显式完全平方守恒差分格式在近岸海流数值模拟中的应用

用显式完全平方守恒差分格式及其改进分解算法对南海月平均流和海面起伏进行了数值模拟，与隐式完全平方守恒差分格式相比，计算时间可省３—５倍，具有良好的时间效益，而且，其计算效果不比隐式完全平方守恒差分格式差。因此，显式完全平方守恒差分格式及其改进分解算法具有良好的实用价值。     

海道测量定位数据后处理的拟合算法研究

根据海道测量定位数据后处理的要求,对定位数据后处理中的拟合算法进行了研究,提出了一种基于多面函数拟合的后处理方法,并给出了相应的数学模型。实例结果表明,后处理中采用多面函数拟合法处理测线定位数据可提高定位数据的可靠性,拟合精度可将精密动态定位控制在厘米级。上述方法有利于提高海道测量中海上定位成果的质量。     

Local and landscape effects on spatial patterns of mangrove forest during wetter and drier periods: Moreton Bay,Southeast Queensland,Australia

Land use/cover and mangrove spatial changes were assessed for ten sites and their sub-catchments in Southeast Queensland, Australia. Two time periods were involved: 1972–1990, a period of relatively high rainfall, and 1990–2004, which was significantly drier. Aerial photographs and Landsat satellite imagery were used to map the inter-tidal wetlands and classify the land use/cover in the sub-catchments. A Maximum Likelihood Classification was used to map three types of land cover: agriculture, built-up and plantation forest. Mangroves (mainly Avicennia marina) were the focus as they have been recorded over recent decades encroaching into salt marsh. The Mangrove-Salt marsh Interface (MSI) Index was developed to quantify the relative opportunity for mangroves to expand into salt marshes, based on the shared boundary between them. The index showed a consistent relationship with mangrove expansion and change. To address problems of high dimensionality and multi-collinearity of predictor variables, a Partial Least Squares Regression (PLSR) model was used. A key finding of this research was that the contribution of environmental variables to spatial changes in the mangroves was altered following a reduction in rainfall. For example, agriculture had more influence on mangrove expansion and change during the wet period than during the dry period.     

杭州湾中部实测波浪特性分析

利用杭州湾中部一年实测波浪资料,分析该地区的波参数统计变化特性,采用最小二乘法拟合得出相关参数之间的关系式,并统计分析了频谱特性。结果表明:杭州湾中部以小浪和轻浪为主,在各月分布较为均匀,年平均周期为2.97 s;最大一次波浪过程为冷空气影响所致,影响强度大于台风莫拉克;常浪向分布在东北至东南向,其中又以小浪出现较多,对应的波周期以2~4 s为主;强浪向主要分布在西北和东北方向,对应的波周期主要分布在3~5 s;多数特征波参数之间相关关系较好;由谱分析得知风浪占多数,且以单峰为主。研究结果可为相关工程和理论研究提供基础资料。     

用于海底目标识别与底质分类的多波束水体波形预处理

多波束水体数据是多波束系统获取的最原始数据,记录了波束从发射到接收整个过程全部的反向散射强度信息,可以为目标识别、水下栖息环境探测等提供重要的数据支撑.目前,针对多波束水体强度时间序列所表现的波形信息的处理及研究仍处于起步阶段,另外水体波形数据易受噪声影响,且存在明显的入射角效应问题,对此,本文提出了一种基于分区异构的...     

