多时相遥感影像提取湖泊边界信息的融合算法

为了有效改善遥感影像提取湖泊边界信息的可靠性和精度,减少人为误差,提出了一种利用多时相遥感影像提取边界信息的加权平均融合算法以及误差的域法修正处理方法.结果表明,该方法能有效融合各时相影像信息,提高湖泊边界信息提取的可靠性,并且对融合时相变化较大的湖泊边界都有一定的普适性.通过融合算法提取的呼伦湖面积为1928.35km2,修正后的面积为1929.85km2.通过利用地统计学理论对算法的验证及误差分析,得出相对误差空间变异拟合模型的块金方差与基台值之比都小于25%,具有很强的空间相关性,修正后的数据空间相关性要优于融合数据,空间变程也得到了有效地降低,显示修正后的数据对半方差函数理论模型的拟合程度更好.     

滆湖磷迁移过程的研究(一)——磷迁移模型的建立

通过滆湖磷的来源途径(入湖河道、湖区径流、湖面沉降、养殖技饵、底泥释放)和湖体各要素(水体、浮游植物、大型水生植物、鱼类等)中磷迁移过程调查资料的分析,建立了描述磷在上述各要素中迁移过程的数学模型.经实测资料验证,模型的计算值与实测值的平均相对误差在9.9%-18.6%.基本反映了磷的迁移过程及动态变化规律,对该湖磷浓度预测及磷资源合理利用具有重要的意义.     

Pathlines of pollutant migration in groundwater of the Visakhapatnam urban area,India

The groundwater regime in the north‐western part of the Visakhapatnam urban area was polluted as early as 1981 by discharge of untreated industrial effluent from a Hindustan Polymers Limited (HPL) plant. A total dissolved solids (TDS) concentration of surficial effluent up to 6500 mg/l and of groundwater in the range 3000–4200 mg/l has been reported in the environs of the HPL plant during May 1992. Groundwater occurs under water table conditions. The groundwater flow model was simulated as a single layer aquifer, using MODFLOW and FLOWPATH computer models. Aquifer parameters were estimated and the value of effective porosity assumed. The water table configuration was mapped in May 1981 using 33 observation wells. The calibrated hydraulic head distribution was used to compute the velocity field using the effective porosity values. The flow paths of groundwater migration from the source locations up to 2002 AD were predicted. Pathlines of particles in the groundwater indicated a predominant north‐east and south‐west migration of groundwater pollution in the area. Copyright © 1999 John Wiley & Sons, Ltd.     

Seismic inversion modeling method for faulted basins:a case study of Liaohe Beach in Bijialing region

There is not much correlation between sand content and P-wave impedance in faulted basins , and the prediction results cannot be guaranteed .Due to sedimentary facies control , there is inconsistency between sand content and low frequency trend of P-wave impedance , causing problems for seismic inversion modeling , which directly affects final seismic inversion results .The acoustic impedance increases with burial depth .When the same layers of sand and shale formation endure different compaction , the acoustic impedance values will be dif-ferent .Therefore , The seismic inversion modeling of faulted basin is different from that of conventional basins . The authors built an inversion model using uncompact sandstone percentage , directly compensating for the low frequency trend of the inversion model .In addition, the model's intermediate frequency is similar to P-wave im-pedance , ensuring that the inversion results are converged correctly .The final results of the inversion can be used directly as sandstone percentage .The aforementioned method was applied to Liaohe Beach in the Bijialing region and obtained optimistic lithology inversion effects:the results were correlated well with the depositional facies map and with lithology in the well borehole .The inversion results can be used to define the sand body horizontally and can separate sand bodies vertically , which is very difficult on conventional seismic section . Therefore the inversion results played an important role in reservoir prediction .     

青岛日偏食对GPS定位精度的影响

2009年7月22日日全食期间,在青岛采用固定点监测单频GPS信号,同时利用非日食期的单频GPS信号监测数据统计对比分析认为,青岛发生的日偏食现象,对GPS单频接收系统的导航定位精度有影响.表现为误差有所增大,接收卫星数减少,PDOP值增大.短时位置偏差最大值为4.02m,历时2min 48s.但青岛地区日偏食对GPS...     

