,湖北大学周边地区的建筑源、交通源和餐饮源是湖北大学校区大气的主要污染源。     

青藏高原牧区大雪期间的水汽和热量平衡

本文通过对１９９６年１月青藏高原牧区大雪期间的水汽和热量收支的计算，分析了大雪期间对流活动的作用和贡献，并与其他地区夏季暴雨期间的能量平衡进行了比较。结果表明，二者都只有一个无辐散层和整层维持上升运动，不同的是降雪期间：１）视水汽汇气柱平均潜热加热率要小得多；２）视水汽汇和视热源的垂直分布差异较大；３）次网格尺度涡动垂直输送主要发生在对流层顶附近     

史灌河流域水量平衡研究

建立了一个水量平衡模型,并用1998、1999年淮河流域能量和水循环试验(HUBEX)期间获得的史灌河流域(HUBEX水文试验区)加密观测资料来率定模型中的参数.结论表明:(1)水量平衡的要素计算合理;(2)梅山、鲇鱼山、蒋集土壤含水量的平均值系列基本上反映了流域蓄水量的变化过程;(3)流域蓄水量的衰减系数、蒸发能力的折算系数比较稳定,不应通过调整这些系数来实现水量平衡.     

基于自动观测站的鲁中地区土壤水分变化规律及精细化预报模型的研究

为了建立鲁中地区土壤水分精细化预报模型,利用2010—2013年农田土壤水分自动站逐日资料进行土壤水分年、月变化特征研究,并结合附近自动气象站资料,以土壤水分平衡方程、农田蒸散模型为基础,采用逐步回归和曲线估计等方法建立4—6月无降水条件下平原水浇田与山旱田土壤水分1 d、7 d降幅的经验预报模型。结果表明:鲁中地区0~100 cm土壤水分贮存量年变化趋势和0~50 cm基本一致,年最高出现在8月,最低出现在6月,年降幅最大出现在3—6月,易出现干旱。对预报模型进行回代和预报检验结果显示,回代平均相对误差为0.07%,7 d模型和1 d模型滚动预报第7天0~50 cm土壤水分贮存量,绝对误差分别为-0.15和-2.17 mm,平均相对误差分别为-0.07%和-1.56%,模型具有较强的理论基础和实用性,预报精度较高,为鲁中地区土壤墒情监测和精细化预报提供支持。     

Estimation of turbulent sensible heat and momentum fluxes over a heterogeneous urban area using a large aperture scintillometer

The accurate determination of surface-layer turbulent fluxes over urban areas is critical to understanding urban boundary layer (UBL) evolution. In this study, a remote-sensing technique using a large aperture scintillometer (LAS) was investigated to estimate surface-layer turbulent fluxes over a highly heterogeneous urban area. The LAS system, with an optical path length of 2.1 km, was deployed in an urban area characterized by a complicated land-use mix (residential houses, water body, bare ground, etc.). The turbulent sensible heat (Q H) and momentum fluxes (τ) were estimated from the scintillation measurements obtained from the LAS system during the cold season. Three-dimensional LAS footprint modeling was introduced to identify the source areas ("footprint") of the estimated turbulent fluxes. The analysis results showed that the LAS-derived turbulent fluxes for the highly heterogeneous urban area revealed reasonable temporal variation during daytime on clear days, in comparison to the land-surface process-resolving numerical modeling. A series of sensitivity tests indicated that the overall uncertainty in the LAS-derived daytime Q H was within 20%-30% in terms of the influence of input parameters and the non-dimensional similarity function for the temperature structure function parameter, while the estimation errors in τ were less sensitive to the factors of influence, except aerodynamic roughness length. The 3D LAS footprint modeling characterized the source areas of the LAS-derived turbulent fluxes in the heterogeneous urban area, revealing that the representative spatial scales of the LAS system deployed with the 2.1 km optical path distance ranged from 0.2 to 2 km2 (a "micro-α scale"), depending on local meteorological conditions.     