A New Retracking Technique for Brown Peaky Altimetric Waveforms

A new Brown-Peaky (BP) retracker has been developed for peaky waveforms that usually appear within ～10 km to the coastline. The main feature of the BP is that it fits peaky waveforms using the Brown model without introducing a peak function. The retracking strategy first detects the peak location and width of a waveform using an adaptive peak detection method, and then estimates retracking parameters using a weighted least squares (WLS) estimator. The WLS assigns a downsized weight to corrupted waveform gates, but an equal weight to other normal waveform gates. The BP retracker has been applied to 4-year Jason-1 waveform (2002–2006) in two Australian coastal zones. The results retracked by BP, MLE4 and ALES retrackers have been validated against tide-gauge observations located at Burnie, Lorne and Broome. The comparison results show that three retrackers have similar performance over open oceans with the correlation coefficient (～0.7) and RMSE (～13 cm) between altimetric and tide-gauge sea levels for distance >7 km offshore. The main improvement of BP retracker occurs for distance ≤7 km to the coastline, where validation results indicate that data retracked by BP are more accurate (15–21 cm) than those by ALES (16–24 cm) and MLE4 (19–37 cm).     

利用超快速精密星历约束的北斗卫星实时精密定轨

以广播星历为起算轨道的北斗卫星实时滤波精密定轨往往需要较长收敛时间,针对此,提出利用超快速精密星历约束的实时精密定轨方法。通过MGEX跟踪网全球分布的51个测站连续7 d的实测数据,利用平方根信息滤波对北斗卫星实时精密轨道进行确定,并以3 d解事后轨道作为参考,评估北斗卫星实时滤波轨道精度。结果表明,利用广播星历作起算轨道时,北斗实时滤波轨道平均需要经过15 h收敛才能达到稳定,而新方法在这段时间内轨道变化较为平稳,未出现明显的收敛现象,并且7 d时间内GEO卫星在切向、法向和径向上RMS分别优于2.5 m、20 cm和30 cm,IGSO和MEO卫星在3个方向上分别优于30 cm、15 cm和10 cm。
     

机载LiDAR地形特征信息快速提取

为更有效地获取地形特征信息,提出一种机载LiDAR地形特征信息快速提取算法。首先,通过构建二次曲面拟合模型,建立实测LiDAR地形数据与拟合曲面的几何规则;然后,采用LM算法迭代参数寻优,获得最优化结果下的地形拟合参数,计算拟合时间及拟合精度;最后,以地形拟合模型为基础,进行地形特征信息的快速提取。通过机载LiDAR实测数据验证,当最优搜索半径为2 m时,地形曲面的拟合时间仅为0.02 s,RMSE仅为5.09 cm。该算法保证了地形特征信息提取效率和精度,能够有效满足机载LiDAR科学研究和工程应用的技术需求。     

稳健的回光反射平面靶心定位算法

针对因回光反射平面标靶点云数据缺失或冗余而难以准确计算靶心坐标的问题,本文提出一种基于距离标靶重心最远点的边缘点提取和靶心定位算法。首先,进行点云数据预处理,先人工大概选取出标靶点云所在位置,并根据回光反射强度信息提取出标靶点云,对标靶点云进行粗差剔除、投影以及坐标旋转等工作;然后,进行边缘点提取,应用所提的边缘点提取算法对投影到二维平面的标靶点云进行边缘点提取;最后,进行靶心定位,先应用抗差最小二乘对边缘点进行拟合计算圆心坐标,然后将其旋转回三维空间作为靶心坐标计算值。实验结果表明,本文提出的边缘点提取算法能高效、准确地提取出标靶边缘点,比文献[12]中的边缘点提取算法节约了大量时间,并且应用所提取出的边缘点能稳健地计算出靶心坐标,与基准值的偏差在亚毫米以内,优于文献[11]、[12]算法靶心计算精度,有效地解决了残缺或冗余的回光反射平面标靶点云靶心定位问题。     

基于圆柱多段拟合的隧道中轴线提取方法研究

提出基于圆柱多段拟合的隧道中轴线提取方法。首先对隧道点云数据进行预处理,并将点云按隧道走向分成不同区段;然后对各区段依据轴线与表面点云法线垂直关系,提取精度较低的中轴线;最后对各区段利用圆柱多段拟合,提取精度较高的中轴线。实验表明,隧道中轴线的提取在一定的采样区间具有较高的稳定性,对直线和弯曲的圆形隧道有良好的适用性,算法可靠,精度较高。