水平条形均布荷载下横观各向同性弹性地基的位移分析

分析了水平条形均布荷载下横观各向同性地基位移规律,归纳了位移随弹性模量比n之不同而变化的规律,提出了水平条形均布荷载下横观各向同性地基位移的近似简化解,以供岩土工程设计人员参考。     

Projections of ocean climate for northwestern Pacific Ocean

The long-term adjustment processes of atmosphere and ocean in response to gradually increased atmospheric CO2 concentration have been analyzed in 70 and 140a integrations with NCAR fully-coupled climate system model (CSM). In these experiments the CO2 concentration has been increased to double and quadruples the initial concentration, respectively. After 70a, at the time of CO2 doubling, the model predicts surface air temperature rises by 1.2 and 1.5K for the globe and the northwestern Pacific Ocean, respectively. The behavior of the quadrupling run is similar: each global and regional mean surface air temperatures increase by 2.8 and 3.0K at the time of CO2 quadrupling. From the experiments, surface air temperature changes in the northwestern Pacific Ocean will be more distinctive compared with the global average, mainly due to exceptionally large warming and sea level change near the entrance of the Kuroshio extension.     

横向分布载荷作用下简支舟桥甲板的弯曲特性

采用轻质高强铝合金材料设计舟桥的甲板时,其强度计算是初始设计者最为关心的问题之一.本次研究的舟桥甲板采用三层夹心板的结构形式,其横向分布载荷下的挠度和应力的求解问题与一般的单层板不同,虽然可以用有限元法对此进行结构计算,但在初始设计阶段使用该法的计算量大,不方便应用.本文旨在寻求在横向分布载荷作用下,简支条件时,夹心甲板的挠度和应力的解析解,并与有限元计算相比较,为舟桥甲板初始设计提供良好的基础理论.     

造山带区域相对海平面变化与全球海平面变化的不一致性

影响区域相对海平面变化的因素错综复杂,既可以单一作用,也可以相互作用;既可以受全球海平面变化的影响,也可以受局部因素的控制,因此,全球海平面与区域海平面相对变化既可以同步,也可以不同步,尤其在造山带地区可以不一致,甚至相反。只有找出这种控制主导因素,才可以把局部地质场放到全球统一场中去。     

深置矩形基础与地基共同作用解析分析

基于集中力作用下的Mindlin解位移公式,推导得到均布荷载作用下的地基柔度系数,对地基上的四周自由板与地基共同作用进行简化计算,得出了考虑埋深时地基基础共同作用的解析公式。在基础板为刚性和弹性、荷载为集中荷载及均布荷载的情况下,对考虑埋深时的Mindlin解与不考虑埋深时的Boussinesq解的计算结果进行比较,表明,埋深比对于基础沉降、地基反力的分布、基础板的弯矩等都有一定的影响。给出了考虑埋深时的沉降修正系数公式,以供工程应用参考。     

水文模型与陆面模式耦合研究进展

水文模型与陆面模式耦合是目前全球变化研究中的热点问题,如何实现分布式水文模型与陆面过程模式的双向耦合,并将其有机嵌入大气模式中,是未来大气环流模式(GCM)和区域气候模式(RCM)发展和完善的重要目标之一.在简单介绍陆面过程模式和水文模型发展历程的基础上,对水文模型和陆面过程耦合研究的国内外进展进行了综述,指出了模式耦合中存在的共同问题和未来工作的研究要点.最后,探讨了分布式水文模型与陆面模式耦合在全球变化研究框架中的地位与意义,并展望了陆面水文过程发展的主流趋势和研究方向.     

象山港海底某公路隧道最小岩石覆盖厚度及选线方案优化研究

通过对国内外海峡海底隧道的调研分析,归纳得到三种确定最小岩石覆盖厚度的方法——挪威经验公式法、日本最小涌水量预测法以及国内顶水采煤经验法。利用上述三种方法,对象山港海底某公路隧道的最小岩石覆盖层厚度进行工程类比。综合考虑三种方法的分析结果,结合隧道地质条件,获得最优的岩石覆盖厚度。结合隧道海底的地形及地质条件,选择一个剖面作为控制剖面,根据隧道的设计坡度分别得到隧道底板线的位置及各个剖面在设计坡度下的岩石覆盖厚度,并与工程类比厚度比较。根据分析比较结果,调整隧道底板线部分段的坡度,使得隧道在满足安全的条件下,得到最短的隧道线路,从而决定隧道的最优选线方案。     