相位误差、位置误差和灰度误差三者关系及SAR原始图像像元不确定性

由于SAR遥感的独特优势，使它得到了广泛的应用。因此，对SAR图像的不确定性研究也越来越必要和迫切了。针对数据分析方法的不足，该文着重从机理的角度探讨SAR原始像元的不确定性。相位误差、位置误差和灰度误差三者关系、各种误差分类和综合以及这些误差对SAR原始像元不确定性作用等问题往往是困扰从机理角度对SAR图像不确定性研究的主要障碍，该文重点讨论这些问题。     

Modelling road surface sediment production using a vector geographic information system

Field investigations indicate that unpaved roads are the largest sediment source on St John, US Virgin Islands. Cross-sectional measurements of eroded road surfaces were used to establish an empirical relationship to predict annual road surface erosion as a function of road gradient and contributing drainage area. A model (ROADMOD) for estimating and mapping average annual sediment production from a road network was developed by combining this empirical relationship with a series of network algorithms to analyse road data stored in a vector geographic information system. ROADMOD was used to estimate road surface erosion in two St John catchments with very different road densities but similar land cover, topography and soils. Unpaved roads were found to increase sediment production in the more densely roaded catchment by a factor of three to eight, and in the less-roaded catchment by a factor of 1·3–2·0. Turbidity measurements in the receiving bays of these two catchments are consistent with model predictions and observed sediment delivery processes. Although this model was developed specifically for St John, it can easily be adapted to other locations by substituting a locally derived predictive equation for road erosion. Model assumptions, limitations and potential improvements are discussed. © 1998 John Wiley & Sons, Ltd.     

Development and application of a distributed catchment-scale hydrological model for the River Ythan,NE Scotland

Mathematical models are being used to develop a decision support system for integrated management of the Ythan catchment in NE Scotland. One component of this has involved the development of a distributed catchment-scale hydrological model. The model is based on subsurface flow routing and calculates the contribution to stream flow from each 50 m×50 m cell in the 548 km² catchment. It uses two topographic parameters, slope and distance to stream following the main line of flow, and five physical parameters. The topographic analysis and distributed flow accumulation are performed by linking the single cell model with a geographic information system. Preliminary results from a three-year simulation of daily flows indicate that the model successfully predicts the main characteristics of the catchment flow. © 1998 John Wiley & Sons, Ltd.     

Runoff quality prediction from small urban catchments using SWMM

The RUNOFF block of EPA's storm water management model (SWMM) was used to simulate the quantity and quality of urban storm water runoff from four relatively small sites (i.e. 5·97–23·56 ha) in South Florida, each with a specific predominant land use (i.e. low density residential, high density residential, highway and commercial). The objectives of the study were to test the applicability of this model in small subtropical urban catchments and provide modellers with a way to select appropriate input parameters to be used in planning studies. A total of 58 storm events, measured by the US Geological Survey (USGS), provided hyetographs, hydrographs and pollutant loadings for biological oxygen demand (BOD₅), total suspended solids (TSS), total Kjeldahl nitrogen (TKN) and lead (Pb), and were used for calibration of the model. Several other catchment characteristics, also measured or estimated by USGS, were used in model input preparation. Application of the model was done using the Green–Ampt equation for infiltration loss computation, a pollutant accumulation equation using a power build-up equation dependent on the number of dry days, and a power wash-off equation dependent on the predicted runoff rate. Calibrated quantity input parameters are presented and compared with suggested values in the literature. The impervious depression storage was generally found to be the most sensitive calibration parameter, followed by the Manning's roughness coefficients of conduit and overland flow, the Green–Ampt infiltration parameters and, finally, the pervious depression storage. Calibrated quality input parameters are presented in the form of regression equations, as a function of rainfall depth and the number of antecedent dry days. A total of 16 independent rainfall events were used for verification of the model, which showed a good comparison with observed data for both hydrographs and pollutant loadings. Average model predictions for the four constituent concentrations from the verification runs also showed good agreement with NURP published values in Florida and US sites. © 1998 John Wiley & Sons, Ltd.     

Simulation of the direct runoff hydrograph at basin outlet

A simple model describing the transformation of effective rainfall to direct runoff through the overland flow mechanism is presented. The model is based on the classical representation of a watershed by a combination of planes and channels. The dynamics of overland flow in each plane is simulated by the non-linear kinematic wave, but the outflow from a given plane is concentrated in the middle of the corresponding drainage channel. The water routing in the channels is carried out by a piece-wise linearized formulation in space of the kinematic wave approximation. Using synthetic events on 10 watersheds, the model was tested by comparing it with results obtained by applying the non-linear kinematic wave to all the elements of the watershed. The model was found to be adequate, even in a form that simplifies the geometric features of the planes through an averaging procedure based on the Horton–Strahler ordering scheme of the watershed. © 1998 John Wiley & Sons, Ltd.