The Dependence of Water Exchanges between the Kuroshio Water and Its Surroundings on the Characteristics of the Kuroshio‘s Meanders

Observation of fluid parcel pathways in the Kuroshio Stream revealed a striking crossstream pattern associated with the Kuroshio‘‘ s meanders. In order to understand the observed pattern, a two-dimensional kinematic model of a meandering jet was developed which could be used to examine the relationship between streamfunction patterns and fluid parcel trajectories. The experiments designed to investigate the dependence of the water exchanges between the Kuroshio water and its surroundings on the characteristics of the Kuroshio‘‘s meanders involved the downstream speed,phase speed and the amplitude of other propagating waves. The results suggested that fluid parcels could cross the meandering jet to and fro; and that the water exchanges between the Kuroshio and its surroundings increased with a) increasing meander amplitude, b) decreasing downstream speed, and c) increasing wave phase speed. The results also showed that when the meandering jet was disturbed by other propagating waves, more effective water exchanges could be induced.     

A Sensitivity Study of Arctic Ice-Ocean Heat Exchange to the Three-Equation Boundary Condition Parametrization in CICE6

In this study, we perform a stand-alone sensitivity study using the Los Alamos Sea ice model version 6(CICE6) to investigate the model sensitivity to two Ice-Ocean(IO) boundary condition approaches. One is the two-equation approach that treats the freezing temperature as a function of the ocean mixed layer(ML) salinity, using two equations to parametrize the IO heat exchanges. Another approach uses the salinity of the IO interface to define the actual freezing temperature, so an equation describ...     

Synthesis of Pb-Feldspar by Ion Exchange Reaction and Its Implications

Feldspar and Pb（NO3）2 were mixed and reacted at T=380℃ to synthesize Pb-feldspar. In the XRD （X-ray diffraction） pattern of the product, the d values （crystal lattice spacing） of the five peaks are 0.654, 0.342, 0.332, 0.327 and 0.257 nm. The XPS analysis results show that the binding energy of Pb 4f（7/2） in the feldspar was between 137.81-138.03 eV. Pb^2＋ can replace alkali and alkali earth cations in the feldspar structure through ion exchange reaction to form Pb-feldspar.     

The biogeochemical sulfur cycle in the marine boundary layer over the Northeast Pacific Ocean

The major components of the marine boundary layer biogeochemical sulfur cycle were measured simultaneously onshore and off the coast of Washington State, U.S.A. during May 1987. Seawater dimethylsulfide (DMS) concentrations on the continental shelf were strongly influenced by coastal upwelling. Concentration further offshore were typical of summer values (2.2 nmol/L) at this latitude. Although seawater DMS concentrations were high on the biologically productive continental shelf (2–12 nmol/L), this region had no measurable effect on atmospheric DMS concentrations. Atmospheric DMS concentrations (0.1–12 nmol/m³), however, were extremely dependent upon wind speed and boundary layer height. Although there appeared to be an appreciable input of non-sea-salt sulfate to the marine boundary layer from the free troposphere, the local flux of DMS from the ocean to the atmosphere was sufficient to balance the remainder of the sulfur budget.     

Hypolimnetic density currents traced by sulphur hexafluoride (SF6)

The artificial tracer sulphur hexafluoride (SF₆) has been used to study the density-driven deep water exchange between two sill-separated basins of Lake Lucerne, Gersauersee and Urnersee. The sources of the density gradients between the two basins are (1) salinity differences between the major inlets due to the different geology of their drainage areas, and (2) temperature differences due to spatial variation of wind forcing. Wind speeds are generally larger in Urnersee, especially in spring during the so-called Föhn events, when winds blow from the south. In contrast, Gersauersee is protected form these winds. In spring 1989, a total of 630 g of SF₆ was released at 80 to 120 m depth in the small Treib Basin located between Urnersee and Gersauersee. During about 100 days the distribution of SF₆ in the lake was determined by gaschromatography. Two models are used to quantify the exchange flow, (1) a one-box mass balance model for SF₆ in the deep part of Treib Basin, and (2) a one-dimensional diffusion/advection model describing the temporal and vertical temperature variation in Urnersee. According to the first model, the flow into the deep hypolimnion of Urnersee, decreases from 21·10⁶ m³·d^?1 at the end of March to about 8·10⁶ m³·d^?1 in late April. The second model yields similar flow rates. The decrease of the flow rate during spring, confirmed by both approaches, is consistent (1) with the decreasing strength of the density gradient above the sill during spring and early summer, and (2) with hydrographic information collected in Lake Lucerne during other years.     

