The effect of water on stress relaxation of faulted and unfaulted sandstone

A series of stress relaxation experiments have been carried out on faulted and intact Tennessee sandstone to explore the influence of pore water on strength at different strain rates. Temperatures employed were 20, 300 and 400°C, effective confining pressure was 1.5 kb and strain rates as low as 10^–10 sec^–1 were achieved. Most samples were prefaulted at 2.5 kb confining pressure and room temperature. This is thought to have secured a reproducible initial microstructure.The strength of the dry rock was almost totally insensitive to strain rate in the range 10^–4 to 10^–10 sec^–1. In contrast, the strength of the wet rock decreased rapidly with strain rate at rates less than 10^–6 sec^–1. Brittle fracture of the quartz grains which constitute this rock is the most characteristic mode of failure under the test conditions used.The experimental data are discussed in terms of the possible deformation rate controlling processes, and it is suggested that in the wet experiments at intermediate to high strain rates (10^–7 to 10^–4 sec^–1) the observed deformation rate is controlled by the kinetics of water assisted stress corrosion, whilst deformation at low strain rates (ca. 10^–9 sec^–1) is controlled by a pressure solution process.The results have implications for the rheology of fault rocks at depths of perhaps 10 to 15 km in sialic crust.     

Velocities of elastic waves andv P/v S ratios in dry and water-saturated rock samples at high pressure

Elastic wave velocities and the ratiov _P/v _S were studied for dry and initially saturated samples of carbonate and crystalline rocks at pressures to 2 kbar. In initially saturated samplesv _P increases in crystalline rock, whereas in sedimentary rock it may either increase or decrease with increasing pressure. Under the same conditionsv _S remains approximately constant in crystalline rocks and decreases in sedimentary samples. The ratiov _P/v _S as a function of pressure increases in dry rocks and decreases in saturated ones. Saturated samples always have higherv _P/v _S ratios than dry ones. It appears that the geometry of the pore space influences the acoustic properties of saturated crystalline rocks.     

裂纹间动态相互作用的实验观测与理论分析──以共线剪切裂纹归并为例

本文以共线剪切裂纹的归并为例,研究裂纹系的动态相互作用．实验结果表明：在张破裂的意义上,小间距共线剪切裂纹的内端部实际上是阻碍结构,通过迂回弯曲的张破裂归并．本文提出一种估计张破裂扩展途径的近似方法,利用张应力破裂判据找出了潜在的破裂扩展途径的第一近似,较好地模拟了共线裂纹的破裂途径,和现有的数值模拟方法比较,可以大大缩短机时,简化计算程序,保证精确度．本研究结出了岩石剪切破裂“隧道效应”（即破裂跳过障碍体,而障碍体本身不破坏）的机理,还给出了脆性介质在摩擦、磨损过程中碎屑产生的机理．     

Experimental study and constitutive modelling of elasto‐plastic damage in heat‐treated mortar

This study investigates the effect of a heat‐treatment upon the thermo‐mechanical behaviour of a model cement‐based material, i.e. a normalized mortar, with a (w/c) ratio of 0.5. First, a whole set of varied experimental results is provided, in order to either identify or validate a thermo‐mechanical constitutive model, presented in the second paper part. Experimental responses of both hydraulic and mechanical behaviour are given after different heating/cooling cycling levels (105, 200, 300, 400^°C). The reference state, used for comparison purposes, is taken after mass stabilization at 60^°C. Typical uniaxial compression tests are provided, and original triaxial deviatoric compressive test responses are also given. Hydraulic behaviour is identified simultaneously to triaxial deviatoric compressive loading through gas permeability K_gas assessment. K_gas is well correlated with volumetric strain evolution: gas permeability increases hugely when ε_v testifies of a dilatant material behaviour, instead of contractile from the test start. Finally, the thermo‐mechanical model, based on a thermodynamics approach, is identified using the experimental results on uniaxial and triaxial deviatoric compression. It is also positively validated at residual state for triaxial deviatoric compression, but also by using a different stress path in lateral extension, which is at the origin of noticeable plasticity. Copyright © 2009 John Wiley & Sons, Ltd.     

The journal Communications in Numerical Methods in Engineering with Biomedical Applications becomes the International Journal for Numerical Methods in Biomedical Engineering (IJNMBE) from 1st January 2010

Communications in Numerical Methods in Engineering, founded by Roland W. Lewis in 1985, will change its title to the ‘International Journal for Numerical Methods in Biomedical Engineering’ and has a revised Aims and Scope. Copyright © 2009 John Wiley & Sons, Ltd.     

����ˮ׼ϵͳ��������ѧ�о�

?????????????????????????????????е???????,???????????????????????????????????????????????????????????????HLS???????????????????     

A New Protocol for the Astrometric Follow-up of Near Earth Asteroids

A new protocol was devised to improve the efficiency of astrometric follow-up observations of Near Earth Asteroids for the accurate determination of their orbits. It was implemented in the activities of the Spaceguard Central Node (SCN, a facility of the Spaceguard Foundation, established with the support of the European Space Agency) in the form of a Priority List. Here we describe this protocol and results obtained during five years of activity (2000–2004).     

A Survey of Newtonian Core-Shell Systems with Pseudo High Order Symplectic Integrator and Fast Lyapunov Indicator

Newtonian core-shell systems, as limiting cases of relativistic core-shell models under the two conditions of weak field and slow motion, could account for massive circumstellar dust shells and rings around certain types of star remnants. Because this kind of systems have Hamiltonians that can be split into a main part and a small perturbing part, a good choice of the numerical tool is the pseudo 8th order symplectic integrator of Laskar ＆ Robutel, and, to match the symplectic calculations, a good choice of chaos indicator is the fast Lyapunov indicator （FLI） with two nearby trajectories proposed by Wu, Huang ＆ Zhang. Numerical results show that the FLI is very powerful when describing not only the transition from regular motion to chaos but also the global structure of the phase space of the system.