Genesis of the Mamut Porphyry Copper Deposit, Sabah, East Malaysia

Abstract: The Mamut deposit of Sabah, East Malaysia, is a porphyry type Cu‐Au deposit genetically related to a quartz monzonite (“adamellite”) porphyry stock associated with upper Miocene Mount Kinabalu plutonism. The genesis of the Mamut deposit is discussed based on petrology of the intrusives in the Mount Kinabalu area combined with ore– and alteration–petrography, fluid inclusion and sulfur isotope studies. Groundmass of the adamellite porphyry at Mamut is rich in K which suggests vapor transport of alkaline elements during the mineralizing magmatic process, while the groundmass of the post‐ore “granodiorite” porphyry at Mamut contains small amounts of normative corundum suggesting depletion in alkaline elements at the root zone of the magma column. Sub‐dendritic tremolitic amphibole rims on hornblende phenocrysts in the Mamut adamellite porphyry suggest interaction between the mineralizing magma and the exsolved fluids. Occurrences of clinopyroxene microphenocrysts and pseudomor‐phic aggregates of shredded biotite and clinopyroxene after hornblende phenocrysts in the barren intrusives imply lower water fugacity and decreasing in water fugacity, respectively. Compositional gap between the core of hornblende phenocrysts and the tremolitic amphibole rims and those in the groundmass of the Mamut adamellite porphyry suggests a decrease in pressure. Higher X_Mg (=Mg/(Mg+Fe) atomic ratio) in the tremolitic amphibole rims in the Mamut adamellite porphyry compared to those of the barren intrusions suggests high oxygen fugacity. High halogen contents of igneous hydrous minerals such as amphiboles, biotite and apatite in the Mamut adamellite porphyry suggest the existence of highly saline fluids during the intrusion and solidification of the mineralizing magma. Fluid inclusions found in quartz veinlet stockworks are characterized by abundant hypersaline polyphase inclusions associated with subordinate amounts of immiscible gaseous vapor. Both Cu and Au are dispersed in disseminated and quartz stockwork ores. Chalcopyrite and pyrrhotite as well as magnetite are the principal ore minerals in the biotitized disseminated ores. Primary assemblage of intermediate solid solution (iss) and pyrrhotite converted to the present assemblage of chalcopyrite and pyrrhotite during cooling. Subsequent to biotitization, quartz veinlet stockworks formed associated with retrograde chlorite alteration. The Cu‐Fe sul–fides associated with stockwork quartz veinlet are chalcopyrite and pyrite. Overlapping Pb and Zn and subsequent Sb mineralizations were spatially controlled by NNE‐trending fractures accompanying the phyllic and advanced argillic alteration envelope. Sulfur isotopic composition of ore sulfides are homogeneous (about +2%) throughout the mineralization stages. These are identical to those of the magmatic sulfides of Mount Kinabalu adamellitic rocks.     

Computing Lippmann Diagrams from Direct Calculation of Mixing Properties of Solid Solutions: Application to the Barite-Celestite System

The Lippmann diagram for the system(Ba, Sr)SO₄-H₂O was computed at 25 °Cby determining the solid-phase activity coefficientsfrom first principles calculations. Directcalculations of the mixing properties of thebarite-celestite series indicate this solid solutionbehaves as non-ideal and non-regular. At 25 °C,the enthalpy of mixing shows a minimum around 50 mole% SrSO₄ due to an ordering tendency. Thefree energy of mixing shows two minima that delimit awide and symmetric miscibility gap (from 2.1 to 97.9 mole% SrSO₄) at this temperature. The excessfree energy of mixing requires a Guggenheim expansionseries of 5 terms to be described, where the termswith odd exponents are null as a consequence of thesymmetric distribution of the mixing properties withcomposition. The Lippmann diagram shows a peritecticpoint that corresponds to the composition of an aqueoussolution which is simultaneously at equilibrium withthe two extremes of the miscibility gap. The largedifference between the solubility products of theendmembers involves a strong preferential partitioningof the less soluble endmember towards the solid phase,which explains the extremely Ba-poor composition ofthe aqueous solution (aqueous activity fraction forBa²⁺ = 0.000446 ) at the peritectic point.     

A mixed finite element method for the solution of the magnetostatic problem with highly discontinuous coefficients in 3D

This paper present a new a mixed finite element method for the simulation of magnetostatic problems with highly discontinuous permeability. The method is derived from the well studied mixed formulation for the div-grad system that is known to be accurate for very large discontinuities. The method robustness is demonstrated on a test model problem.