不同水交换量下皱纹盘鲍转录组测序与分析

养殖过程的循环水交换量能够显著影响皱纹盘鲍(Haliotis discus hannai)的生理状态, 进而影响其养殖存活率和生长率, 然而不同循环水量对于皱纹盘鲍的生理状态影响的分子机制尚不明确。本实验以皱纹盘鲍(Haliotis discus hannai)为研究对象, 将鲍分别置于循环水交换频率为1次/d、2次/d、4次/d的条件下(编号为C0、T2和T4组)暂养3 d, 然后利用Illumina Hiseq 2500技术测定不同处理组鲍鱼的肌肉组织中转录组表达情况。结果表明, 单次换水组(C0)和多次换水组(T2和T4)间差异表达的基因个数较多, 分别为4 095和3 617个, 而T2与T4组之间的差异表达基因个数则较少, 仅为232个。对差异表达基因进行GO和KEGG功能分析显示, 单次换水组(C0)和多次换水组(T2和T4)间差异表达的基因主要集中在能量代谢和免疫反应相关通路或基因, 随机选取10个差异基因进行荧光定量PCR验证, 定量PCR结果与转录谱结果一致, 证实了转录组测序结果的可靠性。本研究说明了更高的水交换量下, 鲍的代谢和免疫相关通路被激活, 可能有助于鲍鱼维持较好的生理和免疫状态, 从而表现出更好的生长、存活等表型。     

Cotton Fiber/ZrO2, A New Material for Adsorption of Cr(VI) Ions in Water

The natural cotton fiber was used to synthesize an anion exchange, containing ZrO₂ film on its surface, NCFZC (natural cotton fiber/ZrO₂ composite). This anion exchanger was produced by the reaction of the zirconium oxychloride and hydroxyl groups on surface of the natural cotton fiber. The material was used for Cr(VI) ions adsorption studies. Adsorption equilibrium time and optimum pH for Cr(VI) adsorption were found to be 6 h and 4.0, respectively. The Langmuir and Temkin isotherms were used to models adsorption equilibrium data. The adsorption capacity of NCFZC was found to be 1.33 mmol/g. Kinetic studies showed that the rate of adsorption of Cr(VI) on NCFZC obeyed a pseudo‐second‐order kinetic model.     

地震数据数字化及实时传输

简要地介绍了地震数据国际交换试验系统和台站地震数据实时采集传输系统的组成、各部分的特性与功能、地震数据数字化及实时传输过程。     

Numerical studies of methane production from Class 1 gas hydrate accumulations enhanced with carbon dioxide injection

Class 1 gas hydrate accumulations are characterized by a permeable hydrate-bearing interval overlying a permeable interval with mobile gas, sandwiched between two impermeable intervals. Depressurization-induced dissociation is currently the favored technology for producing gas from Class 1 gas hydrate accumulations. The depressurization production technology requires heat transfer from the surrounding environment to sustain dissociation as the temperature drops toward the hydrate equilibrium point and leaves the reservoir void of gas hydrate. Production of gas hydrate accumulations by exchanging carbon dioxide with methane in the clathrate structure has been demonstrated in laboratory experiments and proposed as a field-scale technology. The carbon dioxide exchange technology has the potential for yielding higher production rates and mechanically stabilizing the reservoir by maintaining hydrate saturations. We used numerical simulation to investigate the advantages and disadvantages of using carbon dioxide injection to enhance the production of methane from Class 1 gas hydrate accumulations. Numerical simulations in this study were primarily concerned with the mechanisms and approaches of carbon dioxide injection to investigate whether methane production could be enhanced through this approach. To avoid excessive simulation execution times, a five-spot well pattern with a 500-m well spacing was approximated using a two-dimensional domain having well boundaries on the vertical sides and impermeable boundaries on the horizontal sides. Impermeable over- and under burden were included to account for heat transfer into the production interval. Simulation results indicate that low injection pressures can be used to reduce secondary hydrate formation and that direct contact of injected carbon dioxide with the methane hydrate present in the formation is limited due to bypass through the higher permeability gas zone.