Energy Balance Of A Sparse Coniferous High-Latitude Forest Under Winter Conditions

Measurements carried out in Northern Finland on radiation and turbulent fluxes over a sparse, sub-arctic boreal forest with snow covered ground were analysed. The measurements represent late winter conditions characterised by low solar elevation angles. During the experiment (12–24 March 1997) day and night were about equally long. At low solar elevation angles the forest shades most of the snow surface. Therefore an important part of the radiation never reaches the snow surface but is absorbed by the forest. The sensible heat flux above the forest was fairly large, reaching more than 100 W m^-2. The measurements of sensible heat flux within and above the forest revealed that the sensible heat flux from the snow surface is negligible and the sensible heat flux above the forest stems from warming of the trees. A simple model for the surface energy balance of a sparse forest is presented. The model treats the diffuse and direct shortwave (solar) radiation separately. It introduces a factor that accounts for the shading of the ground at low solar elevation angles, and a parameter that deals with the partial transparency of the forest.Input to the model are the direct and diffuse incoming shortwave radiation.Measurements of the global radiation (direct plus diffuse incoming shortwaveradiation) above the forest revealed a considerable attenuation of the globalradiation at low solar elevation. A relation for the atmospheric turbidity asfunction of the solar elevation angle is suggested. The global radiation wassimulated for a three month period. For conditions with a cloud cover of lessthan 7 oktas good agreement between model predictions and measurementswere found. For cloud cover 7 and 8 oktas a considerable spread can beobserved. To apply the proposed energy balance model, the global radiationmust be separated into its diffuse and direct components. We propose a simpleempirical relationship between diffuse shortwave and global radiation asfunction of cloud cover.     

金沙江下游梯级水库运行后三峡水库高洪水期入库水沙特性

泥沙淤积问题直接影响着三峡水库的使用寿命及综合效益的发挥,研究其入库水沙特性对于解决水库泥沙淤积问题具有重要意义。根据水文站实测数据,分析了三峡水库入库水沙输移特性及来源组成变化,重点研究了金沙江下游梯级水库运行后的三峡水库高洪水期入库水沙特性。结果表明:2003—2021年,三峡水库入库泥沙集中于汛期的高洪水期,2013年以后该现象更为显著,泥沙来源也由金沙江为主转变为嘉陵江为主。寸滩站洪峰流量高于50000 m³/s的高洪水期三峡入库沙量显著大于30000～50000 m³/s区间的高洪水期,三峡水库泥沙调度关键在于上游发生编号洪水期间。三峡水库上游沱江或嘉陵江等支流发生流域性大洪水时,易引起高洪水期入库水沙出现“小水大沙”的特点。金沙江下游梯级水库运行后,三峡水库高洪水期入库泥沙大幅减少,中小洪水调度期间泥沙淤积量也大幅减小。研究结果可为三峡水库的泥沙精细化调度和长期高效使用提供基础数据支撑。     

Observational estimation of heat budgets on drifting ice and open water over the Arctic Ocean

It is of major scientific interests to determine the parameters of momentum, heat and vapor exchange in the planetary boundary layer in order to study the effects of ocean-ice-atmosphere interactions and their feedback mechanisms on global climate[1]. Lin…     

Meso-scale testing and development of test procedures to maintain mass balance

The Conrad Blucher Institute for Surveying and Science (Texas A&M University––Corpus Christi) has conducted numerous petroleum experiments at the Shoreline Environmental Research Facility (Corpus Christi, Texas, USA). The meso-scale facility has multiple wave tanks, permitting some control in experimental design of the investigations, but allowing for real-world conditions. This paper outlines the evolution of a materials balance approach in conducting petroleum experiments at the facility. The first attempt at a materials balance was during a 1998 study on the fate/effects of dispersant use on crude oil. Both water column and beach sediment samples were collected. For the materials balance, the defined environmental compartments for oil accumulation were sediments, water column, and the water surface, while the discharge from the tanks was presumed to be the primary sink. The “lessons learned” included a need to quantify oil adhesion to the tank surfaces. This was resolved by adhering strips of the polymer tank lining to the tank sides that could be later removed and extracted for oil. Also, a protocol was needed to quantify any floating oil on the water surface. A water surface (oil slick) quantification protocol was developed, involving the use of solid-phase extraction disks. This protocol was first tested during a shoreline cleaner experiment, and later refined in subsequent dispersant effectiveness studies. The effectiveness tests were designed to simulate shallow embayments which created the need for additional adjustments in the tanks. Since dispersant efficacy is largely affected by hydrodynamics, it was necessary to scale the hydrodynamic conditions of the tanks to those expected in our prototype system (Corpus Christi Bay, Texas). The use of a scaled model permits the experiment to be reproduced and/or evaluated under different conditions. To minimize wave reflection in the tank, a parabolic wave dissipater was built. In terms of materials balance, this design reduced available surface area as a sink for oil adsorption.